Applications in Superconducting SIS Mixers and Oscillators: Toward Integrated Receivers

Pavel N. Dmitriev, Lyudmila V. Filippenko, V. P. Koshelets

Published Aug 22, 2017• 5 citations

Abstract

This chapter presents an overview of the Nb-based tunnel junction's technology at Kotelnikov IREE in Moscow. By improving on the fully Nb-based SIR, the chapter develops and studies Nb-AlN-NbN circuits that exhibit an extended operation frequency range. Continuous frequency tuning for the phase-locked superconducting local oscillators (LO) has been experimentally demonstrated in the range of 350-750 GHz. As a result of Nb-AlO x -Nb technology optimization and extensive analysis of the SIS receiver designs, a number of low-noise receivers have been designed and tested. The Josephson flux flow oscillators based on Nb-AlO x -Nb and Nb-AlN-NbN junctions have proven to be the most developed superconducting local oscillator for integration with an SIS mixer in a single-chip submicrometer-wave superconducting integrated receiver. The implementation of an AlN tunnel barrier in combination with a NbN top superconducting electrode is expected to give a significant improvement in SIS THz mixer performance. High-quality Nb-AlN-NbN tunnel junctions were used for development of the superconducting LO and fully integrated superconducting receivers.

DOI: 10.1201/9781315364520-7

Related papers

Phase-locked Local Oscillator for Superconducting Integrated Receiver

V. P. Koshelets, Andrey B. Ermakov, Pavel N. Dmitriev +6 more

A Superconducting Integrated Receiver (SIR) comprises in a single chip a planar antenna combined with a superconductor-insulator-superconductor (SIS) mixer, a superconducting Flux Flow Oscillator (FFO) acting as a Local Oscillator (LO) and a second SIS harmonic mixer (HM) for the FFO phase locking. In this report an overview of the FFO development and optimization is presented. In order to overcome temperature constraints and extend operation frequency of the fully Nb SIR we have developed and studied Nb-AlN-NbN circuits with a gap voltage Vg up to 3.7 mV and extremely low leak currents (Rj/Rn > 30). Continuous tuning of the frequency due to bending and overlapping of the Fiske steps and a possibility to phase lock the Nb-AlN-NbN FFO at any frequency in the range 350-750 GHz has been experimentally demonstrated. After optimization of the FFO design the free-running linewidth between 7 and 1.5 MHz has been measured in the frequency range 350 - 750 GHz, which allows to phase-lock from 50 to 95 % of the emitted FFO power. New designs of the FFO intended for further improvement of its parameters are under development, but even at the present state the Nb-AlN- NbN FFOs are mature enough for practical applications. These achievements enabled development of a 500 - 650 GHz integrated receiver for the Terahertz Limb Sounder (TELIS) project intended for atmosphere study and scheduled to fly on a balloon in 2008.

Apr 1, 20081 citation

Superconducting Integrated Receiver Based on Nb-AlN-NbN-Nb Circuits

Mikhail Yu. Torgashin, V. P. Koshelets, Pavel N. Dmitriev +3 more

The superconducting integrated receiver (SIR) comprising in one chip a superconductor-insulator-superconductor (SIS) mixer and a phase-locked superconducting flux flow oscillator (FFO) is under development for the international project TELIS. To overcome temperature constraints and extend operation frequency of the SIR we have developed and studied Nb-AlN-NbN-Nb circuits with a gap voltage Vg up to 3.7 mV and extremely low leakage currents . Based on these junctions integrated microcircuits comprising FFO and harmonic mixer have been designed, fabricated and tested; the radiation from such circuits has been measured at frequencies up to 700 GHz. Employment of NbN electrode does not result in the appearance of additional noise. For example, FFO linewidth as low as 1 MHz was measured at 600 GHz, that allows us to phase lock up to 92% of the emitted by FFO power and realize very low phase noise about 90 dBc. Preliminary results demonstrated uncorrected DSB noise temperature of the Nb-AlN-NbN SIR below 250 K at frequencies around 600 GHz.

