Cavity quantum electrodynamics (cavity QED) describes the interactions of single atoms and single photons in a resonator. In the laboratory, state-of-the-art experiments are able to observe the dynamics of these simple yet fundamental quantum systems. The recent development of quantum information science has also introduced a new role for cavity QED systems as quantum interfaces, in which information can be coherently mapped between photonic and atomic quantum bits. Groundbreaking optical cavity QED experiments in the past twenty years would not have been possible without the technological development of mirror coatings with extremely low scatter and absorption losses. Thermal noise has typically played a smaller role in cavity QED experiments but in certain instances is nevertheless important to consider. In this chapter, we begin with an overview of optical cavity QED experiments and some of the central questions that they address. It is hoped that this description, while by no means exhaustive, will provide a window for the nonspecialist into basic techniques and motivations in the field. We then turn to focus on the roles played by scattering and absorption loss and mechanical loss. We discuss how these losses have set limits on feasible experiments and the extent to which improvements may be possible. Experimental realizations of cavity QED systems An idealized cavity QED system consists of one atom placed between two highly reflective mirrors (Figure 17.1). In this model, a single atomic transition interacts with photons in a single cavity mode; the atom is often pictured at an antinode of the cavity standing wave, where it has a maximal dipole interaction with the cavity field.
Cavity quantum electrodynamics (cavity QED) describes the interactions of single atoms and single photons in a resonator. In the laboratory, state-of-the-art experiments are able to observe the dynamics of these simple yet fundamental quantum systems. The recent development of quantum information science has also introduced a new role for cavity QED systems as quantum interfaces, in which information can be coherently mapped between photonic and atomic quantum bits. Groundbreaking optical cavity QED experiments in the past twenty years would not have been possible without the technological development of mirror coatings with extremely low scatter and absorption losses. Thermal noise has typically played a smaller role in cavity QED experiments but in certain instances is nevertheless important to consider. In this chapter, we begin with an overview of optical cavity QED experiments and some of the central questions that they address. It is hoped that this description, while by no means exhaustive, will provide a window for the nonspecialist into basic techniques and motivations in the field. We then turn to focus on the roles played by scattering and absorption loss and mechanical loss. We discuss how these losses have set limits on feasible experiments and the extent to which improvements may be possible. Experimental realizations of cavity QED systems An idealized cavity QED system consists of one atom placed between two highly reflective mirrors (Figure 17.1). In this model, a single atomic transition interacts with photons in a single cavity mode; the atom is often pictured at an antinode of the cavity standing wave, where it has a maximal dipole interaction with the cavity field.
A single two-level emitter coupled to a single mode of an electromagnetic resonator constitutes the most fundamental instance of light--matter interaction. Realizations of this type of system are investigated in the field of cavity quantum electrodynamics (cavity QED). Particularly important are schemes in which the coupling is strong enough to exceed the spontaneous emission rate as well as cavity damping. In this case, the coherent exchange of excitation between source and photon is the dominating process, providing the unique possibility to deterministically control the quantum evolution of the system. Great progress has recently been accomplished, technologically as well as conceptually, and the focus section in this issue of Journal of Optics B: Quantum and Semiclassical Optics features five articles highlighting important recent developments in the field. Strong coupling between single atoms and the electromagnetic cavity field have been achieved in two distinct regimes, the optical and the microwave region. The latter is represented by the micromaser, a high-Q microwave cavity pumped by a beam of highly excited Rydberg atoms. It has proved to be an almost ideal system for the generation of non-classical field states. A constraint in these experiments is the fact that the field inside the cavity can only be examined indirectly, by analysing the occupation of atoms leaving the cavity. While only two atomic states were previously identified for this purpose, V A Reshetov shows in his article (pages 119--126) that more information on the field may be extracted by taking advantage of the Zeeman substructure of the atomic levels. In the optical domain of cavity QED, by contrast, the state of the resonator field may be probed directly by measuring the light leaking from the cavity using photodetectors. In order to minimize damping, high-quality cavities must be employed. In most optical experiments these are Fabry--Perot resonators with ultra-high reflectivity mirrors, with losses as low as a few parts per million being state of the art. At the same time, the coupling of atoms and photons is enhanced by reducing the length of the cavity, so that strong coupling conditions are reached. A