Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Alkali Vapors in Mid-Infrared – Towards Gain

Yoel Sebbag, Uriel Levy

Published Jan 1, 2017• 0 citations
Publisher

Abstract

We measured direct influence of a mid-infrared laser at 5.23 µm on the 5D5/2-6P3/2 transition of rubidium (85Rb) pumped by two photons at 780 nm and 776 nm. The hyperfine structure of the 6P3/2 level is clearly identified.
DOI
10.1364/cleo_qels.2017.fm4f.8

Related papers

Scaling of an Optically Pumped Mid-Infrared Rubidium Laser

Paul J. Moran

Abstract : An optically pumped mid-infrared rubidium (Rb) pulsed laser has been demonstrated in a heat pipe along the 62P3/2 - 62S1/2 transition at 2.730 micrometer and the 62P1/2 - 62S1/2 transition at 2.790 micrometer. The bleached limit, slope efficiency, and maximum laser output energy of the mid-IR Rb laser have been shown to scale linearly with increasing Rb density, contrary to prior laser demonstrations. A maximum output energy of 5 nJ per pulse had previously been observed before a rollover occurred in the scaling of output energy with Rb concentration. In this experiment, the maximum laser output energy observed was 100 nJ, with linear scaling to a Rb concentration of 7 x 10 to the 15th power cm-3. A maximum slope efficiency of 1.7 x 0.0001 was observed. Evidence that only a small percentage (2%) of the available pump photons were absorbed at a concentration of 2 x 10 to the 15th power cm-3 and a pump energy of 10 (mu)J. This indicated that there were 20,000 pump photons per Rb atom at a pump energy of 10 mJ, and that the effective laser efficiency was 0.65 percent or higher. The hyperfine structure and absorption spectral profile of the 52S1/2 - 62P1/2 and 52S1/2 - 62P3/2 (blue) pump transitions were studied using a continuous wave (cw) pump source.

•Mar 26, 2015•0 citations

Probing population-inverted Rb vapors with resonant mid-IR radiation

Nafia Rahaman, Russell McLean, Dmitry Budker +1 more

Mid-infrared radiation at 5.23 µm is used to probe the population-inverted 5D 5/2 →6P 3/2 transition in rubidium atoms, key to a widely studied frequency up-conversion scheme that produces coherent blue light. We find that resonant probe light significantly changes the optical properties of the inverted medium, which exhibits high optical gain. The gain has a complex sensitivity to factors such as pump laser detuning, beam alignment, and atomic density. The results are an important step toward characterizing new optical field generation in alkali atoms.

Journal of the Optical Society of America B•Apr 23, 2026•0 citations

Determining the Two-Photon Absorption Cross-Section for the 52S1/2 --> 52D5/2 Transition in Naturally Occurring Rubidium

Jeffrey Gallagher, Glen P. Perram

Recently we demonstrated lasing at 420 nm and 455 nm inside of rubidium and cesium vapor cells respectively, by non-resonant, two photon absorption at near infrared pump wavelengths. Two photon absorption from the ground S1/2 state to excited D3/2,5/2 or higher lying S1/2 state via virtual states and subsequent infrared stimulated emission pumps the upper laser levels, the second excited P1/2,3/2 states. To better understand the mechanism and phenomenology of this type of laser, this paper presents a method for determining the two-photon absorption (TPA) cross-section for the 5S1/2 −→ 5D5/2 transition in naturally occurring rubidium. For an incident pump intensity of 392 W cm2 and a rubidium concentration of 3.34 × 10 atoms cm3 , a peak absorbance of 0.10 is observed. The concentration of the Rb in the test cell is determined by one photon absorption spectra of the D2, indicating a vapor curve shifted by 14 C from the exterior wall temperature. The incident laser beam is focused to a waist of 75 μm. The beam quality is consistent with an M = 1.05 − 1.09. A model for the intensity as a function of propagation distance is developed to interpret the observed absorption spectrum and determine a cross-section for the two photon absorption.

