Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Metal-insulator transition in sliding Luttinger liquid

Alexander L. Chudnovskiy, V. Kagalovsky, I. V. Yurkevich

Published Jun 12, 2017• 1 citation
OpenAlex

Abstract

We investigate the effect of both strong and weak potential scattering caused by local impurities and extended (line) defects in the array of Luttinger liquid wires. We find that in both cases a finite range inter-wire interaction stabilises metallic state. Based on calculation of the scaling dimensions of one-particle scattering operators, we construct the phase diagram for low-temperature transport along the array. We find that unlike local impurity case where only conducting and insulating states are realised (metal-insulator transition driven by interactions), the extended line defects may bring the system into a mixed state where conducting or insulating behavior can be observed depending on bare strength of the scatterer (metal-insulator transition driven by disorder).

Related papers

Metal-insulator transition in a sliding Luttinger liquid with line defects

Alexander L. Chudnovskiy, V. Kagalovsky, I. V. Yurkevich

We investigate the effect of both strong and weak potential scattering caused by local impurities and extended (line) defects in an array of Luttinger liquid wires. We find that in both cases a finite range interwire interaction stabilizes the metallic state. Based on calculations of the scaling dimensions of one-particle scattering operators, we construct a phase diagram for low-temperature transport along the array. We find that unlike the local impurity case where only conducting and insulating states are realized (metal-insulator transition driven by interactions), the extended line defects may bring the system into a mixed state where conducting or insulating behavior can be observed depending on bare strength of the scatterer (metal-insulator transition driven by disorder).

arXiv:1706.03550•Physical review. B./Physical review. B•Oct 6, 2017•7 citations

Edge states in non-Fermi liquids

I. V. Yurkevich

We devise an approach to the calculation of scaling dimensions of generic operators describing scattering within multi-channel Luttinger liquid. The local impurity scattering in an arbitrary configuration of conducting and insulating channels is investigated and the problem is reduced to a single algebraic matrix equation. In particular, the solution to this equation is found for a finite array of chains described by Luttinger liquid models. It is found that for a weak inter-chain hybridisation and intra-channel electron-electron attraction the edge wires are robust against disorder whereas bulk wires, on contrary, become insulating. Thus, the edge state may exist in a finite sliding Luttinger liquid without time-reversal symmetry breaking (quantum Hall systems) or spin-orbit interaction (topological insulators).

arXiv:1702.06406•Feb 21, 2017•1 citation

An impurity in a Luttinger Liquid coupled to Ohmic-class environments

Andisheh Khedri, Antonio Štrkalj, Oded Zilberberg

We investigate the impact of noisy environments on transport through a one dimensional interacting quantum wire containing a scattering impurity. The impurity is known to induce a metal-insulator quantum phase transition as a function of the interaction strength in the wire. By considering Ohmic-class environments (ranging from Ohmic, to sub-Ohmic and super-Ohmic cases), we elucidate the influence of fluctuations on this phase transition. Within a perturbative renormalization group approach, we show that Ohmic environments keep the phase transition intact, while sub- and super-Ohmic environments, modify it into a smooth crossover at a scale that depends on the interaction strength in the wire. The system, however, still undergoes a metal-to-insulator-like transition when moving from sub-Ohmic to super-Ohmic environment noise. We further consider realistic experimental conditions due to finite length and finite temperatures of the wire, and explore the signatures of the phase transition in the temperature dependence of the impurity-induced back-scattering electrical conductance.

•Dec 8, 2020•0 citations

Sliding Luttinger liquid with alternating interwire couplings

S Begum, V Fleurov, V. Kagalovsky +1 more

We study a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in a two-dimensional array in the absence of a magnetic field. We analyse whether the nearest-neighbour inter-wire interactions, stabilise the SLL phase. We construct an analogue of a Su-Schriefer-Heeger (SSH) model (allowing alternating couplings between wires). Calculating the scaling dimensions of the two most relevant perturbations, charge-density wave, and superconducting inter-wire couplings, but excluding the inter-wire single-particle hybridisation, we find a finite stability region for the SLL. It emerges due to the inter-wire forward scattering interaction, and remains stable up to a significant asymmetry between alternating couplings.

arXiv:1903.02920•Journal of Physics Condensed Matter•Jun 17, 2019•5 citations

Instability of sliding Luttinger liquid

V. Fleurov, Kagalovsky, V., Lerner, I.V. +1 more

We revise a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in two- or three-dimensional arrays in the absence of a magnetic field. We analyse whether physically justifiable (reasonable) inter-wire interactions, i.e. either the screened Coulomb or "Coulomb-blockade" type interactions, stabilise the SLL phase. Calculating the scaling dimensions of the most relevant perturbations (the inter-wire single-particle hybridisation, charge-density wave, and superconducting inter-wire couplings), we find that their combination always destroys the SLL phase for the repulsive intra-wire interaction. However, suppressing the inter-wire tunnelling of repulsive fermions (when the charge-density wave is the only remaining perturbation), one can observe a stability region emerging due to the inter-wire forward scattering interaction.

