Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Latin America Optics and Photonics Conference

Quantum noise revisited: complete measurement of spectral field modes

Alessandro S. Villar, A. S. Coelho, F. A. S. Barbosa, K. N. Cassemiro, M. Martinelli, P. Nussenzveig

Published Jan 1, 2014• 0 citations
Publisher

Abstract

We show that quantum noise in the spectral domain usually corresponds to a mixed quantum measurement, and cannot attain complete information about the quantum state of spectral modes [PRL 111, 200402 (2013).]
DOI
10.1364/laop.2014.lf1a.1

Related papers

Introduction to Quantum Noise Quantum Measurement in Quantum Optics

Jeff Kimble

•Jan 1, 1993•0 citations

Assumption-free measurement of the quantum state of light: Exploring the sidebands of intense fields

F. A. S. Barbosa, A. S. Coelho, K. N. Cassemiro +3 more

The quantum noise in photocurrent fluctuations usually gives incomplete information about the quantum state of spectral sideband modes of bright light beams involved in the detection. Each frequency component of the noise spectrum corresponds to two sideband modes symmetrically located around the bright optical field. In the case of the usual homodyne detection, it limits the ability to recover discriminated information of each mode involved. We theoretically show that complete reconstruction of the two-mode quantum state can be obtained by using phase-locked (coherent) resonator detection, even for non-Gaussian states. We experimentally demonstrate the technique by measuring a two-mode displaced coherent state.

Physical Review A•Dec 7, 2020•9 citations

Optical interference by amplitude measurement: Spectral analysis

Xuan Tang, Z. Y. Ou

Optical interference usually requires two interfering paths to be balanced within the coherence length. For the case of unbalanced paths, interference effects can be recovered in the frequency-domain analysis of the superposed resultant optical field because optical frequency filtering in the spectral analysis of the optical field lengthens the coherence length to overcome the path imbalance. However, since optical detection usually is intensity measurement that loses the phase information of the detected optical field, the output photocurrent of intensity measurement cannot recover the lost interference effect in the postprocessing of the data such as electronic spectral analysis. On the other hand, if amplitude measurement can be used to measure the resultant optical field from the path-unbalanced superposition of two fields, the output photocurrent carries complete information of two fields and can restore interference in postdetection processing, even though no interference shows up in direct intensity measurement. In this paper, we use homodyne detection method for amplitude measurement to analyze the output of a path-unbalanced interferometer in the spectral domain. Since complete information about the superposed optical field is contained in the photocurrent, spectral analysis shows interference fringes in frequency that reveal information about the path imbalance. It is found that shot noise is the limiting factor in the visibility of interference but can be reduced with a squeezed state input in the unused port of the unbalanced interferometer. This approach is a different paradigm from the traditional one for studying the coherence between optical fields and should find wide application in remote sensing and precision measurement.

Physical Review Research•Jan 6, 2026•0 citations

How Does Noise Affect a Quantum State?

Joseph H. Eberly, Ting Yu

Springer eBooks•Dec 15, 2011•0 citations

Quantum noise of modulation and squeezed states

Y. Ben-Aryeh

Physics Letters A•Dec 1, 1986•1 citation

Quantum state reconstruction of spectral field modes: Homodyne and resonator detection schemes

F. A. S. Barbosa, A. S. Coelho, K. N. Cassemiro +4 more

We revisit the problem of quantum state reconstruction of light beams from the photocurrent quantum noise. As is well known, but often overlooked, two longitudinal field modes contribute to each spectral component of the photocurrent (sideband modes). We show that spectral homodyne detection is intrinsically incapable of providing all the information needed for the full reconstruction of the two-mode spectral quantum state. Such a limitation is overcome by the technique of resonator detection. A detailed theoretical description and comparison of both methods is presented, as well as an experiment to measure the six-mode quantum state of pump-signal-idler beams of an optical parametric oscillator above the oscillation threshold.

arXiv:1310.2427•Physical Review A•Nov 14, 2013•45 citations
The quantum noise in photocurrent fluctuations usually gives incomplete information about the quantum state of spectral sideband modes of bright light beams involved in the detection. Each frequency component of the noise spectrum corresponds to two sideband modes symmetrically located around the bright optical field. In the case of the usual homodyne detection, it limits the ability to recover discriminated information of each mode involved. We theoretically show that complete reconstruction of the two-mode quantum state can be obtained by using phase-locked (coherent) resonator detection, even for non-Gaussian states. We experimentally demonstrate the technique by measuring a two-mode displaced coherent state.
Optical interference usually requires two interfering paths to be balanced within the coherence length. For the case of unbalanced paths, interference effects can be recovered in the frequency-domain analysis of the superposed resultant optical field because optical frequency filtering in the spectral analysis of the optical field lengthens the coherence length to overcome the path imbalance. However, since optical detection usually is intensity measurement that loses the phase information of the detected optical field, the output photocurrent of intensity measurement cannot recover the lost interference effect in the postprocessing of the data such as electronic spectral analysis. On the other hand, if amplitude measurement can be used to measure the resultant optical field from the path-unbalanced superposition of two fields, the output photocurrent carries complete information of two fields and can restore interference in postdetection processing, even though no interference shows up in direct intensity measurement. In this paper, we use homodyne detection method for amplitude measurement to analyze the output of a path-unbalanced interferometer in the spectral domain. Since complete information about the superposed optical field is contained in the photocurrent, spectral analysis shows interference fringes in frequency that reveal information about the path imbalance. It is found that shot noise is the limiting factor in the visibility of interference but can be reduced with a squeezed state input in the unused port of the unbalanced interferometer. This approach is a different paradigm from the traditional one for studying the coherence between optical fields and should find wide application in remote sensing and precision measurement.
We revisit the problem of quantum state reconstruction of light beams from the photocurrent quantum noise. As is well known, but often overlooked, two longitudinal field modes contribute to each spectral component of the photocurrent (sideband modes). We show that spectral homodyne detection is intrinsically incapable of providing all the information needed for the full reconstruction of the two-mode spectral quantum state. Such a limitation is overcome by the technique of resonator detection. A detailed theoretical description and comparison of both methods is presented, as well as an experiment to measure the six-mode quantum state of pump-signal-idler beams of an optical parametric oscillator above the oscillation threshold.