The nonlinearity is essential for creation of non-classical states of the cavity or mechanical resonator such as squeezed or cat states. A microwave cavity can be made nonlinear by, for instance, adding Josephson junctions. The mechanical resonator is inherently nonlinear. The radiation pressure interaction between cavity and mechanical resonator is also inherently nonlinear but typically under strong drive of the cavity interaction can be linearized. However, if the optomechanical system is in the strong coupling regime nonlinear quantum effects become observable. These three cases provide the motivation for our studies. We start with backaction analysis of the classical regime of a dc SQUID (superconducting quantum interference device) with an embedded mechanical resonator. Then, we perform quantum analysis to understand how the asymmetry of two Josephson junctions influences the coupling strength of optomechanical interactions such as radiation pressure, cross-Kerr and single-photon beam splitter. Using variational method and self-consistent harmonic approximation we estimate the influence of the radiation pressure coupling and Kerr nonlinearity of the cavity on the effective frequency and dissipation of the cavity. The second part of this thesis focuses on the nonlinearity of the mechanical resonator coupled to the optical/microwave cavity. We study in details the nonlinear optomechanical response and draw the response map to summarize all results of the overcoupled and undercoupled cavity for the red and blue sidebands additionally to the weak and strong drive powers. In the end, w e confirm the developed theory by using it to numerically fit the experimental results.
The nonlinearity is essential for creation of non-classical states of the cavity or mechanical resonator such as squeezed or cat states. A microwave cavity can be made nonlinear by, for instance, adding Josephson junctions. The mechanical resonator is inherently nonlinear. The radiation pressure interaction between cavity and mechanical resonator is also inherently nonlinear but typically under strong drive of the cavity interaction can be linearized. However, if the optomechanical system is in the strong coupling regime nonlinear quantum effects become observable. These three cases provide the motivation for our studies. We start with backaction analysis of the classical regime of a dc SQUID (superconducting quantum interference device) with an embedded mechanical resonator. Then, we perform quantum analysis to understand how the asymmetry of two Josephson junctions influences the coupling strength of optomechanical interactions such as radiation pressure, cross-Kerr and single-photon beam splitter. Using variational method and self-consistent harmonic approximation we estimate the influence of the radiation pressure coupling and Kerr nonlinearity of the cavity on the effective frequency and dissipation of the cavity. The second part of this thesis focuses on the nonlinearity of the mechanical resonator coupled to the optical/microwave cavity. We study in details the nonlinear optomechanical response and draw the response map to summarize all results of the overcoupled and undercoupled cavity for the red and blue sidebands additionally to the weak and strong drive powers. In the end, w e confirm the developed theory by using it to numerically fit the experimental results.
In this thesis, we study two different physical systems, namely superconducting circuits and optomechanical cavities. \nIn the first part of the thesis, we study superconducting qubits and resonators and their potential to implement quantum information processing tasks. We propose a circuit quantum electrodynamics realization of a protocol to generate a Greenberger-Horne-Zeilinger (GHZ) state for transmon qubits homogeneously coupled to a microwave cavity in the dispersive limit. We derive an effective Hamiltonian with pairwise qubit exchange interactions of the XY type that can be globally controlled. Starting from a separable initial state, these interactions allow to generate a multi-qubit GHZ state within a time that does not depend on the number of qubits. We discuss how to probe the non-local nature and the genuine multipartite entanglement of the generated state. Finally, we investigate the stability of the proposed scheme to inhomogeneities in the physical parameters and the weak anharmonicity of transmon qubits. \nIn the second part of the thesis, we study optomechanical systems in which the position of a mechanical resonator modulates the resonance frequency of an optical cavity. The resulting radiation-pressure interaction is intrinsically nonlinear and can be used to implement strong Kerr nonlinearities and an effective interaction between photons. We investigate the optical bistability of such a system. The steady-state mean-field equation of the optical mode is identical to the one for a Kerr medium, and thus we expect it to have the same characteristic behavior with a lower, a middle, and an upper branch. However, the presence of position fluctuations of the mechanical resonator leads to a new feature: the upper branch will become unstable at sufficiently strong driving in certain parameter regimes. We identify the appropriate parameter regime for the upper branch to be stable, and we confirm, by numerical investigation of the quantum steady state, that the mechanical mode indeed acts as a Kerr nonlinearity for the optical mode in the low-temperature limit. This equivalence of the optomechanical system and the Kerr medium will be important for future applications of cavity optomechanics in quantum nonlinear optics and quantum information science. \n
