Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Instruments

Research on controlled delay light signal in optical waveguide

Bian Dai-quan

Published Jan 1, 2008• 0 citations
OpenAlex

Abstract

This article propose a kind of all-optical equivalent controlled light speed slowdown method in the optical waveguide,and carry out analysis combining with the imitative and experiment test result.Through the method making use of mask,Bragg gratings are written into the optical waveguide that is made by photorefractive crystal.Then the red beat-frequency laser signal,which are written into through the reverse side of the waveguide,invalidated part of the gratings and formed the moving cavity to save and transmission the signal.Through the method of changing beat-frequency signal′s group velocity,achieve the purpose of control the optical signal velocity.It provides a new method of equivalent light speed slowdown.

Related papers

Research on light signals extraordinary compressed using periodic structure modulated method in photorefractive materials

Mengchao Li, Yanmin Li, Gang Zheng +1 more

During some high processing, such as high-speed photography and so on, the encode pulse or driving signal must be compressed with full optics system. According to the light speed can be slowed down in a photorefractive crystal bar in which written volume-index grating by two laser beam, so as to the light signal may be transmitted in slow speed under 1/ 7 of light speed in vacuum. Because the genesis of the phenomenon is the inner index periodic structure, so the out put signal compressed may be realized through erasing the periodic structure in the opposite direction of signal beam using another laser beam when the signal light transmitting the crystal bar. However, every finite signal stream can be further compressed by the same way again. Different erasing method would get many kinds of out put signal to adapt to various design.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 26, 2007•0 citations

Photorefractive induced slowdown of nanosecond light pulses in the nanosecond regime

Nacera Bouldja, A. A. Grabar, Marc Sciamanna +1 more

Recently, several works have shown that the light group velocity can be reduced using the recording of dynamic refractive index gratings in photorefractive (PR) crystals [1] , [2] , [3] . The slowdown of light is performed using optical beams wave mixing: it yields the output pulse amplification and increases the light dispersion inside the PR crystal. For example, the TWM method demonstrated that the delay time ∆ τ can be varied as a function of the TWM gain values Γ and the input pulse widths T 0 . However, several works have shown that the results achieved by this method are limited in terms of pulse duration. Indeed, only long pulses with time duration of ms−s can be slowdown in a PR crystal both at the visible and the infrared wavelengths [4] .

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 21, 2021•0 citations

Slow Light Characteristics of Fiber Bragg Gratings

Shang Yun-b

The influence of grating length and fringe visibility for slow light of fiber Bragg gratings were investigated by numerical simulation method,and slow light after optimizing the parameters was proposed emphatically.The results showed that the slow light delay increases with grating length and modulation depth,and change rates increases gradually.A certain bandwidth of resonance peaks on both sides of the side lobe and the peak top become extremely flattened.The slow light delay curves are red-shifted and short wave strengths increase to the opposite direction.The right side of the center frequency spectrum side band has a great vibration.By optimizing the structure parameters,the maximum group velocity can be lowed to c/98.This provides theoretical basis for designing the slow light devices based on fiber Bragg gratings.

Journal of Lanzhou University of Arts and Science•Jan 1, 2014•0 citations

Slow Light Based on Semiconductor Optical Amplifier

胡苗苗 HU Miao-miao, 王肇颖 Wang Zhaoying, 杨天新 YANG Tian-xin +1 more

In the semiconductor optical amplifer,based on the theory of four wave mixing effect and refractive modulation-index generated by equivalent grating,dynamic changes of the signal light time delay with the outside controllable parameters,such as the injection current into semiconductor optical amplifier(SOA),the pump light power,the detuning frequency between pump light and signal light,were numerically simulated by the method of subsections model of SOA.Compared with the former simulation of slow light from the slow down factor view,this method has the advantage of associating the signal time delay with outside controllable parameters and providing the intuitional guidce for the experiment.Meanwhile,the method by subsections model of SOA has higher accuracy.Compared with the existing experimental results,it indicates that the numerically simulated results agree well with the measurements.

ACTA PHOTONICA SINICA•Jan 1, 2011•0 citations

Slow light using photorefractive nonlinear optics

Nacera Bouldja, Marc Sciamanna, Delphine Wolfersberger

Slow and fast light are achieved in two experiments using SPS photorefractive crystal at room temperature. We report that the photorefractive gain achieved by the two wave mixing (TWM) method can control the group velocity of the transmitted light pulses at visible wavelength. It is shown theoretically and experimentally that the time delay and the shape of the output pulse change as a function of the photorefractive gain. The beam fanning has also been used to control the velocity propagation of a single light pulse in the same crystal at λ = 1064 nm. Depending on the orientation of the polar axis, it is possible to accelerate or decelerate a short pulse with duration of order of μs in the crystal.