•May 10, 2018•5 citations

Instability of the sliding Luttinger liquid

V Fleurov, V. Kagalovsky, I V Lerner +1 more

We revise a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in two- or three-dimensional arrays in the absence of a magnetic field. We analyse whether physically justifiable (reasonable) inter-wire interactions, i.e. either the screened Coulomb or 'Coulomb-blockade' type interactions, stabilise the SLL phase. Calculating the scaling dimensions of the most relevant perturbations (the inter-wire single-particle hybridisation, charge-density wave, and superconducting inter-wire couplings), we find that their combination always destroys the SLL phase for the repulsive intra-wire interaction. However, suppressing the inter-wire tunnelling of repulsive fermions (when the charge-density wave is the only remaining perturbation), one can observe a stability region emerging due to the inter-wire forward scattering interaction.

arXiv:1711.01639•Journal of Physics Condensed Matter•Mar 26, 2018•5 citations
We investigate the effect of both strong and weak potential scattering caused by local impurities and extended (line) defects in the array of Luttinger liquid wires. We find that in both cases a finite range inter-wire interaction stabilises metallic state. Based on calculation of the scaling dimensions of one-particle scattering operators, we construct the phase diagram for low-temperature transport along the array. We find that unlike local impurity case where only conducting and insulating states are realised (metal-insulator transition driven by interactions), the extended line defects may bring the system into a mixed state where conducting or insulating behavior can be observed depending on bare strength of the scatterer (metal-insulator transition driven by disorder).
We investigate the effect of both strong and weak potential scattering caused by local impurities and extended (line) defects in an array of Luttinger liquid wires. We find that in both cases a finite range interwire interaction stabilizes the metallic state. Based on calculations of the scaling dimensions of one-particle scattering operators, we construct a phase diagram for low-temperature transport along the array. We find that unlike the local impurity case where only conducting and insulating states are realized (metal-insulator transition driven by interactions), the extended line defects may bring the system into a mixed state where conducting or insulating behavior can be observed depending on bare strength of the scatterer (metal-insulator transition driven by disorder).
We devise an approach to the calculation of scaling dimensions of generic operators describing scattering within multi-channel Luttinger liquid. The local impurity scattering in an arbitrary configuration of conducting and insulating channels is investigated and the problem is reduced to a single algebraic matrix equation. In particular, the solution to this equation is found for a finite array of chains described by Luttinger liquid models. It is found that for a weak inter-chain hybridisation and intra-channel electron-electron attraction the edge wires are robust against disorder whereas bulk wires, on contrary, become insulating. Thus, the edge state may exist in a finite sliding Luttinger liquid without time-reversal symmetry breaking (quantum Hall systems) or spin-orbit interaction (topological insulators).
We investigate the impact of noisy environments on transport through a one dimensional interacting quantum wire containing a scattering impurity. The impurity is known to induce a metal-insulator quantum phase transition as a function of the interaction strength in the wire. By considering Ohmic-class environments (ranging from Ohmic, to sub-Ohmic and super-Ohmic cases), we elucidate the influence of fluctuations on this phase transition. Within a perturbative renormalization group approach, we show that Ohmic environments keep the phase transition intact, while sub- and super-Ohmic environments, modify it into a smooth crossover at a scale that depends on the interaction strength in the wire. The system, however, still undergoes a metal-to-insulator-like transition when moving from sub-Ohmic to super-Ohmic environment noise. We further consider realistic experimental conditions due to finite length and finite temperatures of the wire, and explore the signatures of the phase transition in the temperature dependence of the impurity-induced back-scattering electrical conductance.
We study a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in a two-dimensional array in the absence of a magnetic field. We analyse whether the nearest-neighbour inter-wire interactions, stabilise the SLL phase. We construct an analogue of a Su-Schriefer-Heeger (SSH) model (allowing alternating couplings between wires). Calculating the scaling dimensions of the two most relevant perturbations, charge-density wave, and superconducting inter-wire couplings, but excluding the inter-wire single-particle hybridisation, we find a finite stability region for the SLL. It emerges due to the inter-wire forward scattering interaction, and remains stable up to a significant asymmetry between alternating couplings.
We revise a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in two- or three-dimensional arrays in the absence of a magnetic field. We analyse whether physically justifiable (reasonable) inter-wire interactions, i.e. either the screened Coulomb or "Coulomb-blockade" type interactions, stabilise the SLL phase. Calculating the scaling dimensions of the most relevant perturbations (the inter-wire single-particle hybridisation, charge-density wave, and superconducting inter-wire couplings), we find that their combination always destroys the SLL phase for the repulsive intra-wire interaction. However, suppressing the inter-wire tunnelling of repulsive fermions (when the charge-density wave is the only remaining perturbation), one can observe a stability region emerging due to the inter-wire forward scattering interaction.
We revise a phase diagram for the sliding Luttinger liquid (SLL) of coupled one-dimensional quantum wires packed in two- or three-dimensional arrays in the absence of a magnetic field. We analyse whether physically justifiable (reasonable) inter-wire interactions, i.e. either the screened Coulomb or 'Coulomb-blockade' type interactions, stabilise the SLL phase. Calculating the scaling dimensions of the most relevant perturbations (the inter-wire single-particle hybridisation, charge-density wave, and superconducting inter-wire couplings), we find that their combination always destroys the SLL phase for the repulsive intra-wire interaction. However, suppressing the inter-wire tunnelling of repulsive fermions (when the charge-density wave is the only remaining perturbation), one can observe a stability region emerging due to the inter-wire forward scattering interaction.