Real-time monitoring of a quantum state provides powerful tools for studying the backaction of quantum measurement and performing quantum feedback. Historically, this monitoring capability has been the exclusive province of atomic and optical physics. This thesis describes the implementation of the first such high-fidelity readout scheme in a solid state circuit, a superconducting quantum bit (qubit) coupled to a microwave cavity in the circuit quantum electrodynamics (circuit QED) architecture. The qubit-state-dependent resonance frequency of the cavity is probed with a microwave drive tone, and the resulting signal amplified using a fast, ultralow-noise superconducting parametric amplifier. This arrangement enables the observation of quantum jumps between the qubit states in real time. The ability to monitor the qubit continuously with high fidelity and resolve quantum jumps can be used to investigate the backaction of the measurement process on the qubit. This thesis examines the quantum Zeno effect--where strong measurement inhibits the evolution of a quantum system-- as well as the transition to non-ideal measurement with increasing measurement strength in the circuit QED architecture, a phenomenon shown to be due to the upconversion of low-frequency dephasing noise. These data allow probes of ``universal'' flux noise in previously inaccessible frequency ranges. The work presented here opens the door for quantum feedback and error correction in solid-state quantum systems using continuous weak measurement.
Real-time monitoring of a quantum state provides powerful tools for studying the backaction of quantum measurement and performing quantum feedback. Historically, this monitoring capability has been the exclusive province of atomic and optical physics. This thesis describes the implementation of the first such high-fidelity readout scheme in a solid state circuit, a superconducting quantum bit (qubit) coupled to a microwave cavity in the circuit quantum electrodynamics (circuit QED) architecture. The qubit-state-dependent resonance frequency of the cavity is probed with a microwave drive tone, and the resulting signal amplified using a fast, ultralow-noise superconducting parametric amplifier. This arrangement enables the observation of quantum jumps between the qubit states in real time. The ability to monitor the qubit continuously with high fidelity and resolve quantum jumps can be used to investigate the backaction of the measurement process on the qubit. This thesis examines the quantum Zeno effect--where strong measurement inhibits the evolution of a quantum system-- as well as the transition to non-ideal measurement with increasing measurement strength in the circuit QED architecture, a phenomenon shown to be due to the upconversion of low-frequency dephasing noise. These data allow probes of ``universal'' flux noise in previously inaccessible frequency ranges. The work presented here opens the door for quantum feedback and error correction in solid-state quantum systems using continuous weak measurement.
We measure the state of a superconducting quantum bit (qubit) coupled to a microwave cavity by scattering a microwave signal from the cavity. The scattered signal is amplified using a low-noise Josephson parametric amplifier. We carried out measurements to infer the coherence properties of the qubit. In the strong measurement regime, we observe quantum jumps between the qubit states in real time, while we observe stochastic quantum trajectories in the weak measurement regime. The coherence times and measurement fidelity obtained are sufficient for implementing quantum error correction.
Circuit quantum electrodynamics (cQED), exemplified by a coupled system of a superconducting qubit and a microwave cavity, is a powerful framework for the quantum control and measurement of macroscopic quantum states in solid-state circuits. Quantum circuits based on superconducting qubits have emerged as one of the leading platforms in the pursuit of fault-tolerant quantum computing. Despite significant progress in extending qubit lifetimes, refining experimental protocols, and scaling up quantum processors, errors arising from the control and measurement of superconducting qubits continue to hinder the realization of a universal quantum computer. To investigate the error mechanisms for state-of-the-art qubits, we realize long-lived superconducting transmon qubits that exhibit fluctuating lifetimes, with an average of 0.2 ms and a maximum exceeding 0.4 ms. We then investigate their dominant error mechanism. By introducing novel time-resolved error measurements that are synchronized with the operation of the pulse tube cooler in a dilution refrigerator, we find that mechanical vibrations from the pulse tube induce nonequilibrium dynamics in highly coherent qubits, leading to their correlated bit-flip errors. Our findings not only deepen our understanding of qubit error mechanisms but also provide valuable insights into potential error-mitigation strategies for achieving fault tolerance by decoupling superconducting qubits from their mechanical environments. We also present a novel scheme for operating a cQED system in a regime where the cavity is largely displaced. We find that a qubit drive at the bare cavity frequency can effectively displace the cavity field while minimizing the cavity-drive-induced dephasing and the ac Stark shift. Furthermore, we demonstrate that standard cQED protocols, such as qubit control, readout, and cavity single-photon generation, remain compatible with largely displaced cavity fields, even beyond the critical photon number. These findings open new pathways for exploring cQED dynamics in large-photon-number regimes, including the study of nonlinear phenomena in microwave cavities, the saturation of two-level system baths for extending the coherence of microwave quantum states, and the acceleration of the dispersive readout. Finally, mechanical resonators have emerged as integral components in quantum computing for storing and transducing quantum information. Low-frequency mechanical resonators, with extremely low energy dissipation rates, are particularly interesting for extending the lifetimes of stored quantum information. However, integrating low-frequency mechanical resonators with qubits is challenging because their small energy gaps make coherent energy exchange and ground-state preparation difficult. In this thesis, we report the first steps towards the characterization of a hybrid quantum device, consisting of a Transmon qubit and a circuit optomechanical system, both coupled to a 3D microwave cavity.
