Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Optics

The Optimal Transmissivity of Inhomogeneously Broadened Single-mode Laser

Tang Hui-rong

Published Jan 1, 2004• 0 citations
OpenAlex

Abstract

The expressions and distribution curves of the optimal transmissivity for four-level inhomogeneously broadened single-mode laser are given, and then compares them with those of homogeneously broadened single-mode laser.The characteristics of the inhomogeneously broadened single-mode laser are described.

Related papers

Three-mode laser action in an inhomogeneously broadened medium

Shanting Hu

Lamb's quantum theory of lasers is extended to deal with the three-mode laser operation in an in homogeneously broadened solid medium consisting of four-level atoms. The master equation, the operation characteristics and the line-width of the three-mode laser are obtained and discussed. The relevant experimental result is explained and effects of inhomogeneous broadening are studied.

Acta Optica Sinica•Jan 1, 1986•0 citations

Photon number distributions for an inhomogeneously broadened laser with an absorber

Mansour Mortazavi, Surendra Singh

An equation of motion for the density matrix of the field of an inhomogeneously broadened single-mode laser containing a saturable absorber is derived. Using the photon number representation this equation is solved in the steady state. High-intensity photon number distributions are obtained for the on-resonance operation of the laser. Off-resonance operation is also considered. Curves are presented to illustrate the behavior, and the results are compared with earlier investigations.

Annual Meeting Optical Society of America•Jan 1, 1987•0 citations

Conditions for the appearance of an optical instability of a laser with a saturable absorber and an inhomogeneously broadened line

Dinh Van Hoang, Vo Duc Luong

An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.

Soviet Journal of Quantum Electronics•Sep 30, 1987•2 citations

Inhomogeneous broadening

Luigi Lugiato, Franco Prati, Massimo Brambilla

Up to this point we have always assumed that all the atoms which interact with the radiation field have the same atomic transition frequency, with an atomic linewidth given by γ ⊥ . This configuration is called homogeneous broadening. However, in the great majority of lasers the linewidth is inhomogeneously broadened , because the atomic frequency follows a distribution. For example, in solid-state lasers such as the ruby laser and fiber lasers the inhomogeneity is due to the imperfections in the crystalline structure of the material. In gas lasers, where the atoms or molecules are free to move, the inhomogeneous broadening is due to the Doppler effect, for which a molecule moving with velocity v in a field of frequency ω and wave vector k experiences an effective frequency ω ′ = ω − k · v [8]. Since what matters is the difference between the atomic transition frequency and the field frequency, we can keep the field frequency fixed and imagine that the field interacts with different groups of atoms that move with different velocities and therefore have different transition frequencies. The realistic velocity distribution is a Gaussian, for which the corresponding distribution for the modulus of the velocity is Maxwellian. However, in the following we will mainly analyze the case of a Lorentzian distribution for the atomic transition frequency, because this allows an analytical treatment. Again for the sake of simplicity, we will limit our analysis to the case of a ring cavity. In Section 15.1 we will generalize to the inhomogeneous-broadening configuration the modal equations for the case of homogeneous broadening, which were formulated in Chapter 12. In Section 15.2 we will specialize to the single-mode model and discuss its stationary solutions for the laser case. Multimode dynamical equations The atomic transition frequency of the generic group of atoms is given by ω a + δ D , where ω a is the central atomic frequency and δ D takes positive and negative values. We call ω c the frequency of the cavity mode nearest to ω a and denote by δ ac the difference ω a − ω c .

Cambridge University Press eBooks•Feb 28, 2015•2 citations

Laser intracavity absorption

Helen K. Holt

The characteristics of a laser with an intracavity absorption cell have been calculated for the case in which the gain atoms are homogeneously broadened and the absorber atoms are inhomogeneously broadened. The sensitivity of the laser intensity to the density of absorbers is determined.

