In this thesis, I demonstrate and evaluate an on-demand source of single propagating microwaves photons. Working in the context of a quantum network, nodes are connected via propagating, nonclassical states of the electromagnetic field. As such, preparing and detecting propagating quantum states is an essential task. I work with one particular node consisting of a microfabricated, effective two level system coupled to a microwave resonator and study its ability to produce propagating nonclassical states, such as single photon states. In principle, states generated by this node could be sent to other such nodes. However, I send them into a Josephson parametric amplifier (JPA) to characterize the source. In particular, I discuss how to design and couple the two components that form my source: a fixed frequency transmon qubit and a 3D superconducting waveguide cavity. I demonstrate the ability to control of the dynamics of this combined system and implement a single photon generation protocol, which utilizes a single microwave control field that is far detuned from the photon emission frequency. To characterize the generation, I perform tomography on the propagating photon state to determine its density matrix ρ. I perform repeated JPA-backed, linear measurements of the propagating state. Based on the histograms of my measurements, I infer a maximum single photon component ρ₁₁ = 0.36 ± 0.01. I characterize the imperfections of the photon generation and detection, including detection inefficiency and measurement backaction. I find that within uncertainty my measurements match my expectation.
In this thesis, I demonstrate and evaluate an on-demand source of single propagating microwaves photons. Working in the context of a quantum network, nodes are connected via propagating, nonclassical states of the electromagnetic field. As such, preparing and detecting propagating quantum states is an essential task. I work with one particular node consisting of a microfabricated, effective two level system coupled to a microwave resonator and study its ability to produce propagating nonclassical states, such as single photon states. In principle, states generated by this node could be sent to other such nodes. However, I send them into a Josephson parametric amplifier (JPA) to characterize the source. In particular, I discuss how to design and couple the two components that form my source: a fixed frequency transmon qubit and a 3D superconducting waveguide cavity. I demonstrate the ability to control of the dynamics of this combined system and implement a single photon generation protocol, which utilizes a single microwave control field that is far detuned from the photon emission frequency. To characterize the generation, I perform tomography on the propagating photon state to determine its density matrix ρ. I perform repeated JPA-backed, linear measurements of the propagating state. Based on the histograms of my measurements, I infer a maximum single photon component ρ₁₁ = 0.36 ± 0.01. I characterize the imperfections of the photon generation and detection, including detection inefficiency and measurement backaction. I find that within uncertainty my measurements match my expectation.
We demonstrate and evaluate an on-demand source of single itinerant microwave photons. Photons are generated using a highly coherent, fixed-frequency qubit-cavity system, and a protocol where the microwave control field is far detuned from the photon emission frequency. By using a Josephson parametric amplifier (JPA), we perform efficient single-quadrature detection of the state emerging from the cavity. We characterize the imperfections of the photon generation and detection, including detection inefficiency and state infidelity caused by measurement back-action over a range of JPA gains from 17 to 33 dB. We observe that both detection efficiency and undesirable back-action increase with JPA gain. We find that the density matrix has its maximum single-photon component ${\ensuremath{\rho}}_{11}=0.36\ifmmode\pm\else\textpm\fi{}0.01$ at 29 dB JPA gain. At this gain, back-action of the JPA creates cavity photon number fluctuations that we model as a thermal distribution with an average photon number $\overline{n}=0.041\ifmmode\pm\else\textpm\fi{}0.003$.
Using modern micro and nano-fabrication techniques combined with superconducting materials we realize quantum electronic circuits in which we create, store, and manipulate individual microwave photons. The strong interaction of photons with superconducting quantum two-level systems allows us to probe fundamental quantum effects of microwave radiation and also to develop components for applications in quantum technology. Previously we have realized on-demand single photon sources which we have characterized using correlation function measurements [1] and full quantum state tomography [2]. For this purpose we have developed efficient methods to separate the quantum signals of interest from the noise added by the linear amplifiers used for quadrature amplitude detection [3]. We now regularly employ superconducting parametric amplifiers [4] to perform nearly quantum limited detection of propagating electromagnetic fields. These enable us to probe the entanglement which we generate on demand between stationary qubits and microwave photons freely propagating down a transmission line [5]. Using two independent microwave single photon sources, we have recently performed Hong-Ou-Mandel experiments at microwave frequencies [6] and have probed the coherence of two-mode multi-photon states at the out-put of a beam-splitter. The non-local nature of such states may prove to be useful for distributing entanglement in future small-scale quantum networks.
