Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Wavelength conversion of incoherent light by sum-frequency generation

Shin Arahira, Hitoshi Murai

Published May 21, 2014• 20 citations
Publisher

Abstract

In this paper, we reveal that some kinds of optical nonlinearities are further enhanced when incoherent light, instead of a laser, is used as a pump light. This idea was confirmed both theoretically and experimentally in the case of sum-frequency generation (SFG) using the optical second nonlinearity. The conversion efficiency of the SFG with incoherent light pumping increased as the bandwidth of the incoherent pump light decreased, finally reaching twice the conversion efficiency of conventional second harmonic generation (SHG) by laser pumping. This method dramatically relaxes the severe requirements of phase matching in the nonlinear optical process. The conversion efficiency became less sensitive to misalignment of the wavelength of pump light and also of device operation temperature when the bandwidth of the incoherent pump light was sufficiently broad, although the improvement of the conversion efficiency had an inverse relationship with the insensitivity to the phase-matching condition. The temperature tuning range was enhanced by more than two orders of magnitude in comparison with the conventional SHG method. As an example of a promising application of this new idea, we performed the generation of quantum entangled photon-pairs using cascaded optical nonlinearities (SFG and the subsequent spontaneous parametric down conversion) in a single periodically poled LiNbO3 waveguide device, in which the incoherent light was used as the pump source for both the parametric processes. We have achieved high fidelity exceeding 99% in quantum-state tomography experiments.

DOI
10.1364/oe.22.012944

Related papers

Comparison of cascaded χ2 wavelength conversions in quasi-phase-matched (QPM) waveguides

Bo Chen, Chang‐Qing Xu

Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 16, 2004•0 citations

Cascaded wavelength conversions based on sum-frequency generation and difference-frequency generation

Chang‐Qing Xu, Bo Chen

A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.

Optics Letters•Feb 1, 2004•51 citations

All-Optical Wavelength Conversion Based on the Cascaded Sum and Difference Frequency Generation in a Periodically Poled Lithium-Niobate Waveguide

Jian Wang

The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.

Optics & Optoelectronic Technology•Jan 1, 2007•0 citations

Study of broadband multimode light via non-phase-matched sum frequency generation

Denis A. Kopylov, Kirill Yu. Spasibko, T. V. Murzina +1 more

We propose non-phase-matched sum frequency generation (SFG) as a method for characterizing broadband multimode light. Both the central wavelength and the bandwidth are in this case not limited by the phase matching condition. As an example, we consider bright squeezed vacuum (BSV) generated through high-gain parametric down conversion (PDC). In the spectrum of SFG from BSV, we observe the coherent peak and the incoherent background. We show that the ratio of their widths is equal to the number of frequency modes in BSV, which in the case of low-gain PDC gives the degree of frequency entanglement for photon pairs. By generating the sum frequency in the near-surface region of a nonlinear crystal, we increase the SFG efficiency and get rid of the modulation caused by chromatic dispersion, known as Maker fringes. This allows one to use non-phasematched SFG as a wavelength-independent autocorrelator. Furthermore, we demonstrate efficient non-phase-matched three- and four-frequency summation of broadband multimode light, hardly possible under phase matching. We show that the latter contains the coherent peak while the former does not.

arXiv:1810.02760•New Journal of Physics•Feb 26, 2019•11 citations

Channel-selective wavelength conversion and tuning in periodically poled Ti:LiNbO3 waveguides

Yeung Lak Lee, Changsoo Jung, Young-Chul Noh +4 more

All-optical wavelength-selective single- and dual-channel wavelength conversion and tuning has been demonstrated in a periodically poled Ti:LiNbO(3) waveguide that has two second-harmonic phase-matching peaks by cascaded sum and difference frequency generation (cSFG/DFG). The wavelength conversion efficiency was measured to be -7 dB with coupled pump power of 233 mW.

