Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

apra

Phonon Recycling for Ultrasensitive Kinetic Inductance Detectors

Jonas Stasys Zmuidzinas

Published Jan 1, 2014• 0 citations
OpenAlex

Related papers

Properties of a Nanowire Kinetic Inductance Detector Array

Jacob Glasby, Adrian K. Sinclair, Philip D. Mauskopf +4 more

Journal of Low Temperature Physics•Dec 23, 2019•1 citation

Ultrasensitive hot-electron kinetic-inductance detectors operating well below the superconducting transition

Andrei V. Sergeev, Vladimir Mitin, Boris S. Karasik

While most experimental studies of kinetic-inductance sensors have been limited so far by the temperature range near the superconducting transition, kinetic-inductance detectors can be very sensitive at temperatures well below the transition, where the number of equilibrium quasiparticles is exponentially small. In this regime, a shift of the quasiparticle chemical potential under radiation results in the change of the kinetic inductance. We modeled the noise characteristics of the kinetic-inductance detectors made from disordered superconducting Nb, NbC, and MoRe films. Low-phonon transparency of the interface between the superconductor and the substrate causes substantial retrapping of phonons providing high quantum efficiency and the operating time of ∼1 ms at ≈1 K. Due to the small number of quasiparticles, the noise equivalent power of the detector determined by the quasiparticle generation–recombination noise can be as small as ∼10−19 W/Hz at He4 temperatures.

Applied Physics Letters•Feb 4, 2002•77 citations

Ultrasensitive hot-electron kinetic-inductance detectors

A. Sergeev, Boris S. Karasik, I. G. Gogidze +1 more

While experimental studies of kinetic-inductance sensors have been limited so far by the temperature range near the superconducting transition, these detectors can be very sensitive at temperatures well below the transition, where the number of equilibrium quasiparticles is exponentially small. In this regime, a shift of the quasiparticle chemical potential under radiation results in the change of the kinetic inductance, which can be measured by a sensitive SQUID readout. We modeled the kinetic inductance response of detectors made from disordered superconducting Nb, NbC, and MoRe films. Low phonon transparency of the interface between the superconductor and the substrate causes substantial re-trapping of phonons providing high quantum efficiency and the operating time of ∼1 ms at ≈1 K. Due to the small number of quasiparticles, the noise equivalent power of the detector determined by the quasiparticle generation-recombination noise can be as small as ∼10−19 W/√Hz at He4 temperatures.

AIP conference proceedings•Jan 1, 2002•3 citations

Lumped Element Kinetic Inductance Detectors

Simon M. Doyle, Philip D. Mauskopf, Jack Alexander Naylon +2 more

Journal of Low Temperature Physics•Jan 10, 2008•285 citations

Mitigation of cosmic ray effect on microwave kinetic inductance detector arrays

K. Karatsu, Akira Endo, Juan Bueno +6 more

For space observatories, the glitches caused by high energy phonons created by the interaction of cosmic ray particles with a detector substrate lead to dead time during observation. Mitigating the impact of cosmic rays is therefore an important requirement for detectors to be used in future space missions. In order to investigate possible solutions, we carry out a systematic study by testing four large arrays of Microwave Kinetic Inductance Detectors (MKIDs), each consisting of ∼960 pixels and fabricated on monolithic 55 mm × 55 mm × 0.35 mm Si substrates. We compare the response to cosmic ray interactions in our laboratory for different detector arrays: A standard array with only the MKID array as reference, an array with a low Tc superconducting film as a phonon absorber on the opposite side of the substrate, and arrays with MKIDs on membranes. The idea is that the low Tc layer down converts the phonon energy to values below the pair breaking threshold of the MKIDs, and the membranes isolate the sensitive part of the MKIDs from phonons created in the substrate. We find that the dead time can be reduced up to a factor of 40 when compared to the reference array. Simulations show that the dead time can be reduced to below 1% for the tested detector arrays when operated in a spacecraft in an L2 or a similar far-Earth orbit. The technique described here is also applicable and important for large superconducting qubit arrays for future quantum computers.

arXiv:1901.02387•Applied Physics Letters•Jan 21, 2019•63 citations

Towards X-ray Thermal Kinetic Inductance Detectors

Antonino Miceli, T. Cecil, Lisa Gades +1 more

Journal of Low Temperature Physics•Jan 7, 2014•13 citations
While most experimental studies of kinetic-inductance sensors have been limited so far by the temperature range near the superconducting transition, kinetic-inductance detectors can be very sensitive at temperatures well below the transition, where the number of equilibrium quasiparticles is exponentially small. In this regime, a shift of the quasiparticle chemical potential under radiation results in the change of the kinetic inductance. We modeled the noise characteristics of the kinetic-inductance detectors made from disordered superconducting Nb, NbC, and MoRe films. Low-phonon transparency of the interface between the superconductor and the substrate causes substantial retrapping of phonons providing high quantum efficiency and the operating time of ∼1 ms at ≈1 K. Due to the small number of quasiparticles, the noise equivalent power of the detector determined by the quasiparticle generation–recombination noise can be as small as ∼10−19 W/Hz at He4 temperatures.
While experimental studies of kinetic-inductance sensors have been limited so far by the temperature range near the superconducting transition, these detectors can be very sensitive at temperatures well below the transition, where the number of equilibrium quasiparticles is exponentially small. In this regime, a shift of the quasiparticle chemical potential under radiation results in the change of the kinetic inductance, which can be measured by a sensitive SQUID readout. We modeled the kinetic inductance response of detectors made from disordered superconducting Nb, NbC, and MoRe films. Low phonon transparency of the interface between the superconductor and the substrate causes substantial re-trapping of phonons providing high quantum efficiency and the operating time of ∼1 ms at ≈1 K. Due to the small number of quasiparticles, the noise equivalent power of the detector determined by the quasiparticle generation-recombination noise can be as small as ∼10−19 W/√Hz at He4 temperatures.
For space observatories, the glitches caused by high energy phonons created by the interaction of cosmic ray particles with a detector substrate lead to dead time during observation. Mitigating the impact of cosmic rays is therefore an important requirement for detectors to be used in future space missions. In order to investigate possible solutions, we carry out a systematic study by testing four large arrays of Microwave Kinetic Inductance Detectors (MKIDs), each consisting of ∼960 pixels and fabricated on monolithic 55 mm × 55 mm × 0.35 mm Si substrates. We compare the response to cosmic ray interactions in our laboratory for different detector arrays: A standard array with only the MKID array as reference, an array with a low Tc superconducting film as a phonon absorber on the opposite side of the substrate, and arrays with MKIDs on membranes. The idea is that the low Tc layer down converts the phonon energy to values below the pair breaking threshold of the MKIDs, and the membranes isolate the sensitive part of the MKIDs from phonons created in the substrate. We find that the dead time can be reduced up to a factor of 40 when compared to the reference array. Simulations show that the dead time can be reduced to below 1% for the tested detector arrays when operated in a spacecraft in an L2 or a similar far-Earth orbit. The technique described here is also applicable and important for large superconducting qubit arrays for future quantum computers.