Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

The Rochester Conferences on Coherence and Quantum Optics and the Quantum Information and Measurement meeting

Ultra-low Noise Upconversion Single-Photon Detector in the Telecom Band

Guo-Liang Shentu, Jason S. Pelc, Xiao-Dong Wang, M. M. Fejer, Qiang Zhang, Jian-Wei Pan

Published Jan 1, 2013• 0 citations
Publisher

Abstract

We demonstrate upconversion single-photon detection for the 1550-nm band using a PPLN waveguide, long-wavelength pump, and narrowband filtering. We achieve total-system detection efficiency of 30% with noise at the dark-count level of a silicon APD.
DOI
10.1364/qim.2013.w6.53

Related papers

Long-wavelength-pumped upconversion single-photon detector at 1550 nm: performance and noise analysis

Jason S. Pelc, Long Ma, Christopher R. Phillips +5 more

We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.

Optics Express•Oct 17, 2011•242 citations

Low-noise PPLN-based single-photon detector

Xu Hai, Lijun Ma, Oliver Slattery +1 more

This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 9, 2007•13 citations

Efficient and low-noise single-photon detection in 1550 nm communication band by frequency upconversion in periodically poled LiNbO_3 waveguides

Hidehiko Kamada, Masaki Asobe, Toshimori Honjo +5 more

We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).

Optics Letters•Mar 18, 2008•50 citations

Upconversion detection near 2 μm at the single photon level

Guo-Liang Shentu, Xiu-Xiu Xia, Qi-Chao Sun +4 more

We have demonstrated upconversion detection at the single photon level in the 2 μm spectral window using a pump wavelength near 1550 nm, a periodically poled lithium niobate (PPLN) waveguide, and a volume Bragg grating (VBG) to reduce noise. We achieve a system photon detection efficiency of 10%, with a noise count rate of 24,500 counts per second, competitive with other 2 μm single photon detection technologies. This detector has potential applications in environmental gas monitoring, life science, and classical and quantum communication.

Optics Letters•Nov 19, 2013•22 citations

Enhancing the detectivity of an upconversion single-photon detector by spatial filtering of upconverted parametric fluorescence

Lichun Meng, Lasse Høgstedt, Peter Tidemand‐Lichtenberg +2 more

Due to advantages of low dark-count rate, reduced dead-time, and room-temperature operation, single-photon upconversion detectors for the telecom band are gaining strong interest as an alternative to other single-photon counters. In this work, we investigate the spatial and spectral distribution of upconverted spontaneous parametric downconversion (USPDC) noise, which is the typical dominant noise source in short-wavelength-pumped single-photon upconversion detectors for 1.5 µm - 1.6 µm. Our upconversion detector relies on a bulk periodically poled lithium niobate (PPLN) crystal and a 1064 nm intracavity pump system that spectrally translates the signal to the visible (~630 nm) where efficient, uncooled, and low dark-count Si based single-photon detectors operate. Experimental results show that the spectral and spatial distribution of the USPDC noise has a relatively broadband and radially modulated pattern that depends on the PPLN temperature, which is in good agreement with our numerical simulations. We also demonstrate that for narrow-linewidth 1575 nm signal photons, the dark-count rate can be significantly reduced by (1) using a phase-matched signal angle that corresponds to an upconverted output angle where the USPDC noise is at a "local minimum" and (2) applying a spatial filter (instead of an ultra-narrow bandpass filter) at the output. This simple spatial filtering technique resulted in a 14 dB dark-count rate reduction. Due to a corresponding decrease in the interaction length of the signal with the pump, the upconversion efficiency also decreased, but only with a 2.2 dB penalty.

Optics Express•Sep 6, 2018•15 citations

Detection and spectral measurement of single photons in communication bands using up-conversion technology

Long Ma, Oliver Slattery, Xiao Hong Tang

Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.

Laser Physics•Apr 2, 2010•11 citations
We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.
This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.
We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).
We have demonstrated upconversion detection at the single photon level in the 2 μm spectral window using a pump wavelength near 1550 nm, a periodically poled lithium niobate (PPLN) waveguide, and a volume Bragg grating (VBG) to reduce noise. We achieve a system photon detection efficiency of 10%, with a noise count rate of 24,500 counts per second, competitive with other 2 μm single photon detection technologies. This detector has potential applications in environmental gas monitoring, life science, and classical and quantum communication.
Due to advantages of low dark-count rate, reduced dead-time, and room-temperature operation, single-photon upconversion detectors for the telecom band are gaining strong interest as an alternative to other single-photon counters. In this work, we investigate the spatial and spectral distribution of upconverted spontaneous parametric downconversion (USPDC) noise, which is the typical dominant noise source in short-wavelength-pumped single-photon upconversion detectors for 1.5 µm - 1.6 µm. Our upconversion detector relies on a bulk periodically poled lithium niobate (PPLN) crystal and a 1064 nm intracavity pump system that spectrally translates the signal to the visible (~630 nm) where efficient, uncooled, and low dark-count Si based single-photon detectors operate. Experimental results show that the spectral and spatial distribution of the USPDC noise has a relatively broadband and radially modulated pattern that depends on the PPLN temperature, which is in good agreement with our numerical simulations. We also demonstrate that for narrow-linewidth 1575 nm signal photons, the dark-count rate can be significantly reduced by (1) using a phase-matched signal angle that corresponds to an upconverted output angle where the USPDC noise is at a "local minimum" and (2) applying a spatial filter (instead of an ultra-narrow bandpass filter) at the output. This simple spatial filtering technique resulted in a 14 dB dark-count rate reduction. Due to a corresponding decrease in the interaction length of the signal with the pump, the upconversion efficiency also decreased, but only with a 2.2 dB penalty.
Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.