To achieve photon-pair generation scaling, we optimize the quality factor of microring resonators for efficient continuous-wave-pumped spontaneous four-wave mixing. Numerical studies indicate that a high intrinsic quality factor makes high pair rate and pair brightness possible, in which the maximums take place under overcoupling and critical-coupling conditions, respectively. We fabricate six all-pass-type microring resonator samples on a silicon-on-insulator chip involving gap width as the only degree of freedom. The signal count rate, pair brightness, and coincidence rate of all the samples are characterized, which are then compared with the modified simulations by taking the detector saturation and nonlinear loss into account. Being experimentally validated for the first time to the best of our knowledge, this work explicitly demonstrates that reducing the round-trip loss in a ring cavity and designing the corresponding optimized gap width are more effective to generate high-rate or high-brightness photon pairs than the conventional strategy of simply increasing the quality factor. (C) 2018 Chinese Laser Press
To achieve photon-pair generation scaling, we optimize the quality factor of microring resonators for efficient continuous-wave-pumped spontaneous four-wave mixing. Numerical studies indicate that a high intrinsic quality factor makes high pair rate and pair brightness possible, in which the maximums take place under overcoupling and critical-coupling conditions, respectively. We fabricate six all-pass-type microring resonator samples on a silicon-on-insulator chip involving gap width as the only degree of freedom. The signal count rate, pair brightness, and coincidence rate of all the samples are characterized, which are then compared with the modified simulations by taking the detector saturation and nonlinear loss into account. Being experimentally validated for the first time to the best of our knowledge, this work explicitly demonstrates that reducing the round-trip loss in a ring cavity and designing the corresponding optimized gap width are more effective to generate high-rate or high-brightness photon pairs than the conventional strategy of simply increasing the quality factor. (C) 2018 Chinese Laser Press
One of the key building blocks of quantum photonic systems is a source of indistinguishable photons. Silicon ring resonators can be used as photon pair sources by taking advantage of silicon's large third order nonlinearity with a process known as spontaneous four wave mixing. These sources are capable of producing pairs of indistinguishable photons but typically suffer from an effective 50% loss. By slightly decoupling the input waveguide from the ring, the desired photons generated in the ring can be directed to the drop port. Thus, the ratio between the coincidences from the drop port and the total number of coincidences from all ports (coincidence efficiency) can be significantly increased, with the trade-off being that the pump is less efficiently coupled into the ring. This asymmetric coupling scheme was used to demonstrate a dual-bus microring source with a coincidence efficiency of ~96%. Unfortunately, the penalty to pump power was quite large, with a required ~10x increase in the pump power to maintain the same pair generation rate.\nTo further improve upon this result, a microring source was designed with multipoint evanescent couplers to induce a strong spectral dependence in the coupling coefficients. This coupler design can be used on both sides of the ring resonator so that resonances supported by one of the couplers are suppressed by the other. This is the ideal configuration for a ring-based photon-pair source as it can only support the pump photons at the input side while only allowing the generated photons to leave through the output side. Asymmetric coupling was also used in this configuration but in a different way than in the previous source. In this case, the input side of the ring was configured to be critically coupled for maximal resonance enhancement while the output side was configured to be over coupled to minimize photon-pair loss within the ring. This device design was used to demonstrate a photon-pair source with coincidence efficiencies of 0.9981+-6.425x10^-4 and 0.9979+-1.665x10^-3 for degenerate and non-degenerate pump configuration respectively.\nIn addition to the source development, work was done to move some of the pump rejection filtering onto the photonic chip. While the fabricated device only exhibited an extinction of 50 dB, the root cause of the limited extinction was explored and a new filter design was proposed to overcome these limitations. With the combination of the microring source with its greatly improved efficiency and the movement toward reducing the required off-chip filtering, this work represents a significant advancement in the scalability of integrated quantum photonic systems which can enable high performance quantum computing and communication systems.
