Cambridge University Press eBooks

Special limits in the single-mode model

Luigi Lugiato, Franco Prati, Massimo Brambilla

Published Feb 28, 2015• 0 citations

Abstract

The relaxation rates κ , γ ⊥ and γ ∥ which appear in the single-mode model are irrelevant for the stationary state. Instead, their values become critical when we consider dynamical, i.e. time-dependent, phenomena. In particular, they control the possibility of eliminating adiabatically some of the variables in play, thus reducing the complexity of the problem. In this chapter we first illustrate, in Section 19.1, the useful laser classification introduced by Arecchi. Next, in Section 19.2, we discuss the dynamical behavior of the solutions of a model obtained from the single-mode model (derived in Chapter 12) by performing the adiabatic elimination of the atomic variables, which procedure is called the good-cavity limit in the literature. Section 19.2.1 is devoted to the case of the free-running laser ( class-A laser ) and discusses in particular, at the end, the cubic single-mode laser model which is the simplest model capable of describing a laser. On the other hand, in Section 19.2.2 we discuss the case of optical bistability in the good-cavity limit. If we eliminate adiabatically the atomic polarization only, we obtain, instead, the single- mode rate equations which are discussed in Section 19.3. In particular, Section 19.3.1 concerns the case of class-B lasers and focusses especially on the phenomenon of relaxation oscillations. Special attention is paid to demonstrating the equivalence of the model which describes class-B lasers to the rate-equation laser model derived in Chapter 1 and the semiconductor laser model obtained in Chapter 16. In Section 19.3.2 we describe the generation of a giant pulse in class-B lasers, a phenomenon which is called active Q- switching . The final section, Section 19.4, deals with the model obtained by adiabatically eliminating the field variable in the so-called bad-cavity limit . Classification of lasers Arecchi [243] identifies three especially important kinds of laser, which he calls class-A, class-B and class-C lasers, respectively. (1) Class-A lasers are characterized by the condition κ ≪ γ ⊥ , γ ∥ . In this case the atomic variables can be adiabatically eliminated. The He–Ne laser, argon laser and quantum-cascade laser belong to this class.

DOI: 10.1017/cbo9781107477254.022

Related papers

Self-pulsing in other optical systems

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

This chapter concludes the discussion about temporal instabilities and self-oscillations, considering the instabilities that arise in the systems analyzed in Chapter 13, with the exception of optical bistability, which has been discussed separately in Chapter 11. Section 25.1 focuses on the laser with an injected signal. As already mentioned in Section 13.1, in this system self-pulsing instabilities are rather ubiquitous, and on exploring the parameter space one meets an extremely rich variety of oscillatory behaviors. For example, under extremely high-gain conditions, breathing, spiking and chaos have been identified over various ranges of the driving field strength [294]. In this section we show some results that arise under parametric conditions that are more accessible experimentally. We illustrate especially the coexistence, for the same parametric values, of different oscillatory behaviors that are reached by starting from different initial conditions. On the other hand, Section 25.2 deals with a laser with a saturable absorber. In this system even the full scenario of stationary intensity solutions in the single-mode model is very complex. For the sake of simplicity, in this section we focus on a simpler rate-equation model that is obtained from the single-mode model of Eqs. (13.13)–(13.17) by adiabatically eliminating the atomic polarization of both active and passive medium. As in Chapter 13, we assume that the atomic transition frequencies are equal and also coincide with a cavity frequency. In this way all the variables in the model can be assumed real, and the linearization around the stationary solution described in Section 13.2 leads to a cubic eigenvalue equation. The spontaneous oscillations which arise from this instability are called repetitive passive Q-switching in the literature. Section 25.3 considers the stability of the stationary solutions of the degenerate optical parametric oscillator described in Section 13.4 and outlines the scenario of period doubling and chaos that arises under appropriate parametric conditions.

Cambridge University Press eBooksFeb 28, 20150 citations

Absorptive Optical Bistability in a bad cavity

Paul Mandel, Thomas Erneux

In a theoretical discussion of optical bistability, it is often necessary to resort to some approximation scheme to discuss time-dependent properties. The standard method consists in assuming a very good cavity (κ«γ⊥, γ11) Or a very bad cavity (γ11 <<κ1, γ⊥ ) and to perform an adiabatic elimihation of the fast varying variables. In the good cavity limit /1/ the atomic variables are eliminated and one is left with an equation for the field. In the bad cavity limit /2/ the field and the atomic polarization are eliminated and one is left with an eouation for the atomic inversion.

Topical Meeting on Optical Bistability (OB)Jan 1, 19832 citations

Single- and two-mode models

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

In the first section we discuss the stationary solutions for a laser with an injected signal, the active counterpart of the optical bistability analyzed in Chapter 11. Next, in Section 13.2 we consider another very interesting system, namely a laser with a saturable absorber, a free-running laser in which the optical cavity contains a passive medium in addition to the active medium. The single-mode model for this system can be constructed by combining the single-mode models for the free-running laser and for optical bistability. The discussion is then focussed on its stationary states. In Section 13.3 we return to the single-mode model for optical bistability and, by introducing an appropriate “cubic limit” on the parameters in play, we derive a cubic model for dispersive optical bistability with two-level atoms. The stationary equation for such a model formally coincides with that derived and discussed for a Kerr medium in Section 11.2. In the last section we start from the equations for a quadratic nonlinear medium in the degenerate configuration derived in Chapter 6 and combine them with the appropriate boundary conditions for the two field envelopes in play, assuming that the quadratic medium is contained in a ring cavity as happens in an optical parametric oscillator or in second-harmonic generation in a cavity. Next, by introducing the low-transmission limit and the single-mode limit we derive a two-mode model that describes the dynamics of a degenerate optical parametric oscillator or of second-harmonic generation in a cavity. Finally, for the case of a parametric oscillator we illustrate extensively the stationary solutions of the equations. A laser with an injected signal From a technical point of view, this system is interesting because of the possibility of stabilizing the frequency and the phase of separate lasers by taking advantage of the known affinity of nonlinear oscillators to lock onto a periodic forcing element. In 1972 Spencer and Lamb [125] predicted the possibility of bistable behavior in a laser with an injected signal before the surge of interest in optical bistability in the passive configuration.

