Resonator-based Hole Spin Qubit Readout
Eoin G. Kelly
Spin qubits in gate-defined semiconductor quantum dots are a promising platform for realising a scalable quantum computer. This platform encodes quantum information into the intrinsic angular momentum (spin) of individual electrons or holes. In particular, hole spins in quantum dots enable the possibility of all-electrical spin control due to their intrinsic spin-orbit coupling. One important criterion of a quantum computer is the ability to reliably read out the state of the qubit. This is done by mapping spin information to the charge degree of freedom, combined with a method for charge detection. Charge detection can be facilitated by coupling a resonator directly to the quantum dot gate or to a charge sensor and measuring the resonator's phase or amplitude response. In this thesis, we describe a set of experiments relating to the implementation of hole spin qubit readout with superconducting resonators. First, we study gate-based charge sensing in a Si fin field-effect transistor (finFET) device using a superconducting NbN nanowire resonator. We find that the resonator amplifies capacitive crosstalk when electrical control pulses are applied to gate electrodes in this device. This occurs whenever a spectral component of qubit control pulses overlaps with the resonance frequency, which we show may occur for both baseband and radio-frequency (RF) drive signals. We quantify this crosstalk in a transport-based method, and attribute its source to the capacitance between the bondpads of neighbouring gate electrodes. In a second experiment, we use an RF charge sensor with the same nanowire technology to read out hole spin qubits formed in the quantum well of a Ge/SiGe heterostructure. A screening layer approach is used to facilitate RF matching due to large RF dissipation found in the heterostructure. We implement a double-latched readout scheme in this system to reduce errors arising from both spin and charge decay during readout. The spin-to-charge conversion process and its dependence on magnetic field orientation is studied. Spin and charge decay processes arising after spin-to-charge conversion are mitigated by choosing an optimal working point for the field orientation, field amplitude and readout pulse times. By doing so, we achieve an average single-shot state-preparation-and-measurement fidelity of 97%, primarily bounded by imperfect state preparation and limited signal-to-noise ratio. Finally, we study coplanar waveguide resonators fabricated from NbN. We investigate the feasibility of integrating this type of resonator onto the same chip as the Si finFET quantum dots. We then develop a novel resonator readout technique by the interference of two microwave sidebands. We demonstrate the insensitivity of this technique to common-mode phase and amplitude noise both theoretically and experimentally. This technique is then used to study resonator noise arising from two-level system defects. These results highlight both the practical constraints and the potential for achieving high readout fidelities using resonator-based hole spin qubit readout. This work establishes a blueprint for mitigating resonator-induced crosstalk and enabling high-fidelity readout in lossy materials by incorporating a screening layer.
•Jan 1, 2025•0 citations