Weak value amplification (WVA) is a measurement technique in which the effect of a pre- and post-selected system on a weakly interacting probe is magnified. In this thesis, I present the first experimental observation of WVA of a single photon. We observed that a signal photon - sent through a polarization interferometer and post-selected by photodetection in the almost-dark port - can act like eight photons. The effect of this single photon is measured as a nonlinear phase shift on a separate laser beam. The interaction between the two is mediated by a sample of laser- cooled 85Rb atoms. Electromagnetically induced transparency (EIT) is used to enhance the nonlinearity and overcome resonant absorption. I believe this work to be the first demonstration of WVA where a deterministic interaction is used to entangle two distinct optical systems. In WVA, the amplification is contingent on discarding a large portion of the original data set. While amplification increases measurement sensitivity, discarding data worsens it. Questioning whether these competing effects conspire to improve or diminish measurement accuracy has resulted recently in controversy. I address this question by calculating the maximum amount of information achievable with the WVA technique. By comparing this information to that achievable by the standard technique, where no post-selection is employed, I show that the WVA technique can be advantageous under a certain class of noise models. Finally, I propose a way to optimally apply the WVA technique.
Weak value amplification (WVA) is a measurement technique in which the effect of a pre- and post-selected system on a weakly interacting probe is magnified. In this thesis, I present the first experimental observation of WVA of a single photon. We observed that a signal photon - sent through a polarization interferometer and post-selected by photodetection in the almost-dark port - can act like eight photons. The effect of this single photon is measured as a nonlinear phase shift on a separate laser beam. The interaction between the two is mediated by a sample of laser- cooled 85Rb atoms. Electromagnetically induced transparency (EIT) is used to enhance the nonlinearity and overcome resonant absorption. I believe this work to be the first demonstration of WVA where a deterministic interaction is used to entangle two distinct optical systems. In WVA, the amplification is contingent on discarding a large portion of the original data set. While amplification increases measurement sensitivity, discarding data worsens it. Questioning whether these competing effects conspire to improve or diminish measurement accuracy has resulted recently in controversy. I address this question by calculating the maximum amount of information achievable with the WVA technique. By comparing this information to that achievable by the standard technique, where no post-selection is employed, I show that the WVA technique can be advantageous under a certain class of noise models. Finally, I propose a way to optimally apply the WVA technique.
In 1988, Aharonov, Albert, and Vaidman introduced a new paradigm of quantum measurement in a paper which had the unwieldy but provocative title "How the result of a measurement of a component of the spin of a spin-1=2 particle can turn out to be 100." This paradigm, so-called "weak measurement," has since been the subject of widespread theoretical and experimental attention, both for the perspective it offers on quantum reality and for possible applications to precision measurement. Yet almost all of the weak-measurement experiments carried out so far could be alternatively understood in terms of the classical (electro-magnetic wave) theory of optics. Here we present a truly quantum version, the first in which a measurement apparatus deterministically entangles two distinct optical beams, enabling us to experimentally ask a question directly analogous to that of the original proposal: "In a two-arm interferometer containing one photon in total, can the result of a measurement of the photon number in one arm turn out to be greater than 1?" Specifically, we show that a single photon, when properly post-selected, can have an effect equal to that of eight photons: that is, in a system where a single photon has been calibrated to write a nonlinear phase shift of ϕ_0 on a probe beam, we measure phase shifts as large as 8ϕ_0 for appropriately post-selected single photons. This is the first deterministic weak-value experiment in optics which defies classical explanation, and constitutes a realization of our proposal for weak-value amplification (WVA) of the small optical nonlinearity at the single-photon level. It opens up a new regime for the study of entanglement of optical beams, as well as further investigations of the power of WVA for the measurement of small quantities.
Weak value amplification (WVA) has emerged as a powerful technique that enhances measurement precision. However, traditional table-top WVA setups and on-chip demonstrations have not achieved an amplification over 20 dB. The practical limit of the amplification is the fidelity of photon post-selection. To address this limit, we design a weak value device with an over 30 dB interferometer extinction ratio, where the stray light in the dark port is minimized with thermally tunable phase shifters. As a result, the device successfully shows 30 dB WVA, termed ultra-high WVA. This WVA optimization strategy by improving interferometer extinction is extensible to a wide range of WVA-based detections, paving the way for their broader application in practical precision measurements.
