Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Noise sensing and quantum simulation with trapped atomic ions

Dylan J Gorman

Published Jan 1, 2017• 0 citations
OpenAlex

Abstract

In this work, we present a novel method to couple any two vibrational modes of a single trapped ion, allowing energy to be swapped between the two modes. We use the scheme to perform ground state cooling and heating rate measurements of vibrational modes without direct optical access. This lessens experimental design constraints in trapped ion experi- ments, particularly in surface trap apparatus where optical access can be difficult.We use a single ion as an electric-field noise sensor to study noise processes originating on the metallic surfaces of microfabricated ion traps. We show that realistic models of surface noise predict a specific polarization of the electric-field fluctuations relative to the trap geometry. In contrast, technical noise sources predict a different polarization direction and magnitude which can be inferred by electrostatic simulation of the trapping electrodes. We show that, by comparing heating rates of the two radial modes of a single trapped ion, one can determine whether technical noise sources are a significant contribution to heating. This is an important test for experiments aimed at studying surface noise effects. We also study dephasing due to surface noise, in which the electric potential curvature due to surface noise sources disturbs the phase of the ion motion. We measure the dephasing time for trapped ion motion. Using a noise model featuring dipolar noise sources, we probe the power spectrum of surface noise effects. These measurements, especially if repeated in a trap with smaller ion-electrode distances, may yield new insights as to the physical origin of surface noise effects.We demonstrate a two-ion quantum simulation of vibrationally-assisted energy transfer, an important phenomenon in biochemical energy transfer. We show that the quantum simulator performs well when benchmarked against exact numerical simulation. We believe that our approach can be scaled to more complicated systems beyond the reach of classical simulation, and discuss several methods for extending the simulation.

Related papers

Microscopic model of electric-field-noise heating in ion traps

Arghavan Safavi-Naini, Peter Rabl, Philippe F. Weck +1 more

Motional heating of ions in microfabricated traps is one of the open challenges hindering experimental realizations of large-scale quantum processing devices. Recently, a series of measurements of the heating rates in surface-electrode ion traps characterized their frequency, distance, and temperature dependencies, but our understanding of the microscopic origin of this noise remains incomplete. In this work we develop a theoretical model for the electric field noise which is associated with a random distribution of adsorbed atoms on the trap electrode surface. By using first-principles calculations of the fluctuating dipole moments of the adsorbed atoms we evaluate the distance, frequency, and temperature dependence of the resulting electric field fluctuation spectrum. Our theory reproduces correctly the ${d}^{\ensuremath{-}4}$ dependence with distance of the ion from the electrode surface and calculates the noise spectrum beyond the standard scenario of two-level fluctuators by incorporating all the relevant vibrational states. Our model predicts a regime of $1/f$ noise which commences at roughly the frequency of the fundamental phonon transition rate and a thermally activated noise spectrum which for higher temperatures exhibits a crossover as a function of frequency.

arXiv:1106.1949•Physical Review A•Aug 22, 2011•91 citations

van der Waals-corrected density functional study of electric field noise heating in ion traps caused by electrode surface adsorbates

Keith G. Ray, Brenda M Rubenstein, Wenze Gu +1 more

Abstract In order to realize the full potential of ion trap quantum computers, an improved understanding is required of the motional heating that trapped ions experience. Experimental studies of the temperature-, frequency-, and ion–electrode distance-dependence of the electric field noise responsible for motional heating, as well as the noise before and after ion bombardment cleaning of trap electrodes, suggest that fluctuations of adsorbate dipoles are a likely source of so-called ‘anomalous heating,’ or motional heating of the trapped ions at a rate much higher than the Johnson noise limit. Previous computational studies have investigated how the fluctuation of model adsorbate dipoles affects anomalous heating. However, the way in which specific adsorbates affect the electric field noise has not yet been examined, and an electric dipole model employed in previous studies is only accurate for a small subset of possible adsorbates. Here, we analyze the behavior of both in-plane and out-of-plane vibrational modes of twenty-one adsorbate–electrode combinations within the independent fluctuating dipole model, utilizing accurate first principles computational methods to determine the surface-induced dipole moments. We find the chemical specificity of the adsorbate can change the electric field noise by seven orders of magnitude and specifically that soft in-plane modes of weakly-adsorbed hydrocarbons produce the greatest noise and ion heating. We discuss the dynamics captured by the fluctuating dipole model, namely the adsorbate-dependent turn-on temperature and electric field noise magnitude, and also discuss the model’s failure to reproduce the measured 1/ω noise frequency scaling with a single adsorbate species. We suggest future research directions for improved, quantitatively predictive models based on extensions of the present framework to multiple interacting adsorbates.

