It has been proved that quantum coherence effects in highly-excited Rydberg atoms could provide a revolutionary solution for RF field measurement. A two-photon transition due to interaction of RF electric field with cesium Rydberg atoms will be discussed. RF E-field whose carrier frequency satisfies a two-photon transition can induce an Autler-Townes splitting within electromagnetically induced transparency (EIT) spectroscopy, and the field strength is directly linked to the measured energy splitting and Planck's constant. Proof-of-concept measurement results will be presented, which also indicate the possibility of sub-wavelength sensing. This work is of major significance for developing quantum-based RF field metrology.
It has been proved that quantum coherence effects in highly-excited Rydberg atoms could provide a revolutionary solution for RF field measurement. A two-photon transition due to interaction of RF electric field with cesium Rydberg atoms will be discussed. RF E-field whose carrier frequency satisfies a two-photon transition can induce an Autler-Townes splitting within electromagnetically induced transparency (EIT) spectroscopy, and the field strength is directly linked to the measured energy splitting and Planck's constant. Proof-of-concept measurement results will be presented, which also indicate the possibility of sub-wavelength sensing. This work is of major significance for developing quantum-based RF field metrology.
We discuss a fundamentally new method for electric (E) field strength (V/m) metrology applicable to the near-field. This new approach is significantly different from currently used field measurement techniques in that it is based on the interaction of radio-frequency (RF) E-fields with Rydberg atoms (alkali atoms placed in a glass vapor cell that are excited optically to Rydberg states). The applied RF E-field alters the state of the atoms. The Rydberg atoms act like an RF-to-optical transducer, converting an RF E-field strength to an optical-frequency response. In this new approach, we employ the phenomena of electromagnetically induced transparency (EIT) and Autler-Townes splitting. The RF transition in the four-level atomic system causes a split of the EIT transmission spectrum of a probe laser into two peaks. This splitting is easily measured and is directly proportional to the applied RF E-field amplitude. The significant dipole response of Rydberg atoms enables this technique to make self-calibrating measurements over a large frequency band including 500 MHz to 500 GHz (and possibly up to 1 THz and down to 10s of megahertz). In this paper, we report on our results in the development of this metrology approach, including the first fiber-coupled vapor-cell for E-field measurements. We also discuss key applications, including self-calibrated measurements, millimeter-wave and sub-THz measurements, field mapping, and sub-wavelength and near-field imaging. We show results for mapping the fields inside vapor cells, for measuring the E-field distribution along the surface of a circuit board, and for measuring the near-field at the aperture in a cavity. We also discuss the uncertainties of this measurement technique.
In this presentation, we discuss a fundamentally new approach for an electric (E) field probe design. This new approach is significantly different than currently used field probes in that it is based on the interaction of RF-fields with Rydberg atoms (alkali atoms placed in a glass vapor cell are excited optically to Rydberg states). The applied RF-field alters the resonant state of the atoms. The Rydberg atoms act like an RF-to-optical transducer, converting an RF E-field to an optical-frequency response. The RF probe utilizes the concept of Electromagnetically Induced Transparency (EIT). The RF transition in the four-level atomic system causes a split of the EIT transmission spectrum for a probe laser. This splitting is easily measured and is directly proportional to the applied RF field amplitude. The significant dipole response of Rydberg atoms enables this technique to make self-calibrating measurements over a large frequency band including 1-500 GHz. In this paper, we report on our results in the development of this probe. We also discuss two key applications: that is, self-calibrated measurements and sub-wavelength imaging and field mapping.
Rydberg atoms, with large principal quantum number, exhibit certain properties, such as long lifetimes and strong interactions with fields and other atoms, which have been extensively investigated recently. One of the properties is the electromagnetically induced transparency (EIT) of Rydberg ladder system, which can be used to measure the radio frequency (RF) field with high sensitivity. In this paper, we investigate the quantum coherent effect of cesium Rydberg atom in a three-level ladder system involving the ground state (6S1/2), the excited state (6P3/2) and 49S1/2 Rydberg state in room temperature vapor cell. The probe laser (852 nm) drives the transition of 6S1/2(F=4)→6P3/2(F'=5), while the coupling laser (510 nm) couples the Rydberg transition of 6P3/2 (F'=5)→nS1/2. A typical electromagnetically induced transparency spectrum is obtained when the weak probe laser is scanned through the transition of 6S1/2(F=4)→6P3/2(F'=5) and the coupling laser tuning to Rydberg transition. The two-photon RF spectra are observed when the RF field with a frequency of ～16.9 GHz couples the Rydberg transition of 49S1/2→47D3/2, where the EIT signal is split into two EIT peaks due to the interaction between the RF field and Rydberg atoms. The dependences of EIT splitting on the power of RF field are investigated. The results show that the EIT splitting increases with the power of RF field, which can inversely be used to measure the RF field with a higher spatial resolution in the future.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.
We present a significantly new approach for an electric (E) field probe design. The probe is based on the interaction of RF-fields with Rydberg atoms, where alkali atoms are excited optically to Rydberg states and the applied RF-field alters the resonant state of the atoms. For this probe, the Rydberg atoms are excited in a glass vapor cell. The Rydberg atoms act like an RF-to-optical transducer, converting an RF E-field to an optical-frequency response. The probe utilizes the concept of Electromagnetically Induced Transparency (EIT). The RF transition in the four-level atomic system causes a split of the EIT transmission spectrum for the probe laser. This splitting is easily measured and is directly proportional to the applied RF field amplitude. Therefore, by measuring this splitting we get a direct measurement of the RF E-field strength. The significant dipole response of Rydberg atoms over the GHz regime enables this technique to make traceable measurements over a large frequency band including 1-500 GHz. We will show that, with one probe, measurements can be made over a very large frequency range. This is a truly broadband probe/sensor. In this paper, we report on our results in the development of this probe.
We demonstrate the use of multiple atomic-level Rydberg-atom schemes for continuous frequency detection of radio-frequency (RF) fields. Resonant detection of RF fields by electromagnetically induced transparency and Autler-Townes (AT) splitting in Rydberg atoms is typically limited to frequencies within the narrow bandwidth of a Rydberg transition. By applying a second field resonant with an adjacent Rydberg transition, far-detuned fields can be detected through a two-photon resonance AT splitting. This two-photon AT splitting method is several orders of magnitude more sensitive than off-resonant detection using the Stark shift. We present the results of various experimental configurations and a theoretical analysis to illustrate the effectiveness of this multiple level scheme. These results show that this approach allows for the detection of frequencies in a continuous band between resonances with adjacent Rydberg states.