Coupling electromagnetic waves in a cavity and mechanical vibrations via the radiation pressure of photons is a promising platform for investigations of quantum-mechanical properties of motion. A drawback is that the effect of one photon tends to be tiny, and hence one of the pressing challenges is to substantially increase the interaction strength. A novel scenario is to introduce into the setup a quantum two-level system (qubit), which, besides strengthening the coupling, allows for rich physics via strongly enhanced nonlinearities. Here we present a design of cavity optomechanics in the microwave frequency regime involving a Josephson junction qubit. We demonstrate boosting of the radiation-pressure interaction by six orders of magnitude, allowing to approach the strong coupling regime. We observe nonlinear phenomena at single-photon energies, such as an enhanced damping attributed to the qubit. This work opens up nonlinear cavity optomechanics as a plausible tool for the study of quantum properties of motion.
In this dissertation, I theoretically investigate the open system dynamics of cavity optomechanical systems in the quantum limit, where a mechanical resonator couples to a cavity mode via radiation pressure force. Recent developments in nano-fabrication and cooling techniques make it possible to optically control and manipulate the motion of micro- and nano-mechanical resonator. Several experiments have demonstrated the possibility of preparing macroscopic mechanical resonators into their quantum ground state, which makes optomechanical systems an ideal candidate for studying the quantum behavior of macroscopic objects. One important direction in quantum optomechanics is the study of the decoherence of optomechanical system due to the interaction with their external environments. This dissertation explores the decoherence effects by considering the influence of the radiation pressure coupling on the interaction between optomechanical system and its environments. Because the effects of the nonlinear interaction vary with the optomechanical coupling strength, three different interaction regimes are fully studied here: the weak coupling, the intermediate coupling and the strong coupling.
In the late 1960s and early 1970s, the development of mechanical resonators was pushed forward in efforts to record gravitational waves. In order to push down the limit of the smallest detectable force, the radiation circulating in a Fabry-Perot cavity was demonstrated to modify the damping of the cavity end-mirror suspended to act as a mechanical resonator. A few years later, motivated by the study of the internal properties of atoms and ions, the radiation pressure of light was realized as a means to cool atomic motion. In the following years, the ground-state cooling of ion motion was achieved in landmark studies. For mechanical resonators parametrically coupled to Fabry-Perot cavities, it took much longer to reach quantum ground-state cooling, both in the microwave domain, where the original experiments took place, and in the optical domain. Ground-state cooling in both regimes was reached by three groups during the preparation of this thesis and was largely due to advancements in the fabrication methods. \n \nGround-state cooling allows, in principle, the quantum nature of mechanical resonators to be probed and harnessed. Microwave domain devices, which are focused on in this thesis, have the advantage that nonlinear elements (superconducting quantum bits, qubits) are readily available. These elements enable nonclassical state preparation of the qubit and the subsequent transfer to the microwave cavity. The goal is to transfer these quantum states to mechanical resonators. This would allow mechanics to be used as a quantum mechanical memory in quantum information processing thanks to their long lifetimes. \n \nIn this thesis, various aspects of microwave domain circuit optomechanics are studied. The main goal of this thesis is to study how to enhance the coupling between a quantum regime microwave device and a mechanical resonator by using Josephson junction –based qubits. Coherent interaction between a superconducting qubit and a classical driven mechanical field is demonstrated. The analysis presented in this thesis predicts that ground-state cooling and coherent state transfer is possible in the single-phonon regime with transmon-regime qubits. Also, traditional linear optomechanical systems are considered in which the mechanical resonator is coupled to an electrical resonator. Such systems exhibit a rich spectrum of phenomena from which the quantum-limited amplification and multimode effects are considered in this thesis. It is shown that the system operates near quantum-limited amplification, which could be reached if the mechanical resonator was in the ground state.