Cambridge University Press eBooksFeb 28, 20150 citations

The adiabatic elimination principle

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

The adiabatic elimination principle [91, 92] is universal in the area of nonlinear dissipative dynamical systems, and its importance arises from the fact that it allows one to reduce the number of the equations which govern the dynamics of the system. We introduce it at this stage in the book in order to be able to describe the optical pumping mechanisms which can be exerted to attain population inversion. However, this principle will be applied repeatedly in the following chapters for other purposes. In the first subsection we describe the principle in general, while the following subsections concern the issue of optical pumping. We show first that it is not possible to obtain population inversion between the two levels of the lasing transition if the pump involves only these two levels. Next we illustrate the three-level pumping scheme and the four-level pumping scheme. We demonstrate that, by adiabatically eliminating the probabilities of the additional energy levels, one arrives at an equation identical to Eq. (4.12), which, for appropriate ranges of values of the parameters involved in the pumping, allows one to obtain population inversion. General formulation of the principle In a dissipative dynamical system the dynamical variables undergo relaxation processes associated with suitable rate constants such as, for example, the rate γ ⊥ for the normalized atomic polarization P and the rate γ ∥ for the normalized population difference D . The inverses of these rates provide the time scales which characterize the evolution of each variable. Therefore we can distinguish a set of fast variables , which evolve over short time scales and are therefore characterized by large relaxation rates, and a set of slow variables , which display small relaxation rates. A remarkable simplification in the analysis of dynamical systems is obtained by using the technique of adiabatic elimination of fast variables, which Haken considered as a basis for the discipline which he formulated and called Synergetics [91, 92].

Cambridge University Press eBooksFeb 28, 20151 citation

Modal equations for the ring cavity. The single-mode model

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

In the previous chapters we considered the Maxwell–Bloch equations with the boundary condition appropriate for a unidirectional ring cavity and calculated the stationary solutions for laser and optical bistability, respectively. Next, we showed that the exact stationary solutions simplify appreciably in the low-transmission limit. In this chapter we want, first of all, to apply the low-transmission approximation on the dynamical equations directly, beyond the stationary case. We start from the Maxwell–Bloch equations (4.35)–(4.37) and the boundary condition (8.36). The latter is complex and includes the retardation Δ t and some parameters such as the transmissivity and reflectivity coefficients T and R , the input field y and the cavity detuning δ 0 . We introduce a transformation of the coordinates z and t and a transformation of the variables F and P [121–123]. As a result, the boundary condition reduces to a simple periodic boundary condition, and the electric-field equation incorporates the parameters which previously appeared in the boundary condition. The virtue of the periodic boundary condition is that it allows one to expand the electric field in terms of modal amplitudes and to recast the field equation in the form of a set of time-evolution equations for the modal amplitudes. All of this is shown in Section 12.1. In Section 12.2 we apply the low-transmission approximation and the Maxwell–Bloch equations assume a form that is a generalization of a set of equations commonly used in the literature to describe the ring laser [124]. Together with the Bloch equations for the atomic variables, the modal equations provide a model that lends itself ideally to a numerical resolution of the equations. In Section 12.3 we show that, if we assume that only the resonant cavity mode is active, this model reduces to a simple single-mode model consisting in three coupled ordinary differential equations, which will be analyzed in Part II of this book. Next, in the same section we derive the single-mode model in a more direct way, without passing through the multimodal equations.

Cambridge University Press eBooksFeb 28, 20150 citations

Dynamical aspects in optical bistability

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

Although the discovery of oscillatory instabilities (both single-mode and multimode) in free-running lasers was achieved in the 1960s, investigations on oscillatory instabilities in optical bistability did not take place until the 1970s and 1980s. The first section of this chapter does not deal with oscillatory instabilities, but instead concerns an interesting dynamical phenomenon in optical bistability that arises when the input field approaches a boundary of the bistable domain, and is called critical slowing down . This has been investigated both theoretically and experimentally. The remainder of this chapter is entirely devoted to oscillatory instabilities, following a historical order. With an inverse approach with respect to the laser case, we discuss multimode instabilities first. In Section 24.2.1 we start with the description of the instability which arises under exactly resonant conditions. While this is the counterpart in optical bistability of the resonant multimode laser instability discussed in Section 22.5, a striking difference from the laser case is that in the passive configuration there is no corresponding single-mode instability. This difference disappears, however, when we consider the generalization of the multimode instability of optical bistability to the detuned configuration. Finally we show that in the detuned case it has been possible to achieve a convincing experimental observation of the multimode instability in a long microwave cavity. After some relevant miscellaneous considerations in Section 24.2.2, in Section 24.2.3 we address the subject of the multimode Ikeda instability which leads to period doubling and chaos and aroused a lot of interest in optical chaos. We emphasize also the intrinsic connections with the standard multimode instability discussed in Section 24.2.1, showing, in particular, that the Ikeda instability requires conditions far from the low-transmission limit, i.e. that ∝L is not small. In Section 24.3 we discuss single-mode instabilities in optical bistability. In Section 24.3.1 we illustrate a configuration for the single-mode instability that includes also the Gaussian shape of the electric field in the beam section, and leads to periodic, close-to-sinusoidal self-pulsations.

Cambridge University Press eBooksFeb 28, 20150 citations