Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Perturbation theory; Variational method; Sudden and adiabatic theory

Victor Galitski, Boris Mikhailovich Karnakov, Vladimir I Kogan, Victor Galitski

Published Feb 28, 2013• 0 citations
Publisher

Abstract

Abstract This chapter analyzes problems that deal with stationary perturbation theory (discrete spectrum); variational method; stationary perturbation theory (continuous spectrum); non-stationary perturbation theory (transitions in continuous spectrum); sudden perturbations; and adiabatic approximation.
DOI
10.1093/acprof:oso/9780199232710.003.0008

Related papers

Perturbations and approximation methods

Gennaro Auletta, Mauro Fortunato, Giorgio Parisi A

In this chapter, we present some fundamental issues about approximation methods that are often used when a quantum-mechanical system is perturbed and about the relationship between classical and quantum mechanics. In Sec. 10.1 we introduce the stationary perturbation theory, while Sec. 10.2 is devoted to time-dependent perturbations. In Sec. 10.3 we briefly examine the adiabatic theorem. In Sec. 10.4 we introduce the variation method, an approximation method that is not based on perturbation theory. In Sec. 10.5 we discuss the classical limit of the quantum-mechanical equations, whereas in Sec. 10.6 we deal with the semiclassical approximation, in particular the WKB method. On the basis of the previous approximation methods in Sec. 10.7 we present scattering theory. Finally, in Sec. 10.8 we treat a method that has a wide range of applications: the path-integral method. Stationary perturbation theory Perturbation theory is a rather general approximation method that may be applied when a small additional force (the perturbation) acts on a system (the unperturbed system), whose quantum dynamics is fully known. If the disturbance is small, it modifies both the energy levels and the stationary states. This allows us to make an expansion in power series of a perturbation parameter, which is assumed to be small. Perturbation theory may be applied both to the case where the additional force is time-independent (in which case a stationary treatment suffices – the subject of the present section) as well as to the case where it explicitly depends on time.

Cambridge University Press eBooks•Apr 16, 2009•0 citations

One-dimensional motion

Victor M. Galitski, Boris Mikhailovich Karnakov, Vladimir I Kogan +1 more

Abstract This chapter analyzes problems that deal with stationary states in the discrete spectrum; the Schrödinger equation in momentum space (the Green function and integral form of the Schrödinger equation); the continuous spectrum (reflection from and transmission through potential barriers); and systems with several degrees of freedom (particle in a periodic potential).

•Feb 28, 2013•0 citations

Perturbation theory

Giampiero V. M. Esposito, Giuseppe Marmo, George Sudarshan

The subject of perturbation theory in non-relativistic quantum mechanics is introduced. First, perturbation theory for stationary states in the absence of degeneracy is studied. The case of nearby levels, perturbations of a one-dimensional harmonic oscillator, the occurrence of degeneracy, Stark and Zeeman effects are then described in detail. After a brief outline of the variational method, the Dyson series for time-dependent perturbation theory is derived, with application to harmonic perturbations. The Fermi golden rule is also presented. The chapter ends with an assessment of four branches of the subject: regular perturbation theory, asymptotic perturbation theory, and summability methods, spectral concentration and singular perturbations. Approximate methods for stationary states It is frequently the case, in physical problems, that the full Hamiltonian operator H consists of an operator H 0 whose eigenvalues and eigenfunctions are known exactly, and a second term V resulting from a variety of sources (e.g. the interaction with an electric field, or a magnetic field, or the relativistic corrections to the kinetic energy, or the effects of spin). The problems and aims of perturbation theory for stationary states can be therefore summarized as follows. (i) Once the domain of (essential) self-adjointness of the ‘unperturbed’ Hamiltonian H 0 is determined, find on which domain the ‘sum’ H = H 0 + V represents an (essentially) self-adjoint operator (the reader should remember from appendix 4. A that in general, once some operators A and B are given, the intersection of their domains, on which their sum is defined, might be the empty set). […]

Cambridge University Press eBooks•Mar 11, 2004•0 citations

Perturbation theory

Kenichi Konishi, Giampiero Paffuti

Abstract One of the most frequently used approximation methods—perturbation theory—will be discussed in this chapter. Often a physical system is characterized by an “unperturbed” Hamiltonian H0 whose spectrum is known, and by a small part of the Hamiltonian, the “perturbation” V .

•Mar 5, 2009•0 citations

Quantum Mechanics

A. M. Perelomov, Y B Zeldovich

Discrete spectrum continuous spectrum analytic properties of the wave function the green's function and perturbation theory quasi-classical approximation exact solutions of certain non-stationary problems quasi-stationary states. Appendices: Schroedinger equation spectrum in specific cases quasi-classical properties of the highly excited levels in the Coulomb field.

