Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Optically controlled light-pulse propagation in closed-loop configuration with saturable erbium-doped fiber

Anna Shlyagina, Serguei I. Stepanov

Published Sep 19, 2014• 1 citation
Publisher

Abstract

We report experimental results on the 1550 nm modulated light propagation in a closed-loop all-fiber resonance configuration, which includes a segment of the erbium-doped fiber with saturable optical absorption. It is shown that by a simple increase of the average incident light power, one can switch from the undercoupling to the overcoupling with the closed-loop cavity, which leads to a dramatic change from advancement to delay in the transmitted optical signal with the resonance carrier frequency. In the reported experiments with the ≈4.4 m long closed-loop cavity (with a 2.4 m long EDF segment) we observed a switch from ≈0.26 fractional advancement to ≈0.65 fractional delay in 166 ns periodic light pulses with a resonance frequency in the 1550 nm wavelength range when the average incident power was changed from 0.09 to 0.6 mW.

DOI
10.1364/josab.31.002414

Related papers

Controllable propagation of light pulses in Er-doped fibers with saturable absorption

Serguei I. Stepanov, Eliseo Hernández

We report controllable (slow or fast) propagation of low-intensity probe-light pulses through erbium-doped fiber periodically saturated by the synchronized master-pulse sequence. These two pulse sequences could have significantly different carrier wavelengths within the fundamental absorption spectrum 1470-1570 nm of Er(+3) ions. The effect of fractional delay or advancement grew with the fiber optical absorption at the probe wavelength and could be significantly stronger than that at the saturating wavelength. The probe-pulse advancement was observed in the case when the saturating and probe waves were modulated approximately in antiphase. The observed effects are explained in the framework of a simple model of a periodically saturated homogeneously broadened absorption line.

Optics Letters•Sep 26, 2008•13 citations

Observation of superluminal and slow light propagation in erbium-doped optical fiber

Aaron Schweinsberg, Nikolay N. Lepeshkin, Matthew S. Bigelow +2 more

We observe both extremely slow and superluminal pulse propagation speeds at room temperature in an erbium-doped fiber (EDF). A signal at 1550 nm is sent through an erbium-doped fiber with varying powers of a 980 nm pump. The degree of signal delay or advancement is found to depend significantly on the pump intensity. We observe a maximum fractional advancement of 0.124 and a maximum fractional delay of 0.089. The effect is demonstrated both for a sinusoidally modulated signal and for Gaussian pulses. The ability to control the sign and magnitude of the pulse velocity could have important implications for applications in photonics.

Europhysics Letters (EPL)•Dec 1, 2005•185 citations

Observation of slow light propagation in saturable erbium doped fiber via transient fluorescence at the fiber side

Anna Shlyagina, Marcos Plata Sánchez, Serguei I. Stepanov

Erbium-doper fiber (EDF) is a flexible and promising model medium for investigation of the slow/fast light propagation in saturable optical materials. The experiments are usually performed in the spectral range 1480-1570 nm of the absorption/gain of Er3+ ions using the input power of a sub-mW scale. Conventional experimental configuration allows one to observe, however, the input and the output pulse profiles only. We report an original nondestructive technique for observation of a spatial propagation of the pulses via observation of the transient fluorescence excited by the propagating light-pulses at the fiber side, from which we are able to reconstruct how does the fractional delay and the amplitude of the propagating pulses change along the fiber. Results of a numerical simulation of the nonlinear pulse propagation performed for a saturable two-level medium in low contrast approximation proved to be in a reasonable agreement with the experimental observations.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 5, 2011•0 citations

Modulation-frequency-controlled change from sub- to superluminal regime in highly doped erbium fibers

Sonia Melle, Óscar G. Calderón, E. Cesar +3 more

We report a change from sub- to superluminal propagation upon increasing the modulation frequency of an amplitude-modulated 1,550 nm signal when propagating through highly doped erbium fibers pumped at 980 nm. We show that the interplay between the pump absorption and the pump-power broadening of the spectral hole induced by coherent population oscillations may drastically affect the fractional advancement or delay of the signal for the considered fibers.

Optics Letters•Apr 11, 2008•16 citations

Controllable delay of light pulses in erbium-doped optical fibers with saturable absorption

Serguei I. Stepanov, Eliseo Hernández

We report a controllable delay of the probe light pulse sequence by a master, saturating pulses of significantly different wavelength (at 1526 and 1568 nm respectively) observed in erbium-doped single-mode fiber with saturable absorption.

