Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Optimizing up-conversion single-photon detectors for quantum key distribution

Ni Yao, Quan Yao, Xiu-Ping Xie, Yang Liu, Peizhen Xu, Wei Fang, Ming-Yang Zheng, Jingyun Fan, Qiang Zhang, Limin Tong, Jian-Wei Pan

Published Aug 3, 2020• 21 citations
Publisher

Abstract

High-performance single-photon detectors (SPDs) at 1550-nm band are critical for fiber-based quantum communications. Among many types of SPDs, the up-conversion SPDs based on periodically poled lithium niobate waveguides are of great interest. Combined with a strong pump laser, the telecom single-photons are converted into short wavelength ones and detected by silicon-based SPDs. However, due to the difficulty of precise controlling waveguide profile, the direct coupling between a single-mode fiber and the waveguide is not efficient. Here by utilizing fiber taper with proper diameter, optimal mode-matching is achieved and coupling efficiency up to 93% is measured. With an optimized design, a system detection efficiency of 36% and noise counting rate of 90 cps are realized. The maximum detection efficiency is characterized as 40% with a noise counting rate of 200 cps. Numerical simulation results indicate that our device can significantly improve the performance of QKD and extend the communication distance longer than 200 km.

DOI
10.1364/oe.397767

Related papers

Efficient and low-noise single-photon detection in 1550 nm communication band by frequency upconversion in periodically poled LiNbO_3 waveguides

Hidehiko Kamada, Masaki Asobe, Toshimori Honjo +5 more

We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).

Optics Letters•Mar 18, 2008•50 citations

Detection and spectral measurement of single photons in communication bands using up-conversion technology

Long Ma, Oliver Slattery, Xiao Hong Tang

Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.

Laser Physics•Apr 2, 2010•11 citations

Low-noise PPLN-based single-photon detector

Xu Hai, Lijun Ma, Oliver Slattery +1 more

This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 9, 2007•13 citations

Low jitter up-conversion detectors for telecom wavelength GHz QKD

Rob Thew, Sébastien Tanzilli, L. Krainer +6 more

We have developed a hybrid single photon detection scheme for telecom wavelengths based on nonlinear sum-frequency generation and silicon single-photon avalanche diodes (SPADs). The SPAD devices employed have been designed to have very narrow temporal response, i.e. low jitter ∼40 ps, which we can exploit for increasing the allowable bit rate for quantum key distribution. The wavelength conversion is obtained using periodically poled lithium niobate waveguides (W/Gs). The inherently high efficiency of these W/Gs allows us to use a continuous wave laser to seed the nonlinear conversion so as to have a continuous detection scheme. We also present a 1.27 GHz qubit repetition rate, one-way phase encoding, quantum key distribution experiment operating at telecom wavelengths that takes advantage of this detection scheme. The proof-of-principle experiment shows a system capable of MHz raw count rates with a QBER less than 2% and estimated secure key rates greater than 100 kbit s −1 over 25 km.

arXiv:quant-ph/0512054•New Journal of Physics•Mar 6, 2006•139 citations

Long-wavelength-pumped upconversion single-photon detector at 1550 nm: performance and noise analysis

Jason S. Pelc, Long Ma, Christopher R. Phillips +5 more

We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.

Optics Express•Oct 17, 2011•242 citations

Upconversion single-photon detectors based on integrated periodically poled lithium niobate waveguides [Invited]

Fei Ma, Longyue Liang, Jiu-Peng Chen +6 more

We demonstrate upconversion single-photon detectors based on integrated periodically poled lithium niobate waveguides that incorporate two mode filters and a directional coupler. The two mode filters are optimized for the fiber-waveguide coupling efficiencies for 1550 and 1950 nm, respectively, while the directional coupler plays the role of wavelength combiner, making the overall system portable and low cost. The two wavelengths pump each other in our detection system. We achieve detection efficiencies of 28% for 1550 nm and 27% for 1950 nm, respectively. This scheme provides an efficient integrated single-photon detection method for any two well-separated spectral bands in the whole low-loss range of lithium niobate waveguides.

arXiv:1902.06464•Journal of the Optical Society of America B•Aug 7, 2018•25 citations
High-performance single-photon detectors (SPDs) at 1550-nm band are critical for fiber-based quantum communications. Among many types of SPDs, the up-conversion SPDs based on periodically poled lithium niobate waveguides are of great interest. Combined with a strong pump laser, the telecom single-photons are converted into short wavelength ones and detected by silicon-based SPDs. However, due to the difficulty of precise controlling waveguide profile, the direct coupling between a single-mode fiber and the waveguide is not efficient. Here by utilizing fiber taper with proper diameter, optimal mode-matching is achieved and coupling efficiency up to 93% is measured. With an optimized design, a system detection efficiency of 36% and noise counting rate of 90 cps are realized. The maximum detection efficiency is characterized as 40% with a noise counting rate of 200 cps. Numerical simulation results indicate that our device can significantly improve the performance of QKD and extend the communication distance longer than 200 km.
We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).
Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.
This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.
We have developed a hybrid single photon detection scheme for telecom wavelengths based on nonlinear sum-frequency generation and silicon single-photon avalanche diodes (SPADs). The SPAD devices employed have been designed to have very narrow temporal response, i.e. low jitter ∼40 ps, which we can exploit for increasing the allowable bit rate for quantum key distribution. The wavelength conversion is obtained using periodically poled lithium niobate waveguides (W/Gs). The inherently high efficiency of these W/Gs allows us to use a continuous wave laser to seed the nonlinear conversion so as to have a continuous detection scheme. We also present a 1.27 GHz qubit repetition rate, one-way phase encoding, quantum key distribution experiment operating at telecom wavelengths that takes advantage of this detection scheme. The proof-of-principle experiment shows a system capable of MHz raw count rates with a QBER less than 2% and estimated secure key rates greater than 100 kbit s −1 over 25 km.
We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.
We demonstrate upconversion single-photon detectors based on integrated periodically poled lithium niobate waveguides that incorporate two mode filters and a directional coupler. The two mode filters are optimized for the fiber-waveguide coupling efficiencies for 1550 and 1950 nm, respectively, while the directional coupler plays the role of wavelength combiner, making the overall system portable and low cost. The two wavelengths pump each other in our detection system. We achieve detection efficiencies of 28% for 1550 nm and 27% for 1950 nm, respectively. This scheme provides an efficient integrated single-photon detection method for any two well-separated spectral bands in the whole low-loss range of lithium niobate waveguides.