We investigate the secure energy efficiency of a cooperative network where two legitimate users (Alice and Bob) communicate with the help of a relay node, in the presence of a passive eavesdropper (Eve). Power is adequately allocated between Alice and the relay using a Dinkelbach-based iterative power allocation algorithm. We assume channel state information of the legitimate channel only and compare the secure energy efficiency of several cooperative schemes, namely, selective decode-and-forward (SDF), fixed decode-and-forward (DF), amplify-and-forward (AF) and cooperative jamming (CJ). Our results show that, in terms of secure energy efficiency, SDF outperforms the other cooperative schemes in many scenarios. However, when the transmit rate increases or when Eve is close to the legitimate nodes, CJ stands out as the most advantageous scheme.
We investigate the secure energy efficiency of a cooperative network where two legitimate users (Alice and Bob) communicate with the help of a relay node, in the presence of a passive eavesdropper (Eve). Power is adequately allocated between Alice and the relay using a Dinkelbach-based iterative power allocation algorithm. We assume channel state information of the legitimate channel only and compare the secure energy efficiency of several cooperative schemes, namely, selective decode-and-forward (SDF), fixed decode-and-forward (DF), amplify-and-forward (AF) and cooperative jamming (CJ). Our results show that, in terms of secure energy efficiency, SDF outperforms the other cooperative schemes in many scenarios. However, when the transmit rate increases or when Eve is close to the legitimate nodes, CJ stands out as the most advantageous scheme.
This paper evaluates the secure energy efficiency (SEE) of a cooperative network subject to partial secrecy requirements, implemented through a fractional equivocation parameter θ ∈ (0, 1] that allows partial secrecy when θ <; 1. We assume that only the channel state information (CSI) of the legitimate channel is available, while the CSI with respect to the eavesdropper is unknown. Then, we propose a CSI-aided decode-and-forward (DF) scheme, in which the transmitter uses the available CSI in order to choose between direct and cooperative paths. Moreover, the relay employs either repetition coding (CSI-RC), i.e., source and relay use the same codebook, or parallel coding (CSI-PC), when different codebooks are used. By resorting to the Dinkelbach algorithm, we propose a joint power allocation scheme, which also optimizes θ to maximize the SEE. Our schemes are compared with the traditional DF, amplify- and-forward, and cooperative jamming (CJ). In most scenarios, CSI-RC performs best in terms of SEE. Nevertheless, we observe that CSI-PC achieves the highest SEE when θ → 1 and if the relay is close to either the transmitter or the receiver. Moreover, CJ also stands out to maximize the SEE if the relay is placed closer to the eavesdropper. In addition, the influence of θ in the system performance is evaluated, showing that a joint θ and power optimization considerably improves the SEE.
In this letter, we investigate the secure energy efficiency (SEE) in a cooperative scenario where all nodes are equipped with multiple antennas. Moreover, we employ secrecy rate and power allocation at Alice and at the relay in order to maximize the SEE, subjected to a constraint in terms of a minimal required secrecy outage probability. Only the channel state information (CSI) with respect to the legitimate nodes is available. Then, we compare the artificial-noise (AN) scheme with CSI-aided decode-and-forward (CSI-DF), which exploits the CSI to choose the best communication path (direct or cooperative). Our results show that CSI-DF outperforms AN in terms of SEE in most scenarios, except when eavesdropper (Eve) is closer to the relay or with the increase of antennas at Eve. Additionally, we also show that the maximization of SEE implies in an optimal number of antennas to be used at each node, which is due to the tradeoff between secure throughput and power consumption.
The growing demand for wireless communications systems makes security an important and difficult design task. Therefore, in this thesis we approached different studies at physical layer security considering different scenarios of partial secrecy requirements, multiple antennas and finite blocklenghts. With respect to the partial secrecy regime, we evaluate the secure energy efficiency (SEE) of a cooperative network subject to partial secrecy requirements, implemented through a fractional equivocation parameter θ ϵ (0, 1] that allows partial secrecy when θ < 1. We assume that only the channel state information (CSI) of the legitimate channel is available, while the CSI with respect to the eavesdropper is unknown. Then, we propose a CSI-Aided Decode-and-Forward (DF) scheme, in which the transmitter uses the available CSI in order to choose between direct and cooperative paths. Moreover, the relay employs either Repetition Coding (CSI-RC), i.e., source and relay use the same codebook, or Parallel Coding (CSI-PC), when different codebooks are used. By resorting to the Dinkelbach algorithm, we propose a joint power allocation scheme, which also optimizes θ to maximize the SEE. Our schemes are compared with the traditional DF, Amplify-and-Forward (AF), and Cooperative Jamming (CJ). Extending the previous analysis, we also study the SEE in a cooperative scenario where all nodes are equipped with multiple antennas. Moreover, we employ secrecy rate and power allocation at Alice and at the relay in order to maximize the SEE, subjected to a constraint in terms of a minimal required secrecy outage probability. Considering this MIMO scenario in which only the CSI with respect to the legitimate nodes is available at Alice, we compare the Artificial-Noise (AN) scheme with CSI-Aided Decode-and-Forward (CSI-DF). Lastly, considering a more restrictive scenario with respect to the CSI, but more realistic, in which the legitimate transmitter has no knowledge of the instantaneous channel state information with respect to neither the legitimate receiver nor the eavesdropper, we investigate the secure throughput in a delay-critical scenario, such as in some applications of machine-to-machine communications, so that users communicate with a finite blocklength. In this approach, the performance of direct and selective decode-and-forward cooperative communication strategies are compared.
