Design, Fabrication, and Characterisation of PCFs for Photon Pair Generation

Soller, Brecht, Mosley +4 more

Shengwang Du

Chunle Xiong

This thesis introduces the linear and nonlinear properties of photonic crystal fibre (PCF), describes the fabrication and characterisation of different PCFs, and demonstrates their applications to supercontinuum (SC) generation and single-photon sources. The linear properties of PCF include endlessly single-mode transmission, highly controllable dispersion and birefringence. These unique properties have made PCFs the best media to demonstrate all kinds of nonlinear effects such as self-phase modulation (SPM), cross-phase modulation (XPM), Raman effects, four-wave mixing and modulation instability (FWM and MI), and soliton effects. The combination of these nonlinear effects has led to impressive spectral broadening known as SC generation in PCFs. The intrinsic correlation of signal and idler photons from FWM has brought PCF to the application of single-photon generation. Four projects about SC generation were demonstrated. The first was visible continuum generation in a monolithic PCF device, which gave a compact, bright (-20 dBm/nm), flat and single-mode visible continuum source extending to short wavelength at 400 nm. The second was polarised SC generation in a highly bire-fringent PCF. A well linearly polarised continuum source spanning 450-1750 nm was achieved with >99% power kept in a single linear polarisation. This polarised continuum source was then applied to tuneable visible/UV generation in a BIBO crystal. The third was residual pump peak removal for SC generation in PCFs. The fourth was to design an all-fibre dual-wavelength pumping for spectrally localised continuum generation. Two projects about photon pair generation using FWM were then demonstrated. One was an all-fibre photon pair source designed in the telecom band for quantum communication. This source achieved >50% heralding efficiency which is the highest in fibre photon pair sources reported so far. Another one was to design birefringent PCFs for naturally narrow band photon pair generation in the Si SPAD high detection efficiency range. 0.122 nm bandwidth signal photons at 596.8 nm were generated through cross polarisation phase matched FWM in a weakly birefringent PCF pumped by a picosecond Ti:Sapphire laser at 705 nm in the normal dispersion regime.

Robert J. A. Francis-Jones

Mateusz J. Olszewski, R.J. Mears, Leah R. Murphy +2 more

Longitudinal variations in photonic crystal fibres broaden four-wave mixing, limiting photon-pair source performance. We present precise characterisation of highly uniform PCF, where non-uniformities are minimised by tight tolerances and high drawing tension.

Antonio Diez, Miguel Vicente Andrés, Enrique Silvestre +5 more

The interplay between chromatic dispersion and nonlinear effects is patent. Once a photonic crystal fiber (PCF) preform has been prepared, changing the parameters that control the fabrication process it is possible to adjust the dispersion properties of the fiber. In addition, it is very useful to develop postprocessing techniques that enable a fine adjustment of the dispersion along a section of PCF. The tapering of PCF, using a fusion and pulling technique, has been established as a rather useful technique to engineer the dispersion properties along tens of centimeters. Some of our recent experiments demonstrate that the use of erbium doped PCF enables an optical control of the dispersion through optical pumping of the rare earth ions. Our interest is focused on the exploitation of nonlinear PCF for the development of fiber light sources. Thus, we will present several experiments on supercontinuum and photon pairs generation, through degenerated four-wave mixing (FWM), in order to illustrate the control that one can achieve on the optical spectra of these light sources as a function of different dispersion control approaches.