Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics Conference Series

Noise reduction methods of single photon detector based on InGaAs/InP avalanche photodiodes

G. K. Krivyakin, A. S. Pleshkov, Alexey Zverev, I. I. Ryabtsev, V. L. Kurochkin

Published Oct 27, 2014• 6 citations
Publisher

Abstract

This work is dedicated to the problem of noise reduction of single photon detector development based on InGaAs-InP avalanche photodiodes. Dark count probability and quantum efficiency of the detectors have been measured. We present the experimental fiber based quantum key distribution setup with phase coding of single photon states. The autocompensation two way optical scheme (plug&play) is used. The single photon source is the strongly attenuated laser pulse which goes through two paths of Mach-Zehnder interferometer where it undergoes the phase coding. Quantum channel is formed by 25 km single mode fiber. To generate the quantum key the four phases BB84 protocol is used.

DOI
10.1088/1742-6596/541/1/012050

Related papers

Using single-photon detectors for quantum key distribution in an experimental fiber-optic communication system

V. L. Kurochkin, A. V. Zverev, Yu. V. Kurochkin +2 more

This paper gives experimental results of quantum key distribution on a fiber-optic setup at a telecom wavelength of 1555 nm. A self-compensated two-channel optical circuit is used. Quantum key distribution was performed by coding the phase states of single photons radiated by a pulsed semiconductor laser in two alternative nonorthogonal bases. Specially developed single photon counters based on InGaAs: InP avalanche photodiodes were employed as high-sensitivity photodetectors. The results of investigation of the quantum efficiency, probability of afterpulses, and noise level for various operating modes of the detectors at temperatures from −40 to −60°C are given. A key distribution rate of 450 bit/s was obtained for a single-mode fiber-optic quantum communication channel between the receiver and sender 25 km long at a laser pulse clock frequency of 5 MHz and an average number of photons per pulse of about 0.2. For the achieved photodetector characteristics, the average number of errors in the quantum key did not exceed 3.7%.

Optoelectronics Instrumentation and Data Processing•Aug 1, 2009•10 citations

Single-photon detector for long-distance fiber-optic quantum key distribution

Naoto Namekata, Yuuki Makino, Shuichiro Inoue

We have investigated the performance of an InGaAs/InP avalanche photodiode for photon counting at 1550 nm in the temperature range of thermoelectric cooling. A quantum efficiency of 13.7% was obtained at -55 degrees C , while the dark-count probability per gate (?1 ns) was kept as small as 2.4x10(-5) . The developed single-photon detector would yield a 104.4-km fiber-optic quantum key distribution in the ideal condition.

Optics Letters•Jun 1, 2002•55 citations

Using InP/InGaAs avalanche photodiodes for 1.3 um photon detection

A. A. Anisimov, Andrei V. Medvedev, Sergey I. Markov

InGaAs/InP avalanche photodiode in photon detection mode was researched. The automatic experimental setup was developed. The parameters of single photon detector were optimized for quantum cryptography application in temperature range -38...-57C for 1.3 μm wavelength. Quantum efficiency 16% at quantum bit error rate 10% and dark count probability 7 10-5 at -38C was achieved.

