Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Underdamped vortex flow devices

Amy Duwel

Published Jan 1, 1995• 0 citations
OpenAlex

Abstract

Discrete arrays of underdamped Josephson junctions can be used as oscillators and transistors for superconducting electronic applications.Both devices require that the system be biased in the flux-flow regime of its current-voltage characteristic.We present measurements and models for the performance of these devices.We find that the presence of a superconducting ground plane improves all of the device parameters except the transresistance.We further refined the devices by connecting two arrays in series.Magnetic coupling between adjacent loops of this array has a significant influence on the dynamics.A theoretical treatment shows that the coupling causes splitting of Fiske steps, zero-field steps, and flux-flow steps.Since we are considering device applications, our measurements focus on the splitting of the flux-flow step.This configuration produces steps at higher voltage levels with improved transresistances, but with degraded output resistance.The power and bandwidth are relatively unaffected.Inductively coupled arrays may be promising for some applications, but the dynamics must be more thoroughly investigated before this potential can be realized.

Related papers

Discrete underdamped vortex flow devices

Amy Duwel, Herre S. J. van der Zant, Terry P. Orlando

Vortex flow devices consisting of discrete arrays of underdamped Josephson junctions have been fabricated and measured. These devices and their long, continuous junction counterparts are based on the ability to magnetically control the Eck voltage in an underdamped system. We find that both transistor and oscillator parameters are improved by placing the arrays above a superconducting ground plane and by connecting two arrays in series. We developed models for the device behavior which numerically account for the measured parameters. Our models also suggest that junctions with smaller capacitances will further improve the device parameters.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•6 citations

Eck peak in underdamped discrete superconducting vortex flow devices

Herre S. J. van der Zant, Terry P. Orlando

We have measured vortex motion in a long one-dimensional array of small underdamped niobium tunnel junctions which are coupled in parallel by superconducting wires. In the current-voltage characteristic, a resonant step occurs similar to the Eck peak in long continuous junctions. Due to the discrete nature of our samples, the voltage of this resonant step follows a sinusoidal dependence on the magnetic field rather than the linear dependence found in long continuous junctions. With a control current applied parallel to the array of junctions, the device can be operated as a vortex-flow transistor or as a tunable vortex-flow oscillator. Compared to long continuous junctions, the performance of discrete transistors is better with regard to the threshold current and transresistance, but worse with regard to the output resistance. Discrete oscillators have the advantage over their continuous counterparts in that the output impedance is of the order of 10 Ω. Numerical simulations indicate power levels around 0.5 μW and frequencies above 500 GHz.

Journal of Applied Physics•Dec 1, 1994•19 citations

Experimental results of a vortex flow transistor amplifier

David P. McGinnis, Gert K. G. Hohenwarter, M.A. Ketkar +2 more

A niobium-based superconducting amplifier consisting of a series array of 60 vortex flow transistors (VFT) was fabricated and tested. Each VFT consisted of a long Josephson junction biased in the flux flow state, magnetically coupled to a current based on a distributed amplifier configuration. The transresistance of the amplifier in a 50- Omega environment for frequencies up to 1 MHz was measured. The transresistance of the array was less than the expected value calculated from measurements obtained on a single VFT. The difference was probably due to nonuniformities in the fabrication process, which caused some of the junctions not to be biased in the flux flow state or receive the same amount of magnetic field from the control line. However, measurements of the array showed that a large number of VFTs could be connected in series and simultaneously be biased into the flux flow state.>

IEEE Transactions on Magnetics•Mar 1, 1989•11 citations

DC and AC Responses of Josephson Vortex Flow Transistors with High Tc Superconducting Thin Films

Yasushi Doda

We fabricated Josephson vortex flow transistors (JVFTs) with a parallel array of Josephson junctions that were prepared using c-axis-oriented 100-nm-thick YBa 2 Cu 3 O 7-δ (YBCO) thin films grown on 24° bicrystal MgO (100) substrates. We observed clear modulations of the critical current and the flow voltage with DC current input to the control line that was inductively coupled to the array of junctions. From the results, we estimated the parameters of the device, e.g., the mutual inductance and the self-inductance, and calculated the operation frequency at which the device potentially exhibited these parameters. Moreover, the current gain and the transresistance were evaluated and found to be 0.5 and 0.15 Ω, respectively. In addition, we observed the high-frequency responses of the JVFT to the input AC current of the sine wave or the square pulse wave. A clear oscillation of the output voltage could be observed with a 1 MHz sine wave and 250 kHz square pulse wave. We also discussed the feasibility of higher frequency operation by using it as an input interface for a single flux quantum (SFQ) logic circuit.