Frontiers in Optics•Jan 1, 2008•0 citations

Optical-fiber ring cavity with saturable rare-earth-doped fiber

E. Aguilar, S. Srepanov, E. Hernandez

Resonance properties of the all-fiber ring cavity filled with nonlinear material - saturable rare-earth-doped fiber are analyzed and experimentally investigated. Unlike the earlier investigated erbium-doped fiber at 1550nm where the optical absorption photo-induced change (saturation) is observed only, the ytterbium-doped fiber at 1064nm demonstrates the saturation of the refractive index mainly. For this configuration we report experimental observation of the optical bistability and hysteresis in the transmitted output light at the 10mW-scale incident light power. The experimental results are in qualitative agreement with the theoretical analysis that takes into account the saturation of both parameters: the optical absorption and the refractive index of the doped fiber. The reported results seem promising for applications in high-sensitivity interferometric configurations at 1064nm operation wavelength.

Suplemento de la Revista Mexicana de Física•Mar 31, 2021•1 citation
We report experimental results on the 1550 nm modulated light propagation in a closed-loop all-fiber resonance configuration, which includes a segment of the erbium-doped fiber with saturable optical absorption. It is shown that by a simple increase of the average incident light power, one can switch from the undercoupling to the overcoupling with the closed-loop cavity, which leads to a dramatic change from advancement to delay in the transmitted optical signal with the resonance carrier frequency. In the reported experiments with the ≈4.4 m long closed-loop cavity (with a 2.4 m long EDF segment) we observed a switch from ≈0.26 fractional advancement to ≈0.65 fractional delay in 166 ns periodic light pulses with a resonance frequency in the 1550 nm wavelength range when the average incident power was changed from 0.09 to 0.6 mW.
We report controllable (slow or fast) propagation of low-intensity probe-light pulses through erbium-doped fiber periodically saturated by the synchronized master-pulse sequence. These two pulse sequences could have significantly different carrier wavelengths within the fundamental absorption spectrum 1470-1570 nm of Er(+3) ions. The effect of fractional delay or advancement grew with the fiber optical absorption at the probe wavelength and could be significantly stronger than that at the saturating wavelength. The probe-pulse advancement was observed in the case when the saturating and probe waves were modulated approximately in antiphase. The observed effects are explained in the framework of a simple model of a periodically saturated homogeneously broadened absorption line.
We observe both extremely slow and superluminal pulse propagation speeds at room temperature in an erbium-doped fiber (EDF). A signal at 1550 nm is sent through an erbium-doped fiber with varying powers of a 980 nm pump. The degree of signal delay or advancement is found to depend significantly on the pump intensity. We observe a maximum fractional advancement of 0.124 and a maximum fractional delay of 0.089. The effect is demonstrated both for a sinusoidally modulated signal and for Gaussian pulses. The ability to control the sign and magnitude of the pulse velocity could have important implications for applications in photonics.
Erbium-doper fiber (EDF) is a flexible and promising model medium for investigation of the slow/fast light propagation in saturable optical materials. The experiments are usually performed in the spectral range 1480-1570 nm of the absorption/gain of Er3+ ions using the input power of a sub-mW scale. Conventional experimental configuration allows one to observe, however, the input and the output pulse profiles only. We report an original nondestructive technique for observation of a spatial propagation of the pulses via observation of the transient fluorescence excited by the propagating light-pulses at the fiber side, from which we are able to reconstruct how does the fractional delay and the amplitude of the propagating pulses change along the fiber. Results of a numerical simulation of the nonlinear pulse propagation performed for a saturable two-level medium in low contrast approximation proved to be in a reasonable agreement with the experimental observations.
Resonance properties of the all-fiber ring cavity filled with nonlinear material - saturable rare-earth-doped fiber are analyzed and experimentally investigated. Unlike the earlier investigated erbium-doped fiber at 1550nm where the optical absorption photo-induced change (saturation) is observed only, the ytterbium-doped fiber at 1064nm demonstrates the saturation of the refractive index mainly. For this configuration we report experimental observation of the optical bistability and hysteresis in the transmitted output light at the 10mW-scale incident light power. The experimental results are in qualitative agreement with the theoretical analysis that takes into account the saturation of both parameters: the optical absorption and the refractive index of the doped fiber. The reported results seem promising for applications in high-sensitivity interferometric configurations at 1064nm operation wavelength.