Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Niobium Josephson junction bolometers for optical detection in the visible-infrared region

E. Monticone, V. Lacquaniti, R. Steni, M. Rajteri, Maria Luisa Rastello, L. Parlato, Giuseppe Ammendola

Published Jun 1, 1999• 4 citations
Publisher

Abstract

The response of Nb Josephson junctions fabricated on different substrates, silicon and amorphous glass, is measured under optical illumination at several conditions of light intensity and light chopping frequency. The linearity of the response on the optical power extends over five orders of magnitude. The signal of the junction on silicon is 2 orders of magnitude lower than that of the junction on amorphous glass, but at least one order of magnitude faster, as the time constant of a directly irradiated junction on silicon is lower than 10 /spl mu/s. The signal dependence on chopping frequency of the junction on amorphous glass is typical of a strong thermal coupling between film and substrate, while for the junction on silicon it depends mainly on the thermal boundary resistance between film and substrate.

DOI
10.1109/77.783871

Related papers

Analysis of NB Josephson Junction Properties under Optical Irradiation

E. Monticone, M. Rajteri, Sabino Maggi +6 more

The gap voltage shift of Nb Josephson junctions fabricated on different substrates is measured under optical illumination at several conditions of light intensity and chopping frequency. The signal dependence on the chopping frequency for junctions realized on glass substrates is bolometer-like with a strong thermal coupling between film and substrate. The responsivity of a junction of 50 μ m × 20 μ m is 50 V/W in vacuum and at liquid helium temperature, and its time constant is lower than 10 μ s . The linearity of the response on the optical power extends over five order of magnitude. The response of junctions fabricated on silicon substrates is flat versus the chopping frequency and about 100 times lower than a junction on glass with the same incident optical power. The shift of the gap at temperatures between 1.2 K and 4.2 K has been measured to separate the nonequilibrium effects from the heating effects.

International Journal of Modern Physics B•Apr 20, 1999•1 citation

Enhanced optical detection in a Josephson junction

M. S. Wire, Lee O. Heflinger, Bruce J. Dalrymple +4 more

Shifting of the energy gap of a Nb Josephson junction under direct optical illumination was measured. The response is linear with optical input power over more than five orders of magnitude and is nearly independent of temperature from 4 to 8 K. The rise time of this signal is faster than the 2- mu s rise time of the chopped light signal. These direct signals are 500 to 1500 times larger than those obtained when the same optical power is focused elsewhere on the substrate. This enhanced direct response is interpreted as resulting from thermal isolation of the Josephson junction from the substrate due to thermal boundary resistance.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•2 citations

Far infrared detection with Josephson junctions. Final report

C. K. So, William O. Hamilton

The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.

•Dec 1, 1976•0 citations

Response of Nb-aSi-Nb junctions to 604 GHz radiation

W. C. Danchi, John U. Free, F. Habbal +2 more

We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.

IEEE Transactions on Magnetics•Mar 1, 1985•3 citations

Niobium nitride-niobium Josephson tunnel junctions with sputtered amorphous silicon barriers

D. W. Jillie, Harry Kroger, L. N. Smith +2 more

Niobium nitride-niobium Josephson tunnel junctions with sputtered amorphous silicon barriers (NbN-αSi-Nb) have been prepared using processing that is fully compatible with integrated circuit fabrication. These junctions are of suitable quality and uniformity for digital circuit and S-I-S detector applications. The junction quality depends critically upon the properties of the NbN surface, and seems to correlate well with the UV/visible reflectivity of this surface.

Applied Physics Letters•Apr 15, 1982•40 citations

Untuned Josephson detectors of microwave and millimeter-wave radiation

C. K. So, William O. Hamilton

The intrinsic response of Josephson junctions to microwave and far-infrared radiation is studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junction. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22 to 105 GHz. The dependence of the responsivity of these currents on film thickness over a range from 50 to 500 Å is studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies. The observed responsivity of a 50-Å film junction at 22 GHz is (6±3) ×10−2 V/W. To facilitate comparison of our results with other experiments, a more conventional coupling configuration in which the wave electric field rather than the wave magnetic field is coupled to the junction is studied. The results are comparable with other experiments with the responsivity in the E field coupling case 106 times larger than in the B field coupling configuration. We demonstrate that for successful use of simple Josephson junction detectors in the microwave and millimeter region it seems crucial to impedance match the junctions to the radiation source, probably by making them a part of a resonant structure.

Journal of Applied Physics•May 1, 1977•1 citation
The response of Nb Josephson junctions fabricated on different substrates, silicon and amorphous glass, is measured under optical illumination at several conditions of light intensity and light chopping frequency. The linearity of the response on the optical power extends over five orders of magnitude. The signal of the junction on silicon is 2 orders of magnitude lower than that of the junction on amorphous glass, but at least one order of magnitude faster, as the time constant of a directly irradiated junction on silicon is lower than 10 /spl mu/s. The signal dependence on chopping frequency of the junction on amorphous glass is typical of a strong thermal coupling between film and substrate, while for the junction on silicon it depends mainly on the thermal boundary resistance between film and substrate.
The gap voltage shift of Nb Josephson junctions fabricated on different substrates is measured under optical illumination at several conditions of light intensity and chopping frequency. The signal dependence on the chopping frequency for junctions realized on glass substrates is bolometer-like with a strong thermal coupling between film and substrate. The responsivity of a junction of 50 μ m × 20 μ m is 50 V/W in vacuum and at liquid helium temperature, and its time constant is lower than 10 μ s . The linearity of the response on the optical power extends over five order of magnitude. The response of junctions fabricated on silicon substrates is flat versus the chopping frequency and about 100 times lower than a junction on glass with the same incident optical power. The shift of the gap at temperatures between 1.2 K and 4.2 K has been measured to separate the nonequilibrium effects from the heating effects.
Shifting of the energy gap of a Nb Josephson junction under direct optical illumination was measured. The response is linear with optical input power over more than five orders of magnitude and is nearly independent of temperature from 4 to 8 K. The rise time of this signal is faster than the 2- mu s rise time of the chopped light signal. These direct signals are 500 to 1500 times larger than those obtained when the same optical power is focused elsewhere on the substrate. This enhanced direct response is interpreted as resulting from thermal isolation of the Josephson junction from the substrate due to thermal boundary resistance.>
The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.
We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.
The intrinsic response of Josephson junctions to microwave and far-infrared radiation is studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junction. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22 to 105 GHz. The dependence of the responsivity of these currents on film thickness over a range from 50 to 500 Å is studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies. The observed responsivity of a 50-Å film junction at 22 GHz is (6±3) ×10−2 V/W. To facilitate comparison of our results with other experiments, a more conventional coupling configuration in which the wave electric field rather than the wave magnetic field is coupled to the junction is studied. The results are comparable with other experiments with the responsivity in the E field coupling case 106 times larger than in the B field coupling configuration. We demonstrate that for successful use of simple Josephson junction detectors in the microwave and millimeter region it seems crucial to impedance match the junctions to the radiation source, probably by making them a part of a resonant structure.