SPIE Conference on Nonlinear Optics and its Applications•Apr 1, 2020•1 citation

Experimental observation of the slowdown of optical beams by a volume-index grating in a photorefractive LiNbO_3 crystal

Shiuan Huei Lin, Ken Y. Hsu, Pochi Yeh

We investigate the group velocity of light in a one-dimensional volume-index grating inside a photorefractive LiNbO(3) crystal. The slowdown of the group electromagnetic propagation is observed experimentally by tuning of the wave number of the optical beam close to the outside edge of the forbidden bandgap. We obtain a large group index of up to 7.5 in a 3.5-cm crystal sample. The group index is compared with the result of a theoretical derivation. The results are presented and discussed.

Optics Letters•Nov 1, 2000•43 citations
This article propose a kind of all-optical equivalent controlled light speed slowdown method in the optical waveguide,and carry out analysis combining with the imitative and experiment test result.Through the method making use of mask,Bragg gratings are written into the optical waveguide that is made by photorefractive crystal.Then the red beat-frequency laser signal,which are written into through the reverse side of the waveguide,invalidated part of the gratings and formed the moving cavity to save and transmission the signal.Through the method of changing beat-frequency signal′s group velocity,achieve the purpose of control the optical signal velocity.It provides a new method of equivalent light speed slowdown.
During some high processing, such as high-speed photography and so on, the encode pulse or driving signal must be compressed with full optics system. According to the light speed can be slowed down in a photorefractive crystal bar in which written volume-index grating by two laser beam, so as to the light signal may be transmitted in slow speed under 1/ 7 of light speed in vacuum. Because the genesis of the phenomenon is the inner index periodic structure, so the out put signal compressed may be realized through erasing the periodic structure in the opposite direction of signal beam using another laser beam when the signal light transmitting the crystal bar. However, every finite signal stream can be further compressed by the same way again. Different erasing method would get many kinds of out put signal to adapt to various design.
Recently, several works have shown that the light group velocity can be reduced using the recording of dynamic refractive index gratings in photorefractive (PR) crystals [1] , [2] , [3] . The slowdown of light is performed using optical beams wave mixing: it yields the output pulse amplification and increases the light dispersion inside the PR crystal. For example, the TWM method demonstrated that the delay time ∆ τ can be varied as a function of the TWM gain values Γ and the input pulse widths T 0 . However, several works have shown that the results achieved by this method are limited in terms of pulse duration. Indeed, only long pulses with time duration of ms−s can be slowdown in a PR crystal both at the visible and the infrared wavelengths [4] .
The influence of grating length and fringe visibility for slow light of fiber Bragg gratings were investigated by numerical simulation method,and slow light after optimizing the parameters was proposed emphatically.The results showed that the slow light delay increases with grating length and modulation depth,and change rates increases gradually.A certain bandwidth of resonance peaks on both sides of the side lobe and the peak top become extremely flattened.The slow light delay curves are red-shifted and short wave strengths increase to the opposite direction.The right side of the center frequency spectrum side band has a great vibration.By optimizing the structure parameters,the maximum group velocity can be lowed to c/98.This provides theoretical basis for designing the slow light devices based on fiber Bragg gratings.
In the semiconductor optical amplifer,based on the theory of four wave mixing effect and refractive modulation-index generated by equivalent grating,dynamic changes of the signal light time delay with the outside controllable parameters,such as the injection current into semiconductor optical amplifier(SOA),the pump light power,the detuning frequency between pump light and signal light,were numerically simulated by the method of subsections model of SOA.Compared with the former simulation of slow light from the slow down factor view,this method has the advantage of associating the signal time delay with outside controllable parameters and providing the intuitional guidce for the experiment.Meanwhile,the method by subsections model of SOA has higher accuracy.Compared with the existing experimental results,it indicates that the numerically simulated results agree well with the measurements.
Slow and fast light are achieved in two experiments using SPS photorefractive crystal at room temperature. We report that the photorefractive gain achieved by the two wave mixing (TWM) method can control the group velocity of the transmitted light pulses at visible wavelength. It is shown theoretically and experimentally that the time delay and the shape of the output pulse change as a function of the photorefractive gain. The beam fanning has also been used to control the velocity propagation of a single light pulse in the same crystal at λ = 1064 nm. Depending on the orientation of the polar axis, it is possible to accelerate or decelerate a short pulse with duration of order of μs in the crystal.