Lasers for Measurements and Information Transfer•Feb 16, 2005•0 citations

Single Photon Detector Comparison in a Quantum Key Distribution Link Testbed

Jonathan L. Habif, David Pearson, Robert H. Hadfield +3 more

We provide a direct comparison between the InGaAs avalanche photodiode (APD) and the NbN superconducting single photon detector (SSPD) for applications in fiber-based quantum cryptography. The quantum efficiency and dark count rate were measured for each detector, and used to calculate the quantum bit error rate (QBER) and shared key rate for a QKD link. The results indicate that, despite low quantum efficiency, the speed of the SSPD makes it a superior detector for quantum information applications. Finally, we present results of an initial integration of an SSPD into a receiver node of the DARPA quantum network to perform quantum key distribution. Encoding quantum information on single photons has enabled the realization of a number of unique communication schemes such as the implementation of the BB84 protocol for quantum key distribution 1 and quantum dense coding. 2 Furthermore, the implementation of these schemes using photons at telecommunication wavelengths has permitted their extension to fiber optic networks, 3,4 drastically increasing the practicality of quantum information processing. To date, the state of the art in commercially available single photon detection at telecommunication wavelengths (1550 nm) has been the thermo-electrically cooled InGaAs avalanche photodiode (APD). The cooled InGaAs APD is generally operated at T = -60°C in the reverse-biased Geiger mode. Though these detectors have been successfully implemented in operating QKD links in optical fiber, the InGaAs APD suffers from afterpulsing effects that limit the key exchange rates. New SPD (single photon detector) technologies based on superconducting materials are emerging that hold tremendous promise for drastically increasing the photon counting rate and eliminating dark noise.57 The SSPD consists of a NbN thin film (t ∼ 5 nm) patterned into a narrow (w ∼ 100 nm) microstrip meander that is ∼ 500μm in length. The detector is cooled to T < 4K in a closed cycle refrigeration unit and a bias current I b is supplied to the device just below the superconducting critical current (I c ). When a photon is incident upon the microstrip superconductivity is broken in the region local to photon absorption and a normal state region is formed in the device. The current passing through the device causes a measurable voltage pulse in the detector that can be amplified and shaped to act as an input for traditional logic circuitry. Due to the unique electronic bandstructure in a superconducting material the intrinsic response time of the device is on the order of picoseconds, so that the repetition rate may be increased above 1 GHz 8 without being susceptible to afterpulsing effects that plague the InGaAs APD. 9 To make a direct comparison between the InGaAs APD and the SSPD both were placed in a SPD characterization testbed to measure quantum efficiency and dark count rate at a variety of bias conditions. The QBER for a QKD link is calculated from the measured parameters and then compared to requirements for a provably secure QKD link. Following detector characterization, one of the nodes of the DARPA Quantum Network operated by BBN Technologies 3 utilized an SSPD in the receiver to transmit key material. The demonstration provides an in situ comparison between the InGaAs APD, normally operated in the BBN link, and the SSPD.

Applied Physics Letters•Oct 25, 2006•0 citations

Single-photon avalanche diode detectors for quantum key distribution

Gerald S. Buller, Ryan E. Warburton, Saverio Pellegrini +5 more

The application of quantum key distribution (QKD) has raised particular demands for single-photon detectors. One of the most promising candidates at the low-loss optical fibre communications windows is the planar geometry InGaAs/InP single-photon avalanche diode. These detectors have been modelled, fabricated and characterised at 1.55 µm wavelength. Their performance in terms of single-photon detection efficiency, dark count rate, timing jitter and afterpulsing behaviour are reported and compared with the best commercially available, linear multiplication avalanche photodiodes operated in Geiger-mode. Their use in the application of QKD is discussed.

IET Optoelectronics•Dec 10, 2007•14 citations

High-rate quantum key distribution over 100 km using ultra-low-noise, 2-GHz sinusoidally gated InGaAs/InP avalanche photodiodes

Naoto Namekata, Hiroki Takesue, Toshimori Honjo +2 more

We have demonstrated quantum key distribution (QKD) over 100 km using single-photon detectors based on InGaAs/InP avalanche photodiodes (APDs). We implemented the differential phase shift QKD (DPS-QKD) protocol with electrically cooled and 2-GHz sinusoidally gated APDs. The single-photon detector has a dark count probability of 2.8 × 10(-8) (55 counts per second) with a detection efficiency of 6 %, which enabled us to achieve 24 kbit/s secure key rate over 100 km of optical fiber. The DPS-QKD system offers better performances in a practical way than those achieved using superconducting single-photon detectors. Moreover, the distance that secure keys against the general individual attacks can be distributed has been extended to 160 km.