IEEE Transactions on Applied SuperconductivityJun 1, 200749 citations

Superconducting Integrated Receivers for Radio Astronomy and Atmospheric Monitoring

V. P. Koshelets, Pavel N. Dmitriev, Andrey B. Ermakov +8 more

comprises in one chip a planar antenna integrated with a superconductor-insulator-superconductor (SIS) mixer, a superconducting Flux Flow Oscillator (FFO) acting as Local Oscillator (LO) and a second SIS harmonic mixer (HM) for the FFO phase locking. A new generation of the SIR devices with improved FFO performance and optimized interface between FFO and SIS/HM has been developed and comprehensively tested. To overcome temperature constraints and extend operation frequency of the all-Nb SIR we have developed and studied Nb-AlN-NbN circuits with a gap voltage Vg up to 3.7 mV and extremely low leakage currents (Rj/Rn> 30). A possibility to phase lock the Nb-AlN-NbN FFO at any frequency in the frequency range 350-720 GHz has been experimentally demonstrated. Phase–locked SIR operation over frequency range 450 – 700 GHz has been realized, spectral resolution below

Jan 1, 20070 citations

0.5-THz waveguide SIS mixers with NbN/AlN/NbN technology

Jing Li, Masanori Takeda, Zhen Wang +1 more

Heterodyne mixers based on superconducting SIS (superconductor-insulator-superconductor) tunnel junctions have been demonstrated to be the most sensitive coherent detectors at millimeter and submillimeter wavelengths. In fact, conventional superconducting SIS mixers with Nb/AlOx/Nb junction and Nb/SiO2/Nb tuning circuit have shown good performances with the noise temperature reaching as low as three times the quantum limit below 0.7THz, which is the gap frequency of Nb-based SIS junctions. However, due to the large loss in Nb thin-film superconducting microstrip lines, the noise performance of Nb SIS mixers deteriorates significantly above 0.7THz. With a gap frequency double that of Nb-based SIS junctions, NbN-based SIS junctions are of particular interest for the development of heterodyne mixers in the terahertz region. Considering the bandwidth and output power of local-oscillator (LO) signal sources are quite limited around 1THz, we firstly develop a waveguide NbN-based SIS mixer at 0.5THz. Three types of SIS junctions, i.e., long junction, parallel-connected tunnel junction (PCTJ) and distributed junction array (DJ) are investigated. They are all comprised of NbN-AlN-NbN tri-layer fabricated on an MgO substrate and have the same current density (Jc) of 10kA/cm2. In this paper, we describe their design, fabrication and preliminary experimental results.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIENov 29, 20073 citations

Superconducting integrated THz receivers: development and applications

V. P. Koshelets, Andrey B. Ermakov, Lyudmila V. Filippenko +7 more

A Superconducting Integrated Receiver (SIR) comprises on one chip all elements needed for heterodyne detection: a low-noise SIS mixer with quasioptical antenna, a Flux-Flow Oscillator (FFO) acting as a Local Oscillator (LO) and a second SIS harmonic mixer (HM) for the FFO phase locking. Light weight and low power consumption combined with nearly quantum limited sensitivity and a wide tuning range of the FFO make SIR a perfect candidate for many practical applications. In particular, the SIR developed for novel balloon borne instrument TELIS (TErahertz and submillimeter LImb Sounder) covers frequency range 480 - 650 GHz. As a result of recent receiver's optimization the DSB noise temperature was measured as low as 120 K for the SIR with intermediate frequency (IF) band 4 - 8 GHz. The capability of the SIR for high resolution atmospheric spectroscopy has been successfully proven with scientific balloon flights from Kiruna, North Sweden. Diurnal cycles of ClO and BrO has been observed with BrO line level of only about 0.5 K. Possibility to use the SIRs for analysis of the breathed out air at medical survey has been demonstrated.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIENov 3, 201019 citations

Single Junction Design for 790-950GHz SIS Receiver

Kirill Rudakov, Khudchenko Andrey, Dmitriev Pavel +3 more

Two years ago, we have fabricated and tested superconductor-insulator-superconductor (SIS) mixers based on Nb/AlN/NbN twin tunnel junctions for waveguide receiver operating in frequency range of 790 - 950 GHz, which demonstrated noise temperature from 250 K at low frequencies to 500 K at the high end of the band. Due to high current density of the junctions (up to 30 kA/cm2 ), a wideband design was realized. Based on result for twin junction, a new mixer design with single SIS junction was proposed and produced. The single junction design is expected to have narrower frequency range than twin-based one, but still wide enough, and provide better coupling in the middle of the band. In addition, the critical current suppression will be much better, than for twin junction, which has an intrinsic problem of difference between areas of individual junctions. The SIS junction in new design is made by Nb/AlN/NbN technology and incorporated in a microstrip line consisting of a 300 nm thick bottom electrode (ground plane) made of NbTiN and a 500 nm thick top electrode made of Al. The top Al electrode is passivated by the SiO2 layer for protection. The DC tects of the fabricated wafer shows, that optimization of the technology allowed to realize gap voltage of 3.2 mV even for junctions of 0.5 square micron area fabricated on the NbTiN bottom layer. The FTS and noise temperature measurement of new mixers will be done in the nearest future and will be presented in comparison with the twin junction design results at the conference.

Apr 12, 20160 citations