In chapters 13 and 14 we focused on perturbation theories for time-independent and time-dependent perturbations. For time-independent perturbations we obtained first-order and second-order corrections to energy eigenvalues and eigenfunctions. For time-dependent perturbations we obtained the probability for a system to make a transition from an ith initial state to fth final state. We have also discussed how to study the effect of adiabatic and sudden perturbations. In the present chapter we consider the variational method. The variational method can be used to construct an approximate ground state eigenfunction. In some cases the method can be used for finding approximately the energy of first few discrete states of a bound system. The perturbation theory uses a set of unperturbed states and the perturbation Hamiltonian H(1) to construct the eigenfunctions and eigenvalues through highly formalized approximations. In contrast, the variational method is based on a guess for the state-a trial state which is used to determine the corresponding energy. Any well behaved trial state introduced will yield an appropriate energy, although some trial states will be better than other, but whatever the guess, we can always make systematic improvements. We can construct a reasonably accurate eigenfunction often by a physical insight and ingenuity.
In chapters 13 and 14 we focused on perturbation theories for time-independent and time-dependent perturbations. For time-independent perturbations we obtained first-order and second-order corrections to energy eigenvalues and eigenfunctions. For time-dependent perturbations we obtained the probability for a system to make a transition from an ith initial state to fth final state. We have also discussed how to study the effect of adiabatic and sudden perturbations. In the present chapter we consider the variational method. The variational method can be used to construct an approximate ground state eigenfunction. In some cases the method can be used for finding approximately the energy of first few discrete states of a bound system. The perturbation theory uses a set of unperturbed states and the perturbation Hamiltonian H(1) to construct the eigenfunctions and eigenvalues through highly formalized approximations. In contrast, the variational method is based on a guess for the state-a trial state which is used to determine the corresponding energy. Any well behaved trial state introduced will yield an appropriate energy, although some trial states will be better than other, but whatever the guess, we can always make systematic improvements. We can construct a reasonably accurate eigenfunction often by a physical insight and ingenuity.
The variational method can be used to construct an approximate ground state eigenfunction. In some cases the method can be used for finding approximately the energy of first few discrete states of a bound system. The perturbation theory uses a set of unperturbed states and the perturbation Hamiltonian H to construct the eigenfunctions and eigenvalues through highly formalized approximations. In contrast, the variational method is based on a guess for the state – a trial state is used to determine the corresponding energy. Any well behaved trial state introduced will yield an appropriate energy, although some trial states will be better than other, but whatever the guess, we can always make systematic improvements.
We now consider systems for which the Hamiltonian contains time-dependent interaction terms. In such cases we cannot reduce the time-dependent Schro¨dinger equation to an eigenvalue equation. However, if the time-dependent terms can be regarded as small perturbations, we can develop a form of perturbation theory that can be used to calculate the effects of time-dependent terms. Consider a system for which the Hamiltonian may be written as the sum of a dominant unperturbed part Hˆ0 and a small perturbation Hˆ ′ as Hˆ = Hˆ0 + λHˆ ′(t) , (10.1.1) where the unperturbed Hamiltonian Hˆ0 is independent of time, whereas the perturbation Hˆ ′ may depend on time. The parameter 0 < λ < 1 has been introduced to keep track of various orders of approximations as in the case of time-independent perturbation theory discussed in Chapter 8. The basic idea is that a small perturbation to the Hamiltonian will produce a small change in the wave function. For a time-dependent perturbation, this change means that a system, initially in a particular eigenstate of Hˆ0, will find itself in a time-dependent admixture of the eigenstates. Thus the time-dependent perturbation causes the system to undergo transition to different eigenstates of Hˆ0. So for time-dependent perturbations our interest lies in calculating the probabilities for transition to different states.
As in classical mechanics the number of exactly soluble quantum mechanical problems is very limited and in most cases of practical interest numerical techniques and approximation methods are unavoidable. The availability of fast computers has turned quantum computation into a major industry. This chapter looks at the several approximation techniques. In seeking to solve the Schrodinger equation with the perturbed Hamiltonian, it is convenient to work with series expansions by introducing a dimensionless parameter λ. In many cases the system of interest differs from an exactly soluble system by only a small disturbance, enabling an approximation to be made by expanding in powers of a smallness parameter. The Variational Method provides a very simple method of approximating energy eigenvalues. It is most useful for computing ground state energies and its success depends on our being able to make a reasonable guess for the form of the ground state wave function.
Throughout our discussion of the general principles of quantum mechanics we have emphasized the importance of the eigenvalues and eigenfunctions of the operators representing physical quantities. However, we have seen that solving the basic eigenvalue equations determining these is often not straightforward. In the early chapters discussing the energy eigenvalue equation (or time-independent Schro¨dinger equation) for example, we found that this could often not be solved exactly and that, even when a solution was possible, it frequently required considerable mathematical analysis. Because of this, methods have been developed to obtain approximate solutions to eigenvalue equations. One of the most important of such techniques is known as time-independent perturbation theory and will be the first method to be discussed in the present chapter. Another, known as the variational principle, will be discussed later. We shall confine our discussion to the timeindependent Schro¨dinger equation, but generalization to other eigenvalue equations is quite straightforward. We shall mainly use the wave function representation, but we shall restate some of the important results in Dirac notation so that they can be readily transformed to a matrix representation if desired.
In this chapter, we present some fundamental issues about approximation methods that are often used when a quantum-mechanical system is perturbed and about the relationship between classical and quantum mechanics. In Sec. 10.1 we introduce the stationary perturbation theory, while Sec. 10.2 is devoted to time-dependent perturbations. In Sec. 10.3 we briefly examine the adiabatic theorem. In Sec. 10.4 we introduce the variation method, an approximation method that is not based on perturbation theory. In Sec. 10.5 we discuss the classical limit of the quantum-mechanical equations, whereas in Sec. 10.6 we deal with the semiclassical approximation, in particular the WKB method. On the basis of the previous approximation methods in Sec. 10.7 we present scattering theory. Finally, in Sec. 10.8 we treat a method that has a wide range of applications: the path-integral method. Stationary perturbation theory Perturbation theory is a rather general approximation method that may be applied when a small additional force (the perturbation) acts on a system (the unperturbed system), whose quantum dynamics is fully known. If the disturbance is small, it modifies both the energy levels and the stationary states. This allows us to make an expansion in power series of a perturbation parameter, which is assumed to be small. Perturbation theory may be applied both to the case where the additional force is time-independent (in which case a stationary treatment suffices – the subject of the present section) as well as to the case where it explicitly depends on time.
Perturbation theory for non-degenerate and degenerate systems, variational methods, and WKB approximation are covered in this chapter. First, second, and kth order corrections to energy and wave function ket of non-degenerate states, energy eigenvalues, and wave functions kets of anharmonic oscillator, first-order perturbation theory for degenerate states and linear stark effect are written under perturbation theory. Second part of the chapter includes the variational methods for computation of the energy for ground state of helium atom, Rayleigh-Ritz variational method and its application to hydrogen molecule ion, calculation of energy of excited states, and its application to 1D harmonic oscillator. The topics which are covered under WKB approximation are the classical and non-classical regions of particle motion, alternative derivation of WKB formulae, connecting formulae, and quantum condition for bound state. The kth order corrections to energy and wave function kets for non-degenerate perturbation theory, treatment of WKB approximation from two different approaches and the detailed derivation of connecting formulae, application of variational method to compute energy for excited states are topics which are not generally found in existing text books on quantum mechanics. A good number of solved examples illustrating the importance of approximation methods in contemporary fields are added at the end of chapter.