Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Research on light signals extraordinary compressed using periodic structure modulated method in photorefractive materials

Mengchao Li, Yanmin Li, Gang Zheng, Songlin Zhuang

Published Jan 26, 2007• 0 citations
Publisher

Abstract

During some high processing, such as high-speed photography and so on, the encode pulse or driving signal must be compressed with full optics system. According to the light speed can be slowed down in a photorefractive crystal bar in which written volume-index grating by two laser beam, so as to the light signal may be transmitted in slow speed under 1/ 7 of light speed in vacuum. Because the genesis of the phenomenon is the inner index periodic structure, so the out put signal compressed may be realized through erasing the periodic structure in the opposite direction of signal beam using another laser beam when the signal light transmitting the crystal bar. However, every finite signal stream can be further compressed by the same way again. Different erasing method would get many kinds of out put signal to adapt to various design.

DOI
10.1117/12.725503

Related papers

Research on controlled delay light signal in optical waveguide

Bian Dai-quan

This article propose a kind of all-optical equivalent controlled light speed slowdown method in the optical waveguide,and carry out analysis combining with the imitative and experiment test result.Through the method making use of mask,Bragg gratings are written into the optical waveguide that is made by photorefractive crystal.Then the red beat-frequency laser signal,which are written into through the reverse side of the waveguide,invalidated part of the gratings and formed the moving cavity to save and transmission the signal.Through the method of changing beat-frequency signal′s group velocity,achieve the purpose of control the optical signal velocity.It provides a new method of equivalent light speed slowdown.

Optical Instruments•Jan 1, 2008•0 citations

Detection of phase-modulated optical signals through two-wave mixing in photorefractive materials

L. Boutsikaris, Fred Davidson

Two-wave mixing in photorefractive crystals has been shown to combine coherently a modulated optical signal beam with a strong pump optical field.’ For a phase-modulated signal beam, the induced index of refraction phase grating inside the crystal yields a coupling of the optical fields of the pump and signal so that subsequent intensity detection results in apparent intensity modulation of the transmitted signal or pump beams. This provides an easy way to detect phase differences between two optical beams. Some of the advantages the above scheme offers over commonly used coherent optical phase detection schemes are: no loss of 3 dB in the signal beam intensity at the 50/50 beam splitter (used to combine signal and local oscillator fields); automatic alignment of the index of refraction grating with the two incident optical wavefronts; insensitivity to slow random changes in the phases of both beams. Experimental results are given, and a new definition for the resulting mixing gain for the phase-modulated beam is introduced, through which optimal conditions for input beam intensity ratios can be found. Applications to coherent homodyne detection are discussed.

Annual Meeting Optical Society of America•Jan 1, 1988•0 citations

Coherent optical detection through two-wave mixing in photorefractive materials

F. Davidson, Michael A. Krainak, L. Boutsikaris

Photorefractively induced index-of-refraction phase gratings are shown to combine coherently the optical fields of a strong pump and a suitably amplitude- or phase-modulated signal beam in such a way that an apparent amplification of the modulating waveform appears as intensity modulation of the transmitted signal and pump beam intensities. The source of the signal gain is shown to be the square-law (intensity) detection of the coherently combined pump and modulated signal beams, just as in coherent optical communication systems in which a strong local-oscillator field is coherently added with a weak optical signal field by a beam splitter.