very attractive application of this type of cavity QED setup is the possibility of exerting control over the quantum dynamics of the system. An impressive example is the implementation of quantum feedback, reported in the paper by W P Smith and L A Orozco (pages 127--134). Using information gained from detecting a single photon escaping from the cavity, active feedback is applied to halt the dynamical evolution of the system. This is the first time active feedback has been used to modify the quantum evolution of a system at the single-photon level. The authors discuss how detunings between the subsystems affect the quantum feedback, an issue particularly relevant for ensembles of atoms with a spread in detuning. Perfect quantum feedback in this case requires the use of additional parameters to control the system. The majority of optical cavity QED experiments performed so far have used as a medium atoms traversing the cavity on random trajectories, such as, for example, thermal atomic beams. In this case, the observation of quantum effects is degraded in two ways. The Doppler effect and the finite transit time lead to line broadening, while the spatial structure of the cavity mode results in atoms in different locations experiencing different coupling with the photonic field. J E Reiner et al (pages 135--142) investigate the impact of these effects on quantum fluctuations in their cavity QED system. In order to overcome line broadening, they have developed a continuous cold atomic beam, extracted from a magneto-optical trap. An even better control of broadening effects and fluctuating coupling strength is provided by trapping the atoms inside the cavity and cooling them to temperatures at which their position spread is smaller than the optical wavelength. Much recent activity has been devoted to developing such an ultimate cavity QED system. A Vukics et al (pages 143--153) present a theoretical proposal for dynamically trapping and cooling atoms inside a cavity. By driving the atoms with a standing wave injected from the side of the cavity and by weakly exciting the cavity field itself, they predict three-dimensional trapping of the atom for periods around 1 second, an extremely long time on the typical scale of cavity QED dynamics. The essential component of their scheme is the interference between the two driving fields, determining the temperature of the particle and the stable trapping positions. In the quest for better confinement of radiation, lately, an appealing alternative to the Fabry--Perot cavity has been investigated -- the optical microsphere resonator. A sphere with a diameter of a few tens of microns, it supports so-called whispering gallery modes near its circumference, for which quality factors up to 10 10 have been measured. In order to exploit the correspondingly low field damping rates for cavity QED, a method must be found to couple atomic or solid state emitters to these modes. S Göotzinger et al (pages 154--158) report the coupling of single nanocrystals on the surface of a microsphere through the evanescent field of the mode. Selective excitation of a single nano-emitter was accomplished with a scanning confocal microscope. The system is a promising candidate for cavity QED with single-quantum emitters. The ability to fully control the quantum dynamics of atoms and light is beginning to spawn early applications. The most notable example is quantum information processing. This requires the coherent manipulation of single-quantum systems, which is ideally provided by cavity QED interaction in the strong-coupling limit. The development of practical devices will be among the principal future tasks for research in the field. This will include physical systems, which have not been covered in this issue, such as semiconductors, quantum dots as emitters, or photonic crystals as resonator structures. Cavity QED is therefore guaranteed to remain a vigorous field in the years to come.
Cavity quantum electrodynamics (QED), the system of a single atom interacting with a single mode of a high finesse optical resonator, has tremendous potential for use in quantum logic, quantum information processing, and in enabling observation of quantum mechanical effects in the laboratory. The work of this thesis demonstrates a number of steps toward realizing these goals, by employing an experimental system with the strongest atom-field coupling achieved to date in optical cavity QED. The effects of strong coupling in cavity QED are studied for single cold atoms measured one at a time, in real time. The passage of single atoms through the cavity is employed to map out the frequency response of the system, and to demonstrate that quantum rather than semiclassical theory provides the correct theoretical model. The mechanical effects of strong coupling on single atoms are explored, these experiments demonstrating the first trapping of single atoms with single photons. Additionally, strong coupling enables high signal-to-noise ratio for monitoring atomic position at single photon field strengths; this capability is employed to investigate the motion of atoms trapped within the cavity. The transmitted cavity field is used to reconstruct the trajectories of single atoms, thereby realizing a new form of microscopy - the Atom-Cavity Microscope. Technical developments necessary to create the cavities used in this experiment are detailed. Ideas for future extensions to the experiment are proposed; a zero light-shift dipole force trap, and measurement of photon statistics of a single strongly coupled atom (which realizes a photon blockade device) are discussed.
