This work showed experimentally how the planar multiturn input coil of a flux transformer could be integrated with a coplanar resonator while still permitting one to couple radio frequency (rf) signals to an rf SQUID. A new layout of a multiturn flux transformer with one pickup loop and two input coils, one single turn and one multiturn, has been fabricated on (001) substrates and evaluated. A planar double-hole washer SQUID was inductively coupled to the two separate input coils via a flip chip configuration. With this layout the best magnetometer showed magnetic field white noise of at 77 K in a magnetically shielded surrounding.
We demonstrate the efficient modulation of flux-tunable superconducting resonators (FTRs) using flip-chip or on-chip-based input coils. The FTRs we use are aluminum-based quarter-wave coplanar waveguide resonators terminated with 100um or 200um-wide square loop dc superconducting quantum interference devices (SQUIDs) employing 1um-sized Josephson junctions. We employ SQUIDs with a geometric loop inductance of up to 0.7nH to increase the flux transfer efficiency. The geometric inductance of the SQUID results in a non-zero screening parameter
βL, whose branch switching effect is mitigated by using asymmetric junctions. We achieve flux modulation of the FTRs by more than one GHz and flux responsivities of up to tens of GHz/
Φ0 with uA-scale on-chip currents. We compare flip-chip with on-chip input-coil-based flux modulation, where the former is realized through galvanically connected and closely spaced chips, while the latter is achieved through superconducting air-bridge connections. We achieve a flux-transfer efficiency from the input coil to the SQUID loop of up to 20%. Our work paves the way for efficient low current flux modulation of FTRs and sensitive measurement of flux signals.
This paper demonstrates a design of a planar multi-turn flux transformer integrated with a superconducting labyrinth resonator serving as the planar tank circuit for a radio frequency (rf) superconducting quantum interference device (SQUID) magnetometer. All structures were patterned from 200 nm-thick epitaxial YBa/sub 2/Cu/sub 3/O/sub 7/ (YBCO) films grown on 10/spl times/10 mm/sup 2/ LaAlO/sub 3/ substrates. A double-hole washer SQUID had one hole coupled to the input coil of the labyrinth resonator and the other hole coupled to the input coil of the multi-turn flux transformer using a flip-chip configuration to form a magnetometer. This resonator has a good high-frequency coupling to the double-hole rf SQUID, thus securing its optimum operation. For the voltage-to-flux (transfer function) coefficient, a value of 300-500 /spl mu/V//spl Phi//sub 0/ was obtained. A SQUID magnetometer with an inductance of 210 pH exhibited white flux noise of 11.5 /spl mu//spl Phi//sub 0///spl radic/Hz at 77 K. This corresponded to a white magnetic field noise of 11.5 fT//spl radic/Hz.