arXiv:1810.10199•New Journal of Physics•Apr 11, 2019•10 citations

Polarization of electric-field noise near metallic surfaces

Philipp Schindler, Dylan J Gorman, Nikos Daniilidis +1 more

Electric-field noise in proximity to metallic surfaces is a poorly understood phenomenon that appears in different areas of physics. Trapped ion quantum information processors are particularly susceptible to this noise, leading to motional decoherence, which ultimately limits the fidelity of quantum operations. On the other hand, trapped ions present an ideal tool to study this effect, opening new possibilities in surface science. In this work we analyze and measure the polarization of the noise field in a microfabricated ion trap for various noise sources. We find that technical noise sources and noise emanating directly from the surface give rise to different degrees of polarization, which allows us to differentiate between the two noise sources. Based on this we demonstrate a method to infer the magnitude of surface noise in the presence of technical noise.

arXiv:1505.01237•Physical Review A•Jul 16, 2015•10 citations

Implications of surface noise for the motional coherence of trapped ions

Ishan Talukdar, Dylan J Gorman, Nikos Daniilidis +5 more

Electric noise from metallic surfaces is a major obstacle towards quantum applications with trapped ions due to motional heating of the ions. Here, we discuss how the same noise source can also lead to pure dephasing of motional quantum states. The mechanism is particularly relevant at small ion-surface distances, thus imposing a constraint on trap miniaturization. By means of a free induction decay experiment, we measure the dephasing time of the motion of a single ion trapped 50 $\ensuremath{\mu}\mathrm{m}$ above a Cu-Al surface. From the dephasing times we extract the integrated noise below the secular frequency of the ion. We find that none of the most commonly discussed surface noise models for ion traps describes both the observed heating as well as the measured dephasing satisfactorily. Thus, our measurements provide a benchmark for future models for the electric noise emitted by metallic surfaces.

arXiv:1511.04819•Physical Review A•Apr 20, 2016•28 citations

Predicting electric-field noise in ion traps using fluctuation electrodynamics

Markus Teller, Da An, Alberto M. Alonso +4 more

Electric-field noise in microfabricated surface ion traps contributes to gate errors in trapped-ion quantum computers, but this noise has been challenging to predict. Here, we present a method to predict the electric-field noise arising from fluctuations in the bulk of dielectric and metallic materials. The method is valid for arbitrary trap geometries, and the only relevant material property is energy loss. We apply it to an ion trap with an electrically floating electrode and find the contribution from dielectrics to be dominant. Our model predicts the observed noise for this trap within a factor of four. In addition, we apply our model to typical surface trap designs and analyze how the electrode structures shield the noise.

quant-pharXiv:2610.01693•Oct 2, 2026•0 citations

Multi-ion sensing of dipolar noise sources in ion traps

Fernando Galve, Joseba Alonso, Roberta Zambrini

Trapped-ion quantum platforms are subject to ``anomalous'' heating due to interactions with electric-field noise sources of nature not yet completely known. There is ample experimental evidence that this noise originates at the surfaces of the trap electrodes, and models assuming fluctuating pointlike dipoles are consistent with observations, but the exact microscopic mechanisms behind anomalous heating remain undetermined. Here we show how a two-ion probe displays a transition in its dissipation properties, enabling experimental access to the mean orientation of the dipoles and the spatial extent of dipole-dipole correlations. This information can be used to test the validity of candidate microscopic models, which predict correlation lengths spanning several orders of magnitude. Furthermore, we propose an experiment to measure these effects with currently available traps and techniques.

