This paper proposes a new location-based multicasting technique, for dual phase amplify-and-forward (AF) large networks, aiming to improve the security in the presence of non-colluding passive eavesdroppers. These eavesdroppers could also be part of this cooperative network as relays. In order to reduce the impact of these eavesdroppers on the network security, we propose a new transmission strategy where, for the first hop of each transmission time, while the destination is jamming, the source randomly chooses a different subset K of the total T relays, to transmit its message toward the destination. For practical implementation, sectoral transmission can be achieved with analog beamforming at the source's side. In the second hop, using the distributed beamforming technique, the K AF relays retransmit the received signal to the destination. We analytically demonstrated that the proposed technique decreases the probability of choosing the same sector that has certain eavesdroppers again, for each transmission time, to K/T. Moreover, we also show that the secrecy capacity scaling of our technique is still the same as for broadcasting. Hereafter, the lower and upper bounds of the secrecy outage probability are calculated, and it is shown that the security performance is remarkably enhanced, compared to conventional multicasting technique.
This paper proposes a new location-based multicasting technique, for dual phase amplify-and-forward (AF) large networks, aiming to improve the security in the presence of non-colluding passive eavesdroppers. These eavesdroppers could also be part of this cooperative network as relays. In order to reduce the impact of these eavesdroppers on the network security, we propose a new transmission strategy where, for the first hop of each transmission time, while the destination is jamming, the source randomly chooses a different subset K of the total T relays, to transmit its message toward the destination. For practical implementation, sectoral transmission can be achieved with analog beamforming at the source's side. In the second hop, using the distributed beamforming technique, the K AF relays retransmit the received signal to the destination. We analytically demonstrated that the proposed technique decreases the probability of choosing the same sector that has certain eavesdroppers again, for each transmission time, to K/T. Moreover, we also show that the secrecy capacity scaling of our technique is still the same as for broadcasting. Hereafter, the lower and upper bounds of the secrecy outage probability are calculated, and it is shown that the security performance is remarkably enhanced, compared to conventional multicasting technique.
This paper studies the secrecy capacity scaling in an Amplify-and-Forward (AF) dual-phase large network containing K relays. In our model, part of these K relays are assumed to be potential eavesdroppers. Before transmitting the message in the first phase, the multi-antennas source divides it to partial messages and multicasts each part to a different disjoint sector. During the second phase, the K relays use the distributed beamforming (DBF) technique to retransmit the message to the destination. We investigate the ergodic secrecy capacity considering two different behaviours of the untrustworthy relays; the passive behaviour, when the untrustworthy relays work separately from each other to intercept the signal, and the aggressive one, when the untrusted relays collaborate to hijack the message. As demonstrated, our location-based multicasting scenario is significantly increasing the security compared to the recent works that employ broadcasting schemes. Additionally, it also increases the secrecy capacity scaling remarkably. Finally, our analytical derivations are confirmed by the simulation.
Wireless networks have experienced rapid evolutions toward sustainability, scalability and interoperability. The digital economy is driven by future networked societies to a more holistic community of intelligent infrastructures and connected services for a more sustainable and smarter society. Furthermore, an enormous amount of sensitive and confidential information, e.g., medical records, electronic media, financial data, and customer files, is transmitted via wireless channels. The implementation of higher layer key distribution and management was challenged by the emergence of these new advanced systems. In order to resist various malicious abuses and security attacks, physical layer security (PLS) has become an appealing alternative. The basic concept behind PLS is to exploit the characteristics of wireless channels for the confidentiality. Its target is to blind the eavesdroppers such that they cannot extract any confidential information from the received signals. This thesis presents solutions and analyses to improve the PLS in wireless networks. \n \nIn the second chapter, we investigate the secrecy capacity performance of an amplify-andforward (AF) dual-hop network for both distributed beamforming (DBF) and opportunistic relaying (OR) techniques. We derive the capacity scaling for two large sets; trustworthy relays and untrustworthy aggressive relays cooperating together with a wire-tapper aiming to intercept the message. We show that the capacity scaling in the DBF is lower bounded by a value which depends on the ratio between the number of the trustworthy and the untrustworthy aggressive relays, whereas the capacity scaling of OR is upper bounded by a value depending on the number of relays as well as the signal to noise ratio (SNR). \n \nIn the third chapter, we propose a new location-based multicasting technique, for dual phase AF large networks, aiming to improve the security in the presence of non-colluding passive eavesdroppers. We analytically demonstrate that the proposed technique increases the security by decreasing the probability of re-choosing a sector that has eavesdroppers, for each transmission time. Moreover, we also show that the secrecy capacity scaling of our technique is the same as for broadcasting. Hereafter, the lower and upper bounds of the secrecy outage probability are calculated, and it is shown that the security performance is remarkably enhanced, compared to the conventional multicasting technique. \n \nIn the fourth chapter, we propose a new cooperative protocol, for dual phase amplify-andforward large wireless sensor networks, aiming to improve the transmission security while taking into account the limited capabilities of the sensor nodes. In such a network, a portion of the K relays can be potential passive eavesdroppers. To reduce the impact of these untrustworthy relays on the network security, we propose a new transmission protocol, where the source agrees to share with the destination a given channel state information (CSI) of source-trusted relay-destination link to encode the message. Then, the source will use this CSI again to map the right message to a certain sector while transmitting fake messages to the other sectors. Adopting such a security protocol is promising because of the availability of a high number of cheap electronic sensors with limited computational capabilities. For the proposed scheme, we derived the secrecy outage probability (SOP) and demonstrated that the probability of receiving the right encoded information by an untrustworthy relay is inversely proportional to the number of sectors. We also show that the aggressive behavior of cooperating untrusted relays is not effective compared to the case where each untrusted relay is trying to intercept the transmitted message individually. \n \nFifth and last, we investigate the physical layer security performance over Rayleigh fading channels in the presence of impulsive noise, as encountered, for instance, in smart grid environments. For this scheme, secrecy performance metrics were considered with and without destination assisted jamming at the eavesdropper’s side. From the obtained results, it is verified that the SOP, without destination assisted jamming, is flooring at high signal-to-noise-ratio values and that it can be significantly improved with the use of jamming.
