Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEICE Technical Report; IEICE Tech. Rep.

[Technical Exhibition] Software Defined Receiver with SFQ Digital Devices

Sekiya Akito, Nishido Yoshinori, Akaike Hiroyuki, Hiraku Okada, Masumi Inoue, Yamazato Takaya, Fujimaki Akira, Masaaki Katayama

Published Jul 21, 2005• 0 citations
OpenAlex

Related papers

Introduction of Superconducting Technology to Software-Defined Radio Receivers

Fujimaki Akira, Sekiya Akito, Nishido Yoshinori +1 more

IEICE Technical Report; IEICE Tech. Rep.•Apr 19, 2006•0 citations

Digital SFQ electronics

Pascal Febvre

•Sep 25, 2022•0 citations

Broad band software-defined radio receivers based on superconductive devices

Akira Fujimaki, K. Nakazono, H. Hasegawa +6 more

We have studied software-defined radios (SDRs) based on superconducting devices. The increasing data rate in mobile communications will require a band-width of up to a few hundred MHz in the future. We have confirmed numerically the broad-band characteristic of oversampled analog-to-digital converters including a lowpass and bandpass modulator. Furthermore, the bandpass modulator constructed without a resistor is found to have sensitivity improved by two orders of magnitude compared to that of the lowpass modulator. This result means that the digital RF radio architecture based on a bandpass ADC is better suited for a future SDR receiver.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•30 citations

Digital SFQ electronics: practical design on examples

Pascal Febvre

•Sep 29, 2024•0 citations

High-Resolution Analog-to-Digital Converters toward Software-Defined-Radio Receivers

Akira Fujimaki

We describe three types of software-defined-radio (SDR) receivers based on superconducting technologies. The superconducting analog bandpass filters are essential for all types of the receivers. Another key component is an analog-to-digital converters (ADCs), which are required to have high resolution with a broad band width. The complementary A ADC based on the single-flux-quantum circuit is a promising candidate for the SDR receivers because it has a practical nature together with above-mentioned requirements. The experimentally obtained signal-to-noise ratio (SNR) and sensitivity, which are closely related to the resolution, are 34 dB and 20 μA for a quarter of the full-scale input with a band width of about 20 MHz. If we use the optimum decimation filter, the ADC is expected to have the SNR of 82 dB and the sensitivity of 300 nA. These values meet the requirements of the easiest type of the SDR receiver. After new fabrication process has been introduced and the architecture of the ADC has been improved, all types of recievers could be realized based on suoerconductors.

IEICE Transactions on Electronics•Feb 1, 2006•4 citations

Digital SFQ electronics: from the Josephson junction to the SFQ principle

Pascal Febvre

•Sep 29, 2024•0 citations
We have studied software-defined radios (SDRs) based on superconducting devices. The increasing data rate in mobile communications will require a band-width of up to a few hundred MHz in the future. We have confirmed numerically the broad-band characteristic of oversampled analog-to-digital converters including a lowpass and bandpass modulator. Furthermore, the bandpass modulator constructed without a resistor is found to have sensitivity improved by two orders of magnitude compared to that of the lowpass modulator. This result means that the digital RF radio architecture based on a bandpass ADC is better suited for a future SDR receiver.
We describe three types of software-defined-radio (SDR) receivers based on superconducting technologies. The superconducting analog bandpass filters are essential for all types of the receivers. Another key component is an analog-to-digital converters (ADCs), which are required to have high resolution with a broad band width. The complementary A ADC based on the single-flux-quantum circuit is a promising candidate for the SDR receivers because it has a practical nature together with above-mentioned requirements. The experimentally obtained signal-to-noise ratio (SNR) and sensitivity, which are closely related to the resolution, are 34 dB and 20 μA for a quarter of the full-scale input with a band width of about 20 MHz. If we use the optimum decimation filter, the ADC is expected to have the SNR of 82 dB and the sensitivity of 300 nA. These values meet the requirements of the easiest type of the SDR receiver. After new fabrication process has been introduced and the architecture of the ADC has been improved, all types of recievers could be realized based on suoerconductors.