Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

The temperature dependence of decoherence in superconducting flux qubits coupled to microwave resonators

Jean-Luc Orgiazzi, Chunqing Deng, Feiruo Shen, Nicolas Zapata González, Adrian Lupaşcu

Published Mar 2, 2015• 0 citations
OpenAlex

Related papers

Decoherence of superconducting flux qubits in coplanar waveguide resonators

Adrian Lupaşcu, Jean-Luc Orgiazzi, David Layden +4 more

Bulletin of the American Physical Society•Mar 4, 2014•0 citations

Circuit Quantum Electrodynamics with Flux Qubits

Jean-Luc Orgiazzi

This thesis presents circuit quantum electrodynamic (cQED) experiments done with artificial atoms coupled to a high quality factor superconducting microwave resonator. This work discusses the theoretical framework, design, fabrication, implementation and characterization of a multi-qubit system using superconducting persistent current qubits, often referred as flux qubits. \n \nWe developed a new type of cryogenic aid for fast turnaround microwave experiments. The minimum turnaround time to perform microwave experiments in dilution refrigerators is typically a few days, as required by cooling down and warming up the entire refrigerator. The cryogenic microwave payload and wiring needed for each qubit and resonator add a significant heat load to \nthe system which typically only has a few µW s of cooling power at millikelvin temperatures. We present a new experimental approach we developed in which a suitable sample holder is attached to a cold-insertable probe and brought in contact with transmission lines permanently mounted inside the cryostat. The total turnaround time is reduced to 8 hours if the target temperature is 80 mK. This new measurement method increased our ability to successfully identify good devices with fast design-characterization iterations, while allowing months-long measurements at 30 mK. \n \nOur device architecture uses several qubits, each of which is controlled via on-chip fast flux bias lines. Readout of the qubit’s quantum state is performed by homodyne detection of the resonator field at large driving power. We observe long coherence times at the optimal bias point of the flux qubits and present decoherence measurements around this optimal point, where the \nflux qubits couple mostly to magnetic flux noise. Dynamical decoupling techniques employing fast microwave pulses are used to protect the qubit’s coherence and allow calculating the magnetic flux noise power spectral density of the qubit’s environment. Photon-mediated interaction between distant qubits in the resonator allows the implementation of a two-qubit controlled-NOT gate \nusing the selective darkening technique. \n \nThis multi-qubit superconducting design is an interesting platform to study the decoherence properties of flux qubits, the properties of strong interaction of electromagnetic radiation with macroscopic quantum systems. These results demonstrate the potential of cQED as a platform for fundamental investigations of decoherence and quantum dynamics of flux qubits.

•Sep 23, 2019•0 citations

Phase versus flux coupling between resonator and superconducting flux qubit

Jeffrey Birenbaum, Sean R. O’Kelley, S.M. Anton +11 more

Bulletin of the American Physical Society•Mar 21, 2013•0 citations

Control of the transition frequency of a superconducting flux qubit by longitudinal coupling to the photon number degree of freedom in a resonator

Hiraku Toida, Takuya Ohrai, Yuichiro Matsuzaki +2 more

We control the transition frequency of a superconducting flux qubit coupled to a frequency-tunable resonator comprising a direct current superconducting quantum interference device (dc SQUID) by microwave driving. The dc SQUID mediates the coupling between microwave photons in the resonator and a flux qubit. The polarity of the frequency shift depends on the sign of the flux bias for the qubit and can be both positive and negative. The absolute value of the frequency shift becomes larger by increasing the photon number in the resonator. These behaviors are reproduced by a model considering the magnetic interaction between the flux qubit and dc SQUID. The tuning range of the transition frequency of the flux qubit reaches $\ensuremath{\approx}1.9\phantom{\rule{0.16em}{0ex}}\mathrm{GHz}$. The effect of photon number fluctuation in the resonator to the dephasing rate of the flux qubit is also discussed.

arXiv:2005.06155•Physical review. B./Physical review. B•Sep 3, 2020•5 citations

Fast control and decoherence in superconducting quantum circuits

Chunqing Deng

This thesis discusses a series of experimental and theoretical studies on fast control and decoherence in superconducting quantum circuits. These two subjects are complementary aspects of the problem of improving the gate fidelities in quantum information processing devices based on superconducting circuits. \n \nIn the first part of this thesis, we present experiments on fast control of a superconducting flux qubit using strong driving. We explore driving with short pulses and a driving strength significantly exceeding the transition frequency. The observed dynamics is described in terms of quasienergies and quasienergy states, in agreement with Floquet theory. We observe the role of pulse shaping in the dynamics, as determined by non-adiabatic transitions between Floquet states. In addition, based on adiabatic perturbation theory in the Floquet picture, we propose a control scheme for fast and high-fidelity single-qubit operations with strong driving. These results pave the way to quantum control with a fidelity beyond the threshold of fault-tolerant quantum computation. \n \nIn the second part of this thesis, we discuss experimental methods and present the characterization of decoherence in superconducting resonators and superconducting qubits. Firstly, we present an analysis method on the measurements of photon loss in superconducting resonators. We use this method to characterize the microwave loss of aluminum oxide, an important material in superconducting circuits. The power and temperature dependence of the measured loss is consistent with loss due to two-level defects in amorphous materials. Secondly, we present experimental results on decoherence and noise spectroscopy of a superconducting flux qubit. Using the qubit as a noise spectrometer, we perform detailed measurements on the power spectral density of the flux noise in superconducting circuits over a wide range of frequencies, from 10^-3 to 10^8 Hz, and over a temperature range from 35 to 130 mK. We also present measurements of frequency and temperature dependence of the qubit energy relaxation.

