Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of the IEEE

Millimeter and submillimeter wave detection and mixing with superconducting weak links

P. L. Richards, F. Auracher, T. Van Duzer

Published Jan 1, 1973• 41 citations
Publisher

Abstract

A weak link between two bulk superconductors can exhibit Josephson effects and can be used as a fast sensitive detector or mixer for electromagnetic radiation. Emphasis is placed on the millimeter and submillimeter range where such applications are potentially most important, though such devices should also work well at lower frequencies. The peculiar properties of the weak link make possible a variety of modes of operation including one in which it is both local oscillator and mixer. These modes of operation are analyzed and the pivotal experiments are reviewed. Noise and impedance matching are considered and comparison is made with other types of detectors of millimeter and submillimeter waves.

DOI
10.1109/proc.1973.8967

Related papers

Superconducting devices for millimeter and submillimeter wavelengths

P. L. Richards

Josephson junctions are highly nonlinear and respond up to infrared frequencies. A wide variety of high frequency applications have been explored. In addition, several high frequency superconducting devices are being developed which do not use the Josephson effect. These include a superconducting version of the Schottky barrier diode for use as a heterodyne mixer and a video detector, and also a composite superconducting bolometer. In this review, the state of development of superconducting mixers, detectors, and parametric amplifiers at microwave, millimeter, and submillimeter wavelengths is discussed. Emphasis will be placed on developments which have taken place since 1974 when a previous review was circulated.

De Gruyter eBooks•Dec 31, 1977•7 citations

Millimeter and submillimeter wave mixers based on superconducting weak links

Janusz Konopka, I. Wolff

Principles of operation of superconducting mixers based on: Superconductor-Insulator-Superconductor (SIS) tunnel junctions, Josephson junctions in high temperature superconductors and on superconducting hot-electron-microbolometers are presented. Most recent results on all types of superconducting mixers, with special attention paid to noise properties is reviewed.

International Conference on Microwaves, Radar & Wireless Communications•Nov 27, 2002•0 citations

THE JOSEPHSON JUNCTION AS A 100 GHz OSCILLATOR-MIXER,

Andrew Longacre, Sidney Shapiro

Abstract : The term 'Josephson effects' refers to a number of unusual properties of current flow through a barrier or weak link between two superconductors. Such a structure--called a Josephson junction--gives rise to frequency conversion effects that suggest its use as an oscillator-mixer in the millimeter and submillimeter region. Such a device would offer high sensitivity, broad bandwidth, tunability, and, in certain modes of operation, the possibility of conversion gain. These frequency conversion effects were observed in the range of 100 GHz to 600 GHz and beyond. The junctions were driven by a 75 GHz or 25 GHz klystron while coupled either to a coaxial cavity resonant at 20 GHz or to a resonance at about 500 GHz associated with the junction structure. Lines in the junction voltage-current characteristic were observed which demonstrated that, at certain values of junction bias, power at the rf--or its harmonics--was converted to power at the resonance frequency. An explanation of the experiment is given together with the necessary background, which provides the basis for a discussion of such operational considerations as upper frequency limit, sensitivity, temperature of operation, and saturation behavior at high signal levels. (Author)

•Apr 1, 1970•1 citation

Submillimeter-wave detection with superconducting tunnel diodes

Michael J. Wengler

The review presents a theoretical framework for understanding submillimeter detection using an optical photodiode theory. Both gain and noise in the superconductor-insulator-superconductor (SIS) mixer are described in terms of mixing on a photodiode. The role of impedance matching in the proper design of an SIS mixer is described. A variety of methods for achieving good impedance match at submillimeter frequencies are presented. The state of the submillimeter SIS mixer art as practiced in a variety of laboratories is described and summarized.>

Proceedings of the IEEE•Jan 1, 1992•74 citations

Superconductive devices for millimeter wave detection mixing and amplification

P. L. Richards, T. M. Shen

Single particle (quasiparticle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very low noise detectors and mixers for millimeter wavelengths. The nonlinearity of the I-V curve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasiparticle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limit T sub M = h omega/k. Both of these predictions have been experimentally realized at 36GHz using superconductor-insulator-superconductor junctions. It appears probable that these quasiparticle detectors and mixers will supercede the corresponding Josephson effect devices at millimeter wavelengths. (Author)

NASA STI/Recon Technical Report N•Jan 1, 1980•0 citations

Frequency conversion with superconducting point contacts operating as oscillator-mixers and its application to the measurement of the linewidth of the Josephson current at very high frequency

G. Vernet, Robert Adde

The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.

Revue de Physique Appliquée•Jan 1, 1974•3 citations
A weak link between two bulk superconductors can exhibit Josephson effects and can be used as a fast sensitive detector or mixer for electromagnetic radiation. Emphasis is placed on the millimeter and submillimeter range where such applications are potentially most important, though such devices should also work well at lower frequencies. The peculiar properties of the weak link make possible a variety of modes of operation including one in which it is both local oscillator and mixer. These modes of operation are analyzed and the pivotal experiments are reviewed. Noise and impedance matching are considered and comparison is made with other types of detectors of millimeter and submillimeter waves.
Josephson junctions are highly nonlinear and respond up to infrared frequencies. A wide variety of high frequency applications have been explored. In addition, several high frequency superconducting devices are being developed which do not use the Josephson effect. These include a superconducting version of the Schottky barrier diode for use as a heterodyne mixer and a video detector, and also a composite superconducting bolometer. In this review, the state of development of superconducting mixers, detectors, and parametric amplifiers at microwave, millimeter, and submillimeter wavelengths is discussed. Emphasis will be placed on developments which have taken place since 1974 when a previous review was circulated.
Abstract : The term 'Josephson effects' refers to a number of unusual properties of current flow through a barrier or weak link between two superconductors. Such a structure--called a Josephson junction--gives rise to frequency conversion effects that suggest its use as an oscillator-mixer in the millimeter and submillimeter region. Such a device would offer high sensitivity, broad bandwidth, tunability, and, in certain modes of operation, the possibility of conversion gain. These frequency conversion effects were observed in the range of 100 GHz to 600 GHz and beyond. The junctions were driven by a 75 GHz or 25 GHz klystron while coupled either to a coaxial cavity resonant at 20 GHz or to a resonance at about 500 GHz associated with the junction structure. Lines in the junction voltage-current characteristic were observed which demonstrated that, at certain values of junction bias, power at the rf--or its harmonics--was converted to power at the resonance frequency. An explanation of the experiment is given together with the necessary background, which provides the basis for a discussion of such operational considerations as upper frequency limit, sensitivity, temperature of operation, and saturation behavior at high signal levels. (Author)
The review presents a theoretical framework for understanding submillimeter detection using an optical photodiode theory. Both gain and noise in the superconductor-insulator-superconductor (SIS) mixer are described in terms of mixing on a photodiode. The role of impedance matching in the proper design of an SIS mixer is described. A variety of methods for achieving good impedance match at submillimeter frequencies are presented. The state of the submillimeter SIS mixer art as practiced in a variety of laboratories is described and summarized.>
Single particle (quasiparticle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very low noise detectors and mixers for millimeter wavelengths. The nonlinearity of the I-V curve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasiparticle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limit T sub M = h omega/k. Both of these predictions have been experimentally realized at 36GHz using superconductor-insulator-superconductor junctions. It appears probable that these quasiparticle detectors and mixers will supercede the corresponding Josephson effect devices at millimeter wavelengths. (Author)
The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.