Optics Express•May 16, 2011•84 citations
This work is dedicated to the problem of noise reduction of single photon detector development based on InGaAs-InP avalanche photodiodes. Dark count probability and quantum efficiency of the detectors have been measured. We present the experimental fiber based quantum key distribution setup with phase coding of single photon states. The autocompensation two way optical scheme (plug&play) is used. The single photon source is the strongly attenuated laser pulse which goes through two paths of Mach-Zehnder interferometer where it undergoes the phase coding. Quantum channel is formed by 25 km single mode fiber. To generate the quantum key the four phases BB84 protocol is used.
This paper gives experimental results of quantum key distribution on a fiber-optic setup at a telecom wavelength of 1555 nm. A self-compensated two-channel optical circuit is used. Quantum key distribution was performed by coding the phase states of single photons radiated by a pulsed semiconductor laser in two alternative nonorthogonal bases. Specially developed single photon counters based on InGaAs: InP avalanche photodiodes were employed as high-sensitivity photodetectors. The results of investigation of the quantum efficiency, probability of afterpulses, and noise level for various operating modes of the detectors at temperatures from −40 to −60°C are given. A key distribution rate of 450 bit/s was obtained for a single-mode fiber-optic quantum communication channel between the receiver and sender 25 km long at a laser pulse clock frequency of 5 MHz and an average number of photons per pulse of about 0.2. For the achieved photodetector characteristics, the average number of errors in the quantum key did not exceed 3.7%.
We provide a direct comparison between the InGaAs avalanche photodiode (APD) and the NbN superconducting single photon detector (SSPD) for applications in fiber-based quantum cryptography. The quantum efficiency and dark count rate were measured for each detector, and used to calculate the quantum bit error rate (QBER) and shared key rate for a QKD link. The results indicate that, despite low quantum efficiency, the speed of the SSPD makes it a superior detector for quantum information applications. Finally, we present results of an initial integration of an SSPD into a receiver node of the DARPA quantum network to perform quantum key distribution. Encoding quantum information on single photons has enabled the realization of a number of unique communication schemes such as the implementation of the BB84 protocol for quantum key distribution 1 and quantum dense coding. 2 Furthermore, the implementation of these schemes using photons at telecommunication wavelengths has permitted their extension to fiber optic networks, 3,4 drastically increasing the practicality of quantum information processing. To date, the state of the art in commercially available single photon detection at telecommunication wavelengths (1550 nm) has been the thermo-electrically cooled InGaAs avalanche photodiode (APD). The cooled InGaAs APD is generally operated at T = -60°C in the reverse-biased Geiger mode. Though these detectors have been successfully implemented in operating QKD links in optical fiber, the InGaAs APD suffers from afterpulsing effects that limit the key exchange rates. New SPD (single photon detector) technologies based on superconducting materials are emerging that hold tremendous promise for drastically increasing the photon counting rate and eliminating dark noise.57 The SSPD consists of a NbN thin film (t ∼ 5 nm) patterned into a narrow (w ∼ 100 nm) microstrip meander that is ∼ 500μm in length. The detector is cooled to T < 4K in a closed cycle refrigeration unit and a bias current I b is supplied to the device just below the superconducting critical current (I c ). When a photon is incident upon the microstrip superconductivity is broken in the region local to photon absorption and a normal state region is formed in the device. The current passing through the device causes a measurable voltage pulse in the detector that can be amplified and shaped to act as an input for traditional logic circuitry. Due to the unique electronic bandstructure in a superconducting material the intrinsic response time of the device is on the order of picoseconds, so that the repetition rate may be increased above 1 GHz 8 without being susceptible to afterpulsing effects that plague the InGaAs APD. 9 To make a direct comparison between the InGaAs APD and the SSPD both were placed in a SPD characterization testbed to measure quantum efficiency and dark count rate at a variety of bias conditions. The QBER for a QKD link is calculated from the measured parameters and then compared to requirements for a provably secure QKD link. Following detector characterization, one of the nodes of the DARPA Quantum Network operated by BBN Technologies 3 utilized an SSPD in the receiver to transmit key material. The demonstration provides an in situ comparison between the InGaAs APD, normally operated in the BBN link, and the SSPD.
The application of quantum key distribution (QKD) has raised particular demands for single-photon detectors. One of the most promising candidates at the low-loss optical fibre communications windows is the planar geometry InGaAs/InP single-photon avalanche diode. These detectors have been modelled, fabricated and characterised at 1.55 µm wavelength. Their performance in terms of single-photon detection efficiency, dark count rate, timing jitter and afterpulsing behaviour are reported and compared with the best commercially available, linear multiplication avalanche photodiodes operated in Geiger-mode. Their use in the application of QKD is discussed.
We have demonstrated quantum key distribution (QKD) over 100 km using single-photon detectors based on InGaAs/InP avalanche photodiodes (APDs). We implemented the differential phase shift QKD (DPS-QKD) protocol with electrically cooled and 2-GHz sinusoidally gated APDs. The single-photon detector has a dark count probability of 2.8 × 10(-8) (55 counts per second) with a detection efficiency of 6 %, which enabled us to achieve 24 kbit/s secure key rate over 100 km of optical fiber. The DPS-QKD system offers better performances in a practical way than those achieved using superconducting single-photon detectors. Moreover, the distance that secure keys against the general individual attacks can be distributed has been extended to 160 km.