AIAA Plasmadynamics and Lasers Conference•Jun 1, 2011•1 citation

Investigation on the Monochromatic Two-Photon Transition Spectroscopy of Rubidium by Using Intensity Modulation Method

Sandan Wang, Jinpeng Yuan, Lirong Wang +2 more

We experimentally study the high-resolution two-photon spectroscopy of rubidium using a single laser. The 5S1/2 − 5P3/2 − 5D5/2 transition is realized via 778.1 nm laser beams acting on the vapor with a counter-propagating configuration. The intensity modulation method is employed to improve the signal-to-noise ratio of the spectrum by two orders of magnitude compared with that for direct measurement. The effects of the vapor temperature, the frequency-scanning speed of the laser, the polarization combination of the laser beams, and the laser power on the spectra are investigated to obtain the optimal experimental parameters. This research is expected to be beneficial for potential applications since it can be used to realize a compact and high-precision frequency standard for optical communication.

Journal of the Physical Society of Japan•Jul 18, 2018•7 citations

Wavelength diversity in optically pumped alkali vapor lasers

Glen P. Perram

Alternative wavelengths for optically pumped alkali vapor lasers have been developed using single photon excitation of higher lying P-states, stimulated Raman processes, two-photon excitation of S and D states, and electric quadruple excitation on S-D transitions. Two photon excitation of Cs 72D leads to competing and cascade lasing producing red and infrared lasers operating on the D-P transitions, followed by ultraviolet, blue, the standard near infrared DPAL transitions operating on P-S transitions. The S-D pump transitions are fully bleached at pump intensities exceeding 1 MW/cm2, allowing for lasing transitions that terminate on the ground state. The kinetics of these systems are complex due to competition for population inversion among the many optical transitions. An optically pumped mid-infrared rubidium pulsed, mirrorless laser has also been demonstrated in a heat pipe along both the 62P3/2 - 62S1/2 transition at 2.73 μm and the 62P1/2 - 62S1/2 transition at 2.79 μm with a maximum energy of ~100 nJ. Performance improves dramatically as the rubidium vapor density is increased, in direct contradiction with the prior work. No scaling limitations associated with energy pooling or ionization kinetics have been observed. Practical application for infrared counter measures depends on the further development of blue diode pump sources. Finally, stimulated electronic Raman scattering and hyper-Raman processes in potassium vapor near the D1 and D2 lines have been observed using a stable resonator and pulsed laser excitation. First and second order Stokes and anti-Stokes lines were observed simultaneously and independently for a pump laser tuning range exceeding 70 cm-1. When the pump is tuned between the K D1 and D2 lines, an efficient hyper-Raman process dominates with a slope efficiency that exceeds 10%. Raman shifted laser may be useful as a target illuminator or atmospheric compensation beacon for a high power diode pumped alkali laser.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 13, 2017•1 citation

Frequency stabilization of diode laser on the wavelength of 5P3/2→5D5/2of rubidium transition

A.Yu. Kalatskiy, Anton E. Afanasiev, Павел Николаевич Мелентьев +1 more

The method of frequency stabilization of diode laser on the wavelength of 5P3/2→5D5/2 of rubidium (776 nm) has been realized. The two-photon absorption spectroscopy of the rubidium vapors is underlie of the suggested scheme. The basic parameters such as the intensity of laser radiation and concentration of the vapors have been investigated. The frequency stability of radiation was about 1 MHz