We present a self-contained analytical model for biphoton generation in microring resonators. Encompassing both all-pass and add-drop geometries, identical and distinct pump and biphoton coupling coefficients, and continuous-wave and pulsed pumping, our interaction-picture-based approach reveals time-frequency biphoton correlations while also predicting absolute generation rates. Under continuous-wave excitation, we find critical coupling of both the pump and biphoton to maximize the rate of single photons extracted from the microring, whereas critical coupling of the pump but overcoupling of the biphoton maximize the two-photon rate. Under pulsed pumping, overcoupling of both pump and biphoton (to different degrees) maximizes photon extraction probabilities, albeit under a tradeoff with spectral factorability that we quantify via parameter scans over a range of coupler pairings. As a whole, our formalism should prove valuable for the practical design of integrated photon sources, merging a flexible and intuitive biphoton-centric depiction with quantitative predictions closely tied to experimental parameters.
Efficient generation of correlated photon pairs through spontaneous four-wave mixing (SFWM) in silicon devices serves as a crucial resource for integrated quantum photonic technologies. Enhancing the intracavity field in high-quality-factor (Q) resonators enables energy-efficient photon-pair generation, with the photon-pair generation rate (PGR) scaling cubically with the Q factor. In this work, we demonstrate a high-brightness on-chip photon-pair source based on a racetrack resonator with a high Q factor of 1.75 × 105, fabricated on a silicon-on-insulator (SOI) platform requiring only a single-etch process. By combining uniform multimode waveguides with optimized Euler bends, we suppress fundamental mode loss and minimize round-trip cavity dispersion, thereby improving both field enhancement and frequency matching for SFWM processes. With a continuous-wave pump of only 44.67 µW, we achieve an on-chip brightness of 1.54 GHz·mW−2·nm−1. These results establish a fabrication-friendly and efficient photon-pair source architecture for integrated quantum photonic systems.
Entangled photon-pair sources are essential components for emerging quantum information-processing technologies. Among various platforms, on-chip microresonators offer strong potential due to their resonant enhancement and suitability for wafer-scale integration. In this study, we demonstrate ultrabright entangled photon-pair generation from high- Q silicon microring resonators. By optimizing the device geometry and coupling configuration to suppress sidewall scattering and selectively excite the fundamental mode, we achieve single-mode resonance with an intrinsic Q -factor of 1.26 × 10 6 using only standard fabrication processes available in CMOS foundries. The resulting high- Q resonator yields a record-high brightness coefficient of 3.9 × 10 9 Hz/GHz/mW 2 . At an on-chip pump power of 240 μW, we obtain a maximum brightness of 22.0 MHz/GHz and a maximum photon-pair generation rate of 9.19 MHz. At a low-pump power of 10 μW, Franson-type two-photon interference exhibits a visibility of 98.0 ± 0.2%, confirming high-quality time–energy entanglement. These results show that narrow bandwidth and high generation rate can be achieved simultaneously in CMOS-compatible silicon photonic sources, thereby advancing their use in quantum repeaters and scalable quantum networks.
Compact, efficient, high-quality and scalable non-classical photon sources are one of the most critical building blocks for quantum information processing and communications. Photon pair generation via spontaneous four wave mixing is being recognized as an attractive platform for quantum optics which is compatible with the rapidly-maturing classical integrated photonics technology using silicon wafers, which is adopted in industry for its low cost, high performance and scalability. Traditionally, the photon pairs generated from silicon photonic devices, however, have not compared favorably with traditional nonlinear crystals in terms of overall rate, quality and efficiency. This dissertation discusses the factors that affect the quality and efficiency of photon pair generation in silicon integrated photonic microrings, together with their design and characterization. Furthermore, we show how the microrings can be integrated with other photonic devices on the silicon-on-insulator platform, and using proof-of-concept experiments, discuss the feasibility of using these photon-pair sources with technology that is already present in, or will soon be present in, practical fiber-optic networks, such as integrated lasers and modulated classical data streams.
Efficient and bright single photon sources on photonic chips are key to scaling quantum technologies. Spontaneous four wave mixing in micro-ring resonators creates excellent narrowband and tunable photon sources. We experimentally demonstrate the optimization of heralding efficiency and brightness by tuning the coupling of the pump, signal and idler modes into the resonator whilst operating in a pulsed pump regime. We observe a maximum detected pair rate of over 93,000~coincidences per second in a moderately over-coupled regime, alongside a high intrinsic idler heralding efficiency of 97.87$\pm$8.97\% when operating close to maximal over-coupling. The measured dependence on coupling strength is in strong agreement with theoretical predictions, experimentally validating the predicted trade-off between brightness and heralding efficiency.