Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Optical pumping in a microfabricated Rb vapor cell using a microfabricated Rb discharge light source

Vinu Venkatraman, Songbai Kang, C. Affolderbach, Herbert R. Shea, G. Mileti

Published Feb 3, 2014• 15 citations
Publisher

Abstract

Miniature (<few cm3) vapor-cell based devices using optical pumping of alkali atoms, such as atomic clocks and magnetometers, today mostly employ vertical-cavity surface-emitting lasers as pump light sources. Here, we report on the demonstration of optical pumping in a microfabricated alkali vapor resonance cell using (1) a microfabricated Rb discharge lamp light source, as well as (2) a conventional glass-blown Rb discharge lamp. The microfabricated Rb lamp cell is a dielectric barrier discharge (DBD) light source, having the same inner cell volume of around 40 mm3 as that of the resonance cell, both filled with suitable buffer gases. A miniature (∼2 cm3 volume) test setup based on the Mz magnetometer interrogation technique was used for observation of optical-radiofrequency double-resonance signals, proving the suitability of the microfabricated discharge lamp to introduce efficient optical pumping. The pumping ability of this light source was found to be comparable to or even better than that of a conventional glass-blown lamp. The reported results indicate that the micro-fabricated DBD discharge lamp has a high potential for the development of a new class of miniature atomic clocks, magnetometers, and quantum sensors.

DOI
10.1063/1.4864080

Related papers

Demonstration of optical pumping using a micro-fabricated Rb dielectric barrier discharge (DBD) lamp

Songbai Kang, Vinu Venkatraman, C. Affolderbach +2 more

Recently, a low-power, mm-scale (~0.3 cm3) Rb dielectric barrier discharge (DBD) lamp was demonstrated, in view of the development of a chip-scale atomic clock based on the traditional double-resonance (DR) interrogation scheme. Here, we report on the demonstration of optical pumping in a micro-fabricated Rb vapor cell (~0.3 cm3), using such a DBD Rb lamp as a pump light source. As a first step, we demonstrate Zeeman optical pumping in the Mz magnetometer configuration and observe the DR error signals. Comparative studies between DBD lamp and glass-blown (GB) lamp on the intensity noise and the DR error signals were performed. These results show that the performances of DBD lamp are comparable to those of a conventional glass-blown lamp, which indicates a high potential of the DBD lamp for the development of miniature atomic clocks, magnetometers and quantum sensors.

European Frequency and Time Forum•Jun 1, 2014•0 citations

Microfabricated chip-scale rubidium plasma light source for miniature atomic clocks

Vinu Venkatraman, Yves Pétremand, C. Affolderbach +3 more

We present the microfabrication and characterization of a low-power, chip-scale Rb plasma light source, designed for optical pumping in miniature atomic clocks. A dielectric barrier discharge (DBD) configuration is used to ignite a Rb plasma in a micro-fabricated Rb vapor cell on which external indium electrodes were deposited. The device is electrically driven at frequencies between 1 and 36 MHz, and emits 140 μW of stable optical power while coupling less than 6 mW of electrical power to the discharge cell. Optical powers of up to 15 and 9 μW are emitted on the Rb D2 and D1 lines, respectively. Continuous operation of the light source for several weeks has been demonstrated, showing its capacity to maintain stable optical excitation of Rb atoms in chip-scale double-resonance atomic clocks.

IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control•Mar 1, 2012•11 citations

Microfabrication and packaging of a Rubidium vapor cell as a plasma light source for MEMS atomic clocks

Vinu Venkatraman, Yves Pétremand, C. Affolderbach +3 more

We report on the micro-fabrication and characterization of a chip-scale plasma light source based on a Rubidium (Rb) vapor cell. The Rb plasma light source is intended for use as an integrated optical pump-light source in miniature double-resonance Rb atomic clocks. The RF plasma is capacitively coupled using external electrodes, and the light source is impedance matched to the source for frequencies between 1 and 36 MHz. Rb vapor cells have been previously developed as reference cells for atomic clocks but not as light sources. This is the first reported Rb plasma emitted from a chip-scale device. Stable light emission is observed for over 18 days.

International Conference on Solid-State Sensors, Actuators and Microsystems•Jun 1, 2011•3 citations

Laser-pumped double-resonance atomic clock using a micro-fabricated Rb cell

Matthieu Pellaton, Yves Pétremand, C. Affolderbach +2 more

We present first results on a laser-pumped, double resonance (DR) Rubidium atomic clock, based on micro-fabricated Rb vapour cells. The study aims towards a miniature atomic clock based on DR, using a low-power laser as pump light source and a miniaturized microwave coupling structure (that will replace the bulky microwave cavity employed in today's much bigger Rb clocks). Good signal amplitude, low background light level, and no need for GHz laser modulation are among the advantages of this approach.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2011•0 citations

Microfabrication and Measurement of Rb-Ne Microcell for Chip-Scale Atomic Clocks

Fan Zhang, Yong Ruan, Yanying Feng +1 more

We report the fabrication of a micro vapor cell which has Rb and Ne inside with internal volumes of several millimeters, which is the key component of chip-scale atomic devices like clocks and magnetometers. The cells were filled with Ne at a controlled pressure as the buffer gas by using glass-silicon anodic bonding techniques and dispenser pills of SAES Getters. And a special two-step bonding method was taken to avoid breakdown caused by the buffer gas and to secure the quality of the bonding. We also built an optical measuring system and measured the coherent population trapping (CPT) resonance of85Rb D1 line with a linewidth below 2.0 kHz and a contrast about 1.1%. Zeeman spectrum for CPT resonance was also detected in these microcells. These results show that these vapor cells are capable to be used in atomic clocks or magnetometers.

