Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

On the question of cooling without spontaneous emission via the bichromatic force

Leland Aldridge, David P. DeMille

Published May 30, 2018• 0 citations
OpenAlex

Related papers

The Bichromatic Force for Laser Cooling Without Spontaneous Emission

Christopher Corder, Brian Arnold, Harold J. Metcalf

Bulletin of the American Physical Society•Jun 5, 2014•0 citations

Simulation of Bichromatic Force Cooling

Hua Xiang, Christopher Corder, Harold J. Metcalf

Bulletin of the American Physical Society•May 25, 2016•0 citations

Toward Laser Cooling without Spontaneous Emission

Christopher Corder, Brian Arnold, Harold J. Metcalf

Bulletin of the American Physical Society•Jun 5, 2012•0 citations

Phase control of spontaneous emission by cascade bichromatic excitation

Xiangming Hu, Wenxing Shi, Qing Yang Xu +3 more

Physics Letters A•Dec 30, 2005•19 citations

Optical Forces on Metastable Helium

Christopher Corder

Optical forces using lasers allow precise control over the motion of atoms. The bichromatic optical force (BF) is unique in its large magnitude and velocity range, arising from the absorption and stimulated emission processes. These properties were used to transversely collimate a beam of metastable helium (He∗ ) using the 2^{3}S − 2^{3}P transition. The collimation created a very bright beam of He∗ , allowing experiments of neutral atom lithography. The He∗ beam was used to pattern material surfaces using a resist-based lithography technique, where the pattern was determined by either mechanical or optical masks. The optical masks produced features with a separation of half the wavelength of the light used. Patterning was successfully demonstrated with both IR and UV optical masks. The etched pattern resolution was ∼ 100 nm and limited by the material surface. Further experiments were performed studying the ability of the bichromatic force to cool. The finite velocity range of the BF allows estimation of a characteristic cooling time which is independent of the excited state lifetime, only depending on the atomic mass and optical transition energy. Past experiments, including the helium collimation used for neutral atom lithography, have demonstrated that the BF can collimate and longitudinally slow atomic beams, but required long interaction times that included many spontaneous emission (SE) events. The effect of SE can be mitigated, and is predicted to not be necessary for BF cooling. Since the BF cooling time is not related to the excited state lifetime, a transition can be chosen such that the cooling time is shorter than the SE cycle time, allowing direct laser cooling on atoms and molecules that do not have cycling transitions. Experiments using the helium 2^{3}S− 3^{3}P transition were chosen because the BF cooling time (285 ns) is on the order of the average SE cycle time (260 ns). Numerical simulations of the experimental system were run predicting compression of the atomic velocity distribution. Our experimental results demonstrate the stimulated nature of the force through many atomic recoils from the light in less than one SE cycle time. A large range of the atomic velocity distribution is accelerated and accumulates at the velocity limit of the force. This accumulation results in an increase in the velocity space density, demonstrating cooling. | 112 pages

•Jan 1, 2014•0 citations

MOT loading enhancement with stimulated light forces

Tara Cubel Liebisch, E. Blanshan, Elizabeth A. Donley +1 more

We demonstrate atom number enhancement in a magneto-optical trap (MOT) by use of bichromatic cooling to slow an atomic beam that is loaded into a MOT. Bichromatic cooling employs stimulated emission to apply strong cooling forces that are not limited by spontaneous emission. We demonstrate a factor of 3.5 increase in atom number captured from the atomic beam for a 1.5 cm cooling length. For a 1.5 cm effective cooling length, our technique yields MOT atom number enhancement that is about three times higher than the enhancement achieved via spontaneous emission.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2011•0 citations
Optical forces using lasers allow precise control over the motion of atoms. The bichromatic optical force (BF) is unique in its large magnitude and velocity range, arising from the absorption and stimulated emission processes. These properties were used to transversely collimate a beam of metastable helium (He∗ ) using the 2^{3}S − 2^{3}P transition. The collimation created a very bright beam of He∗ , allowing experiments of neutral atom lithography. The He∗ beam was used to pattern material surfaces using a resist-based lithography technique, where the pattern was determined by either mechanical or optical masks. The optical masks produced features with a separation of half the wavelength of the light used. Patterning was successfully demonstrated with both IR and UV optical masks. The etched pattern resolution was ∼ 100 nm and limited by the material surface. Further experiments were performed studying the ability of the bichromatic force to cool. The finite velocity range of the BF allows estimation of a characteristic cooling time which is independent of the excited state lifetime, only depending on the atomic mass and optical transition energy. Past experiments, including the helium collimation used for neutral atom lithography, have demonstrated that the BF can collimate and longitudinally slow atomic beams, but required long interaction times that included many spontaneous emission (SE) events. The effect of SE can be mitigated, and is predicted to not be necessary for BF cooling. Since the BF cooling time is not related to the excited state lifetime, a transition can be chosen such that the cooling time is shorter than the SE cycle time, allowing direct laser cooling on atoms and molecules that do not have cycling transitions. Experiments using the helium 2^{3}S− 3^{3}P transition were chosen because the BF cooling time (285 ns) is on the order of the average SE cycle time (260 ns). Numerical simulations of the experimental system were run predicting compression of the atomic velocity distribution. Our experimental results demonstrate the stimulated nature of the force through many atomic recoils from the light in less than one SE cycle time. A large range of the atomic velocity distribution is accelerated and accumulates at the velocity limit of the force. This accumulation results in an increase in the velocity space density, demonstrating cooling. | 112 pages
We demonstrate atom number enhancement in a magneto-optical trap (MOT) by use of bichromatic cooling to slow an atomic beam that is loaded into a MOT. Bichromatic cooling employs stimulated emission to apply strong cooling forces that are not limited by spontaneous emission. We demonstrate a factor of 3.5 increase in atom number captured from the atomic beam for a 1.5 cm cooling length. For a 1.5 cm effective cooling length, our technique yields MOT atom number enhancement that is about three times higher than the enhancement achieved via spontaneous emission.