The theory of quantum measurement is an important element for quantum computation.In this work, I discuss quantum measurement in the quantum information technologies with some results of my doctor research.I have the following two main achievements: 1. proposal and analysis on improved control scheme of adaptive measurement for state preparation; CONTENTS iii 4.1.2Weak value as an expected value . . . . . . . . . . . . . .4.2 WVA with full-order calculation . . . . . . . . . . . . . . . . . .4.2.1 Review of WVA experiment with Sagnac interferometer .4.2.2Full-order calculation to analyze the experiment [58] based on wave optics theory . . . . . . . . . . . . . . . . . . . .4.2.3WVA on the two-level measured system . . . . . . . . . .4.3 Information change by the weak value amplification . . . . . . .4.3.1The state transition through the AAV weak measurement 4.3.2SLD-Fisher information and weak value . . . . . . . . . .4.3.3Evaluation of the post-selection with SLD-Fisher information . . . . . . . . . . . . . .
The theory of quantum measurement is an important element for quantum computation.In this work, I discuss quantum measurement in the quantum information technologies with some results of my doctor research.I have the following two main achievements: 1. proposal and analysis on improved control scheme of adaptive measurement for state preparation; CONTENTS iii 4.1.2Weak value as an expected value . . . . . . . . . . . . . .4.2 WVA with full-order calculation . . . . . . . . . . . . . . . . . .4.2.1 Review of WVA experiment with Sagnac interferometer .4.2.2Full-order calculation to analyze the experiment [58] based on wave optics theory . . . . . . . . . . . . . . . . . . . .4.2.3WVA on the two-level measured system . . . . . . . . . .4.3 Information change by the weak value amplification . . . . . . .4.3.1The state transition through the AAV weak measurement 4.3.2SLD-Fisher information and weak value . . . . . . . . . .4.3.3Evaluation of the post-selection with SLD-Fisher information . . . . . . . . . . . . . .
The ability to manipulate light has allowed scientists to verify fundamental theories of physics and to develop a new generation of technologies that use photons as a primary resource. Recent developments in quantum measurement theory have offered new alternatives to approach some of the most remarkable problems in quantum physics. Consequently, the principles of quantum mechanics have been exploited in the development of quantum technologies such as optical metrology, quantum communication, and quantum information. In recent years, weak measurements and two of its most remarkable variants: weak value amplification and direct measurement, have been developed and are considered important resources for quantum applications. In this paper, we discuss weak measurements and some significant applications of weak values. We elaborate on how distinct forms of weak values are used to observe and amplify small effects or to directly measure the quantum wave function of photons, a crucial task for schemes for quantum communication and quantum information. We also review some of the most recent methods for weak value amplification and direct measurement that our group has developed.
The quantum theory of measurement has been with us since quantum mechanics was invented. It has recently been invigorated, partly due to the increasing interest in quantum information science. In this partly pedagogical review I attempt to give a self-contained overview of non-relativistic quantum theory of measurement expressed in density matrix formalism. I will not dwell on the applications in quantum information theory; it is well covered by several books in that field. The focus is instead on applications to the theory of weak measurement, as developed by Aharonov and collaborators. Their development of weak measurement combined with what they call post-selection - judiciously choosing not only the initial state of a system (pre-selection) but also its final state - has received much attention recently. Not the least has it opened up new, fruitful experimental vistas, like novel approaches to amplification. But the approach has also attached to it some air of mystery. I will attempt to demystify it by showing that (almost) all results can be derived in a straight-forward way from conventional quantum mechanics. Among other things, I develop the formalism not only to first order but also to second order in the weak interaction responsible for the measurement. I apply it to the so called Leggett-Garg inequalities, also known as Bell inequalities in time. I also give an outline, even if rough, of some of the ingenious experiments that the work by Aharonov and collaborators has inspired. As an application of weak measurement, not related to the approach by Aharonov and collaborators, the formalism also allows me to derive the master equation for the density matrix of an open system in interaction with an environment. An issue that remains in the weak measurement plus post-selection approach is the interpretation of the so called weak value of an observable. Is it a bona fide property of the system considered? I have no definite answer to this question; I shall only exhibit the consequences of the proposed interpretation. Quanta 2013; 2: 18–49.
In these notes, based on lectures given as part of the Les Houches summer school on Quantum Optics and Nanophotonics in August, 2013, I have tried to give a brief survey of some important approaches and modern tendencies in quantum measurement. I wish it to be clear from the outset that I shy explicitly away from the "quantum measurement problem," and that the present treatment aims to elucidate the theory and practice of various ways in which measurements can, in light of quantum mechanics, be carried out; and various formalisms for describing them. While the treatment is by necessity largely theoretical, the emphasis is meant to be on an experimental "perspective" on measurement -- that is, to place the priority on the possibility of gaining information through some process, and then attempting to model that process mathematically and consider its ramifications, rather than stressing a particular mathematical definition as the {\it sine qua non} of measurement. The textbook definition of measurement as being a particular set of mathematical operations carried out on particular sorts of operators has been so well drilled into us that many have the unfortunate tendency of saying "that experiment can't be described by projections onto the eigenstates of a Hermitian operator, so it is not really a measurement," when of course any practitioner of an experimental science such as physics should instead say "that experiment allowed us to measure something, and if the standard theory of measurement does not describe it, the standard theory of measurement is incomplete." Idealisations are important, but when the real world breaks the approximations made in the theory, it is the theory which must be fixed, and not the real world.
