Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics Conference Series

Using Spatial Correlations of SPDC Sources for Increasing the Signal to Noise Ratio in Images

A I Ruíz, R Caudillo, Víctor Velázquez, E Barrios

Published May 26, 2017• 1 citation
Publisher

Abstract

We experimentally show that, by using spatial correlations of photon pairs produced by Spontaneous Parametric Down-Conversion, it is possible to increase the Signal to Noise Ratio in images of objects illuminated with those photons; in comparison, objects illuminated with light from a laser present a minor ratio. Our simple experimental set-up was capable to produce an average improvement in signal to noise ratio of 11dB of Parametric Down-Converted light over laser light. This simple method can be easily implemented for obtaining high contrast images of faint objects and for transmitting information with low noise.

DOI
10.1088/1742-6596/839/1/012025

Related papers

Quantum imaging with a photon counting camera

Osian Wolley, Thomas Gregory, Sebastian M. J. Beer +2 more

Classical light sources emit a randomly-timed stream of individual photons, the spatial distribution of which can be detected with a camera to form an image. Quantum light sources, based on parametric down conversion, emit photons as correlated photon-pairs. The spatial correlations between the photons enables imaging systems where the preferential selection of photon-pairs allows for enhancements in the noise performance over what is possible using classical light sources. However, until now the technical challenge of measuring, and correlating both photons has led to system complexity. Here we show that a camera capable of resolving the number of individual photons in each pixel of the detector array can be used to record an image formed from these photon-pair events and hence achieve a greater contrast than possible using a classical light source. We achieve an enhancement in the ratio of two-photon events compared to one-photon events using spatially correlated SPDC light compared to uncorrelated illumination by a LED. These results indicate the potential advantages of using photon counting cameras in quantum imaging schemes and these advantages will further increase as the technology is developed. Operating in photon sparse regimes such systems have potential applications in low-light microscopy and covert imaging.

Scientific Reports•May 18, 2022•47 citations

Robust Ghost Imaging Based on Degenerate Spontaneous Parametric Down-Conversion

Ling‐Jun Kong, Yu Si, Rui Liu +5 more

In traditional ghost imaging, the entangled photon pairs produced from the spontaneous parametric down conversion (SPDC) process are used. There is an intrinsic disadvantage that the utilization efficiency of the photon pairs is very low. Inasmuch as all the correlated photon pairs produced by the degenerate SPDC process can be used to record the image of an object, the ghost imaging scheme we present here has a higher utilization efficiency of the photon pairs. We also investigate the robustness of our experimental scheme. The experimental results show that, no matter whether the photon-pair source is two light cones or two beam-like spots, the clear image of the object can be obtained. The slight rotation of the nonlinear crystal has no influence on the imaging quality. Our experimental results also demonstrate that when the part of the photon-pair source in the signal path or the idler path is blocked by unwanted things, the clear ghost image of the object can still be recorded.

Chinese Physics Letters•May 1, 2017•0 citations

Noise-tolerant object detection and ranging using quantum correlations

Hashir Kuniyil, Helin Ozel, Hasan Yılmaz +1 more

Abstract Imaging, detection and ranging of objects in the presence of significant background noise is a fundamental challenge in optical sensing. Overcoming the limitations imposed in conventional methods, quantum light sources show higher resistance against noise in a time-correlation-based quantum illumination. Here, we introduce the advantage of using not only time correlations but also polarization correlations in photon pairs in the detection of an object that is embedded in a noisy background. In this direction, a time- and polarization-correlated photon pair source using the spontaneous parametric down-conversion process is exploited. We found that the joint measurement of correlated pairs allows distinguishing the signal from the noise photons and that leads to an improved signal-to-noise ratio. Our comparative study revealed that using polarization correlations in addition to time correlations provides improved noise rejection. Furthermore, we show that polarization correlation allows undoing the detector limitation where high background often leads to detector saturation.

arXiv:2111.04062•Journal of Optics•Aug 15, 2022•9 citations

Noise-Tolerant Object Ranging with a Time- and Polarization-Correlated Photon Pair Source

Hashir Kuniyil, Helin Ozel, Hasan Yılmaz +1 more

Imaging, detection and ranging of objects in the presence of significant background noise is a fundamental challenge in optical sensing. Overcoming the limitations imposed in conventional methods, quantum light sources show higher resistance against noise in a time correlation-based detection scheme. Here, we introduce the advantage of using not only time correlations, but also polarization correlations in photon pairs in the detection of an object that is embedded in a noisy background. In this direction, a time- and polarization-correlated photon-pair source using the spontaneous parametric down-conversion process is exploited. We found that the joint measurement of correlated pairs allows to distinguish the signal from the noise photons and that leads to an improved signal-to-noise ratio. Our comparative study revealed that using polarization correlations in addition to time correlations provides improved noise rejection.

