Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.
Very low intensity and phase fluctuations are present in a bright light field such as a laser beam. These subtle quantum fluctuations may be used to encode quantum information. Although intensity is easily measured with common photodetectors, accessing the phase information requires interference experiments. We introduce one such technique, the rotation of the noise ellipse of light, which employs an optical cavity to achieve the conversion of phase to intensity fluctuations. We describe the quantum noise of light and how it can be manipulated by employing an optical resonance technique and compare it to similar techniques, such as Pound–Drever–Hall laser stabilization and homodyne detection.
The quantum noise in photocurrent fluctuations usually gives incomplete information about the quantum state of spectral sideband modes of bright light beams involved in the detection. Each frequency component of the noise spectrum corresponds to two sideband modes symmetrically located around the bright optical field. In the case of the usual homodyne detection, it limits the ability to recover discriminated information of each mode involved. We theoretically show that complete reconstruction of the two-mode quantum state can be obtained by using phase-locked (coherent) resonator detection, even for non-Gaussian states. We experimentally demonstrate the technique by measuring a two-mode displaced coherent state.
Well-stabilized lasers emit radiation that is a close approximation to a coherent state: a classical mean field which varies sinusoidally in time at optical frequency ω0, superposed with broad-band noise fields due to the field's quantum uncertainty in its ground state (i.e. vacuum fluctuations). When detected by a standard photodetector, the interference between these vacuum fields and the coherent mean field causes the noise floor commonly referred to as the "shot-noise limit." The vacuum noise also causes fluctuations in the phase of the beam that are independent and uncorrelated with the amplitude fluctuations, and to which photodetectors are insensitive. The amplitude and phase fluctuations of the field can be represented by quadrature amplitudes X ^ A ( δ ) and X ^ ϕ ( δ ) which are the Fourier components of amplitude and phase modulation or fluctuation at a particular modulation frequency δ. These quadrature amplitudes are non-commuting quantum observables which obey the uncertainty principle.
Conventional devices for measuring the amplitude of a light wave absorb the light, thus destroying it. Recently, quantum nondemolition (QND) methods based on the optical Kerr effect have been shown capable of measuring optical amplitude fluctuations with near quantum-limited sensitivity.1 In these experiments, amplitude fluctuations of a signal beam are transferred to the phase fluctuation quadrature of a probe beam which co-propagates with the signal beam, by the intensity-dependent refractive index, without absorption of the signal beam. A pure Kerr nonlinearity can cause only phase modulation of the light wave, and the amplitude of the signal wave is preserved. Such methods should more properly be called back-action evading measurement schemes since the quantity being measured is not perturbed by the back-action that quantum mechanics requires for any measurement. The signal-to-noise ratio achieved in these experiments was limited by the small magnitude of the Kerr nonlinearity relative to the excess phase noise imposed on the probe beam by thermal light scattering processes in the glass fibers that were employed.
We present a cavity-enhanced optical absorption measurement technique based on high-bandwidth Pound-Drever-Hall (PDH) sideband locking, which naturally provides a real-time, resonant amplitude quadrature readout that can be mapped onto the cavity’s internal loss rate. Cavity-enhancement is widely used in the detection of small signals -- an optical cavity traps photons between two highly reflective mirrors, thereby enhancing the effective path length through the absorber [Romanini et al., 2014]. Most of the available techniques, however, probe transmission signals and/or do not provide the stability required for the detection of fast signals.To ensure optimal enhancement of absorption sensitivity, probe light must be locked on resonance with the cavity. PDH locking relies on phase modulation of a laser beam, creating two sidebands on the original carrier frequency [Black, 2001]. Upon reflection from a cavity, this modulated light produces a heterodyne signal (beat note) that can be detected and demodulated. We use the phase quadrature of the beat note to lock the cavity on resonance with one of the sidebands, achieving a locking bandwidth in the MHz range that keeps cavity and probe light resonant for hours [Reinhardt et al., 2017]. Simultaneously, we monitor the amplitude quadrature, which provides a continuous, real-time, heterodyne-amplified readout of the cavity’s internal absorption. Our PDH sideband cavity-enhanced absorption readout technique (SideCAR) ensures high sensitivity without reaching saturation limits in the intracavity medium by keeping a relatively low intracavity power, since only one of the sidebands is allowed to enter the cavity, but the signal is boosted above the detector noise by heterodyne detection (using the carrier as a local oscillator).This thesis presents the theoretical formulation of the sensing technique together with the expressions for the sensitivity limit (ultimately given by the laser quantum noise), and the experimental results from a test cavity setup. Probing a proof-of-concept 5-cm-long Fabry-Perot cavity with a coupled power of 160 uW, we measure an absorption sensitivity of 7*10^(-11) cm^(-1)/sqrt(Hz) at 100 kHz (roughly the cavity bandwidth), a factor of 11 from the shot-noise limit. This technique allows the detection of small, transient signals against absorptive backgrounds with sensitivity close to the shot noise limit using a reflection-based measurement in a fairly simple setup, opening the possibility of developing new microscopic single-port real-world sensors for transients, for example using micron-scale optical fiber cavities
According to quantum mechanics, there exists a class of observables for which is possible to confine the perturbation produced by a continuous measurement to the conjugate variable. Therefore, it is possible to devise experimental schemes that allow estimating the observed variable with arbitrary accuracy, or preparing it in a well-known state. Such schemes are referred to as quantum non-demolition measurements (QND). Among these observables there is the amplitude of the light field. Indeed, it is possible to exploit a movable mirror to implement a QND scheme [1]. Intensity fluctuations of an optical field impinging on it are not affected by the interaction. However, the movable mirror is excited by the associated radiation pressure. This, in turn, affects the phase of the field.
Information carried by an optical beam of light can usually be conveyed in the form of a temporal modulation of the intensity, phase, frequency or the polarization of the constituent mode(s). In that regard, homodyne detection is one of the most popular and standard method to measure the quantum mechanical properties of light Yuen & Shapiro (1978); Yuen et al. (1979); Yuen & Shapiro (1980); Yurke (1985). The quantum theory of homodyne detection originated principally from the works of Yuen and Shapiro et al. Yuen & Shapiro (1978); Yuen et al. (1979). In this method, a weak signal field is combined with a strong local oscillator field at a beam splitter, and the resulting signal is measured as a photocurrent. With the homodyne detection method, the quantum state of the signal field, such as the quadrature amplitude of the squeezed state, is easily measured Slusher et al. (1985); Wu et al. (1986 ); Polzik et al. (1992), and the quasiprobability distribution function can be measured by using the so-called optical homodyne tomography Smithey et al. (1993); Banaszek & W’odkiewicz (1996); Wallentowitz & Vogel (1996); Youn et al. (2001). Furthermore, optical homodyne detection is used to eavesdrop on the quantum key in quantum cryptography Hirano et al. (2000).