Abstract : The Doppler-broadened two-photon absorption (TPA) cross-section for the 52S1/2- 52D5/2 transition in Rb is measured using direct absorption methods. A detailed model of the intensity profile was developed to account for a focused Gaussian beam propagating through a two-photon absorption medium. A peak absorbance of 24% was observed for an intensity of 6.28 kW/cm2 at the focus, a Rb density of 4.6 x 1015 cm-3 concentrations from 1.61-8.52 x 10(15) cm-3 line. Extracting the hyperfine-broadened TPA cross-section from 87 test configurations, while varying the pump power, alkali concentration and focal length, yielded an error weighted average of 6.75x10-21 cm4/W. This cross-section is sufficient for a pulsed dye laser to bleach the pump transition in the Two-Photon Pumped Alkali Laser (TPAL) that lases at 420 nm and 5.2 mum. Additionally, optically pumped atomic rubidium lasers pumped in the blue satellite of the D2 line from the ground Rb-Ar or Rb-Kr collision pair to the dissociative B2 sum 1/2 produce laser emission at 780.2 nm. Lasing is achieved for the Rb-Ar system and 757.1 - 760.4 nm for the Rb-Kr system. Slope efficiencies exceed 0.25% using a heat pipe configuration. The gain is very high with photon build-up times of 1-3.7 ns.
Abstract : The Doppler-broadened two-photon absorption (TPA) cross-section for the 52S1/2- 52D5/2 transition in Rb is measured using direct absorption methods. A detailed model of the intensity profile was developed to account for a focused Gaussian beam propagating through a two-photon absorption medium. A peak absorbance of 24% was observed for an intensity of 6.28 kW/cm2 at the focus, a Rb density of 4.6 x 1015 cm-3 concentrations from 1.61-8.52 x 10(15) cm-3 line. Extracting the hyperfine-broadened TPA cross-section from 87 test configurations, while varying the pump power, alkali concentration and focal length, yielded an error weighted average of 6.75x10-21 cm4/W. This cross-section is sufficient for a pulsed dye laser to bleach the pump transition in the Two-Photon Pumped Alkali Laser (TPAL) that lases at 420 nm and 5.2 mum. Additionally, optically pumped atomic rubidium lasers pumped in the blue satellite of the D2 line from the ground Rb-Ar or Rb-Kr collision pair to the dissociative B2 sum 1/2 produce laser emission at 780.2 nm. Lasing is achieved for the Rb-Ar system and 757.1 - 760.4 nm for the Rb-Kr system. Slope efficiencies exceed 0.25% using a heat pipe configuration. The gain is very high with photon build-up times of 1-3.7 ns.
Recently we demonstrated lasing at 420 nm and 455 nm inside of rubidium and cesium vapor cells respectively, by non-resonant, two photon absorption at near infrared pump wavelengths. Two photon absorption from the ground S1/2 state to excited D3/2,5/2 or higher lying S1/2 state via virtual states and subsequent infrared stimulated emission pumps the upper laser levels, the second excited P1/2,3/2 states. To better understand the mechanism and phenomenology of this type of laser, this paper presents a method for determining the two-photon absorption (TPA) cross-section for the 5S1/2 −→ 5D5/2 transition in naturally occurring rubidium. For an incident pump intensity of 392 W cm2 and a rubidium concentration of 3.34 × 10 atoms cm3 , a peak absorbance of 0.10 is observed. The concentration of the Rb in the test cell is determined by one photon absorption spectra of the D2, indicating a vapor curve shifted by 14 C from the exterior wall temperature. The incident laser beam is focused to a waist of 75 μm. The beam quality is consistent with an M = 1.05 − 1.09. A model for the intensity as a function of propagation distance is developed to interpret the observed absorption spectrum and determine a cross-section for the two photon absorption.
Abstract : An optically pumped mid-infrared rubidium (Rb) pulsed laser has been demonstrated in a heat pipe along the 62P3/2 - 62S1/2 transition at 2.730 micrometer and the 62P1/2 - 62S1/2 transition at 2.790 micrometer. The bleached limit, slope efficiency, and maximum laser output energy of the mid-IR Rb laser have been shown to scale linearly with increasing Rb density, contrary to prior laser demonstrations. A maximum output energy of 5 nJ per pulse had previously been observed before a rollover occurred in the scaling of output energy with Rb concentration. In this experiment, the maximum laser output energy observed was 100 nJ, with linear scaling to a Rb concentration of 7 x 10 to the 15th power cm-3. A maximum slope efficiency of 1.7 x 0.0001 was observed. Evidence that only a small percentage (2%) of the available pump photons were absorbed at a concentration of 2 x 10 to the 15th power cm-3 and a pump energy of 10 (mu)J. This indicated that there were 20,000 pump photons per Rb atom at a pump energy of 10 mJ, and that the effective laser efficiency was 0.65 percent or higher. The hyperfine structure and absorption spectral profile of the 52S1/2 - 62P1/2 and 52S1/2 - 62P3/2 (blue) pump transitions were studied using a continuous wave (cw) pump source.
