Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

All-Optical Bistabilities in Reflection and Luminescence

B. Ullrich, Takayoshi Kobayashi

Published Jan 1, 1995• 0 citations
OpenAlex

Abstract

First reports of absorptive all-optical bistabilities in reflectance and luminescence of a Fabry-Perot cavity consisting of thin (0.70 ,cem) ZnSe film are presented. We demonstrate that the observation of bistability in the reflected beam does not require necessarily the appearance of bistability in the transmitted beam. Luminescence bistabilities, however, are observed both in the light captured Lrom the incident side 0L the film and in the light emitted from the transmission side. The bistabilities in reflection and luminescence are explained quite satisfactorily by the principle of increasing absorption due to photo-irradiation and the dependence of the luminescence intensity on a photo-thermally induced temperature change, respectively. A11 experiments were carried out at room temperature with the 488 nm line of an argon laser.

Related papers

All-optical bistability in luminescence of thin CdS films

B. Ullrich, Takayoshi Kobayashi

Recently, we have discovered that the excitation of thin CdS films with the 514.5 nm line causes an all-optical bistable luminescent emission in the near infrared part of the spectrum. A first insight in mechanism and origin of all-optical bistability in luminescence of semiconductors is presented. We show that the initial and final states of the bistable luminescence are determined by the thermal properties of the luminescence intensity of the thin CdS film. However, during the bistable switch of the luminescence thermal effects and electronic ones take place. Thus, all-optical bistability in luminescence is a thermally induced electronic bistability.

Physica Scripta•Jan 1, 1994•2 citations

All-Optical Absorptive and Dispersive Bistabilities in Luminescence of a Thin CdS Film

B. Ullrich, Takayoshi Kobayashi

All-optical photo-thermal bistabilities in the near infrared luminescence (800 nm) of a thin ( 5.5 µm) spray-pyrolyzed CdS film are studied with the 514.5 nm line of an argon laser. We report the first observation of both dispersive and absorptive luminescence bistabilities in the same CdS film. The temperature dependence of the luminescence intensity and self-focusing are found to be the origins of absorptive and dispersive luminescence bistabilities, respectively. Furthermore, it is demonstrated that the shape of the bistable response of the luminescence depends crucially on the entrance slit width of the monochromator.

Japanese Journal of Applied Physics•Nov 1, 1994•4 citations

Demonstration of the independence of absorptive all-optical bistabilities in reflection and luminescence

B. Ullrich, Algirdas Kazlauskas, Toyohide Kobayashi

The dependence on the source location of photothermal bistabilities of a thin CdS:Cu film is demonstrated by the investigation of bistability in luminescence in reflection geometry. Particularly, it is shown that the infrared portion in the reflected beam clearly exhibits contrasting bistable loops in contrast to the reflection itself. The unexpected effect is explained by the fact that bistability in luminescence is a bulk feature which is not affected by the surface region.

Applied Physics Letters•Mar 27, 1995•5 citations

Optical bistability of a dielectric cladded thin film near the total internal reflection state: theory and experiment

I. C. Khoo, Jingya Hou

A nonlinear thin film bounded by two dielectric media can act as an optical switching bistable device owing to two mechanisms at work near the total internal reflection state. One is the intensity-dependent index change induced by the optical field in the thin film before transmission occurs, and the other is the nonlinear Fabry-Perot interference associated with the high reflectivities at the two interfaces just after transmission takes place.

Conference on Lasers and Electro-Optics•Jan 1, 1985•0 citations

All-optical material characterization techniques and optical data links by the application of bistability in luminescence

B. Ullrich, Kazuhiko Misawa, T Kobayashi +1 more

All-optical bistability in luminescence of thin (⩽ 10 μm) CdS and CdS: Cu sprayed films on pyrex® was studied in the range of 700-1000 nm. The films were investigated between 80-210 K and excited by the 514.5 nm Ar + - laser line. The measurements were performed in transmission or reflection geometries using a monochromator or cut-off filters, respectively. The pronounced dependence of the luminescence intensity on temperature in the near infrared is found to be the origin of bistability in luminescence. Furthermore, we demonstrate that the loop contrasts depend on the wavelength investigated. By the application of this feature, we present, to the best of our knowledge for the first time, a possibility to measure doping concentrations of a semiconductor with a bistable device. Finally, new concepts are discussed to use luminescence bistability in all-optical or hybrid data links.

Physica Scripta•Apr 1, 1995•2 citations

All-Optical Bistabilities in Reflection and Luminescence of Thin ZnSe Films

B. Ullrich, Takayoshi Kobayashi

Optical Review•Nov 1, 1995•1 citation
First reports of absorptive all-optical bistabilities in reflectance and luminescence of a Fabry-Perot cavity consisting of thin (0.70 ,cem) ZnSe film are presented. We demonstrate that the observation of bistability in the reflected beam does not require necessarily the appearance of bistability in the transmitted beam. Luminescence bistabilities, however, are observed both in the light captured Lrom the incident side 0L the film and in the light emitted from the transmission side. The bistabilities in reflection and luminescence are explained quite satisfactorily by the principle of increasing absorption due to photo-irradiation and the dependence of the luminescence intensity on a photo-thermally induced temperature change, respectively. A11 experiments were carried out at room temperature with the 488 nm line of an argon laser.
Recently, we have discovered that the excitation of thin CdS films with the 514.5 nm line causes an all-optical bistable luminescent emission in the near infrared part of the spectrum. A first insight in mechanism and origin of all-optical bistability in luminescence of semiconductors is presented. We show that the initial and final states of the bistable luminescence are determined by the thermal properties of the luminescence intensity of the thin CdS film. However, during the bistable switch of the luminescence thermal effects and electronic ones take place. Thus, all-optical bistability in luminescence is a thermally induced electronic bistability.
All-optical photo-thermal bistabilities in the near infrared luminescence (800 nm) of a thin ( 5.5 µm) spray-pyrolyzed CdS film are studied with the 514.5 nm line of an argon laser. We report the first observation of both dispersive and absorptive luminescence bistabilities in the same CdS film. The temperature dependence of the luminescence intensity and self-focusing are found to be the origins of absorptive and dispersive luminescence bistabilities, respectively. Furthermore, it is demonstrated that the shape of the bistable response of the luminescence depends crucially on the entrance slit width of the monochromator.
All-optical bistability in luminescence of thin (⩽ 10 μm) CdS and CdS: Cu sprayed films on pyrex® was studied in the range of 700-1000 nm. The films were investigated between 80-210 K and excited by the 514.5 nm Ar + - laser line. The measurements were performed in transmission or reflection geometries using a monochromator or cut-off filters, respectively. The pronounced dependence of the luminescence intensity on temperature in the near infrared is found to be the origin of bistability in luminescence. Furthermore, we demonstrate that the loop contrasts depend on the wavelength investigated. By the application of this feature, we present, to the best of our knowledge for the first time, a possibility to measure doping concentrations of a semiconductor with a bistable device. Finally, new concepts are discussed to use luminescence bistability in all-optical or hybrid data links.