Physical (PHY) layer security approaches for wireless communications can prevent eavesdropping without upper layer data encryption. However, they are hampered by wireless channel conditions: absent feedback, they are typically feasible only when the source-destination channel is better than the source-eavesdropper channel. Node cooperation is a means to overcome this challenge and improve the performance of secure wireless communications. This paper addresses secure communications of one source-destination pair with the help of multiple cooperating relays in the presence of one or more eavesdroppers. Three cooperative schemes are considered: decode-and-forward (DF), amplify-and-forward (AF), and cooperative jamming (CJ). For these schemes, the relays transmit a weighted version of a reencoded noise-free message signal (for DF), a received noisy source signal (for AF), or a common jamming signal (for CJ). Novel system designs are proposed, consisting of the determination of relay weights and the allocation of transmit power, that maximize the achievable secrecy rate subject to a transmit power constraint, or, minimize the transmit power subject to a secrecy rate constraint. For DF in the presence of one eavesdropper, closed-form optimal solutions are derived for the relay weights. For other problems, since the optimal relay weights are difficult to obtain, several criteria are considered leading to suboptimal but simple solutions, i.e., the complete nulling of the message signals at all eavesdroppers (for DF and AF), or the complete nulling of jamming signal at the destination (for CJ). Based on the designed relay weights, for DF in the presence of multiple eavesdroppers, and for CJ in the presence of one eavesdropper, the optimal power allocation is obtained in closed-form; in all other cases the optimal power allocation is obtained via iterative algorithms. Numerical evaluation of the obtained secrecy rate and transmit power results show that the proposed design can significantly improve the performance of secure wireless communications.
In a cooperative wireless network, we exploited node cooperation for achieving physical layer based security. In this paper, the case of one source-destination pair with the help of multiple cooperating nodes(relay nodes and jamming nodes) in the presence of one eavesdropper was considered to improve the performance of secure wireless communications. A novel cooperative scheme joint decode-and-forward and cooperative jamming(JDFCJ) was proposed. In this scheme, the relay nodes transmit a weighted version of the source signals and the jamming nodes just transmit a common weighted jamming signal to confound the eavesdropper. The novel system design is proposed to minimize the transmit power subject to a secrecy rate constraint. For JDFCJ, the optimal power allocation is obtained in closed-form in the condition of the complete nulling of jamming signals at the destination. The numerical evaluation of the transmit power results shows that the proposed scheme can significantly improve the performance of secure wireless communications, as compared to the DF scheme.
This paper investigates cooperative security in wireless networks, where a source (Alice) intends to transmit a confidential message to a legitimate destination (Bob), with the help of a cooperative jammer (Charlie), coexisting with multiple passive eavesdroppers (Eves). In particular, by assuming knowledge of Bob's perfect channel state information (CSI) but only Eves’ statistical CSIs, secrecy beamforming with artificial noise (AN) is utilized for secure transmission, and cooperative jamming (CJ) is explored to further enhance secrecy. We first derive an accurate closed-form expression for the secrecy outage probability (SOP), and establish the condition under which positive secrecy rate is achievable. Then, we provide a secure transmit design for maximizing the SOP constrained secrecy rate. Moreover, based on a strict mathematical analysis, we characterize the impact of the main channel quality and the number of Eves on transmit design and secrecy performance. Specifically, optimal power allocation ratio between the information-bearing signal and the AN signal increases as the main channel quality improves, and decreases with the number of Eves. Numerical results confirm that our design achieves performance improvement in terms of both secrecy rate and secure energy efficiency, as compared to the approach without CJ.