International Conference on Submillimeter Waves and Their Applications

Josephson Junctions as Heterodyne Detectors

Y. Taur, J. H. Claassen, P. L. Richards

Published Jun 1, 1974• 16 citations

Abstract

Heterodyne detection with a point contact Josephson junction has been investigated both experimentally and theoretically. From our results at 36 GHz, we can extrapolate a potentially impressive performance for these devices at submillimeter wavelengths.

DOI: 10.1109/icswa.1974.9333735

Related papers

Josephson Junctions as Heterodyne Detectors

Y. Taur, J. H. Claassen, P. L. Richards

Heterodyne detection with a point-contact Josephson junction has been investigated both experimentally and theoretically. The measured performance of the device at 36 GHz is in good agreement with the theory. By operating vanadium point contacts at 1.4 K, we have achieved a single-sideband (SSB) mixer noise temperature of 54K with a conversion gain of 1.35 and a signal bandwidth on the order of 1 GHz. From our results we can extrapolate a potentially impressive performance for these devices at submillimeter wavelengths.

IEEE Transactions on Microwave Theory and TechniquesDec 1, 197427 citations

Josephson mixers at submillimeter wavelengths: present experimental status and future developments

T. G. Blaney

The use of Josephson mixers with an external local oscillator for sensitive heterodyne reception at submillimeter wavelengths is discussed. Recent experiments, primarily at 450 GHz (0.66 mm wavelength), together with our present theoretical knowledge, allow realistic estimates of future receiver performance to be made. Although some practical problems remain, the probability of building field‐usable receivers with very competitive sensitivity now appears good. A discussion is also given of the use of the high‐harmonic mixing properties of Josephson devices for frequency measurement in the far infrared.

AIP conference proceedingsJan 1, 19787 citations

Studies of noise in Josephson-effect mixers and their potential for submillimeter heterodyne detection

Robert J. Schoelkopf

NOTE: Text or symbols not renderable in plain ASCII are indicated by [...]. Abstract is included in .pdf document. This thesis describes both theoretical and experimental investigations into the dynamics and noise processes of Josephson junctions, with the intent of evaluating their potential as mixers in heterodyne instruments for submillimeter-wave (i.e., the frequency range from 300 GHz to 3THz) detection. Superconducting tunnel junctions utilizing the nonlinearity due to photon-assisted tunneling of quasiparticles (SIS mixers) have become the state-of-the-art technology for sensitive heterodyne detection up to frequencies of about 700 [...]. Recent progress in the fabrication of high [...], superconductors has led to Josephson-effect devices with [...] products of up to ten millivolts, which might be suitable for mixing at frequencies of many terahertz. The key question for weighing the prospects for high-frequency Josephson mixers is that of the sensitivity which can be attained. Previous experimental work on Josephson mixing suggests the existence of an "excess" noise, which degrades the sensitivity. Theoretical modeling of mixer performance, based on the resistivelyshunted junction (RSJ) model for the dynamics of the device, also indicates the presence of larger noise than expected. The origin of this noise was not clearly understood, however, nor was its exact magnitude or expected scaling with frequency or junction characteristics known. In addition, previous experiments utilized crude devices of the point-contact type, which were unstable and thus undesirable for real applications. In the first part of this thesis research, extensive numerical simulations were performed with the RSJ model, including calculations of mixer noise and conversion efficiency. These calculations have revealed that the source of excess noise is the AC Josephson oscillations of the device, which can be completely incoherent, with a linewidth comparable to their frequency. Thus they appear as a broadband noise source. While this noise is intrinsic and unavoidable, an optimized mixer is still shown to be capable of interesting sensitivity levels, and the excess noise is expected to become relatively less important as the operating frequency is increased. Secondly, a process has been developed for the fabrication of stable, well-characterized, and reproducible Josephson devices based on resistively-shunted Nb and NbN tunnel junctions. The devices utilize submicron-area, high current-density tunnel junctions and a AuGe shunt resistor to yield completely non-hysteretic I-V curves, normal-state resistances of about [...] products of about half a millivolt. These devices should be nearly optimal for mixing at [...]. Heterodyne measurements using these junctions have been performed in a waveguide mixer mount. Receiver temperatures as low as 190 K (DSB), with -6 dB conversion efficiency, have been obtained at 100 [...], but these results are still a factor of about four higher than those predicted by the RSJ simulations. Accurate measurements of the available noise power of the junctions at the intermediate frequency of 1.5 [...] were made, and confirmed that the receivers were limited by elevated junction output noise. The deviations of the noise from theoretical predictions are shown to be caused by the nonlinear interaction of the junction with the embedding circuit. While this work points out some of the complexity introduced by the strong nonlinearity of Josephson devices, it is still expected that Josephson-effect mixers may be useful for heterodyne detection at very high frequencies.

Nov 7, 20074 citations

Far infrared detection by Josephson junctions

Chi Kong So

A group at Bell Telephone Laboratories has reported using superconducting point contacts that show zerovoltage Josephson current as “sensitive, broadband, high-speed detectors of millimeter and submillimeter radiation.” The work was done by C. C. Grimes, P. L. Richards and S. Shapiro and reported in Physical Review Letters 17, 431 (1966).

Physics TodayNov 1, 19660 citations

Superconducting devices for millimeter and submillimeter wavelengths

P. L. Richards

Josephson junctions are highly nonlinear and respond up to infrared frequencies. A wide variety of high frequency applications have been explored. In addition, several high frequency superconducting devices are being developed which do not use the Josephson effect. These include a superconducting version of the Schottky barrier diode for use as a heterodyne mixer and a video detector, and also a composite superconducting bolometer. In this review, the state of development of superconducting mixers, detectors, and parametric amplifiers at microwave, millimeter, and submillimeter wavelengths is discussed. Emphasis will be placed on developments which have taken place since 1974 when a previous review was circulated.

De Gruyter eBooksDec 31, 19777 citations

Josephson heterodyne detection at high thermal background levels

Tim Poorter

Point-contact Josephson junctions with a submicron contact diameter have been used as high-frequency mixers (170–220 GHz) under high thermal background conditions. The junction is formed across a full height (0.56×1.06 mm2) waveguide between a 3–5-μm thick Nb whisker and a 0.2-mm diam Nb center conductor of a coaxial line. The best single-side band mixer-noise temperature that was measured is 165 K (± 25%) with a corresponding single-side band conversion efficiency of 0.36±0.03 (a loss of 4.5 ±0.4 dB) at a signal frequency of 185 GHz, including losses in the coupling horn and the waveguide. The performance was measured with the hot-cold source technique. The effects of nonheterodyne response in that situation were investigated in detail. The junctions have been operated in a coherent receiver that can be used on a telescope with only small adaptations. The instantaneous bandwidth of the receiver is about 20 GHz.

Journal of Applied PhysicsJan 1, 198227 citations