arXiv:1703.09657•Physical Review A•Sep 14, 2017•5 citations
In this work, we present a novel method to couple any two vibrational modes of a single trapped ion, allowing energy to be swapped between the two modes. We use the scheme to perform ground state cooling and heating rate measurements of vibrational modes without direct optical access. This lessens experimental design constraints in trapped ion experi- ments, particularly in surface trap apparatus where optical access can be difficult.We use a single ion as an electric-field noise sensor to study noise processes originating on the metallic surfaces of microfabricated ion traps. We show that realistic models of surface noise predict a specific polarization of the electric-field fluctuations relative to the trap geometry. In contrast, technical noise sources predict a different polarization direction and magnitude which can be inferred by electrostatic simulation of the trapping electrodes. We show that, by comparing heating rates of the two radial modes of a single trapped ion, one can determine whether technical noise sources are a significant contribution to heating. This is an important test for experiments aimed at studying surface noise effects. We also study dephasing due to surface noise, in which the electric potential curvature due to surface noise sources disturbs the phase of the ion motion. We measure the dephasing time for trapped ion motion. Using a noise model featuring dipolar noise sources, we probe the power spectrum of surface noise effects. These measurements, especially if repeated in a trap with smaller ion-electrode distances, may yield new insights as to the physical origin of surface noise effects.We demonstrate a two-ion quantum simulation of vibrationally-assisted energy transfer, an important phenomenon in biochemical energy transfer. We show that the quantum simulator performs well when benchmarked against exact numerical simulation. We believe that our approach can be scaled to more complicated systems beyond the reach of classical simulation, and discuss several methods for extending the simulation.
Motional heating of ions in microfabricated traps is one of the open challenges hindering experimental realizations of large-scale quantum processing devices. Recently, a series of measurements of the heating rates in surface-electrode ion traps characterized their frequency, distance, and temperature dependencies, but our understanding of the microscopic origin of this noise remains incomplete. In this work we develop a theoretical model for the electric field noise which is associated with a random distribution of adsorbed atoms on the trap electrode surface. By using first-principles calculations of the fluctuating dipole moments of the adsorbed atoms we evaluate the distance, frequency, and temperature dependence of the resulting electric field fluctuation spectrum. Our theory reproduces correctly the ${d}^{\ensuremath{-}4}$ dependence with distance of the ion from the electrode surface and calculates the noise spectrum beyond the standard scenario of two-level fluctuators by incorporating all the relevant vibrational states. Our model predicts a regime of 1/f1/f1/f noise which commences at roughly the frequency of the fundamental phonon transition rate and a thermally activated noise spectrum which for higher temperatures exhibits a crossover as a function of frequency.
Abstract In order to realize the full potential of ion trap quantum computers, an improved understanding is required of the motional heating that trapped ions experience. Experimental studies of the temperature-, frequency-, and ion–electrode distance-dependence of the electric field noise responsible for motional heating, as well as the noise before and after ion bombardment cleaning of trap electrodes, suggest that fluctuations of adsorbate dipoles are a likely source of so-called ‘anomalous heating,’ or motional heating of the trapped ions at a rate much higher than the Johnson noise limit. Previous computational studies have investigated how the fluctuation of model adsorbate dipoles affects anomalous heating. However, the way in which specific adsorbates affect the electric field noise has not yet been examined, and an electric dipole model employed in previous studies is only accurate for a small subset of possible adsorbates. Here, we analyze the behavior of both in-plane and out-of-plane vibrational modes of twenty-one adsorbate–electrode combinations within the independent fluctuating dipole model, utilizing accurate first principles computational methods to determine the surface-induced dipole moments. We find the chemical specificity of the adsorbate can change the electric field noise by seven orders of magnitude and specifically that soft in-plane modes of weakly-adsorbed hydrocarbons produce the greatest noise and ion heating. We discuss the dynamics captured by the fluctuating dipole model, namely the adsorbate-dependent turn-on temperature and electric field noise magnitude, and also discuss the model’s failure to reproduce the measured 1/ω noise frequency scaling with a single adsorbate species. We suggest future research directions for improved, quantitatively predictive models based on extensions of the present framework to multiple interacting adsorbates.
Electric-field noise in proximity to metallic surfaces is a poorly understood phenomenon that appears in different areas of physics. Trapped ion quantum information processors are particularly susceptible to this noise, leading to motional decoherence, which ultimately limits the fidelity of quantum operations. On the other hand, trapped ions present an ideal tool to study this effect, opening new possibilities in surface science. In this work we analyze and measure the polarization of the noise field in a microfabricated ion trap for various noise sources. We find that technical noise sources and noise emanating directly from the surface give rise to different degrees of polarization, which allows us to differentiate between the two noise sources. Based on this we demonstrate a method to infer the magnitude of surface noise in the presence of technical noise.
Electric noise from metallic surfaces is a major obstacle towards quantum applications with trapped ions due to motional heating of the ions. Here, we discuss how the same noise source can also lead to pure dephasing of motional quantum states. The mechanism is particularly relevant at small ion-surface distances, thus imposing a constraint on trap miniaturization. By means of a free induction decay experiment, we measure the dephasing time of the motion of a single ion trapped 50 $\ensuremath{\mu}\mathrm{m}$ above a Cu-Al surface. From the dephasing times we extract the integrated noise below the secular frequency of the ion. We find that none of the most commonly discussed surface noise models for ion traps describes both the observed heating as well as the measured dephasing satisfactorily. Thus, our measurements provide a benchmark for future models for the electric noise emitted by metallic surfaces.
Electric-field noise in microfabricated surface ion traps contributes to gate errors in trapped-ion quantum computers, but this noise has been challenging to predict. Here, we present a method to predict the electric-field noise arising from fluctuations in the bulk of dielectric and metallic materials. The method is valid for arbitrary trap geometries, and the only relevant material property is energy loss. We apply it to an ion trap with an electrically floating electrode and find the contribution from dielectrics to be dominant. Our model predicts the observed noise for this trap within a factor of four. In addition, we apply our model to typical surface trap designs and analyze how the electrode structures shield the noise.
Trapped-ion quantum platforms are subject to ``anomalous'' heating due to interactions with electric-field noise sources of nature not yet completely known. There is ample experimental evidence that this noise originates at the surfaces of the trap electrodes, and models assuming fluctuating pointlike dipoles are consistent with observations, but the exact microscopic mechanisms behind anomalous heating remain undetermined. Here we show how a two-ion probe displays a transition in its dissipation properties, enabling experimental access to the mean orientation of the dipoles and the spatial extent of dipole-dipole correlations. This information can be used to test the validity of candidate microscopic models, which predict correlation lengths spanning several orders of magnitude. Furthermore, we propose an experiment to measure these effects with currently available traps and techniques.