Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Wiley eBooks

Quantum Noise: Basic Measurements and Techniques

Hans‐A. Bachor, Timothy C. Ralph

Published Jul 5, 2019• 1 citation
Publisher

Abstract

This chapter focuses on the measurement of quantum noise, that is the fundamental noise we observe on the photocurrent when we detect optical beams with a large coherent amplitude using photodetectors. It also focuses on continuous wave laser beams and the noise associated with the intensity, amplitude, and phase of the light. Three different techniques are commonly used: direct detection, balanced detection, and homodyne detection. The choice depends on the properties of laser beam. Heterodyne detection is frequently used to determine the linewidth of an unknown laser. The intensity noise of a laser can be reduced using an electro-optic modulator and a feedback controller, known as a noise eater. The chapter explains Frequency Stabilization process and Locking of Cavities. It outlines the principles of the locking technique. The commonly used locking techniques include Pound-Drever-Hall Locking, tilt locking and optical injection locking.

DOI
10.1002/9783527695805.ch8

Related papers

The conversion of phase to amplitude fluctuations of a light beam by an optical cavity

Alessandro S. Villar

Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.

arXiv:0805.0528•American Journal of Physics•Sep 15, 2008•68 citations

Quantum Noise: Basic Measurements and Techniques

Hans‐A. Bachor, Timothy C. Ralph

This chapter contains sections titled: Detection and calibration of quantum noise Intensity noise The intensity noise eater Frequency stabilization, locking of cavities Injection locking

Wiley eBooks•Jan 28, 2004•0 citations

Study of phase-sensitive heterodyne locking

Peng Yang, Xuezhi Ke, Lei Zhang +1 more

Traditional locking techniques, such as PDH (Pound-Drever-Hall), HC (Hansh-Couillaud), spatial mode interference technique, offset sideband locking technique, quantum noise locking, etc., have been widely applied to laser frequency stabilization and precision optical interferometry measurement. Here, a new technique, which we call phase-sensitive heterodyne locking (PSHL), is investigated by use of frequency-synthesized light to obtain a phase-sensitive high-frequency photoelectric readout to lock the phase of a squeezed light. Comparing with above techniques, there are several kinds of advantages for PSHL to be advocated. Frequency-synthesized light, which allows arbitrary control of the amplitudes and phases of the modulation sidebands relative to the carrier, is derived by the AOM (acousto-optic modulator), not the EOM (electro-optic modulator). Interferometic signals coming from a balanced heterodyne detector are high-frequency AC photoelectric current which can easily get rid of low-frequency classical noise and lead to reach or break through the shot noise limit. A theoretical derivation of the PSHL error signal and the associated stability of the squeezed and anti-squeezed lock points will be carried out in this work.

Tenth International Conference on Information Optics and Photonics•Nov 1, 2021•0 citations

Locking the phase of balanced homodyne detection system for squeezed light

Zhang Yan, Xudong Yu, Ke Di Ma +2 more

The balanced homodyne detection technique is an important method to detect the quantum light field. The signal light injected into the phase sensitive optical parameter amplifier (OPA) is phase modulated. The output squeezed light of OPA is detected by the balanced homodyne detection system. When the phase sensitive OPA is operated at parametric amplification and deamplification respectively, we can judge which quadrature component of the quantum light field is measured by observing the modulation signal. We can demodulate the phase modulation signal to achieve the error signal, which is used to lock the relative phase of zero between the local and the quantum light fields (corresponding to the quadrature-amplitude of the unknown light field).

Acta Physica Sinica•Jan 1, 2013•8 citations

Introduction

Hans‐A. Bachor, Timothy C. Ralph

This introduction presents an overview of key concepts discussed in the subsequent chapters of this book. The book focuses on a classical model of light. It presents the properties of optical components and devices. The book provides a detailed description of lasers and amplifiers. It also presents a detailed discussion of photodetection for single photons and beams. The book explores the technical details required for reliable experimentation with quantum noise, including techniques such as cavity locking and feedback controller. It introduces the concept of squeezing is central to most attempts to improve optical devices beyond the quantum noise limit. The book describes the various squeezing experiments and discusses their results. It describes the applications of squeezed light with a detailed description of the largest application, the detection of gravitational waves. The book also discusses quantum non-demolition experiments.

