The influence of radio frequency microwaves on the Coulomb blockade characteristics in small Josephson junctions was studied using a one-dimensional array of ten small Al tunnel junctions in the frequency range from 1 MHz to 1000 MHz. Coulomb blockade voltage (
Vth) is diminished with increasing microwave power (
Vac), where the
Vth-
Vac plots for varied frequencies fall on a single curve. We observed and theoretically analyzed a magnetic field
dependent renormalization of the applied microwave power, in addition to a magnetic-field
independent renormalization effect explained using an effective circuit approach of the array. Due to its high sensitivity to microwave power, the array is well-suited for on-chip detection applications in low temperature environments.
This doctorate thesis focuses on the effects of the electromagnetic environment on applied electromagnetic fields in single small junctions as well as arrays. We apply radio-frequency (RF) microwaves in the sub-gigahertz frequency range on a one-dimensional array of small Josephson junctions exhibiting distinct Coulomb blockade characteristics. We observed a gradual lifting of Coulomb blockade with increase in the microwave power which we interpret is due to photon-assisted tunneling of Cooper pairs in the classical (multi-photon absorption) regime. We observe that, due to its high sensitivity to microwave power, the array is well-suited for in situ microwave detection applications in low temperature environments. A detailed analysis of the characteristics in the classical (multi-photon absorption) limit reveals that the microwave amplitude is rescaled (renormalized), which we attribute to the difference in dc and ac voltage response of the array. We proceed to rigorously consider the origin of the aforementioned renormalization effect by considering the effect of the electromagnetic environment of the Josephson junction on applied oscillating voltages. We theoretically demonstrate that its effect is simply to renormalize the amplitude of oscillation in a predictable manner traced to the physics of wave function renormalization (Lehmann weights) consistent with circuit-QED. We also introduce Einstein's A and B coefficients for small Josephson junctions, in a bid to relate the renormalization effect to the modification of photon absorption and emission amplitudes. Such renormalization implies that the sensitivity of the single junction and the array to oscillating electromagnetic fields (e.g. microwaves) is modulated and depends on the environmental impedance. The renormalization effect can be exploited to configure `opaque', `translucent' or `transparent' quantum circuits to microwaves.
The design, fabrication, and the characterization of a 0.5-V Josephson junction array device are presented for the quantum voltage standards in the National Institute of Metrology (NIM) of China. The device consists of four junction arrays, each of which has 1200 3-stacked Nb/Nb x Si1−x /Nb junctions and an on-chip superconducting microwave circuit which is mainly a power divider enabling each Josephson array being loaded with an equal amount of microwave power. A direct current (dc) quantum voltage of about 0.5 V with a ∼1-mA current margin of the 1st quantum voltage step is obtained. To further prove the quality of NIM device, a comparison between the NIM device with the National Institute of Standards and Technology (NIST) programmable Josephson voltage standard (PJVS) system device is conducted. The difference of the reproduced 0.5-V quantum voltage between the two devices is about 0.55 nV, which indicates good agreement between the two devices. With the homemade device, we have realized a precise and applicable 0.5-V applicable-level quantum voltage.