•Nov 7, 2021•0 citations

Single-pixel imaging with heralded single photons

Steven Johnson, Alex R. McMillan, Cyril Torre +3 more

Traditional remote sensing applications are often based on pulsed laser illumination with a narrow linewidth and characteristic repetition rate, which are not conducive to covert operation. Whatever methods are employed for covert sensing, a key requirement is for the probe light to be indistinguishable from background illumination. We present a method to perform single-pixel imaging that suppresses the effect of background light and hence improves the signal-to-noise ratio by using correlated photon-pairs produced via spontaneous parametric down conversion. One of the photons in the pair is used to illuminate the object whilst the other acts as a temporal reference, allowing the signal photons to be distinguished from background noise. Understanding the noise regime is key to producing higher contrast images using this heralding method.

Optics Continuum•Mar 22, 2022•16 citations

Full field measurement of spatial correlated photon pairs with an EMCCD camera

M. Edgar, D. S. Tasca, Frauke Izdebski +5 more

The spatial correlations between the photon pairs produced by spontaneous parametric down conversion (SPDC) have been investigated in a number of different configurations over the last two decades (1). The high dimensionality of the transverse spatial degrees of freedom (DOF) of the photon pairs can be explored either by projections onto a discrete (infinite) basis, such as the LG modes, or by using a continuous basis defined by the transverse position or momentum of the photons. For instance, it has been shown that their transverse position and momentum display EPR-type correlations (2). Despite the continuous and unbounded nature of both these bases, the most common measurements to date have relied upon the scanning of a single avalanche photodiode or a very small number of individual detectors. This sequential scanning or small number of detectors negates any information capacity advantage in the use of spatial states. Recent years have seen a rapid advance in imaging technologies, particularly for low light levels. Of these technologies the highest quantum efficiency is achieved using electron multiplying CCDs (EMCCD). Developments in low noise EMCCD cameras suggest they are capable of greater than 80% quantum efficiencies and if operated in an ultra-low light environment whilst being maintained at low temperatures, can provide single photon sensitivity (3). EMCCDs have been used in measurements of sub-shot-noise correlations of intensity fluctuations (4, 5) as well as in intensity correlations measurements (6) in the far field of the photon pairs from SPDC. Here we report the observation of spatial correlations from SPDC using an EMCCD camera in both the image and far-field planes of the down conversion crystal. We pump a BBO crystal at 355nm with a few milli-Watts of optical power and use a simple lens system to relay the down-converted light to an EMCCD array which can be positioned in either the image plane or the far-field of the crystal. Our photon flux is around 1/100 per pixel, which approximately doubles the signal obtained when the light is blocked. We typically record 100,000 individual frames and then sum the auto-correlation of the individual frames. We observed intensity correlation and anti-correlation in the image and far-field planes, respectively. In both cases we make the correlations more visible by subtracting a background which is obtained as the average correlation obtained between successive frames. Using this approach we are able to visualize the strength of the correlations in both position and momentum, showing a variance product nearly one order of magnitude below the classical limit in both x and y directions.

