This chapter discusses effective application of low power laser radiations for cooling and use of magnetic field gradient for trapping the atoms. It also discusses the basic principle of operation of Magneto-Optic Traps. Schawlow first showed in the seventies that the optical force of laser radiation can be used to decelerate an atom. This can be accomplished by the absorption of a photon by an atom through a process of stimulated absorption if the laser radiation has a frequency resonant with the energy level difference of the atom. Atoms can be trapped by static magnetic field or a combination of magnetic fields in multipolar, Helmholz or anti-Helmholz configuration or Joffe configuration. Since the atom beams are coherent in nature any beam of atoms from a Bose Einstein condensate can act like an atom laser having high energy that will have very strong penetrating power because of the coherent character of the beam.
This chapter discusses effective application of low power laser radiations for cooling and use of magnetic field gradient for trapping the atoms. It also discusses the basic principle of operation of Magneto-Optic Traps. Schawlow first showed in the seventies that the optical force of laser radiation can be used to decelerate an atom. This can be accomplished by the absorption of a photon by an atom through a process of stimulated absorption if the laser radiation has a frequency resonant with the energy level difference of the atom. Atoms can be trapped by static magnetic field or a combination of magnetic fields in multipolar, Helmholz or anti-Helmholz configuration or Joffe configuration. Since the atom beams are coherent in nature any beam of atoms from a Bose Einstein condensate can act like an atom laser having high energy that will have very strong penetrating power because of the coherent character of the beam.
The advent of the laser opened the way to the development of powerful new methods for manipulating and cooling atoms which were exploited in the realization of Bose–Einstein condensation in alkali atom vapours. To set the stage we describe a typical experiment, which is shown schematically in Fig. 4.1. A beam of sodium atoms emerges from an oven at a temperature of about 600 K, corresponding to a speed of about 800 m s –1 , and is then passed through a so-called Zeeman slower, in which the velocity of the atoms is reduced to about 30 m s –1 , corresponding to a temperature of about 1 K. In the Zeeman slower, a laser beam propagates in the direction opposite that of the atomic beam, and the radiation force produced by absorption of photons retards the atoms. Due to the Doppler effect, the frequency of the atomic transition in the laboratory frame is not generally constant, since the atomic velocity varies. However, by applying an inhomogeneous magnetic field designed so that the Doppler and Zeeman effects cancel, the frequency of the transition in the rest frame of the atom may be held fixed. On emerging from the Zeeman slower the atoms are slow enough to be captured by a magneto-optical trap (MOT), where they are further cooled by interactions with laser light to temperatures of order 100 μK. Another way of compensating for the changing Doppler shift is to increase the laser frequency in time, which is referred to as ‘chirping’. In other experiments the MOT is filled by transferring atoms from a second MOT where atoms are captured directly from the vapour.
This review describes the methods of trapping cold atoms in electromagnetic fields and in the combined electromagnetic and gravity fields. We discuss first the basic types of the dipole radiation forces used for cooling and trapping atoms in the laser fields. We outline next the fundamentals of the laser cooling of atoms and classify the temperature limits for basic laser cooling processes. The main body of the review is devoted to discussion of atom traps based on the dipole radiation forces, dipole magnetic forces, combined dipole radiation-magnetic forces, and the forces combined of the dipole radiation-magnetic and gravity forces. Physical fundamentals of atom traps operating as waveguides and cavities for cold atoms are also considered. The review ends with the applications of cold and trapped atoms in atomic, molecular and optical physics.
