Most introductory courses on physics mention the basics of atomic physics: we learn about the ground state and excited states, and that the excited states have a finite life-time decaying eventually to the ground state while emitting radiation. You might have hoped for a better understanding of these decay processes when you started studying quantum mechanics. If this was the case, you must have been disappointed. Courses on basic quantum mechanics in fact assume that all quantum states have an infinitely long life-time. You learn how to employ the Schrödinger equation to determine the wave function of a particle in various setups, for instance in an infinitely deep well, in a parabolic potential, or in the spherically symmetric potential set up by the nucleus of a hydrogen atom. These solutions to the Schrödinger equation are explained as being stationary, the only time-dependence of the wave function being a periodic phase factor due to the energy of the state. Transitions between different quantum states are traditionally not discussed and left for courses on advanced quantum mechanics. If you have been disappointed by this, then this chapter will hopefully provide some new insight: we learn how matter and radiation interact, and, in particular, how excited atomic states decay to the ground state. Our main tool to calculate emission and absorption rates for radiative processes is Fermi’s golden rule (see Section 1.6.1). We thus start by refreshing the golden rule and specifying its proper use. Before we turn to explicit calculations of transition rates, we use the first part of the chapter for some general considerations concerning emission and absorption, those being independent of the details of the interaction between matter and electromagnetic radiation. In this context we briefly look at master equations that govern the probabilities to be in certain states and we show how to use those to understand properties of the equilibrium state of interacting matter and radiation. We show that it is even possible to understand so-called black-body radiation without specifying the exact interaction Hamiltonian of matter and radiation.
Most introductory courses on physics mention the basics of atomic physics: we learn about the ground state and excited states, and that the excited states have a finite life-time decaying eventually to the ground state while emitting radiation. You might have hoped for a better understanding of these decay processes when you started studying quantum mechanics. If this was the case, you must have been disappointed. Courses on basic quantum mechanics in fact assume that all quantum states have an infinitely long life-time. You learn how to employ the Schrödinger equation to determine the wave function of a particle in various setups, for instance in an infinitely deep well, in a parabolic potential, or in the spherically symmetric potential set up by the nucleus of a hydrogen atom. These solutions to the Schrödinger equation are explained as being stationary, the only time-dependence of the wave function being a periodic phase factor due to the energy of the state. Transitions between different quantum states are traditionally not discussed and left for courses on advanced quantum mechanics. If you have been disappointed by this, then this chapter will hopefully provide some new insight: we learn how matter and radiation interact, and, in particular, how excited atomic states decay to the ground state. Our main tool to calculate emission and absorption rates for radiative processes is Fermi’s golden rule (see Section 1.6.1). We thus start by refreshing the golden rule and specifying its proper use. Before we turn to explicit calculations of transition rates, we use the first part of the chapter for some general considerations concerning emission and absorption, those being independent of the details of the interaction between matter and electromagnetic radiation. In this context we briefly look at master equations that govern the probabilities to be in certain states and we show how to use those to understand properties of the equilibrium state of interacting matter and radiation. We show that it is even possible to understand so-called black-body radiation without specifying the exact interaction Hamiltonian of matter and radiation.
Radiation can change the energy state of matter via three optical processes: spontaneous emission, absorption and stimulated emission. In spontaneous emission, an excited atomic or molecular state decays to a lower energy state with the emission of a photon of energy equal to the difference in the quantum state energies. Photon absorption is the reverse process, with a photon causing excitation from a lower to an excited quantum state. Stimulated emission was first proposed by Einstein in a paper published in 1917. He attempted to balance spontaneous emission and photon absorption, but could not get the correct balance without the postulated process of stimulated emission (see Section 4.2). With stimulated emission, an excited quantum state is stimulated to decay to a lower quantum state by an impinging photon. The existing photon survives with another identical photon being created (so that energy is conserved). The rates at which radiative transitions occur can be calculated using quantum mechanics. The time-dependent Schrodinger equation is used with the system wavefunction comprising time-varying linear combinations of the two wavefunctions for the lower and upper quantum states. In semi-classical treatments, an atom is treated quantum mechanically with the radiation field treated classically. There is a perturbation in energy associated with, say, the electric field of the radiation interacting with the electric dipole of the atom, though other interactions can be significant if the electric dipole interaction energy is small. In absorption, for example, a differential equation representing the change in ‘weighting’ of the wavefunction from the lower to upper state is obtained. A ‘time constant’ for the speed of change represents the rate of the radiative process. We examine the quantum mechanical nature of radiation absorption in Section 10.1 before discussing (Section 10.3) another important parameter arising with radiative transitions between discrete bound quantum states: the lineshape function. Quantum Theory of the Atom–Radiation Interaction An expression for the Einstein B-coefficient for photo-absorption is derived using quantum mechanics in this section. Einstein determined the detailed balance relationship between the rates of spontaneous emission, photo-absorption and stimulated emission when light interacts with an atom by considering an atomic system of two energy levels which are in equilibrium with a black-body radiation field. We use a semi-classical treatment where the atom is treated quantum mechanically and the radiation field is treated as a classical oscillating electric field.