Though superconducting qubits offer the potential for a scalable quantum computing architecture, the high-fidelity readout necessary to execute practical algorithms has thus far remained elusive. Moreover, achievements toward high fidelity have been accompanied by either long measurement times or demolition of the quantum state. In this dissertation, we address these issues with the novel integration of two ultralow-noise, superconducting amplifiers into separate dispersive flux qubit measurements. We first demonstrate a flux qubit inductively coupled to a 1.294-GHz nonlinear oscillator formed by a capacitively shunted DC SQUID. The frequency of the oscillator is modulated by the state of the qubit and is detected via microwave reflectometry. A microstrip SQUID (Superconducting QUantum Interference Device) amplifier (MSA) is used to increase the sensitivity of the measurement over that of a semiconductor amplifier. In the second experiment, we report measurements of a flux qubit coupled via a shared inductance to a quasi-lumped element 5.78-GHz readout resonator formed by the parallel combination of an interdigitated capacitor and a meander line inductor. The system noise is substantially reduced by a near-quantum-limited Josephson parametric amplifier (paramp).We present measurements of increased fidelity and reduced measurement backaction using the MSA at readout excitation levels as low as one hundredth of a photon in the readout resonator, observing a 4.5-fold increase in the readout visibility. Furthermore, at low readout excitation levels below one tenth of a photon in the readout resonator, no reduction in T1 is observed, potentially enabling continuous monitoring of the qubit state. Using the paramp, we demonstrate a continuous, high-fidelity readout with sufficient bandwidth and signal-to-noise ratio to resolve quantum jumps in the flux qubit. This is enabled by a readout which discriminates between the readout pointer state distributions to an error below one part in 1000. This, along with the ability to make many successive readouts in a time T1, permits the use of heralding to ensure initialization to a fiducial state, such as the ground state. This method enables us to eliminate errors due to spurious thermal population, increasing the fidelity to 93.9%. Finally, we use heralding to introduce a simple, fast qubit reset protocol without changing the system parameters to induce Purcell relaxation.