IEICE Transactions on Electronics•Feb 1, 2006•5 citations

Review of microwave distributed superconducting vortex-flow transistor amplifiers

R.C. Yalamanchili, ZHENG AN QIU, Yen-Chu Wang

The dynamics of fluxons in the vortex flow transistor (VFT) has been much studied. The fluxon transit time determines the fundamental speed limit of operation. Since fluxons can travel at the velocity of electromagnetic waves in the junction, the VFT has the potential for operating in high frequency systems ( ≈ 100 GHz). However, owing to the low input and output impedance of the VFT, use of the device in a conventional circuit would be quite limited. A distributed amplifier configuration consisting of many VFTs has been proposed to remedy the problems of low impedance levels. However, the realization of such an amplifier circuit at microwave or millimetre wave frequencies depends on obtaining a circuit model. In this paper, microwave superconducting VFT distributed amplifiers using the balanced control technique is reviewed. This kind of amplifier has the advantage that the capacitive feedthrough effect is decreased to a negligible extent. This is the major limiting factor for high frequency applications. The self-field effect which makes the current step inclined is reduced by injecting bias current only around the region of one end of the junction thus obtaining steeper I- V characteristics. With the asymmetric geometry, the slope of the current step is about one hundred times steeper than those obtained with the conventional overlap geometry. Owing to the diamagnetic behaviour of the Josephson junction, a little of the magnetic field induced by the current in the control line is allowed to penetrate the junction. Thus, the transresistance rm of a VFT is very small. Some methods for maximizing rm and minimizing the output impedance r0 also appear in this review. The feasibility of fabricating VFT distributed amplifiers using low-Tc superconducting material has been demonstrated. The power gain of the amplifier can be as high as 15 dB with a flat frequency response.

International Journal of Electronics•Sep 1, 1992•3 citations

S-parameter measurements and microwave applications of superconducting flux flow transistors

J. Martens, VINCENT M. HIETALA, T. E. Zipperian +3 more

Microwave two-port S-parameter measurements and modeling of superconducting flux flow transistors are presented. The transistors, based on the magnetic control of flux flow in any array of high temperature superconducting weak links, exhibit significant available power gain at microwave frequencies (over 20 dB at 7-10 GHz in some devices). The input impedance is largely inductive while the output impedance is both resistive and inductive. It is shown that the characteristics of these devices are useful in numerous applications including matched amplifiers, phase shifters and active impedance convertors.>