Optics Letters•Jun 1, 1988•22 citations

Manipulation of fast light using photorefractive beam fanning

A. A. Grabar, P. Mathey, Grégory Gadret

Light pulse group velocity manipulations due to the specific dispersion of a medium (so-called “slow” and “fast” light phenomena) can be obtained on the basis of several mechanisms. One of these techniques is two-wave mixing in a photorefractive crystal. This work presents a modification of this method, exploiting the strong beam fanning in Sb-doped Sn2P2S6 crystals. Our experimental results demonstrate a “fast light” behavior of Gaussian pulses transmitted through a Sn2P2S6:Sb sample. The phenomenon is due to the beam fanning (i.e., the self-diffraction of the incident beam on self-induced noisy photorefractive gratings) that ensures a significant depletion of the input beam. Due to the relatively fast photorefractive response of the Sn2P2S6:Sb crystals this depletion occurs with times in the range of 10–100 ms, depending on the beam intensity, and the “fast light” feature is observed. The temporal and amplitude characteristics of the output beam are measured in function of the intensity and polarization azimuth of the incident beam. Besides, a negative phase shift of the periodical output beam relative to a sinusoidal intensity-modulated input beam is also obtained experimentally. It is shown that the phase and amplitude relation between the input and output periodic signals are described by a simple analytical expression that takes into account the beam fanning strength (depletion factor) and its dynamics (depletion time constant). It is also demonstrated that the pulse advance (or phase shift of the modulated signal) can be regulated by the light polarization azimuth. The advantages of the proposed method are discussed.

Journal of the Optical Society of America B•Apr 4, 2014•15 citations

Slow light with photorefractive four-wave mixing

P. Mathey, Grégory Gadret, Konstantin Shcherbin

A slowing down of light pulses using backward-wave four-wave mixing is achieved in photorefractive crystals with different coupling strength. The delay and width of the output pulse are studied as a function of the input pulse width and pump intensity ratio for the amplified transmitted beam and for the phase-conjugated beam. The delay characteristics are compared with those of the two-beam coupling. It is demonstrated that the four-wave mixing process ensures a larger slowing down of short pulses (pulses with width shorter than the photorefractive response time) as compared to the photorefractive two-beam coupling scheme and guarantees the elimination of forerunners. The delay of long pulses in the four-wave mixing configuration is almost the same as the one that can be reached with two-beam coupling. The effect of absorption on the nonlinear shape transformation of the output pulses is discussed qualitatively.

Physical Review A•Dec 1, 2011•12 citations

Slow light in photorefractive phase-engineered index structures

Wolfgang Horn, Jan v Bassewitz, Cornelia Denz

We investigate all-optical tunable index structures, induced in photorefractive materials for the observation of room-temperature slow light. The potential of this technique lies in the possibility of reconfiguration in different spectral windows at low pump intensities and transmission properties comparable to fiber-based resonant delay-lines [1]. Volume-holographic gratings offer low insertion loss and narrow bandwidth selectivity but are nearly insensitive to photo-induced damage in the NIR, thus making them suitable for telecom applications, e.g. WDM filters [2]. The narrow spectral features of the thick volume gratings produce a steep slope in the dispersion which can be considered as the basis of all slow-light experiments. Investigations of increased group index of single band-stop configurations in photorefractive materials without gain have proven this concept [3,4].