Introduction The preceding chapters have focused on atomic transitions induced by applied radiation. That is, there is an optical field illuminating the atoms, and their response is calculated. It is implicitly assumed that an excited atom left alone will spontaneously return to the ground state, and conserve energy by emitting light that satisfies E 2 − E 1 = ħ ω 21 in accordance with the Planck and Bohr pictures. But this spontaneous emission process is not addressed quantitatively in these earlier chapters. Spontaneous emission is one of the most pervasive phenomena of atomic physics, and yet its origins remain among the least well-understood. The number of misconceptions is enormous, and they are to be found in textbooks, journal articles, and lecture notes. Because the natural decay of an excited atom adds energy to what is usually an empty mode of the electromagnetic field, the process is fundamentally quantum mechanical. Classical or even semi-classical descriptions cannot be assured to give correct answers. This is not to say that such discussion is to be avoided, but only that caution is needed in interpreting the results. Toward the end of the nineteenth century, many experimental results made it clear that classical mechanics needed to be supplemented by new theories. The first venture into the new physics was Planck's hypothesis that the energy of classical radiating oscillators like those discussed in Chap. 1 would have to be quantized into integer multiples of ħ ω. This notion led to his famous formula for the spectrum of thermal radiation from a non-reflective object (black body), and this formula describes a radiation field in thermodynamic equilibrium with its environment. The result of Planck's hypothesis in the context of thermal equilibrium plays a vital role in the discussion of spontaneous emission. Einstein A - and B -coefficients Soon after Bohr proposed a model of atomic structure consisting of discrete energy levels, connected by radiation whose energy satisfied Δ E = ħω when atoms made transition between them, Einstein published the first serious attempt to connect the absorption and emission processes. Absorption, he reasoned, could occur only in the presence of applied radiation, whereas spontaneous decay occurred without the application of any field.
So far we have treated the energy levels of an atomic system as stable states with infinite lifetimes. The presence of an electromagnetic field changes this picture. Absorption of photons will excite atoms and ions to higher levels, while stimulated emission will make excited ones decay. Einstein (1917) showed, using purely statistical arguments, that an excited ion will decay through spontaneous emission in the absence of an electromagnetic field. This process can also be derived by using a rigorous quantum electrodynamic treatment, where the field is quantized. In this chapter we start by discussing transitions between atomic levels in a general sense, postulating the operators responsible for the decay. After the first few sections we will concentrate on the most important few multipoles or terms in the expansion of the electromagnetic field. We will introduce a number of different properties describing the transition, and eventually arrive at the measurable transition rate and, directly linked to it, the lifetime of an excited state. We will start, however, with the most basic property, the component strength. Our aim is to arrive at computationally useful expressions as soon as possible. For a more thorough treatment of the theory of radiative transitions we refer to the book by Sobelman (1972). For a brief review of the many factors affecting spectra of atoms, see Martin and Wiese (1996) .
Introduction Until now, our discussion of the interaction between radiation and matter has concentrated only on the spectral aspects of radiation. The results could determine the wavelengths for absorption and emission or the selection rules for such transitions, but could not be used to determine the actual extent of emission or absorption. These too are important considerations which are needed to fully quantify radiative energy transfer. Unfortunately, none of the classical theories can predict the extent of emission from an excited medium, or even the extent of absorption. Although the discussion in Section 4.9 (on the propagation of electromagnetic waves through lossy media) touched briefly on the concept of attenuation by absorption, it failed to show the reasons for the spectral properties of the absorption or to accurately predict its extent. We will see later that the classical results are useful only as a benchmark against which the actual absorber is compared. The objective of this chapter is therefore to present an introduction to quantum mechanical processes that control the emission and absorption by microscopic systems consisting of atoms and molecules. The results will then be used to predict the extent of emission by media when excited by an external energy source and to evaluate the absorption of incident radiation. It is now well recognized that all emission or absorption processes are the result of transitions between quantum mechanical energy levels.
In this work we shall study the interaction of matter and light. In so doing we shall rely heavily on the description of such processes provided by quantum mechanics. This appears on a number of levels: firstly, a quantum description of matter is indispensable if one wants to understand on the microscopic scale the different kinds of interaction processes that can occur. Secondly, a quantum description of light often turns out to be useful, sometimes necessary, to better understand these processes. We shall study phenomena such as spontaneous emission, which can only be properly treated by a theory taking into account the quantum nature of both light and matter. In the following chapters we shall address, amongst others, the following question: ‘given an atom prepared at a given time in a particular state and subjected from this time onwards to electromagnetic radiation, what is the state of the atom and radiation at any later moment in time?’ In order to be able to answer this question it will be necessary for us to know how to calculate the evolution of a quantum system in a small number of typical situations. These methods we shall demonstrate in the first chapter. The evolution of the coupled atom–light system depends on the temporal dependence of the applied light field, which could, for example, be applied from a given moment and thereafter remain unchanged in intensity, or, perhaps, be appreciable only for a finite period of time (pulsed excitation).
Abstract Since the beginning of this century we have a rough understanding about the structure of atoms. They consist of a nucleus and electrons orbiting around this nucleus. We know that electrons occupy only certain discrete energy states. When they decay from a high-energy state to a low-energy state, they emit electromagnetic radiation. Usually, the low-energy state will be the ground state. In that case, the emitted radiation is called resonance radiation.1 Since the resonance photons have an energy that corresponds to the energy of the transition, they can easily be absorbed by other ground-state atoms. A ground-state atom that absorbs the resonance photon is excited to the upper state for some time and will eventually release the photon again. This absorption/reemission process can be repeated many times, until the photon finally escapes from the vapour. This process is called ‘radiation trapping’ (also known as ‘imprisonment of resonance radiation’, ‘radiative transfer of spectral lines’, ‘line transfer’, or ‘radiation diffusion’).