Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Asia-Pacific Microwave Conference (APMC)

High Tc superconductor harmonic mixer at W-band

D. Jing, Wing Shing Chan, Kim Fung Tsang

Published Nov 22, 2002• 0 citations
Publisher

Abstract

Using high Tc superconductor Josephson junctions, a harmonic mixer at W-band has been realized. A local oscillator frequency of 43 GHz is used to down-convert a signal frequency of 96 GHz to an intermediate frequency of 10 GHz. The tangential sensitivity of the mixer was measured to be about -40 dBm.
DOI
10.1109/apmc.1997.659319

Related papers

Harmonic mixing at mm waveband in a high temperature superconducting grain boundary Josephson junction

Huabing Wang, Weiwei Xu, Qilin Cheng +4 more

Using a high Tc superconducting grain boundary Josephson junction, harmonic mixing experiments in the mm waveband were carried out, aiming at as large a harmonic number and as high a signal frequency as possible. The dependencies of intermediate frequency output on dc bias, harmonic number, frequency of local oscillator (LO), and other parameters were carefully studied. Until now, our best result was the mixing between the signal at 95 GHz and the 105th harmonic of LO at about 900 MHz. Preliminary experiments using a high Tc harmonic mixer and phase-locking loop were tried to stabilize the frequency of a mm wave source.

Journal of Applied Physics•Feb 15, 1994•16 citations

Harmonic Mixing Using a HTS Step-Edge Josephson Junction at 0.6 THz Frequency

Jia Du, Colin M. Pegrum, Xiang Gao +4 more

A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.

IEEE Transactions on Applied Superconductivity•Dec 6, 2016•28 citations

Terahertz harmonic mixer based on HTS Josephson junction

Mei Yu, Weiwei Xu, Jin Shi +3 more

High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 29, 2021•0 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

HTS step-edge Josephson junction terahertz harmonic mixer

Jia Du, Andrew R. Weily, Xiang Gao +3 more

A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.

Superconductor Science and Technology•Nov 30, 2016•42 citations

Frequency conversion with superconducting point contacts operating as oscillator-mixers and its application to the measurement of the linewidth of the Josephson current at very high frequency

G. Vernet, Robert Adde

The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.

Revue de Physique Appliquée•Jan 1, 1974•3 citations
Using a high Tc superconducting grain boundary Josephson junction, harmonic mixing experiments in the mm waveband were carried out, aiming at as large a harmonic number and as high a signal frequency as possible. The dependencies of intermediate frequency output on dc bias, harmonic number, frequency of local oscillator (LO), and other parameters were carefully studied. Until now, our best result was the mixing between the signal at 95 GHz and the 105th harmonic of LO at about 900 MHz. Preliminary experiments using a high Tc harmonic mixer and phase-locking loop were tried to stabilize the frequency of a mm wave source.
A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.
High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.
The Josephson frequency conversion in the millimeter and submillimeter wave region is studied with superconducting Nb-Nb point contact junctions at 4.2 K, using the contact both as the local oscillator and the mixer with intermediate frequencies of 0.1 and 9.2 GHz. Frequency conversion signals are only detected in the latter case with a microwave receiver at 9.2 GHz in a range of Josephson frequencies between 145 and 1 600 GHz. The experiments with intermediate frequency fi of 0.1 GHz indicate for this small value of f i that the observed signals are not related to frequency conversion but noise effects. An analysis of the frequency conversion mechanism in a Josephson junction operated as an oscillator-mixer is proposed which includes the noise effects and also the feedback effects induced in a junction driven by a constant current source. We have then investigated the noise properties up to 450 GHz of superconducting point-contacts using the junction as an oscillator-mixer where the Josephson current is mixed with harmonics of an externally applied signal. The emitted intermediate frequency is detected at 9.2 GHz and its linewidth is measured. In the very high frequency range the dc quasiparticle current dominates in a Josephson weak-link and we compare the corresponding theoretical linewidth calculated by Scalapino with our experimental results.