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1991•32 citations
Discrete arrays of underdamped Josephson junctions can be used as oscillators and transistors for superconducting electronic applications.Both devices require that the system be biased in the flux-flow regime of its current-voltage characteristic.We present measurements and models for the performance of these devices.We find that the presence of a superconducting ground plane improves all of the device parameters except the transresistance.We further refined the devices by connecting two arrays in series.Magnetic coupling between adjacent loops of this array has a significant influence on the dynamics.A theoretical treatment shows that the coupling causes splitting of Fiske steps, zero-field steps, and flux-flow steps.Since we are considering device applications, our measurements focus on the splitting of the flux-flow step.This configuration produces steps at higher voltage levels with improved transresistances, but with degraded output resistance.The power and bandwidth are relatively unaffected.Inductively coupled arrays may be promising for some applications, but the dynamics must be more thoroughly investigated before this potential can be realized.
Vortex flow devices consisting of discrete arrays of underdamped Josephson junctions have been fabricated and measured. These devices and their long, continuous junction counterparts are based on the ability to magnetically control the Eck voltage in an underdamped system. We find that both transistor and oscillator parameters are improved by placing the arrays above a superconducting ground plane and by connecting two arrays in series. We developed models for the device behavior which numerically account for the measured parameters. Our models also suggest that junctions with smaller capacitances will further improve the device parameters.>
We have measured vortex motion in a long one-dimensional array of small underdamped niobium tunnel junctions which are coupled in parallel by superconducting wires. In the current-voltage characteristic, a resonant step occurs similar to the Eck peak in long continuous junctions. Due to the discrete nature of our samples, the voltage of this resonant step follows a sinusoidal dependence on the magnetic field rather than the linear dependence found in long continuous junctions. With a control current applied parallel to the array of junctions, the device can be operated as a vortex-flow transistor or as a tunable vortex-flow oscillator. Compared to long continuous junctions, the performance of discrete transistors is better with regard to the threshold current and transresistance, but worse with regard to the output resistance. Discrete oscillators have the advantage over their continuous counterparts in that the output impedance is of the order of 10 Ω. Numerical simulations indicate power levels around 0.5 μW and frequencies above 500 GHz.
A niobium-based superconducting amplifier consisting of a series array of 60 vortex flow transistors (VFT) was fabricated and tested. Each VFT consisted of a long Josephson junction biased in the flux flow state, magnetically coupled to a current based on a distributed amplifier configuration. The transresistance of the amplifier in a 50- Omega environment for frequencies up to 1 MHz was measured. The transresistance of the array was less than the expected value calculated from measurements obtained on a single VFT. The difference was probably due to nonuniformities in the fabrication process, which caused some of the junctions not to be biased in the flux flow state or receive the same amount of magnetic field from the control line. However, measurements of the array showed that a large number of VFTs could be connected in series and simultaneously be biased into the flux flow state.>
We fabricated Josephson vortex flow transistors (JVFTs) with a parallel array of Josephson junctions that were prepared using c-axis-oriented 100-nm-thick YBa 2 Cu 3 O 7-δ (YBCO) thin films grown on 24° bicrystal MgO (100) substrates. We observed clear modulations of the critical current and the flow voltage with DC current input to the control line that was inductively coupled to the array of junctions. From the results, we estimated the parameters of the device, e.g., the mutual inductance and the self-inductance, and calculated the operation frequency at which the device potentially exhibited these parameters. Moreover, the current gain and the transresistance were evaluated and found to be 0.5 and 0.15 Ω, respectively. In addition, we observed the high-frequency responses of the JVFT to the input AC current of the sine wave or the square pulse wave. A clear oscillation of the output voltage could be observed with a 1 MHz sine wave and 250 kHz square pulse wave. We also discussed the feasibility of higher frequency operation by using it as an input interface for a single flux quantum (SFQ) logic circuit.
The dynamics of fluxons in the vortex flow transistor (VFT) has been much studied. The fluxon transit time determines the fundamental speed limit of operation. Since fluxons can travel at the velocity of electromagnetic waves in the junction, the VFT has the potential for operating in high frequency systems ( ≈ 100 GHz). However, owing to the low input and output impedance of the VFT, use of the device in a conventional circuit would be quite limited. A distributed amplifier configuration consisting of many VFTs has been proposed to remedy the problems of low impedance levels. However, the realization of such an amplifier circuit at microwave or millimetre wave frequencies depends on obtaining a circuit model. In this paper, microwave superconducting VFT distributed amplifiers using the balanced control technique is reviewed. This kind of amplifier has the advantage that the capacitive feedthrough effect is decreased to a negligible extent. This is the major limiting factor for high frequency applications. The self-field effect which makes the current step inclined is reduced by injecting bias current only around the region of one end of the junction thus obtaining steeper I- V characteristics. With the asymmetric geometry, the slope of the current step is about one hundred times steeper than those obtained with the conventional overlap geometry. Owing to the diamagnetic behaviour of the Josephson junction, a little of the magnetic field induced by the current in the control line is allowed to penetrate the junction. Thus, the transresistance rm of a VFT is very small. Some methods for maximizing rm and minimizing the output impedance r0 also appear in this review. The feasibility of fabricating VFT distributed amplifiers using low-Tc superconducting material has been demonstrated. The power gain of the amplifier can be as high as 15 dB with a flat frequency response.
Microwave two-port S-parameter measurements and modeling of superconducting flux flow transistors are presented. The transistors, based on the magnetic control of flux flow in any array of high temperature superconducting weak links, exhibit significant available power gain at microwave frequencies (over 20 dB at 7-10 GHz in some devices). The input impedance is largely inductive while the output impedance is both resistive and inductive. It is shown that the characteristics of these devices are useful in numerous applications including matched amplifiers, phase shifters and active impedance convertors.>