Coherent transient effects using a frequency-switched CO 2 laser (A)

Richard G. Brewer, Azriel Z. Genack

R. G. De Voe, Richard G. Brewer

Ralph G. DeVoe, Richard G. Brewer

Maryna D'Souza, Arvind Kumar

A new method of observing two-photon optical transients is proposed, namely, by intensity switching of incident cw laser beams. This method, which is an alternative to the standard dc Stark or frequency-switching techniques, employs the second-order optical (ac) Stark effect to throw the two-photon active levels in or out of resonance by appropriately switching the intensities of the two laser beams. Theoretical treatment for the three basic transients optical nutation, free induction decay, and two-pulse echo in thin samples using intensity switching, is given for both the cases: co- and counter-propagating beams. The feasibility of the method for the $5{S}_{\frac{1}{2}}\ensuremath{-}3{S}_{\frac{1}{2}}$ transition in Na vapor is demonstrated. An important feature is the apearance of an intensity-dependent beat frequency in the optical FID signal.

A. H. Zewail

Recently we have reported[1] on the measurements of electronic dephasing (T_2) and radiationless decay (T_1) in molecules using emission spectroscopy as a probe for the detection of the photon echo. This right-angle photon echo utilizes a single mode of a narrow-band (~MHz) cw dye laser and an intracavity electro-optical (EO) element that modulates the frequency of the laser.[2] Applying voltage pulses into the EO crystal switches the laser frequency from ω_0 (the peak frequency of the transition resonance) into another frequency ω. This switching procedure introduced by Brewer et al. for the observation of transients in the forward direction of the laser allows one to observe coherent transients in gases,[1,2] solids[3-5] and molecular beams.[6] Typically, the dispersion of the nonlinear EO crystal (e.g., AD*P) gives a 60 MHz frequency shift within the inhomogeneous resonance of the optical transition (width ~GHz or larger). Therefore, to switch the laser frequency further, one must use high-voltage signals that are usually hard to obtain especially for multiple-pulse experiments. Secondly, there is a limit on the frequency shift which is conditioned by the mode spacing of the cavity. Thirdly, because the laser is switched into a new group of molecules some complications may arise in interpreting the transient spectra especially in large molecules. This is because in large molecules the density of excited states is high and thus the buildup of transients of w molecules (which could be complex) will be superimposed on the decay of ω_0 molecules. Finally, off-resonance effects (e.g., beats) between the molecules at frequency ω and ω_0 cannot be avoided.

Azriel Z. Genack, Richard G. Brewer

A simple method for observing coherent optical-transient phenomena is described. Effects such as photon echoes and free induction decay (FID) should allow studies of the dynamic properties of atoms, molecules, and solids on a time scale ranging from milliseconds to \ensuremath{\sim} 50 ps. The frequency of a cw dye laser is switched with an intracavity electro-optic modulator, producing in an external sample coherent transients which are detected in the forward beam. Measurements of long dephasing times are possible, as in FID, because the laser can oscillate indefinitely at the new frequency following a step-function switching pulse. Measurements of short decay times are also practical because the switching time is not restricted by the laser gain or cavity ringing time. In addition, the dye's dephasing time of a few picoseconds or less is too rapid to interfere with these observations. Since the pulse sequence can be preselected, the entire class of coherent optical transients is accessible. The method thus incorporates all of the advantages inherent in Stark switching, including heterodyne detection and high sensitivity, without being restricted to Stark-tunable systems. Laser frequency switching is discussed also in terms of a theoretical model which exposes the time-dependent properties of a phase-modulated cavity mode. Dephasing studies have been carried out thus far in atomic and molecular gases and low-temperature solids containing inorganic impurity ions or large organic molecules. The utility of the FID effect is emphasized where precise dephasing times are obtained from time-frequency Fourier transformation of FID signals using a digital computer. The first quantitative and detailed test of FID theory is provided by these experimental techniques.