Recently, the weak-value amplification (WVA) has been extensively investigated as a promising quantum technique for improving an accuracy of a precision measurement.The basic idea of WVA comes from the weak measurement introduced by Aharonov, Albert, and Vaidman in 1988.The weak measurement is the indirect quantum measurement with the weak interaction and postselection of the final state of the measured system.The attention point is that we can measure the quantity called the weak value, which appears in the shift of the measuring probe given by the weak measurement.Because the weak value can be outside the range of the eigenvalues, the shift of the measuring probe obtained by the weak measurement becomes larger than the one given by the conventional measurement.This shift amplification effect by the weak value is the WVA, which has been studied for precisely measuring the small coupling constant.In this thesis, we propose the two possible applications of the WVA.First, we analytically obtain the optimal probe wave function for a given weak value by the variational method.It is shown that the amplification factor obtained by the optimal probe has noupper bound while the one in the Gaussian probe already reported by some researchers has the upper bound.Furthermore, the variance of the optimal probe after the measurement can be zero.We can derive the optimal probe by the Lagrange multiplier method for maximizing the shift of the probe position or minimizing the variance of the final distribution.Second we have developed the way which has a technical advantage of the WVA from the viewpoint of statistics.It is often argued that the WVA is not helpfull for the parameter estimation.Therefore we consider the statistical inferences that the WVA will be advantageous.We propose a method to determine whether the interaction is present or not and evaluate the capability of the WVA for this interaction detection problem by using the hypothesis testing in statistics.As the main result, it is shown that the merit of the WVA is the reduction of the possibility to miss the presence of the interaction more than the conventional measurement while keeping the probability of a misdetection, when the absolute value of the weak value is outside the range of the eigenvalues.In this discussion, we assume that the number of the obtained data is infinitely large and we neglect the data loss by the failure of the postseleciton.iii the deepest appreciation to my ex-supervisor
The weak-value-amplification (WVA) effect, which is also called weak measurement, has been developed extensively in various sensing systems. Here, we report the actual realization of the WVA effect in spin-exchange relaxation-free atomic magnetometer system, wherein the slight separation of transverse momentum of the probe light is amplified by introducing orthogonal pre- and post-selection states. A differential detector is used to obtain the transverse position of the probe light accurately in real time. The weak coupling of the magneto-optical interaction with atoms will be reflected in the differential signal. The WVA effect is observed and demonstrated directly and a high sensitivity of 8 fT/Hz is achieved. Also, we obtain the stable and distinct simulated magnetocardiography signal through our system. The present successful implementation of this probe method paves the way for further technical noise suppression and sensitivity improvement of quantum sensors.
Abstract Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror’s position displacement of one photon. In the weak value amplification (WVA) regime, the weak value of one photon can lie outside the eigenvalue spectrum, proportional to the difference of the mirror’s position displacement between the successful and failed postselection and its successful postselection probability is dependent of the mean photon number of the coherent light and improved by adjusting it accordingly. Outside the WVA regime, the amplification limit can reach the level of the vacuum fluctuations, and when the mean photon number and the optomechanical coupling parameter are selected appropriately, its successful postselection probability becomes higher, which is beneficial to observe the maximum amplification value under the current experimental conditions. This result breaks the constraint that it is difficult to detect outside the WVA regime. This opens up a new regime for the study of a single photon nonlinearity in optomechanical system.
We show the utility of the weak value amplification to observe the quantum interference between two close lying atomic coherent states in a post-selected atomic cat state, produced in a system of N identical two-level atoms weakly interacting with a single photon field. Through the observation of the negative parts of the Wigner distribution of the post-selected atomic cat state, we find that the post-selected atomic cat state becomes more nonclassical when the post-selected polarization state of the single photon field tends toward becoming orthogonal to its pre-selected state. We show that the small phase shift in the post-selected atomic cat state can be amplified via measuring the peak shift of its phase distribution when the post-selected state of the single photon field is nearly orthogonal to its pre-selected state. We find that the amplification factor of 15 [5] can be obtained for a sample of 10 [100] atoms. This effectively provides us with a method to discriminate between two close lying states on the Bloch sphere. We discuss possible experimental implementation of the scheme, and conclude with a discussion of the Fisher information.