Wiley eBooks•Jul 5, 2019•0 citations

Assumption-free measurement of the quantum state of light: Exploring the sidebands of intense fields

F. A. S. Barbosa, A. S. Coelho, K. N. Cassemiro +3 more

The quantum noise in photocurrent fluctuations usually gives incomplete information about the quantum state of spectral sideband modes of bright light beams involved in the detection. Each frequency component of the noise spectrum corresponds to two sideband modes symmetrically located around the bright optical field. In the case of the usual homodyne detection, it limits the ability to recover discriminated information of each mode involved. We theoretically show that complete reconstruction of the two-mode quantum state can be obtained by using phase-locked (coherent) resonator detection, even for non-Gaussian states. We experimentally demonstrate the technique by measuring a two-mode displaced coherent state.

Physical Review A•Dec 7, 2020•11 citations
This chapter focuses on the measurement of quantum noise, that is the fundamental noise we observe on the photocurrent when we detect optical beams with a large coherent amplitude using photodetectors. It also focuses on continuous wave laser beams and the noise associated with the intensity, amplitude, and phase of the light. Three different techniques are commonly used: direct detection, balanced detection, and homodyne detection. The choice depends on the properties of laser beam. Heterodyne detection is frequently used to determine the linewidth of an unknown laser. The intensity noise of a laser can be reduced using an electro-optic modulator and a feedback controller, known as a noise eater. The chapter explains Frequency Stabilization process and Locking of Cavities. It outlines the principles of the locking technique. The commonly used locking techniques include Pound-Drever-Hall Locking, tilt locking and optical injection locking.
Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.
Traditional locking techniques, such as PDH (Pound-Drever-Hall), HC (Hansh-Couillaud), spatial mode interference technique, offset sideband locking technique, quantum noise locking, etc., have been widely applied to laser frequency stabilization and precision optical interferometry measurement. Here, a new technique, which we call phase-sensitive heterodyne locking (PSHL), is investigated by use of frequency-synthesized light to obtain a phase-sensitive high-frequency photoelectric readout to lock the phase of a squeezed light. Comparing with above techniques, there are several kinds of advantages for PSHL to be advocated. Frequency-synthesized light, which allows arbitrary control of the amplitudes and phases of the modulation sidebands relative to the carrier, is derived by the AOM (acousto-optic modulator), not the EOM (electro-optic modulator). Interferometic signals coming from a balanced heterodyne detector are high-frequency AC photoelectric current which can easily get rid of low-frequency classical noise and lead to reach or break through the shot noise limit. A theoretical derivation of the PSHL error signal and the associated stability of the squeezed and anti-squeezed lock points will be carried out in this work.
The balanced homodyne detection technique is an important method to detect the quantum light field. The signal light injected into the phase sensitive optical parameter amplifier (OPA) is phase modulated. The output squeezed light of OPA is detected by the balanced homodyne detection system. When the phase sensitive OPA is operated at parametric amplification and deamplification respectively, we can judge which quadrature component of the quantum light field is measured by observing the modulation signal. We can demodulate the phase modulation signal to achieve the error signal, which is used to lock the relative phase of zero between the local and the quantum light fields (corresponding to the quadrature-amplitude of the unknown light field).
This introduction presents an overview of key concepts discussed in the subsequent chapters of this book. The book focuses on a classical model of light. It presents the properties of optical components and devices. The book provides a detailed description of lasers and amplifiers. It also presents a detailed discussion of photodetection for single photons and beams. The book explores the technical details required for reliable experimentation with quantum noise, including techniques such as cavity locking and feedback controller. It introduces the concept of squeezing is central to most attempts to improve optical devices beyond the quantum noise limit. The book describes the various squeezing experiments and discusses their results. It describes the applications of squeezed light with a detailed description of the largest application, the detection of gravitational waves. The book also discusses quantum non-demolition experiments.
The quantum noise in photocurrent fluctuations usually gives incomplete information about the quantum state of spectral sideband modes of bright light beams involved in the detection. Each frequency component of the noise spectrum corresponds to two sideband modes symmetrically located around the bright optical field. In the case of the usual homodyne detection, it limits the ability to recover discriminated information of each mode involved. We theoretically show that complete reconstruction of the two-mode quantum state can be obtained by using phase-locked (coherent) resonator detection, even for non-Gaussian states. We experimentally demonstrate the technique by measuring a two-mode displaced coherent state.