Abstract Hamiltonian estimation is a cardinal task in applications of quantum metrology, quantum computation, quantum simulation, etc. When the evolution time is short in order to suppress noise and enhance sensitivity, the measurement and postprocessing may incur high cost. In this paper, we propose an adaptive weak measurement scheme for Hamiltonian estimation, which adjusts the pre- and post-selection according to the difference of the mean shift between two orthogonal post-selected states. According to the angle of the post-selected state, the proposed scheme can change from weak value amplification (WVA) to joint weak measurement (JWM). A study of the quantum Fisher information shows that the JWM situation is always optimal. Meanwhile, the WVA approach loses a little information but it can inherit the WVA’s technical advantages, which are suitable for short evolution times. The widely applicable scope of the proposed scheme makes us believe that it offers a new path for the understanding of unknown Hamiltonians.
The weak-value-amplification (WVA) technique has been extensively considered and debated in the field of quantum precision measurement, largely owing to the reduced Fisher information caused by the low probability of successful post-selection. %% In this work we show that, rather than the Gaussian meter state as typically considered, using the optical coherent state as a meter, the WVA measurement can definitely outperform the conventional measurement not involving the strategy of post-selection. %% We also show that the post-selection procedure involved in the WVA scheme can make a mixture of coherent states work better than a pure coherent state with identical average photon numbers. This is in sharp contrast to the claim proved in the absence of post-selection. The post-selection strategy can also result in the precision of Heisenberg (or even "super-Heisenberg") scaling with the photon numbers, but without using any expensive quantum resources. %% The present work may stimulate further investigations for the potential of the post-selection strategy in quantum precision measurements.
Quantum states and measurements are two central physical objects in the theory of quantum mechanics. The preparation, control and measurement of quantum states lies at the heart of modern quantum information processing protocols ranging from secure communication to quantum computation and precision sensing. And yet, the reliable operation of these advanced protocols ultimately rests on a far more essential prerequisite - our ability to calibrate, certify and benchmark the quantum states we prepare and the quantum measurements we perform. Quantum information theory provides a natural framework for these tasks, meaningfully connecting the resources we expend for characterisation with the accuracy and precision we can expect in return. While decades of advances in quantum information have refined our understanding of quantum characterisation and sharpened our practical ability to calibrate with enhanced precision, important questions about the fundamental limits of quantum characterisation remain unanswered. Although incorporating entanglement at the measurement stage is known to enhance the estimation of unknown quantum states, the extent of this improvement remains poorly understood. This leaves open a fundamental question on the utility of complex entangling measurement strategies, impeding progress towards bridging the significant gap between practically achievable precision and the ultimate theoretical quantum limit. Complementary to quantum state estimation, which is relatively well-established in theory and practice, the characterisation of quantum measurements lacks a rigorous information-theoretic foundation, leading to a dearth of principled benchmarks and provably optimal strategies despite growing experimental interest. This thesis develops and applies information-theoretic tools to answer questions in quantum characterisation, with an eye to enabling practical improvements beyond current techniques in the field. First, we introduce a computable measure of entanglement enhancement for quantum state estimation and study its variation across general multi-parameter estimation problems for higher-dimensional quantum states. We show that the entanglement enhancement is maximised for full qudit state tomography but grows only linearly with system dimension even when allowing an asymptotically large number of entangling operations. Our proposed tight upper bound to entanglement enhancement therefore constitutes a strong limitation on the utility of such entangling measurements. Next, we formulate the dual problem of quantum detector estimation, developing a comprehensive framework for maximally precise calibration centred around a newly introduced quantity - the detector quantum Fisher information. This information-theoretic measure stipulates the ultimate precision attainable for measurement calibration and identifies the optimal input states that achieve this precision. Further, our framework enables the first provably optimal detector estimation experiment and reveals the scope for entanglement-based enhancements, thereby placing measurement characterisation on equal footing with state characterisation. Considered together, these results suggest two contrasting conclusions about quantum characterisation. On the one hand, they show that for quantum state estimation, increasingly powerful entangling measurements offer only diminishing returns at the ultimate precision limit. On the other hand, they highlight practical quantum advantages available for detector estimation by providing a framework that can improve calibration performance and guide future experimental design. More broadly, these results complete and advance the triad of state, process, and detector characterisation, positioning quantum information measures as not merely abstract bounds, but practical guides for deciding when complex quantum resources are genuinely worth deploying and where near-term quantum advantages are most likely to be realised.