The association of a quantum bit and a harmonic mode dispersively coupled is one of the most studied systems in the field of quantum electrodynamics of superconducting circuits. It offers one of the most reliable current methods for measuring the state of a quantum bit in a non-destructive manner and has enabled numerous quantum information experiments, studying the information obtained through this measurement and the dynamics of the qubit when subjected to it. It also provides the ability to prepare and manipulate the quantum state of the harmonic mode via the qubit, allowing information to be stored and processed in this mode, which is fundamental to building a quantum processor. This thesis presents two experiments based on this architecture. The first demonstrates how to use qubit fluorescence to non-destructively read the number of photons contained in a microwave cavity in a single shot, that is, before the cavity has relaxed. This makes it possible to measure photon number trajectories and observe them leave the cavity one by one. The analysis of this experiment relies on a fluorescence analysis in terms of propagating modes and addresses a number of questions about the information that these modes may contain. The second is a demonstration of the use of a neural network for quantum state preparation in the cavity. Here, the goal is to accelerate the optimization of control electromagnetic pulses at the frequencies of the cavity and qubit to create a quantum state in the cavity with high fidelity, and this for a broad class of states. To evaluate the efficiency of this new optimization protocol over this class of states, an optimal method to assess the fidelity of the prepared states using a Wigner function measurement protocol was experimentally implemented for the first time.
We address recent advances in quantum optics with propagating microwaves\nin superconducting circuits. This research field exploits on the fact that the coupling between a superconducting artificial atom and propagating microwave photons in a one-dimensional (1D) open transmission line can be made strong enough to observe quantum effects, without using any cavity to confine the microwave photons.\nWe embed an artificial atom, a superconducting transmon qubit, in a 1D open\ntransmission line and investigate the scattering properties of coherent microwaves. When an input coherent state, with an average photon number much less than 1, is on resonance with the artificial atom, we observe extinction of up to 99% in the forward propagating field. We observe the strong nonlinearity of the artificial atom and under strong driving we observe the Mollow triplet. We also study the statistics of the reflected and transmitted beams, which are predicted to be nonclassical states. In particular, we demonstrate photon antibunching in the reflected beam by measuring the second-order correlation function. By applying a second control tone, we observe the Autler-Townes splitting and a giant cross-Kerr effect.\nFurthermore, we demonstrate fast operation of a single-photon router using\nthe Autler-Townes splitting. This device provides important steps towards the realization of a quantum network. This thesis describes the motivation, theoretical background, design, implementation and measurement results.
This thesis presents the experimental achievements of (1) generating entangled-microwave fields propagating on two physically separate transmission lines and (2) verifying the entangled states with efficient measurements. Shared entanglement between two parties is an essential resource for quantum information processing and quantum communication protocols. Experimentally, entangled pairs of electromagnetic fields can be realized by distributing a squeezed vacuum over two separated modes. As a result, entanglement is revealed by the strong cross-correlations between specific quadratures of the two modes. Although it is possible to verify the presence of entanglement with low-efficiency quadrature measurements, higher detection efficiencies are desired for performing protocols that exploit entanglement with high fidelity.\nIn the microwave regime, Josephson parametric amplifiers (JPAs) fulfill the two major tasks mentioned above: JPAs prepare the required squeezed states to generate entanglement and enable us to perform efficient quadrature measurements. Therefore, for the purposes of entanglement generation and verification, ultralow-noise--frequency-tunable JPAs have been developed. Additionally, to increase the efficiency of entanglement generation, we integrate JPAs with two on-chip microwave passive components, a directional coupler and a quadrature hybrid, to form an entangler circuit. The two-mode entangled states are created at the two output modes of the entangler and are measured with a two-channel measurement apparatus where each of the two channels incorporates a JPA as a single-quadrature preamplifier. By employing this measurement scheme, the two measured quadratures of the two output modes can be chosen independently of each other, enabling a full characterization of the two-mode state. To definitively demonstrate the two-mode entanglement, I prove that the measured quadrature variances satisfy the inseparability criterion.
The realization of a quantum network composed of quantum nodes which process quantum fields and quantum channels to transfer quantum information has recently been proposed. In recent years, fundamental experiments produced by superconducting circuits suggest that they are promising candidates for realization of a quantum network. Superconducting circuit QED can act as quantum nodes, which can be linked by quantum channels, to transfer flying microwave photons (quantum information) from site to site on chip with high fidelity. Therefore, controlling the propagating microwave photons on chip is an essential step towards realization of a quantum network.In this thesis, we demonstrate a specific quantum node, namely the single photon router. The active element of the router is a single three-level artificial atom, a superconducting transmon type qubit, strongly coupled to a superconducting 1D transmission line. Strong coupling between the artificial atom and propagating microwave photons, revealed in high degree scattering of the resonance waves, has been observed. By exploiting the phenomenon of electromagnetically induced transparency (EIT), we can route a single photon signal from an input port to either of two output ports with an on-off ratio of approximately 90%. The switching time of the router is shown to be a few nanoseconds, consistent with theoretical expectations and the device parameters. Besides the router, we also observed some fundamental phenomenon of single atom, such as strong nonlinearity, anomalous dispersion and the Mollow Triplet.This thesis describes the motivation, theoretical background, design, implementation and the measurement results.