•Jan 1, 2012•0 citations
We experimentally show that, by using spatial correlations of photon pairs produced by Spontaneous Parametric Down-Conversion, it is possible to increase the Signal to Noise Ratio in images of objects illuminated with those photons; in comparison, objects illuminated with light from a laser present a minor ratio. Our simple experimental set-up was capable to produce an average improvement in signal to noise ratio of 11dB of Parametric Down-Converted light over laser light. This simple method can be easily implemented for obtaining high contrast images of faint objects and for transmitting information with low noise.
Classical light sources emit a randomly-timed stream of individual photons, the spatial distribution of which can be detected with a camera to form an image. Quantum light sources, based on parametric down conversion, emit photons as correlated photon-pairs. The spatial correlations between the photons enables imaging systems where the preferential selection of photon-pairs allows for enhancements in the noise performance over what is possible using classical light sources. However, until now the technical challenge of measuring, and correlating both photons has led to system complexity. Here we show that a camera capable of resolving the number of individual photons in each pixel of the detector array can be used to record an image formed from these photon-pair events and hence achieve a greater contrast than possible using a classical light source. We achieve an enhancement in the ratio of two-photon events compared to one-photon events using spatially correlated SPDC light compared to uncorrelated illumination by a LED. These results indicate the potential advantages of using photon counting cameras in quantum imaging schemes and these advantages will further increase as the technology is developed. Operating in photon sparse regimes such systems have potential applications in low-light microscopy and covert imaging.
In traditional ghost imaging, the entangled photon pairs produced from the spontaneous parametric down conversion (SPDC) process are used. There is an intrinsic disadvantage that the utilization efficiency of the photon pairs is very low. Inasmuch as all the correlated photon pairs produced by the degenerate SPDC process can be used to record the image of an object, the ghost imaging scheme we present here has a higher utilization efficiency of the photon pairs. We also investigate the robustness of our experimental scheme. The experimental results show that, no matter whether the photon-pair source is two light cones or two beam-like spots, the clear image of the object can be obtained. The slight rotation of the nonlinear crystal has no influence on the imaging quality. Our experimental results also demonstrate that when the part of the photon-pair source in the signal path or the idler path is blocked by unwanted things, the clear ghost image of the object can still be recorded.
Abstract Imaging, detection and ranging of objects in the presence of significant background noise is a fundamental challenge in optical sensing. Overcoming the limitations imposed in conventional methods, quantum light sources show higher resistance against noise in a time-correlation-based quantum illumination. Here, we introduce the advantage of using not only time correlations but also polarization correlations in photon pairs in the detection of an object that is embedded in a noisy background. In this direction, a time- and polarization-correlated photon pair source using the spontaneous parametric down-conversion process is exploited. We found that the joint measurement of correlated pairs allows distinguishing the signal from the noise photons and that leads to an improved signal-to-noise ratio. Our comparative study revealed that using polarization correlations in addition to time correlations provides improved noise rejection. Furthermore, we show that polarization correlation allows undoing the detector limitation where high background often leads to detector saturation.
Imaging, detection and ranging of objects in the presence of significant background noise is a fundamental challenge in optical sensing. Overcoming the limitations imposed in conventional methods, quantum light sources show higher resistance against noise in a time correlation-based detection scheme. Here, we introduce the advantage of using not only time correlations, but also polarization correlations in photon pairs in the detection of an object that is embedded in a noisy background. In this direction, a time- and polarization-correlated photon-pair source using the spontaneous parametric down-conversion process is exploited. We found that the joint measurement of correlated pairs allows to distinguish the signal from the noise photons and that leads to an improved signal-to-noise ratio. Our comparative study revealed that using polarization correlations in addition to time correlations provides improved noise rejection.
Traditional remote sensing applications are often based on pulsed laser illumination with a narrow linewidth and characteristic repetition rate, which are not conducive to covert operation. Whatever methods are employed for covert sensing, a key requirement is for the probe light to be indistinguishable from background illumination. We present a method to perform single-pixel imaging that suppresses the effect of background light and hence improves the signal-to-noise ratio by using correlated photon-pairs produced via spontaneous parametric down conversion. One of the photons in the pair is used to illuminate the object whilst the other acts as a temporal reference, allowing the signal photons to be distinguished from background noise. Understanding the noise regime is key to producing higher contrast images using this heralding method.
The spatial correlations between the photon pairs produced by spontaneous parametric down conversion (SPDC) have been investigated in a number of different configurations over the last two decades (1). The high dimensionality of the transverse spatial degrees of freedom (DOF) of the photon pairs can be explored either by projections onto a discrete (infinite) basis, such as the LG modes, or by using a continuous basis defined by the transverse position or momentum of the photons. For instance, it has been shown that their transverse position and momentum display EPR-type correlations (2). Despite the continuous and unbounded nature of both these bases, the most common measurements to date have relied upon the scanning of a single avalanche photodiode or a very small number of individual detectors. This sequential scanning or small number of detectors negates any information capacity advantage in the use of spatial states. Recent years have seen a rapid advance in imaging technologies, particularly for low light levels. Of these technologies the highest quantum efficiency is achieved using electron multiplying CCDs (EMCCD). Developments in low noise EMCCD cameras suggest they are capable of greater than 80% quantum efficiencies and if operated in an ultra-low light environment whilst being maintained at low temperatures, can provide single photon sensitivity (3). EMCCDs have been used in measurements of sub-shot-noise correlations of intensity fluctuations (4, 5) as well as in intensity correlations measurements (6) in the far field of the photon pairs from SPDC. Here we report the observation of spatial correlations from SPDC using an EMCCD camera in both the image and far-field planes of the down conversion crystal. We pump a BBO crystal at 355nm with a few milli-Watts of optical power and use a simple lens system to relay the down-converted light to an EMCCD array which can be positioned in either the image plane or the far-field of the crystal. Our photon flux is around 1/100 per pixel, which approximately doubles the signal obtained when the light is blocked. We typically record 100,000 individual frames and then sum the auto-correlation of the individual frames. We observed intensity correlation and anti-correlation in the image and far-field planes, respectively. In both cases we make the correlations more visible by subtracting a background which is obtained as the average correlation obtained between successive frames. Using this approach we are able to visualize the strength of the correlations in both position and momentum, showing a variance product nearly one order of magnitude below the classical limit in both x and y directions.