In 1925, Einstein predicted the condensation of bosons into the ground state of the system for low (but finite) temperatures. Several phenomena, including superfluidity and superconductivity have been associated with Bose-Einstein condensation, but these systems interact strongly with their environment and pure Bose-Einstein condensation could not be established. It took 70 years, in which time the laser was discovered, and laser cooling techniques to manipulate atoms in a dilute atomic gas, before Bose-Einstein condensation in dilute atomic gases could be demonstrated in 1995. In the first condensation experiments, BECs were created in a magnetic trap. Since in a magnetic trap not all mF states of the atom can be trapped simultaneously, thereby limiting the number of experiments that can be done, other ways of trapping and generating BECs were sought and found. In 2001, the first all-optical BEC was made, where the dipole force was used to trap atoms in the crossing of two far red detuned laser beams. In an optical dipole trap not only atoms in different internal states can be trapped, but also different atomic species simultaneously. In this thesis, the formation of an all-optical Bose-Einstein condensate with rubidium atoms is presented. Conventional all-optical BECs are usually created in high power CO2 laser dipole traps, or have complicated laser cooling schemes and complex dipole trap setups. In our simple and straightforward setup, we load rubidium atoms from a magneto-optical trap into a crossed optical dipole trap created by a single frequency Yb:YAG laser with a wavelength at 1030 nm. The small wavelength allows for a small diffraction limit, and permits us to use standard optical materials, thus making the experimental setup cost effective. Other attempts to achieve Bose-Einstein condensation in a multi-mode (frequency) fiber laser at 1064 nm failed, because the atom loss was quite high. It is assumed that the multi-mode character of the fiber laser induces Raman transitions in rubidium atoms, thereby heating them. We can trap about ∼ 5E7 atoms in a single beam dipole trap out of ∼ 5E9 atoms trapped in theMOT, and ∼ 350,000 atoms can be trapped in a crossed beam dipole trap due to the smaller trap volume. 70% of the atoms in the dipole trap is optically pumped into one mF state. Quantum degeneracy is reached by evaporatively cooling the atoms in the crossed dipole trap by ramping down the laser power with three linear ramps. We can independently change the power of each beam by an AOM. This allows us to use one beam as an atom waveguide for future experiments. After evaporation, we typically have about 10,000 atoms at a temperature below the critical temperature. We have proved Bose-Einstein condensation by using the anisotropic expansion of a quantum degenerate gas trapped in an anisotropic potential. The aspect ratio of our atom cloud changed during a time of flight from 0.7 to 1.2 in 10 ms, thus proving that we have reached quantum degeneracy. We have about 5,000 condensed atoms in our optical dipole trap at a temperature less than 100 nK. The remaining atoms are thermal. Bose-Einstein condensation is obtained within 8 s, and we can repeat the experiment every 30 s. It should be mentioned that the Bose-Einstein experiment was moved from the ”Leibniz Universität Hannover” to the ”Technische Universität Darmstadt”, and had to be completely rebuilt. All-optical Bose-Einstein condensation was reached within one year after the move. Our Bose-Einstein condensation setup presents an ideal starting point for using our condensates in combination with miniaturized atom optical setups based on our novel microfabricated optical elements. With our microlenses, we can create a number of possible dipole trap configurations, such as the dipole trap array or the cylindrical microlens array. Using microlenses in miniaturized atom optical setups opens a completely new field of coherent atom optics. Also because the tight confinement of the microtraps allows us to load a 3D BEC, a 1D BEC, or a Tonks-Girardeau gas in the micropotentials depending on the density.
Presents work on the realization of Bose-Einstein condensates (BEC) in optical and electro-magnetic traps. We have done some theoretical and experimental work on the project. We have proposed an optical funnel or a hollow beam, which are produced from a short micron-sized hollow optical fiber or a set-up of lenses. The cold atoms extracted from an magneto-optical trap experience effective Sisyphus cooling in the dark hollow beam. We calculate the potential barriers for atomic guiding in the dark hollow beam, and analyze the atomic losses during the guiding process. Inside the hollow beam atoms experience an efficient Sisyphus cooling and repumping-beam induced geometric cooling. We have estimated the total loss rate of the cold atoms, and it shows that an ultracold and dense Rb atomic sample with a 3D temperature of /spl sim/1 K can be obtained and the appearance of an optically-trapped Bose-Einstein condensation may be possible in this optical trap. We have also made a proposal of a micro-wave electro-magnetic trap, which is working at the frequency which is very far from the optical transition of the cold atoms. The trapping force comes from the interaction between the electro-magnetic induced magnetic dipole moment with the electro-magnetic field. Theoretical calculation shows that the force can be used to trap the cold atoms in the trap.
We present a simple review of the basic physical processes allowing one to control, with laser beams, the velocity and the position of neutral atoms. The control of the velocity corresponds to a cooling of atoms, that is, a reduction of the atomic velocity spread around a given value. The control of the position means a trapping of atoms in real space. The best present performances will be given, in terms of the lowest temperatures and the highest densities. The corresponding highest quantum degeneracy will also be estimated. It is imposed by fundamental limits, which will be described briefly. We also give the general trends in this field of research and outline the new directions which look promising for observing quantum statistical effects in laser cooled atomic samples, but which are for the moment restricted by unsolved problems. Introducing the Simple Schemes The radiative forces acting on atoms in a light field can be split into two parts, a reactive one and a dissipative one. The dissipative force (radiation pressure), which basically involves scattering processes, is velocity dependent. We will see that this dependence leads to the Doppler cooling scheme and to the concept of optical molasses, and we will give the corresponding minimal achievable temperature. The dissipative force can be made position dependent, through a gradient of the magnetic field, so that the atoms are also trapped in the so-called magneto-optical trap.