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2009•0 citations
During some high processing, such as high-speed photography and so on, the encode pulse or driving signal must be compressed with full optics system. According to the light speed can be slowed down in a photorefractive crystal bar in which written volume-index grating by two laser beam, so as to the light signal may be transmitted in slow speed under 1/ 7 of light speed in vacuum. Because the genesis of the phenomenon is the inner index periodic structure, so the out put signal compressed may be realized through erasing the periodic structure in the opposite direction of signal beam using another laser beam when the signal light transmitting the crystal bar. However, every finite signal stream can be further compressed by the same way again. Different erasing method would get many kinds of out put signal to adapt to various design.
This article propose a kind of all-optical equivalent controlled light speed slowdown method in the optical waveguide,and carry out analysis combining with the imitative and experiment test result.Through the method making use of mask,Bragg gratings are written into the optical waveguide that is made by photorefractive crystal.Then the red beat-frequency laser signal,which are written into through the reverse side of the waveguide,invalidated part of the gratings and formed the moving cavity to save and transmission the signal.Through the method of changing beat-frequency signal′s group velocity,achieve the purpose of control the optical signal velocity.It provides a new method of equivalent light speed slowdown.
Two-wave mixing in photorefractive crystals has been shown to combine coherently a modulated optical signal beam with a strong pump optical field.’ For a phase-modulated signal beam, the induced index of refraction phase grating inside the crystal yields a coupling of the optical fields of the pump and signal so that subsequent intensity detection results in apparent intensity modulation of the transmitted signal or pump beams. This provides an easy way to detect phase differences between two optical beams. Some of the advantages the above scheme offers over commonly used coherent optical phase detection schemes are: no loss of 3 dB in the signal beam intensity at the 50/50 beam splitter (used to combine signal and local oscillator fields); automatic alignment of the index of refraction grating with the two incident optical wavefronts; insensitivity to slow random changes in the phases of both beams. Experimental results are given, and a new definition for the resulting mixing gain for the phase-modulated beam is introduced, through which optimal conditions for input beam intensity ratios can be found. Applications to coherent homodyne detection are discussed.
Photorefractively induced index-of-refraction phase gratings are shown to combine coherently the optical fields of a strong pump and a suitably amplitude- or phase-modulated signal beam in such a way that an apparent amplification of the modulating waveform appears as intensity modulation of the transmitted signal and pump beam intensities. The source of the signal gain is shown to be the square-law (intensity) detection of the coherently combined pump and modulated signal beams, just as in coherent optical communication systems in which a strong local-oscillator field is coherently added with a weak optical signal field by a beam splitter.
Light pulse group velocity manipulations due to the specific dispersion of a medium (so-called “slow” and “fast” light phenomena) can be obtained on the basis of several mechanisms. One of these techniques is two-wave mixing in a photorefractive crystal. This work presents a modification of this method, exploiting the strong beam fanning in Sb-doped Sn2P2S6 crystals. Our experimental results demonstrate a “fast light” behavior of Gaussian pulses transmitted through a Sn2P2S6:Sb sample. The phenomenon is due to the beam fanning (i.e., the self-diffraction of the incident beam on self-induced noisy photorefractive gratings) that ensures a significant depletion of the input beam. Due to the relatively fast photorefractive response of the Sn2P2S6:Sb crystals this depletion occurs with times in the range of 10–100 ms, depending on the beam intensity, and the “fast light” feature is observed. The temporal and amplitude characteristics of the output beam are measured in function of the intensity and polarization azimuth of the incident beam. Besides, a negative phase shift of the periodical output beam relative to a sinusoidal intensity-modulated input beam is also obtained experimentally. It is shown that the phase and amplitude relation between the input and output periodic signals are described by a simple analytical expression that takes into account the beam fanning strength (depletion factor) and its dynamics (depletion time constant). It is also demonstrated that the pulse advance (or phase shift of the modulated signal) can be regulated by the light polarization azimuth. The advantages of the proposed method are discussed.
A slowing down of light pulses using backward-wave four-wave mixing is achieved in photorefractive crystals with different coupling strength. The delay and width of the output pulse are studied as a function of the input pulse width and pump intensity ratio for the amplified transmitted beam and for the phase-conjugated beam. The delay characteristics are compared with those of the two-beam coupling. It is demonstrated that the four-wave mixing process ensures a larger slowing down of short pulses (pulses with width shorter than the photorefractive response time) as compared to the photorefractive two-beam coupling scheme and guarantees the elimination of forerunners. The delay of long pulses in the four-wave mixing configuration is almost the same as the one that can be reached with two-beam coupling. The effect of absorption on the nonlinear shape transformation of the output pulses is discussed qualitatively.
We investigate all-optical tunable index structures, induced in photorefractive materials for the observation of room-temperature slow light. The potential of this technique lies in the possibility of reconfiguration in different spectral windows at low pump intensities and transmission properties comparable to fiber-based resonant delay-lines [1]. Volume-holographic gratings offer low insertion loss and narrow bandwidth selectivity but are nearly insensitive to photo-induced damage in the NIR, thus making them suitable for telecom applications, e.g. WDM filters [2]. The narrow spectral features of the thick volume gratings produce a steep slope in the dispersion which can be considered as the basis of all slow-light experiments. Investigations of increased group index of single band-stop configurations in photorefractive materials without gain have proven this concept [3,4].