Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

OSA Continuum

Constructive interference atomic clock scheme based on coherent population trapping and an extended optical cavity

Suping Qu, De-Huan Cai

Published Jun 5, 2020• 0 citations
Publisher

Abstract

We studied experimentally a left-right circularly polarized light feedback scheme. A vertical-cavity surface-emitting laser (VCSEL) and partial retroreflector formed an extended cavity, allowing ∼4% of the laser to enter the VCSEL. Such design helped to improve the microwave modulation efficiency. Comparing to the conventional circularly polarized light scheme, the resonance amplitude of this method was doubled while the noise was reduced five times because of the usage of the left-right circularly polarized light, which continuously interacted with atoms. The short-term instability was improved by one order of magnitude. This scheme can be applied to small or chip-scale atomic clocks.

DOI
10.1364/osac.392704

Related papers

Interference-enhanced and power-reduced CPT atomic realization approach with an external cavity

Suping Qu, De-Huan Cai

A scheme is studied for a coherent population trapping (CPT) atomic clock with counterpropagating left and right circularly polarized lasers, wherein the vertical-cavity surface-emitting laser and the partially reflecting mirror form an external cavity of an established length. With cancellation of spin-polarized dark states and interaction repeated with atoms, a CPT signal is obtained that is eight times larger than that of the conventional scheme. For the improvement of modulation efficiency, CPT resonance still can be excited with a lower microwave power compared with the conventional scheme. The experimental results suggest that it is an alternative for low-power atomic clocks.

Applied Optics•Jul 18, 2019•1 citation

Coherent population trapping resonance scheme of simultaneously noise suppression and multiple constructive interferences

Suping Qu, Yi Yin, Xianyang Lu

Traditional coherent population trapping (CPT) atomic clocks use single circularly polarized coherent multichromatic light to interact with atoms for preparing CPT dark states. While this configuration is simple, it suffers from the trap states and involves only the ±1st-order sidebands in the CPT resonance, excluding the carrier and other sidebands. This results in a lower CPT signal amplitude and higher laser noise, limiting the frequency stability of CPT atomic clocks. To address this issue, we developed and experimentally validated a scheme utilizing left- and right-circularly polarized light based on multiple coherent superpositions. This scheme significantly enhances the amplitude of the CPT resonance. Furthermore, by incorporating a Michelson interferometer, the polarization direction of the ±1st-order sidebands in the coherent multichromatic light is adjusted from parallel to perpendicular, enabling the filtering of one sideband to be detected while eliminating other unwanted sidebands and effectively suppressing laser noise. The results show that, under identical conditions, the short-term frequency stability of this method is theoretically improved by a factor of seven compared to the traditional circularly polarized light scheme, providing an effective pathway for the development of high-performance CPT atomic clocks.

Review of Scientific Instruments•Jun 1, 2026•0 citations

Performance of a prototype atomic clock based on lin‖lin coherent population trapping resonances in Rb atomic vapor

Eugeniy E. Mikhailov, Travis Horrom, Nathan Belcher +1 more

We report on the performance of the first table-top prototype atomic clock based on coherent population trapping (CPT) resonances with parallel linearly polarized optical fields (lin‖lin configuration). Our apparatus uses a vertical-cavity surface-emitting laser (VCSEL) tuned to the D1 line of 87Rb with the current modulation at the 87Rb hyperfine frequency. We demonstrate cancellation of the first-order light shift by the proper choice of rf modulation power and further improve our prototype clock stability by optimizing the parameters of the microwave lock loop. Operating in these optimal conditions, we measured a short-term fractional frequency stability (Allan deviation) 2×10−11τ−1/2 for observation times 1 s ≤ τ ≤ 20 s. This value is limited by large VCSEL phase noise and environmental temperature fluctuation. Further improvements in frequency stability should be possible with an apparatus designed as a dedicated lin‖lin CPT resonance clock with environmental impacts minimized.

arXiv:0910.5881•Journal of the Optical Society of America B•Feb 3, 2010•53 citations

VCSELs for atomic clocks

Darwin K. Serkland, Gregory M. Peake, K.M. Geib +4 more

The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 9, 2006•60 citations

Spin-polarized dark state free CPT state preparation with co-propagating left and right circularly polarized lasers

Yi Zhang, Suping Qu, Sihong Gu

We have developed and experimentally studied a coherent population trapping (CPT) state preparation scheme for atomic clock application with co-propagating left and right circularly polarized lasers. With realization of constructive interference and spin-polarized dark state free in CPT state preparation, we have obtained CPT resonance signal 3 times larger than that of the conventional scheme used in atomic clock. Polarization fluctuations and CPT signal sensitivity to laser power behaviors are both improved with the scheme. Our study reveals that it is a promising candidate for both normal-size and chip-scale CPT atomic clocks.