Physical Review A•Feb 1, 1975•16 citations

Single-mode and multimode operation in inhomogeneously broadened lasers

Luigi A. Lugiato, Franco Prati, Massimo Brambilla

The instabilities in homogeneously broadened lasers, which we described in the previous chapter, have a paradigmatic importance because they arise in models which allow one to perform the linear-stability analysis in a simple analytic form. The treatment of the corresponding instabilities in the case of in homogeneously broadened lasers is substantially more complex in general. However, it is very interesting because, as we shall see, the instabilities arise in parametric domains that are much more accessible from the experimental viewpoint. A related issue is that of the possibility of multimodal emission in a laser. It is common knowledge that in order to attain multimode emission it is necessary to have a sort of in homogeneity in the gain medium, because in a completely homogeneous configuration all modes interact with all atoms, and the arising competition among modes implies that only one of them survives. There are basically two main kinds of in homogeneity, the first is of spatial nature and the other is of spectral nature. The first kind is realized in Fabry–Perot lasers, because different cavity modes interact with atoms at different spatial positions in the cavity thanks to the standing-wave configuration of the field and to the consequent phenomenon of spatial hole- burning (see Section 14.2 and Fig. 14.1). This circumstance is capable of weakening the mode–mode competition and allowing multimode operation. In unidirectional ring lasers, on the other hand, there is an “inhomogeneous” configuration in the case of inhomogeneous broadening, because different groups of atoms have different transition frequencies and therefore interact with different modes thanks to the spectral hole-burning (see Section 15.2 and Fig. 15.3). Again, this weakens the mode–mode competition and allows multimode operation. However, these are qualitative considerations, and the only reliable and quantitative method to determine the possibility of multimodal operation is the linear-stability analysis of the single-mode stationary solutions.

Cambridge University Press eBooks•Feb 28, 2015•0 citations
An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.
Up to this point we have always assumed that all the atoms which interact with the radiation field have the same atomic transition frequency, with an atomic linewidth given by γ ⊥ . This configuration is called homogeneous broadening. However, in the great majority of lasers the linewidth is inhomogeneously broadened , because the atomic frequency follows a distribution. For example, in solid-state lasers such as the ruby laser and fiber lasers the inhomogeneity is due to the imperfections in the crystalline structure of the material. In gas lasers, where the atoms or molecules are free to move, the inhomogeneous broadening is due to the Doppler effect, for which a molecule moving with velocity v in a field of frequency ω and wave vector k experiences an effective frequency ω ′ = ω − k · v [8]. Since what matters is the difference between the atomic transition frequency and the field frequency, we can keep the field frequency fixed and imagine that the field interacts with different groups of atoms that move with different velocities and therefore have different transition frequencies. The realistic velocity distribution is a Gaussian, for which the corresponding distribution for the modulus of the velocity is Maxwellian. However, in the following we will mainly analyze the case of a Lorentzian distribution for the atomic transition frequency, because this allows an analytical treatment. Again for the sake of simplicity, we will limit our analysis to the case of a ring cavity. In Section 15.1 we will generalize to the inhomogeneous-broadening configuration the modal equations for the case of homogeneous broadening, which were formulated in Chapter 12. In Section 15.2 we will specialize to the single-mode model and discuss its stationary solutions for the laser case. Multimode dynamical equations The atomic transition frequency of the generic group of atoms is given by ω a + δ D , where ω a is the central atomic frequency and δ D takes positive and negative values. We call ω c the frequency of the cavity mode nearest to ω a and denote by δ ac the difference ω a − ω c .
The instabilities in homogeneously broadened lasers, which we described in the previous chapter, have a paradigmatic importance because they arise in models which allow one to perform the linear-stability analysis in a simple analytic form. The treatment of the corresponding instabilities in the case of in homogeneously broadened lasers is substantially more complex in general. However, it is very interesting because, as we shall see, the instabilities arise in parametric domains that are much more accessible from the experimental viewpoint. A related issue is that of the possibility of multimodal emission in a laser. It is common knowledge that in order to attain multimode emission it is necessary to have a sort of in homogeneity in the gain medium, because in a completely homogeneous configuration all modes interact with all atoms, and the arising competition among modes implies that only one of them survives. There are basically two main kinds of in homogeneity, the first is of spatial nature and the other is of spectral nature. The first kind is realized in Fabry–Perot lasers, because different cavity modes interact with atoms at different spatial positions in the cavity thanks to the standing-wave configuration of the field and to the consequent phenomenon of spatial hole- burning (see Section 14.2 and Fig. 14.1). This circumstance is capable of weakening the mode–mode competition and allowing multimode operation. In unidirectional ring lasers, on the other hand, there is an “inhomogeneous” configuration in the case of inhomogeneous broadening, because different groups of atoms have different transition frequencies and therefore interact with different modes thanks to the spectral hole-burning (see Section 15.2 and Fig. 15.3). Again, this weakens the mode–mode competition and allows multimode operation. However, these are qualitative considerations, and the only reliable and quantitative method to determine the possibility of multimodal operation is the linear-stability analysis of the single-mode stationary solutions.