Diode-pumped alkali laser (DPAL) technology offers a means of achieving high-energy gas laser output through optical pumping of the D-lines of Cs, Rb, and K. The exciplex effect, based on weak attractive forces between alkali atoms and polarizable rare gas atoms (Ar, Kr, Xe), provides an alternative approach via broadband excitation of exciplex precursors (XPAL). In XPAL configurations, we have observed multi-quantum excitation within the alkali manifolds which result in infrared emission lines between 1 and 4 μm. The observed excited states include the 42FJ states of both Cs and Rb, which are well above the two-photon energy of the excitation laser in each case. We have observed fluorescence from multi-quantum states for excitation wavelengths throughout the exciplex absorption bands of Cs-Ar, Cs-Kr, and Cs-Xe. The intensity scaling is roughly first-order or less in both pump power and alkali concentration, suggesting a collisional energy pooling excitation mechanism. Collisional up-pumping appears to present a parasitic loss term for optically pumped atomic systems at high intensities, however there may also be excitation of other lasing transitions at infrared wavelengths.
uorescence geometry. The threshold for the blue is modest, 0.3 mJ/pulse, and slope eciencies increase dramatically with alkali concentration. Threshold in the infrared is quite small. Although two photon absorption cross-sections are typically quite low, the intensity dependent cross-section for the Rb 5 2 S1=2 ! 5 2 D5=2 has been previously calculated as 0.57 x 10 18 cm 4 /W and measured as 4 x 10 20 cm 4 /W and 1.2 0.5 x 10 18 cm 4 /W. At the threshold pump energy of 0.3 mJ, the corresponding intensity is 80 kW/cm 2 , yielding an eective absorption cross-section of 10 13 cm 2 . This cross-section is about 15 times lower than the value for single photon absorption on the D2 line with broadening associated with 600 Torr of helium. The standard red DPAL typically exhibits a threshold of 1-2 kW/cm 2 , about 40-80 times less than the present results. The two photon absorption cross-section appears to be large enough to bleach the sample.
Abstract : Mirrorless lasing has been successfully demonstrated in a Rubidium heat pipe. Lasing was observed on the 6(2)P(sub 3/2)-6(2)S(sub 1/2) energy transition at 2.73 microns and on the 6(2)P(sub 1/2)-6(2)S(sub 1/2) transition at 2.79 microns. The transitions were optically pumped from 5(2)S(sub 1/2)-6(2)P(sub 3/2) at 420.2 nm and from 5(2)S(sub 1/2)-6(2)P(sub 1/2) at 421.7 nm, respectively. The 5(2)S(sub 1/2)-6(2)P(sub 3/2) transition was excited over a 36 GHz band, while the 5(2)S(sub 1/2)-6(2)P(sub 1/2) transition was excited over a 24 GHz band. Both pump transitions showed a high degree of saturation and only a small fraction (1%) of the incident pump energy was absorbed. Output energies of up to 5 nJ were obtained at 2.73 microns and of up to 5.4 nJ at 2.79 microns when pumped at pulse energies of 4 mJ. Both transitions experienced bleaching at this 4 mJ pump energy, limiting further IR output energy. Increasing rubidium concentration at bleached pump energies showed no increase in laser energy after 170 deg. C, likely due to second order processes. Slope efficiency for both transitions, however, increased linearly with rubidium concentration up to 11 x .000001 The addition of small amounts of argon, helium, and ethane (5-45 Torr) were found to fully quench lasing action on both transitions.
Photoassociation of alkali-rare gas atomic collision pairs provides an alternative approach to optically pumping atomic alkali lasers. Lasing on the 6 P21/2→6 S21/2 (D1) transition of Cs has been observed when the blue satellite of the 6 P23/2←6 S21/2 (D2) transition, peaking at ∼837 nm for mixtures of Cs vapor, Ar, and ethane, is pumped by a pulsed dye laser. For 50% output coupling, laser threshold with respect to absorbed pump energy is ∼40 μJ at T=435 K and the slope efficiency approaches 10%. The measured spectral breadth for the blue satellite (≳5 nm at 410 K) will accommodate cw pumping of the Cs laser with conventional semiconductor lasers.