Optics Express•Mar 5, 2012•29 citations

External Cavity Laser for Chip-Scale Atomic Clock

Jie Miao, Jiqing Lian, Tianyu Liu +2 more

In this paper we report a new coherent population trapping (CPT) atomic clock based on external cavity laser. Unlike usual CPT atomic clocks, where used the vertical cavity surface emitting laser (VCSEL), we combine the external cavity laser (ECL) with CPT atomic clock to improve the stability. Compared with VCSEL, the ECL has higher laser power of 10 mW and narrower linewidth of 0.8 MHz, meaning that the signal-to-noise ratio of clock can be further improved.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 15, 2023•1 citation
We studied experimentally a left-right circularly polarized light feedback scheme. A vertical-cavity surface-emitting laser (VCSEL) and partial retroreflector formed an extended cavity, allowing ∼4% of the laser to enter the VCSEL. Such design helped to improve the microwave modulation efficiency. Comparing to the conventional circularly polarized light scheme, the resonance amplitude of this method was doubled while the noise was reduced five times because of the usage of the left-right circularly polarized light, which continuously interacted with atoms. The short-term instability was improved by one order of magnitude. This scheme can be applied to small or chip-scale atomic clocks.
A scheme is studied for a coherent population trapping (CPT) atomic clock with counterpropagating left and right circularly polarized lasers, wherein the vertical-cavity surface-emitting laser and the partially reflecting mirror form an external cavity of an established length. With cancellation of spin-polarized dark states and interaction repeated with atoms, a CPT signal is obtained that is eight times larger than that of the conventional scheme. For the improvement of modulation efficiency, CPT resonance still can be excited with a lower microwave power compared with the conventional scheme. The experimental results suggest that it is an alternative for low-power atomic clocks.
Traditional coherent population trapping (CPT) atomic clocks use single circularly polarized coherent multichromatic light to interact with atoms for preparing CPT dark states. While this configuration is simple, it suffers from the trap states and involves only the ±1st-order sidebands in the CPT resonance, excluding the carrier and other sidebands. This results in a lower CPT signal amplitude and higher laser noise, limiting the frequency stability of CPT atomic clocks. To address this issue, we developed and experimentally validated a scheme utilizing left- and right-circularly polarized light based on multiple coherent superpositions. This scheme significantly enhances the amplitude of the CPT resonance. Furthermore, by incorporating a Michelson interferometer, the polarization direction of the ±1st-order sidebands in the coherent multichromatic light is adjusted from parallel to perpendicular, enabling the filtering of one sideband to be detected while eliminating other unwanted sidebands and effectively suppressing laser noise. The results show that, under identical conditions, the short-term frequency stability of this method is theoretically improved by a factor of seven compared to the traditional circularly polarized light scheme, providing an effective pathway for the development of high-performance CPT atomic clocks.
We report on the performance of the first table-top prototype atomic clock based on coherent population trapping (CPT) resonances with parallel linearly polarized optical fields (lin‖lin configuration). Our apparatus uses a vertical-cavity surface-emitting laser (VCSEL) tuned to the D1 line of 87Rb with the current modulation at the 87Rb hyperfine frequency. We demonstrate cancellation of the first-order light shift by the proper choice of rf modulation power and further improve our prototype clock stability by optimizing the parameters of the microwave lock loop. Operating in these optimal conditions, we measured a short-term fractional frequency stability (Allan deviation) 2×10−11τ−1/2 for observation times 1 s ≤ τ ≤ 20 s. This value is limited by large VCSEL phase noise and environmental temperature fluctuation. Further improvements in frequency stability should be possible with an apparatus designed as a dedicated lin‖lin CPT resonance clock with environmental impacts minimized.
The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.
We have developed and experimentally studied a coherent population trapping (CPT) state preparation scheme for atomic clock application with co-propagating left and right circularly polarized lasers. With realization of constructive interference and spin-polarized dark state free in CPT state preparation, we have obtained CPT resonance signal 3 times larger than that of the conventional scheme used in atomic clock. Polarization fluctuations and CPT signal sensitivity to laser power behaviors are both improved with the scheme. Our study reveals that it is a promising candidate for both normal-size and chip-scale CPT atomic clocks.