Optics Express•Jan 1, 2004•35 citations

Analysis of Novel Cascaded $chi^(2)$ (SFG $+$ DFG) Wavelength Conversions in Quasi-Phase-Matched Waveguides

B. Chen, Chang‐Qing Xu

A novel cascaded second-order nonlinear interaction (/spl chi//sup (2)/), which is simultaneously based on sum frequency generation (SFG) and difference frequency generation (DFG) processes, is proposed and analyzed in quasi-phase-matched wavelength converters. Analytical expressions with clear physical insights are derived for the converted light. It is shown that the same conversion efficiency can be achieved by employing two pump sources with lower output power (P/sub p1/,P/sub p2/) in this novel scheme as compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and difference frequency generation (SHG+DFG) with a single higher power pump beam (P/sub p/=P/sub p1/+P/sub p2/). The theoretical results are consistent with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while large 3-dB signal conversion bandwidth is retained. The results show that the novel cascaded /spl chi//sup (2)/ wavelength conversion scheme is very attractive for practical applications.

IEEE Journal of Quantum Electronics•Mar 1, 2004•47 citations
In this paper, we reveal that some kinds of optical nonlinearities are further enhanced when incoherent light, instead of a laser, is used as a pump light. This idea was confirmed both theoretically and experimentally in the case of sum-frequency generation (SFG) using the optical second nonlinearity. The conversion efficiency of the SFG with incoherent light pumping increased as the bandwidth of the incoherent pump light decreased, finally reaching twice the conversion efficiency of conventional second harmonic generation (SHG) by laser pumping. This method dramatically relaxes the severe requirements of phase matching in the nonlinear optical process. The conversion efficiency became less sensitive to misalignment of the wavelength of pump light and also of device operation temperature when the bandwidth of the incoherent pump light was sufficiently broad, although the improvement of the conversion efficiency had an inverse relationship with the insensitivity to the phase-matching condition. The temperature tuning range was enhanced by more than two orders of magnitude in comparison with the conventional SHG method. As an example of a promising application of this new idea, we performed the generation of quantum entangled photon-pairs using cascaded optical nonlinearities (SFG and the subsequent spontaneous parametric down conversion) in a single periodically poled LiNbO3 waveguide device, in which the incoherent light was used as the pump source for both the parametric processes. We have achieved high fidelity exceeding 99% in quantum-state tomography experiments.
Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.
A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.
The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.
We propose non-phase-matched sum frequency generation (SFG) as a method for characterizing broadband multimode light. Both the central wavelength and the bandwidth are in this case not limited by the phase matching condition. As an example, we consider bright squeezed vacuum (BSV) generated through high-gain parametric down conversion (PDC). In the spectrum of SFG from BSV, we observe the coherent peak and the incoherent background. We show that the ratio of their widths is equal to the number of frequency modes in BSV, which in the case of low-gain PDC gives the degree of frequency entanglement for photon pairs. By generating the sum frequency in the near-surface region of a nonlinear crystal, we increase the SFG efficiency and get rid of the modulation caused by chromatic dispersion, known as Maker fringes. This allows one to use non-phasematched SFG as a wavelength-independent autocorrelator. Furthermore, we demonstrate efficient non-phase-matched three- and four-frequency summation of broadband multimode light, hardly possible under phase matching. We show that the latter contains the coherent peak while the former does not.
Analysis of Novel Cascaded chi(2)chi^(2)chi(2) (SFG +++ DFG) Wavelength Conversions in Quasi-Phase-Matched Waveguides
A novel cascaded second-order nonlinear interaction (/spl chi//sup (2)/), which is simultaneously based on sum frequency generation (SFG) and difference frequency generation (DFG) processes, is proposed and analyzed in quasi-phase-matched wavelength converters. Analytical expressions with clear physical insights are derived for the converted light. It is shown that the same conversion efficiency can be achieved by employing two pump sources with lower output power (P/sub p1/,P/sub p2/) in this novel scheme as compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and difference frequency generation (SHG+DFG) with a single higher power pump beam (P/sub p/=P/sub p1/+P/sub p2/). The theoretical results are consistent with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while large 3-dB signal conversion bandwidth is retained. The results show that the novel cascaded /spl chi//sup (2)/ wavelength conversion scheme is very attractive for practical applications.