The article gives an introduction into some of the basic cavity QED concepts, highlights some recent achievements and addresses some of the perspectives opened up by the ability to precisely control individual atomic and photonic quantum objects. Optical cavity QED with its ability to detect individual atoms and single photons plays an increasingly important role for various applications. The importance of optical cavity QED for the advance of quantum electronics can be highlighted by the rapidly growing number of research groups, the exponentially increasing number of publications and citations, and the increasing number of cavity designs ranging from the standard standing-wave Fabry-Perot cavity with dielectric mirrors to nanostructured slabs with a photonic band gap and high-quality running-wave microtoroids with optical fibre coupling.
Cavity quantum electrodynamics (cavity QED) describes electromagnetic fields in a confined space and the radiative properties of atoms in such fields. The simplest example of such system is a single atom interacting with one mode of a high-finesse resonator. Besides observation and exploration of fundamental quantum mechanical effects, this system bears a high potential for applications quantum information science such as, e.g., quantum logic gates, quantum communication and quantum teleportation. In this thesis I present an experiment on the deterministic coupling of a single neutral atom to the mode of a high-finesse optical resonator. In Chapter 1 I describe our basic techniques for trapping and observing single cesium atoms. As a source of single atoms we use a high-gradient magneto-optical trap, which captures the atoms from background gas in a vacuum chamber and cools them down to millikelvin temperatures. The atoms are then transferred without loss into a standing-wave dipole trap, which provides a conservative potential required for experiments on atomic coherence such as quantum information processing and metrology on trapped atoms. Moreover, shifting the standing-wave pattern allows us to deterministically transport the atoms (Chapter 2). In combination with non-destructive fluorescence imaging of individual trapped atoms, this enables us to control their position with submicrometer precision over several millimeters along the dipole trap. The cavity QED system can distinctly display quantum behaviour in the so-called strong coupling regime, i.e., when the coherent atom-cavity coupling rate dominates dissipation in the system. This sets the main requirements on the resonator's properties: small mode volume and high finesse. Chapter 3 is devoted to the manufacturing, assembling, and testing of an ultra-high finesse optical Fabry-Perot resonator, stabilized to the atomic transition. In Chapter 4 I present the transportation of single atoms into the cavity and their coupling to the cavity mode. The strong coupling manifests itself in a strong reduction of the cavity transmission probed by a weak external laser. The atoms remain trapped and coupled to the cavity mode for several seconds until we move them out of the cavity for final analysis of their number and position.
Recent experimental advances in the field of cavity quantum electrodynamics (QED) have opened new possibilities for control of atom‐photon interactions. A laser with “one and the same atom” demonstrates the theory of laser operation pressed to its conceptual limit. The generation of single photons on demand and the realization of cavity QED with well defined atomic numbers N = 0, 1, 2,… both represent important steps toward realizing diverse protocols in quantum information science. Coherent manipulation of the atomic state via Raman transitions provides a new tool in cavity QED for in situ monitoring and control of the atom‐cavity system. All of these achievements share a common point of departure: the regime of strong coupling. It is thus interesting to consider briefly the history of the strong coupling criterion in cavity QED and to trace out the path that research has taken in the pursuit of this goal.
Starting with early experiments about lifetimes of excited atoms near metallic boundaries, I review the evolution of Cavity Quantum Electrodynamics in the microwave and in the optical domains. The coherent coupling of single atoms with photons in high-Q cavities has led to the demonstration of fundamental quantum effects in light-matter interaction processes and to the generation of micromasers and microlasers emitting radiation with non-classical properties. It has made possible the development of single photon light sources and efficient detectors of single atoms as well as the implementation of quantum information and communication procedures in which atoms and photons play the roles of quantum bits. Mesoscopic superpositions of field states have been generated by entangling single atoms to fields made of many photons and the decoherence of these states has been studied, shedding new light on the quantum to classical boundary. Cavity Quantum Electrodynamics has also led recently to the quantum non-demolition counting of photons in a cavity, opening new perspectives for studying non-classical states of radiation. These atomic physics experiments are now extended - with promising applications in perspective - to the study of solid-state devices with microcavities built on substrates and coupled to artificial atoms such as quantum dots or superconducting junctions.