IEEE CSAA Guidance, Navigation and Control Conference (CGNCC)•Aug 1, 2018•0 citations

Microfabricated alkali atom vapor cells

Li‐Anne Liew, Svenja A. Knappe, John Moreland +3 more

We describe the fabrication of chip-sized alkali atom vapor cells using silicon micromachining and anodic bonding technology. Such cells may find use in highly miniaturized atomic frequency references or magnetometers. The cells consist of cavities etched in silicon, with internal volumes as small as 1 mm3. Two techniques for introducing cesium and a buffer gas into the cells are described: one based on chemical reaction between cesium chloride and barium azide, and the other based on direct injection of elemental cesium within a controlled anaerobic environment. Cesium optical absorption and coherent population trapping resonances were measured in the cells.

Applied Physics Letters•Apr 1, 2004•374 citations
Miniature (<few cm3) vapor-cell based devices using optical pumping of alkali atoms, such as atomic clocks and magnetometers, today mostly employ vertical-cavity surface-emitting lasers as pump light sources. Here, we report on the demonstration of optical pumping in a microfabricated alkali vapor resonance cell using (1) a microfabricated Rb discharge lamp light source, as well as (2) a conventional glass-blown Rb discharge lamp. The microfabricated Rb lamp cell is a dielectric barrier discharge (DBD) light source, having the same inner cell volume of around 40 mm3 as that of the resonance cell, both filled with suitable buffer gases. A miniature (∼2 cm3 volume) test setup based on the Mz magnetometer interrogation technique was used for observation of optical-radiofrequency double-resonance signals, proving the suitability of the microfabricated discharge lamp to introduce efficient optical pumping. The pumping ability of this light source was found to be comparable to or even better than that of a conventional glass-blown lamp. The reported results indicate that the micro-fabricated DBD discharge lamp has a high potential for the development of a new class of miniature atomic clocks, magnetometers, and quantum sensors.
Recently, a low-power, mm-scale (~0.3 cm3) Rb dielectric barrier discharge (DBD) lamp was demonstrated, in view of the development of a chip-scale atomic clock based on the traditional double-resonance (DR) interrogation scheme. Here, we report on the demonstration of optical pumping in a micro-fabricated Rb vapor cell (~0.3 cm3), using such a DBD Rb lamp as a pump light source. As a first step, we demonstrate Zeeman optical pumping in the Mz magnetometer configuration and observe the DR error signals. Comparative studies between DBD lamp and glass-blown (GB) lamp on the intensity noise and the DR error signals were performed. These results show that the performances of DBD lamp are comparable to those of a conventional glass-blown lamp, which indicates a high potential of the DBD lamp for the development of miniature atomic clocks, magnetometers and quantum sensors.
We present the microfabrication and characterization of a low-power, chip-scale Rb plasma light source, designed for optical pumping in miniature atomic clocks. A dielectric barrier discharge (DBD) configuration is used to ignite a Rb plasma in a micro-fabricated Rb vapor cell on which external indium electrodes were deposited. The device is electrically driven at frequencies between 1 and 36 MHz, and emits 140 μW of stable optical power while coupling less than 6 mW of electrical power to the discharge cell. Optical powers of up to 15 and 9 μW are emitted on the Rb D2 and D1 lines, respectively. Continuous operation of the light source for several weeks has been demonstrated, showing its capacity to maintain stable optical excitation of Rb atoms in chip-scale double-resonance atomic clocks.
We report on the micro-fabrication and characterization of a chip-scale plasma light source based on a Rubidium (Rb) vapor cell. The Rb plasma light source is intended for use as an integrated optical pump-light source in miniature double-resonance Rb atomic clocks. The RF plasma is capacitively coupled using external electrodes, and the light source is impedance matched to the source for frequencies between 1 and 36 MHz. Rb vapor cells have been previously developed as reference cells for atomic clocks but not as light sources. This is the first reported Rb plasma emitted from a chip-scale device. Stable light emission is observed for over 18 days.
We present first results on a laser-pumped, double resonance (DR) Rubidium atomic clock, based on micro-fabricated Rb vapour cells. The study aims towards a miniature atomic clock based on DR, using a low-power laser as pump light source and a miniaturized microwave coupling structure (that will replace the bulky microwave cavity employed in today's much bigger Rb clocks). Good signal amplitude, low background light level, and no need for GHz laser modulation are among the advantages of this approach.
We report the fabrication of a micro vapor cell which has Rb and Ne inside with internal volumes of several millimeters, which is the key component of chip-scale atomic devices like clocks and magnetometers. The cells were filled with Ne at a controlled pressure as the buffer gas by using glass-silicon anodic bonding techniques and dispenser pills of SAES Getters. And a special two-step bonding method was taken to avoid breakdown caused by the buffer gas and to secure the quality of the bonding. We also built an optical measuring system and measured the coherent population trapping (CPT) resonance of85Rb D1 line with a linewidth below 2.0 kHz and a contrast about 1.1%. Zeeman spectrum for CPT resonance was also detected in these microcells. These results show that these vapor cells are capable to be used in atomic clocks or magnetometers.
We describe the fabrication of chip-sized alkali atom vapor cells using silicon micromachining and anodic bonding technology. Such cells may find use in highly miniaturized atomic frequency references or magnetometers. The cells consist of cavities etched in silicon, with internal volumes as small as 1 mm3. Two techniques for introducing cesium and a buffer gas into the cells are described: one based on chemical reaction between cesium chloride and barium azide, and the other based on direct injection of elemental cesium within a controlled anaerobic environment. Cesium optical absorption and coherent population trapping resonances were measured in the cells.