EPJ Web of Conferences•Dec 13, 2016•0 citations
Abstract : An optically pumped mid-infrared rubidium (Rb) pulsed laser has been demonstrated in a heat pipe along the 62P3/2 - 62S1/2 transition at 2.730 micrometer and the 62P1/2 - 62S1/2 transition at 2.790 micrometer. The bleached limit, slope efficiency, and maximum laser output energy of the mid-IR Rb laser have been shown to scale linearly with increasing Rb density, contrary to prior laser demonstrations. A maximum output energy of 5 nJ per pulse had previously been observed before a rollover occurred in the scaling of output energy with Rb concentration. In this experiment, the maximum laser output energy observed was 100 nJ, with linear scaling to a Rb concentration of 7 x 10 to the 15th power cm-3. A maximum slope efficiency of 1.7 x 0.0001 was observed. Evidence that only a small percentage (2%) of the available pump photons were absorbed at a concentration of 2 x 10 to the 15th power cm-3 and a pump energy of 10 (mu)J. This indicated that there were 20,000 pump photons per Rb atom at a pump energy of 10 mJ, and that the effective laser efficiency was 0.65 percent or higher. The hyperfine structure and absorption spectral profile of the 52S1/2 - 62P1/2 and 52S1/2 - 62P3/2 (blue) pump transitions were studied using a continuous wave (cw) pump source.
Mid-infrared radiation at 5.23 µm is used to probe the population-inverted 5D 5/2 →6P 3/2 transition in rubidium atoms, key to a widely studied frequency up-conversion scheme that produces coherent blue light. We find that resonant probe light significantly changes the optical properties of the inverted medium, which exhibits high optical gain. The gain has a complex sensitivity to factors such as pump laser detuning, beam alignment, and atomic density. The results are an important step toward characterizing new optical field generation in alkali atoms.
Recently we demonstrated lasing at 420 nm and 455 nm inside of rubidium and cesium vapor cells respectively, by non-resonant, two photon absorption at near infrared pump wavelengths. Two photon absorption from the ground S1/2 state to excited D3/2,5/2 or higher lying S1/2 state via virtual states and subsequent infrared stimulated emission pumps the upper laser levels, the second excited P1/2,3/2 states. To better understand the mechanism and phenomenology of this type of laser, this paper presents a method for determining the two-photon absorption (TPA) cross-section for the 5S1/2 −→ 5D5/2 transition in naturally occurring rubidium. For an incident pump intensity of 392 W cm2 and a rubidium concentration of 3.34 × 10 atoms cm3 , a peak absorbance of 0.10 is observed. The concentration of the Rb in the test cell is determined by one photon absorption spectra of the D2, indicating a vapor curve shifted by 14 C from the exterior wall temperature. The incident laser beam is focused to a waist of 75 μm. The beam quality is consistent with an M = 1.05 − 1.09. A model for the intensity as a function of propagation distance is developed to interpret the observed absorption spectrum and determine a cross-section for the two photon absorption.
We experimentally study the high-resolution two-photon spectroscopy of rubidium using a single laser. The 5S1/2 − 5P3/2 − 5D5/2 transition is realized via 778.1 nm laser beams acting on the vapor with a counter-propagating configuration. The intensity modulation method is employed to improve the signal-to-noise ratio of the spectrum by two orders of magnitude compared with that for direct measurement. The effects of the vapor temperature, the frequency-scanning speed of the laser, the polarization combination of the laser beams, and the laser power on the spectra are investigated to obtain the optimal experimental parameters. This research is expected to be beneficial for potential applications since it can be used to realize a compact and high-precision frequency standard for optical communication.
Alternative wavelengths for optically pumped alkali vapor lasers have been developed using single photon excitation of higher lying P-states, stimulated Raman processes, two-photon excitation of S and D states, and electric quadruple excitation on S-D transitions. Two photon excitation of Cs 72D leads to competing and cascade lasing producing red and infrared lasers operating on the D-P transitions, followed by ultraviolet, blue, the standard near infrared DPAL transitions operating on P-S transitions. The S-D pump transitions are fully bleached at pump intensities exceeding 1 MW/cm2, allowing for lasing transitions that terminate on the ground state. The kinetics of these systems are complex due to competition for population inversion among the many optical transitions. An optically pumped mid-infrared rubidium pulsed, mirrorless laser has also been demonstrated in a heat pipe along both the 62P3/2 - 62S1/2 transition at 2.73 μm and the 62P1/2 - 62S1/2 transition at 2.79 μm with a maximum energy of ~100 nJ. Performance improves dramatically as the rubidium vapor density is increased, in direct contradiction with the prior work. No scaling limitations associated with energy pooling or ionization kinetics have been observed. Practical application for infrared counter measures depends on the further development of blue diode pump sources. Finally, stimulated electronic Raman scattering and hyper-Raman processes in potassium vapor near the D1 and D2 lines have been observed using a stable resonator and pulsed laser excitation. First and second order Stokes and anti-Stokes lines were observed simultaneously and independently for a pump laser tuning range exceeding 70 cm-1. When the pump is tuned between the K D1 and D2 lines, an efficient hyper-Raman process dominates with a slope efficiency that exceeds 10%. Raman shifted laser may be useful as a target illuminator or atmospheric compensation beacon for a high power diode pumped alkali laser.