We are currently developing a vertical gravity gradiometer. This new experiment will combine ultracold atoms produced on atom chips and large momentum transfer beamsplitters. Two separated atomic clouds will be interrogated simultaneously to measure the vertical gravity gradient. For that purpose high power laser sources will be developed to get a large separation between the two arms of each interferometer and thus a high sensitivity. We expect a shot noise limited sensitivity of 9.10-12g at ls on a single cloud, and a sensitivity of the gravity gradient measurement of 1, 3.10-1 E at ls, for a separation of lm between the two clouds.
We are currently developing a vertical gravity gradiometer. This new experiment will combine ultracold atoms produced on atom chips and large momentum transfer beamsplitters. Two separated atomic clouds will be interrogated simultaneously to measure the vertical gravity gradient. For that purpose high power laser sources will be developed to get a large separation between the two arms of each interferometer and thus a high sensitivity. We expect a shot noise limited sensitivity of 9.10-12g at ls on a single cloud, and a sensitivity of the gravity gradient measurement of 1, 3.10-1 E at ls, for a separation of lm between the two clouds.
We here present a high sensitivity gravity-gradiometer based on atom interferometry. In our apparatus, two clouds of laser-cooled rubidium atoms are launched in fountain configuration and interrogated by a Raman interferometry sequence to probe the gradient of gravity field. We recently implemented a high-flux atomic source and a newly designed Raman lasers system in the instrument set-up. We discuss the applications towards a precise determination of the Newtonian gravitational constant G. The long-term stability of the instrument and the signal-to-noise ratio demonstrated here open interesting perspectives for pushing the measurement precision below the 100 ppm level.
A transportable atom interferometer-based gravity gradiometer has been developed at JPL to carry out measurements of Earth's gravity field at ever finer spatial resolutions, and to facilitate high-resolution monitoring of temporal variations in the gravity field from ground- and flight-based platforms. Existing satellite-based gravity missions such as CHAMP and GRACE measure the gravity field via precise monitoring of the motion of the satellites; i.e. the satellites themselves function as test masses. JPL's quantum gravity gradiometer employs a quantum phase measurement technique, similar to that employed in atomic clocks, made possible by recent advances in laser cooling and manipulation of atoms. This measurement technique is based on atomwave interferometry, and individual laser-cooled atoms are used as drag-free test masses. The quantum gravity gradiometer employs two identical atom interferometers as precision accelerometers to measure the difference in gravitational acceleration between two points (Figure 1). By using the same lasers for the manipulation of atoms in both interferometers, the accelerometers have a common reference frame and non-inertial accelerations are effectively rejected as common mode noise in the differential measurement of the gravity gradient. As a result, the dual atom interferometer-based gravity gradiometer allows gravity measurements on a moving platform, while achieving the same long-term stability of the best atomic clocks. In the laboratory-based prototype (Figure 2), the cesium atoms used in each atom interferometer are initially collected and cooled in two separate magneto-optic traps (MOTs). Each MOT, consisting of three orthogonal pairs of counter-propagating laser beams centered on a quadrupole magnetic field, collects up to 10(exp 9) atoms. These atoms are then launched vertically as in an atom fountain by switching off the magnetic field and introducing a slight frequency shift between pairs of lasers to create a moving rest frame for the trapped atoms. While still in this moving-frame molasses, the laser frequencies are further detuned from the atomic resonance (while maintaining this relative frequency shift) to cool the atom cloud's temperature to 2 K or below, corresponding to an rms velocity of less than 2 cm/s. After launch, the cold atoms undergo further state and velocity selection to prepare for atom interferometry. The atom interferometers are then realized using laser-induced stimulated Raman transitions to perform the necessary manipulations of each atom, and the resulting interferometer phase is measured using laser-induced fluorescence for state-normalized detection. More than 20 laser beams with independent controls of frequency, phase, and intensity are required for this measurement sequence. This instrument can facilitate the study of Earth's gravitational field from surface and air vehicles, as well as from space by allowing gravity mapping from a low-cost, single spacecraft mission. In addition, the operation of atom interferometer-based instruments in space offers greater sensitivity than is possible in terrestrial instruments due to the much longer interrogation times available in the microgravity environment. A space-based quantum gravity gradiometer has the potential to achieve sensitivities similar to the GRACE mission at long spatial wavelengths, and will also have resolution similar to GOCE for measurement at shorter length scales.