Cooperative relaying and cooperative jamming have been used to improve the secrecy of wireless networks. In this paper, Artificial Noise (AN) based secrecy enhancement of a dual-hop wireless network consisting of ‘n’ amplify-and-forward (AF) relays in the presence of a passive eavesdropper (E) is studied. A practical setting where direct links exist between source-destination (S-D) and source-eavesdropper (S-E) is considered. The source allocates some of its available power to transmit AN in order to confuse the eavesdropper and thereby degrades its channel. The optimum power allocation factor (a) and maximum secrecy rate are estimated analytically and by simulation. The performance is evaluated based on secrecy rate (Rs) and bit error rate (BER); for the case of randomly distributed relays and for any eavesdropper location. Numerical results show the improvement of the proposed cooperative scheme over other schemes.
In this paper, we investigate secure two-user AF relaying networks based on a destination assisted cooperative jamming (DACJ). We consider two sources, one destination, one eavesdropper and multiple amplify-and-forwards (AF) relays. In the first time slot, each source broadcasts the information signal to the relays. In order to protect the source message from being eavesdropped, the destination simultaneously transmits a jamming signal to each relay. The selected relay amplifies and forwards the combined signal to the destination and eavesdropper. We introduce reactive relay selection and power allocation to decrease the power consumption. Closed-form expressions for lower bound of ergodic secrecy capacity (ESC) are provided. Numerical results are presented to verify the exactness of the proposed mathematical analysis.
In this paper, the security of two-phase relaying system with multiple intermediate nodes in the presence of a malicious eavesdropper is investigated. To enhance the secrecy, a joint cooperative beamforming and jamming combined with relay and jammer selection is proposed. First, the source broadcasts its signal to the relays that are located close to source in a cluster, i.e., the source node uses a small amount of power to broadcast its message locally to other nodes of the cluster, while destination and the eavesdropper are located outside this cluster. In the second phase, two relays transmit re-encoded signal with optimal beamforming such that the secrecy rate is maximized. Simultaneously, two other intermediate nodes (which act as friendly jammers) transmit random jamming signals to degrade the eavesdropper’s channel. Our goal in this paper is to maximize the secrecy rate by applying different methods such as cooperative beamforming, cooperative jamming and relay and jammer selection. To avoid operational complexity, we consider the minimum number of intermediate nodes needed for relaying and jamming without losing the performance, i.e., achieving a non-zero secrecy rate. Cooperative beamforming with multiple relays demands high amount of information exchange and therefore increases the operational complexity. Thus, we aim to reduce the number of relays which take part in cooperative beamforming. Limiting the number of relays may have a bad effect on the coding gain which we compensate it with a proposed selection gain scheme. Numerical results demonstrate the advantage of our proposed scheme compared to the scheme with no cooperative jamming. The main contribution of this work is combining cooperative beamforming and jamming with relay and jammer selection to enhance the physical layer security.
In this paper, we propose a destination-assisted jamming and beamforming (DAJB) scheme for physical layer security in a one-way cooperative amplify-and-forward (AF) relay communication system. The system model consists of one source, one destination, one eavesdropper, and N relay nodes, with the individual power constraint of each relay node and the destination-assisted jamming node as well as unknown instantaneous channel state information (CSI) of the eavesdropper. Due to the half-duplex constraint of the relay nodes, there are two phases in our proposed DAJB scheme. In the first phase, the source node broadcasts information signal and all N relay nodes listen simultaneously. In the meantime, the destination node transmits the jamming signal to confuse the potential eavesdropper. In the second phase, all N relay nodes amplify and forward the received signals, covered by the artificial noise (AN), to the destination using the distributed beamforming technology. The optimal beamformer weights and power allocation are obtained by solving the second-order convex cone programming (SOCP) together with a linear programming (LP) problem. Furthermore, the performance of the DAJB scheme is analyzed in terms of the achievable secrecy rate. Compared with the scheme that selects a relay node as the jammer, we obtain larger power gain to achieve higher secrecy rates. Finally, the simulation results verify that the DAJB scheme greatly improves the secrecy rate of a one-way cooperative AF relay communication system.