Though superconducting qubits offer the potential for a scalable quantum computing architecture, the high-fidelity readout necessary to execute practical algorithms has thus far remained elusive. Moreover, achievements toward high fidelity have been accompanied by either long measurement times or demolition of the quantum state. In this dissertation, we address these issues with the novel integration of two ultralow-noise, superconducting amplifiers into separate dispersive flux qubit measurements. We first demonstrate a flux qubit inductively coupled to a 1.294-GHz nonlinear oscillator formed by a capacitively shunted DC SQUID. The frequency of the oscillator is modulated by the state of the qubit and is detected via microwave reflectometry. A microstrip SQUID (Superconducting QUantum Interference Device) amplifier (MSA) is used to increase the sensitivity of the measurement over that of a semiconductor amplifier. In the second experiment, we report measurements of a flux qubit coupled via a shared inductance to a quasi-lumped element 5.78-GHz readout resonator formed by the parallel combination of an interdigitated capacitor and a meander line inductor. The system noise is substantially reduced by a near-quantum-limited Josephson parametric amplifier (paramp).We present measurements of increased fidelity and reduced measurement backaction using the MSA at readout excitation levels as low as one hundredth of a photon in the readout resonator, observing a 4.5-fold increase in the readout visibility. Furthermore, at low readout excitation levels below one tenth of a photon in the readout resonator, no reduction in T1 is observed, potentially enabling continuous monitoring of the qubit state. Using the paramp, we demonstrate a continuous, high-fidelity readout with sufficient bandwidth and signal-to-noise ratio to resolve quantum jumps in the flux qubit. This is enabled by a readout which discriminates between the readout pointer state distributions to an error below one part in 1000. This, along with the ability to make many successive readouts in a time T1, permits the use of heralding to ensure initialization to a fiducial state, such as the ground state. This method enables us to eliminate errors due to spurious thermal population, increasing the fidelity to 93.9%. Finally, we use heralding to introduce a simple, fast qubit reset protocol without changing the system parameters to induce Purcell relaxation.
In this thesis, experimentally relevant aspects and open questions of quantum information processing and measurement in circuit quantum electrodynamics have been investigated theoretically. Circuit quantum electrodynamics is a relatively young field combining superconducting transmission line resonators on-chip with superconducting quantum bits which serve as artificial atoms. Remarkable experiments have underlined the prospects of circuit QED as a possible architecture for quantum information processing as well as a framework within which quantum optics experiments can be performed. In contrast to their optical counterparts, these experiments reach the ultra-strong coupling limit and allow e.g. the generation of Fock states, the study of decoherence and the observation of quantum jumps. We present the physics of superconducting circuits based on the Josephson junction as a non-linear circuit element. We discuss the various types of quantum bits (qubits) before turning to an introduction on cavity QED and conclude the introduction with a brief presentation of the most relevant experiments and a short introduction to the principles and prospects of quantum information processing. Building on the pioneering theoretical and experimental work in which up to three qubits have been integrated on a chip and successfully coupled via a cavity mode, we propose a scheme to overcome the natural limits concerning scalability in these systems. Usually, scalability is severely limited by the resonance width of the qubit transitions and the attainable frequency range for both qubit transition and cavity resonance frequencies. This limits the present setups to at most ten qubits. As a possible solution, we propose and investigate a cross-bar grid layout of cavities with qubits at the intersections. It turns out that this setup, allowing for up to about 1000 qubits, offers significant advantages over e.g. nearest-neighbor coupling schemes. In addition, it can serve as a building block for a truly scalable scheme for fault-tolerant quantum information processing with superconducting circuits by combining 7x7 arrays in a staircase manner. Furthermore, we discuss and simulate different possibilities to improve upon the suggested scheme by e.g. using resonant gates and optimal control theory. Another focus of the present thesis is measurement physics. In order to investigate e.g. the possibilities of using a circuit QED system to dispersively detect single microwave photons or to generate multi-qubit entangled states, we introduce in a pedagogical manner the basics of stochastic master equations which generate quantum trajectories before turning to concrete applications. Quantum trajectories have proven to be a state-of-the-art tool to analyze measurement situations in a very realistic manner by giving access to both the measurement record as well as the internal quantum dynamics conditioned on this record. Using the method of quantum trajectories as generated by stochastic master equations, we discuss a scheme to efficiently generate multi-qubit entangled states in a very flexible way. The method is based on a collective, dispersive qubit readout. By this measurement, a suitable product state of N qubits can be reliably converted into e.g. an N-qubit Greenberger-Horne-Zeilinger or W state. We propose and discuss the scheme and investigate the effects of decoherence and parameter spread as they would be encountered in experiment. Last but not least, we propose and fully analyze a scheme to dispersively detect single itinerant microwave photons. While experiments to generate single microwave photons have already been successfully performed, their single-shot quantum non-demolition detection has not been possible so far. The scheme presented in this thesis closes this gap in the circuit QED toolbox and reaches detection efficiencies of 30% only limited by fundamental quantum mechanics in this case the Quantum Zeno effect. This detection scheme could be used in quantum communication or quantum cryptography applications.