Gravity gradiometers based on atom-wave interferometry hold the promise for increased sensitivity, and suitability for space applications. This capability will significantly advance our knowledge of solid Earth and the oceans, as well as other solar system planets and their moons. The quantum interferometer gravity gradiometer is based on atom-wave interferometry, and is intrinsically more sensitive than laser interferometers, because of the finite mass of the atom and the shorter de Broglie wavelengths associated with atom waves. Recent advances in laser cooling and trapping have made quantum interferometer applications practical. In this paper the principle of the operation of the quantum gravity gradiometer will first be described, together with the progress in its development to date. Estimates for the performance, and projections for the sensitivity will also be presented, together with potential applications to gravity science. Over the past few years advanced in laser cooling has brought about a significant progress towards realization of ultra-high sensitivity gravity gradiometers based on atom wave (matter wave) interferometry. These instruments represent a powerful potential for sensitive measurements of the components of the gravity gradient tensor from space to provide access to three-dimensional maps of geophysical structures deep below the surface. The exquisite sensitivity associated with atom-wave interferometry holds a great promise for new gravity mapping and monitoring capabilities - higher measurement sensitivity, finer spatial resolution, and, most importantly, temporal monitoring. This implies measurement opportunities for the Earth Observing System to develop comprehensive models for the understanding of the planetary inner structure and dynamics, changes in ice sheets and ocean currents, changes in underground water storage, and weather, earthquake, and volcano prediction capabilities. In this paper, we will review briefly the principles of the quantum gravity gradiometer and its advantages in the space environment. We will then describe our laboratory experiment and report some of the component development work towards a space-borne system. Gravity gradiometers based on atom interferometers are currently under development at the Jet propulsion Laboratory under NASA sponsorship.
This work describes the technology developed for the transportable gravity gradiometer, ''GGtop", constructed at the University of Birmingham. The device aims to simultaneously interrogate two physically separated, free-falling cold atom clouds using the technique of Raman interferometry to perform differential gravity measurements. Such a technique will suppress common-mode noise sources, such as vibrations, that otherwise limit classical gravimeters and cold atom interferometers based on single-cloud measurements. The technique is expected to improve speed and sensitivity for field measurements greatly. \nUsing a combination of commercially available components and novel designs, intended to enhance portability and robustness, allowed for demonstration of atomic interference with the apparatus via Ramsey's method of separated oscillatory fields. The achieved fringe contrast of ~2%, defined as the difference in the number of atoms detected in IF = 2>, was limited by drifts stemming from some of the novel designs which prompted continued optimisation of the underpinning subsystems. To address performance issues parts of the experiment were redesigned with the goal of improving reliability at the expense of some portability. Using the retrofitted experiment, interference was once again achieved with fitted fringe spacing of 134.7±2.0 uS in good agreement with the 133.9 uS defined by the experimental control. A factor of 10 improvement in contrast was found with the central fringe demonstrating 18% of the atoms detected in the IF = 2> state when normalised to the total 3D MOT number. The 3.71 ± 0.01 kHz fitted linewidth of the central fringe gives a frequency uncertainty of 5.43 ± 0.01 x 10 - 7. This result leaves the experiment in a good position to begin making measurements of gravity.
We evaluate the sensitivity of a dual cloud atom interferometer to the measurement of vertical gravity gradient. We study the influence of most relevant experimental parameters on noise and long term drifts. Results are also applied to the case of doubly differential measurements of the gravitational signal from local source masses. We achieve a short-term sensitivity of $3\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}9}$ g/Hz to differential gravity acceleration, limited by the quantum projection noise of the instrument. Active control of the most critical parameters allows us to reach a resolution of $5\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}11}$ g after 8000 s on the measurement of differential gravity acceleration. The long-term stability is compatible with a measurement of the gravitational constant G at the level of ${10}^{\ensuremath{-}4}$ after an integration time of about 100 h.
We report progress towards a prototype atom interferometer gravity gradiometer for Earth science studies from a satellite in low Earth orbit.The terrestrial prototype has a target sensitivity of 8 x 10(exp -2) E/Hz(sup 1/2) and consists of two atom sources running simultaneous interferometers with interrogation time T = 300 ms and 12 hk photon recoils, separated by a baseline of 2 m. By employing Raman side band cooling and magnetic lensing, we will generate atomic ensembles with N = 10(exp 6) atoms at a temperature of 3 nK. The sensitivity extrapolates to 7 x 10(exp -5) E/Hz(sup 1/2) in microgravity on board a satellite. Simulations derived from this sensitivity demonstrate a monthly time-variable gravity accuracy of 1 cm equivalent water height at 200 km resolution, yielding an improvement over GRACE by 1-2 orders of magnitude. A gravity gradiometer with this sensitivity would also benefit future planetary, lunar, and asteroidal missions.