WORLD SCIENTIFIC eBooks•Dec 1, 1998•84 citations

- Approximation Methods IV: Variational Approach

S. Rajasekar, R. Velusamy

In chapters 13 and 14 we focused on perturbation theories for time-independent and time-dependent perturbations. For time-independent perturbations we obtained first-order and second-order corrections to energy eigenvalues and eigenfunctions. For time-dependent perturbations we obtained the probability for a system to make a transition from an ith initial state to fth final state. We have also discussed how to study the effect of adiabatic and sudden perturbations. In the present chapter we consider the variational method. The variational method can be used to construct an approximate ground state eigenfunction. In some cases the method can be used for finding approximately the energy of first few discrete states of a bound system. The perturbation theory uses a set of unperturbed states and the perturbation Hamiltonian H(1) to construct the eigenfunctions and eigenvalues through highly formalized approximations. In contrast, the variational method is based on a guess for the state-a trial state which is used to determine the corresponding energy. Any well behaved trial state introduced will yield an appropriate energy, although some trial states will be better than other, but whatever the guess, we can always make systematic improvements. We can construct a reasonably accurate eigenfunction often by a physical insight and ingenuity.

CRC Press eBooks•Dec 11, 2014•0 citations
In this chapter, we present some fundamental issues about approximation methods that are often used when a quantum-mechanical system is perturbed and about the relationship between classical and quantum mechanics. In Sec. 10.1 we introduce the stationary perturbation theory, while Sec. 10.2 is devoted to time-dependent perturbations. In Sec. 10.3 we briefly examine the adiabatic theorem. In Sec. 10.4 we introduce the variation method, an approximation method that is not based on perturbation theory. In Sec. 10.5 we discuss the classical limit of the quantum-mechanical equations, whereas in Sec. 10.6 we deal with the semiclassical approximation, in particular the WKB method. On the basis of the previous approximation methods in Sec. 10.7 we present scattering theory. Finally, in Sec. 10.8 we treat a method that has a wide range of applications: the path-integral method. Stationary perturbation theory Perturbation theory is a rather general approximation method that may be applied when a small additional force (the perturbation) acts on a system (the unperturbed system), whose quantum dynamics is fully known. If the disturbance is small, it modifies both the energy levels and the stationary states. This allows us to make an expansion in power series of a perturbation parameter, which is assumed to be small. Perturbation theory may be applied both to the case where the additional force is time-independent (in which case a stationary treatment suffices – the subject of the present section) as well as to the case where it explicitly depends on time.
The subject of perturbation theory in non-relativistic quantum mechanics is introduced. First, perturbation theory for stationary states in the absence of degeneracy is studied. The case of nearby levels, perturbations of a one-dimensional harmonic oscillator, the occurrence of degeneracy, Stark and Zeeman effects are then described in detail. After a brief outline of the variational method, the Dyson series for time-dependent perturbation theory is derived, with application to harmonic perturbations. The Fermi golden rule is also presented. The chapter ends with an assessment of four branches of the subject: regular perturbation theory, asymptotic perturbation theory, and summability methods, spectral concentration and singular perturbations. Approximate methods for stationary states It is frequently the case, in physical problems, that the full Hamiltonian operator H consists of an operator H 0 whose eigenvalues and eigenfunctions are known exactly, and a second term V resulting from a variety of sources (e.g. the interaction with an electric field, or a magnetic field, or the relativistic corrections to the kinetic energy, or the effects of spin). The problems and aims of perturbation theory for stationary states can be therefore summarized as follows. (i) Once the domain of (essential) self-adjointness of the ‘unperturbed’ Hamiltonian H 0 is determined, find on which domain the ‘sum’ H = H 0 + V represents an (essentially) self-adjoint operator (the reader should remember from appendix 4. A that in general, once some operators A and B are given, the intersection of their domains, on which their sum is defined, might be the empty set). […]
In chapters 13 and 14 we focused on perturbation theories for time-independent and time-dependent perturbations. For time-independent perturbations we obtained first-order and second-order corrections to energy eigenvalues and eigenfunctions. For time-dependent perturbations we obtained the probability for a system to make a transition from an ith initial state to fth final state. We have also discussed how to study the effect of adiabatic and sudden perturbations. In the present chapter we consider the variational method. The variational method can be used to construct an approximate ground state eigenfunction. In some cases the method can be used for finding approximately the energy of first few discrete states of a bound system. The perturbation theory uses a set of unperturbed states and the perturbation Hamiltonian H(1) to construct the eigenfunctions and eigenvalues through highly formalized approximations. In contrast, the variational method is based on a guess for the state-a trial state which is used to determine the corresponding energy. Any well behaved trial state introduced will yield an appropriate energy, although some trial states will be better than other, but whatever the guess, we can always make systematic improvements. We can construct a reasonably accurate eigenfunction often by a physical insight and ingenuity.