Harmonic oscillators might be one of the most fundamental entities described by physics. Yet they stay relevant in recent research. The topological properties associated with exceptional points that can occur when two modes interact have generated much interest in recent years. Harmonic oscillators are also at the heart of new quantum technological applications: the long lifetime of high-Q resonators make them advantageous as quantum memories, and they are employed for narrowband processing of quantum signals, as in Josephson parametric amplifiers. The goal of this thesis is to explore different fundamental regimes of two coupled harmonic oscillators using cavity optomechanics as the experimen- tal platform. With consistent progress in attaining ever increasing Q factors, mechanical and electromagnetic resonators realize near-ideal harmonic oscillators. By parametrically modulating the nonlinear optomechanical interaction between them, an effective linear coupling is achieved, which is tunable in strength and in the relative frequencies of the two modes. Thus cavity optomechanics provides a framework with excellent control over system parameters for the study of two coupled harmonic modes. The specific optomechanical implementation employed are superconducting circuits with the vibrating top plate of a capacitor as the mechanical element. Multimode optomechanical circuits are realized, with two microwave modes interacting with one or two mechanical oscillators. The supplementary modes serve either as intermediaries in the relation of the two modes of interest, or as auxiliaries used to control a parameter of the system. Three main experimental results are achieved. First, an auxiliary microwave mode allows the engineering of the effective dissipation rate of a mechanical oscillator. The latter then acts as a reservoir for the main microwave mode with which it interacts. The microwave mode susceptibility can be tuned, resulting in an instability akin to that of a maser and in resonant amplification of incoming microwave signals with an added noise close to the quantum minimum. Second, we study the conditions for a nonreciprocal interaction between two microwave modes, when the information flows in one direction but not in the other. The two modes interact through two mechanical oscillators, leading to frequency conversion between the two cavities. Dissipation in the mechanical modes is essential to the scheme in two ways: it provides a reciprocal phase necessary for the interference and eliminates the unwanted signals. Third, level attraction between a microwave and a mechanical mode is demonstrated, where the eigenfrequencies of the system are drawn closer as the result of interaction, rather distancing themselves as in the more usual case of level repulsion. The phenomenon is theoretically connected to exceptional points, and a general classification of the possible regimes of interaction between two harmonic modes is exposed, including level repulsion and attraction as special cases.
In a nutshell, a cavity optomechanical system consists of a mechanical oscillator inside an optical cavity. Cavity optomechanics studies the interplay between the light-matter radiation-pressure interaction and the change in the cavity frequency induced by mechanical motion. By leveraging the tools of quantum optics and quantum measurement, cavity quantum optomechanics enables the engineering of nonclassical quantum states of bulk matter. In this thesis, I present protocols for engineering such nonclassical quantum states in Part II. First, I introduce a scheme to ‘grow’ a quantum kitten state of a mechanical oscillator into a macroscopic Schrödinger cat state using a series of nonlinear pulsed optomechanical interactions. Next, I detail our proposed schemes to generate and verify entanglement between two mechanical oscillators. Moving on from pulsed optomechanics, I describe the theory behind an experiment that achieved multi-phonon subtraction from a mechanical oscillator in a continuously driven Brillouin optomechanical system. In the final chapter of Part II, I provide a theoretical preview of an experiment that investigates the behaviour of the mechanical oscillator when no light is detected at the output. In Part III, I introduce a new framework for nonlinear cavity quantum optomechanics that incorporates the intrinsic nonlinearity of the radiation-pressure interaction, the nonlinearity from the cavity enhancement, and higher-order mechanical position terms in the expansion of the cavity frequency. I then propose a scheme for measuring mechanical position using general-dyne detection, applicable to pulsed and continuous measurements. This predicts a new regime of operation, the “stochastic Gaussian” regime. Finally, I discuss a protocol for deterministic mechanical squeezing that utilizes the cavity response.