•Aug 24, 2015•1 citation

Cavity-induced decoherence in a long-lived superconducting flux qubit

Fei Yan, Archana Kamal, Theodore Gudmundsen +3 more

Bulletin of the American Physical Society•Mar 2, 2015•0 citations
This thesis presents circuit quantum electrodynamic (cQED) experiments done with artificial atoms coupled to a high quality factor superconducting microwave resonator. This work discusses the theoretical framework, design, fabrication, implementation and characterization of a multi-qubit system using superconducting persistent current qubits, often referred as flux qubits. \n \nWe developed a new type of cryogenic aid for fast turnaround microwave experiments. The minimum turnaround time to perform microwave experiments in dilution refrigerators is typically a few days, as required by cooling down and warming up the entire refrigerator. The cryogenic microwave payload and wiring needed for each qubit and resonator add a significant heat load to \nthe system which typically only has a few µW s of cooling power at millikelvin temperatures. We present a new experimental approach we developed in which a suitable sample holder is attached to a cold-insertable probe and brought in contact with transmission lines permanently mounted inside the cryostat. The total turnaround time is reduced to 8 hours if the target temperature is 80 mK. This new measurement method increased our ability to successfully identify good devices with fast design-characterization iterations, while allowing months-long measurements at 30 mK. \n \nOur device architecture uses several qubits, each of which is controlled via on-chip fast flux bias lines. Readout of the qubit’s quantum state is performed by homodyne detection of the resonator field at large driving power. We observe long coherence times at the optimal bias point of the flux qubits and present decoherence measurements around this optimal point, where the \nflux qubits couple mostly to magnetic flux noise. Dynamical decoupling techniques employing fast microwave pulses are used to protect the qubit’s coherence and allow calculating the magnetic flux noise power spectral density of the qubit’s environment. Photon-mediated interaction between distant qubits in the resonator allows the implementation of a two-qubit controlled-NOT gate \nusing the selective darkening technique. \n \nThis multi-qubit superconducting design is an interesting platform to study the decoherence properties of flux qubits, the properties of strong interaction of electromagnetic radiation with macroscopic quantum systems. These results demonstrate the potential of cQED as a platform for fundamental investigations of decoherence and quantum dynamics of flux qubits.
We control the transition frequency of a superconducting flux qubit coupled to a frequency-tunable resonator comprising a direct current superconducting quantum interference device (dc SQUID) by microwave driving. The dc SQUID mediates the coupling between microwave photons in the resonator and a flux qubit. The polarity of the frequency shift depends on the sign of the flux bias for the qubit and can be both positive and negative. The absolute value of the frequency shift becomes larger by increasing the photon number in the resonator. These behaviors are reproduced by a model considering the magnetic interaction between the flux qubit and dc SQUID. The tuning range of the transition frequency of the flux qubit reaches $\ensuremath{\approx}1.9\phantom{\rule{0.16em}{0ex}}\mathrm{GHz}$. The effect of photon number fluctuation in the resonator to the dephasing rate of the flux qubit is also discussed.
This thesis discusses a series of experimental and theoretical studies on fast control and decoherence in superconducting quantum circuits. These two subjects are complementary aspects of the problem of improving the gate fidelities in quantum information processing devices based on superconducting circuits. \n \nIn the first part of this thesis, we present experiments on fast control of a superconducting flux qubit using strong driving. We explore driving with short pulses and a driving strength significantly exceeding the transition frequency. The observed dynamics is described in terms of quasienergies and quasienergy states, in agreement with Floquet theory. We observe the role of pulse shaping in the dynamics, as determined by non-adiabatic transitions between Floquet states. In addition, based on adiabatic perturbation theory in the Floquet picture, we propose a control scheme for fast and high-fidelity single-qubit operations with strong driving. These results pave the way to quantum control with a fidelity beyond the threshold of fault-tolerant quantum computation. \n \nIn the second part of this thesis, we discuss experimental methods and present the characterization of decoherence in superconducting resonators and superconducting qubits. Firstly, we present an analysis method on the measurements of photon loss in superconducting resonators. We use this method to characterize the microwave loss of aluminum oxide, an important material in superconducting circuits. The power and temperature dependence of the measured loss is consistent with loss due to two-level defects in amorphous materials. Secondly, we present experimental results on decoherence and noise spectroscopy of a superconducting flux qubit. Using the qubit as a noise spectrometer, we perform detailed measurements on the power spectral density of the flux noise in superconducting circuits over a wide range of frequencies, from 10^-3 to 10^8 Hz, and over a temperature range from 35 to 130 mK. We also present measurements of frequency and temperature dependence of the qubit energy relaxation.